This paper presents a reconfigurable RF front-end for multi-mode multi-standard(MMMS) applications. The designed RF front-end is fabricated in 0.18 μm RF CMOS technology. The low noise characteristic is achieved by t...This paper presents a reconfigurable RF front-end for multi-mode multi-standard(MMMS) applications. The designed RF front-end is fabricated in 0.18 μm RF CMOS technology. The low noise characteristic is achieved by the noise canceling technique while the bandwidth is enhanced by gate inductive peaking technique. Measurement results show that, while the input frequency ranges from 100 MHz to 2.9 GHz, the proposed reconfigurable RF front-end achieves a controllable voltage conversion gain(VCG) from 18 dB to 39 dB. The measured maximum input third intercept point(IIP3) is-4.9 dBm and the minimum noise figure(NF) is 4.6 dB. The consumed current ranges from 16 mA to 26.5 mA from a 1.8 V supply voltage. The chip occupies an area of 1.17 mm^2 including pads.展开更多
A low power fast settling multi-standard CMOS fractional-N frequency synthesizer is proposed. The current reusing and frequency presetting techniques are adopted to realize the low power fast settling multi-standard f...A low power fast settling multi-standard CMOS fractional-N frequency synthesizer is proposed. The current reusing and frequency presetting techniques are adopted to realize the low power fast settling multi-standard fractional-N frequency synthesizer. An auxiliary non-volatile memory （NVM） is embedded to avoid the repetitive calibration process and to save power in practical application. This PLL is implemented in a 0.18 #m technology. The frequency range is 0.3 to 2.54 GHz and the settling time is less than 5 #s over the entire frequency range. The LC-VCO with the stacked divide-by-2 has a good figure of merit of-193.5 dBc/Hz. The measured phase noise of frequency synthesizer is about -115 dBc/Hz at 1 MHz offset when the carrier frequency is 2.4 GHz and the reference spurs are less than -52 dBc. The whole frequency synthesizer consumes only 4.35 mA @ 1.8 V.展开更多
With the rapid evolution of wireless communication technology, integrating various communication modes in a mobile terminal has become the popular trend. Because of this, multi-standard wireless technology is one of t...With the rapid evolution of wireless communication technology, integrating various communication modes in a mobile terminal has become the popular trend. Because of this, multi-standard wireless technology is one of the hot spots in current research. This paper presents a wideband fractional-N frequency divider of the multi-standard wireless transceiver for many applications. High-speed divider-by-2 with traditional source- coupled-logic is designed for very wide band usage. Phase switching technique and a chain of divider-by-2/3 are applied to the programmable frequency divider with 0.5 step. The phase noise of the whole frequency synthesizer will be decreased by the narrower step of programmable frequency divider. A-E modulator is achieved by an improved MASH 1-1-1 structure. This structure has excellent performance in many ways, such as noise, spur and input dynamic range. Fabricated in TSMC 0.18/tin CMOS process, the fractional-N frequency divider occupies a chip area of 1130 × 510μm^2 and it can correctly divide within the frequency range of 0.8-9 GHz. With 1.8 V supply voltage, its division ratio ranges from 62.5 to 254 and the total current consumption is 29 mA.展开更多
This paper proposes a sigma-delta fractional-N frequency synthesizer-based multi-standard I/Q carrier generation system.With reasonable frequency planning,the system can be used in multi-standard wireless communicatio...This paper proposes a sigma-delta fractional-N frequency synthesizer-based multi-standard I/Q carrier generation system.With reasonable frequency planning,the system can be used in multi-standard wireless communication applications（GSM,WCDMA,GPRS,TD-SCDMA,WLAN（802.11a/b/g））.The implementation is achieved by a 0.13μm RF CMOS process.The measured results demonstrate that three quadrature VCOs（QVCO） continuously cover the frequency from 3.1 to 6.1 GHz（65.2%）,and through the successive divide-by-2 prescalers to achieve the frequency from 0.75 to 6.1 GHz continuously.The chip was fully integrated with the exception of an off-chip filter.The entire chip area is only 3.78 mm^2,and the system consumes a 21.7 mA@1.2 V supply without output buffers.The lock-in time of the PLL frequency synthesizer is less than 4μs over the entire frequency range with a direct frequency presetting technique and the auxiliary non-volatile memory（NVM）can store the digital configuration signal of the system,including presetting signals to avoid the calibration process case by case.展开更多
A low-power, highly linear, multi-standard, active-RC filter with an accurate and novel tuning architecture is presented. It exhibits IEEE 802.11 a/b/g （9.5 MHz） and DVB-H （3 MHz, 4 MHz） application. The filter ex...A low-power, highly linear, multi-standard, active-RC filter with an accurate and novel tuning architecture is presented. It exhibits IEEE 802.11 a/b/g （9.5 MHz） and DVB-H （3 MHz, 4 MHz） application. The filter exploits digitally-controlled polysilicon resistor banks and a phase lock loop type automatic tuning system. The novel and complex automatic frequency calibration scheme provides better than 4 corner frequency accuracy, and it can be powered down after calibration to save power and avoid digital signal interference. The filter achieves OIP3 of 26 dBm and the measured group delay variation of the receiver filter is 50 ns （WLAN mode）. Its dissipation is 3.4 mA in RX mode and 2.3 mA （only for one path） in TX mode from a 2.85 V supply. The dissipation of calibration consumes 2 mA. The circuit has been fabricated in a 0.35μm 47 GHz SiGe BiCMOS technology; the receiver and transmitter filter occupy 0.21 mm^2 and 0.11 mm^2 （calibration circuit excluded）, respectively.展开更多
基金Supported by the National Nature Science Foundation of China(No.61674037)the Priority Academic Program Development of Jiangsu Higher Education Institutions,the National Power Grid Corp Science and Technology Project(No.SGTYHT/16-JS-198)the State Grid Nanjing Power Supply Company Project(No.1701052)
文摘This paper presents a reconfigurable RF front-end for multi-mode multi-standard(MMMS) applications. The designed RF front-end is fabricated in 0.18 μm RF CMOS technology. The low noise characteristic is achieved by the noise canceling technique while the bandwidth is enhanced by gate inductive peaking technique. Measurement results show that, while the input frequency ranges from 100 MHz to 2.9 GHz, the proposed reconfigurable RF front-end achieves a controllable voltage conversion gain(VCG) from 18 dB to 39 dB. The measured maximum input third intercept point(IIP3) is-4.9 dBm and the minimum noise figure(NF) is 4.6 dB. The consumed current ranges from 16 mA to 26.5 mA from a 1.8 V supply voltage. The chip occupies an area of 1.17 mm^2 including pads.
基金Project supported by the National Natural Science Foundation of China(No.60976023)the National Science and Technology Major Project of China(Nos.2009ZX03007-001,2012ZX03004007-002)
文摘A low power fast settling multi-standard CMOS fractional-N frequency synthesizer is proposed. The current reusing and frequency presetting techniques are adopted to realize the low power fast settling multi-standard fractional-N frequency synthesizer. An auxiliary non-volatile memory （NVM） is embedded to avoid the repetitive calibration process and to save power in practical application. This PLL is implemented in a 0.18 #m technology. The frequency range is 0.3 to 2.54 GHz and the settling time is less than 5 #s over the entire frequency range. The LC-VCO with the stacked divide-by-2 has a good figure of merit of-193.5 dBc/Hz. The measured phase noise of frequency synthesizer is about -115 dBc/Hz at 1 MHz offset when the carrier frequency is 2.4 GHz and the reference spurs are less than -52 dBc. The whole frequency synthesizer consumes only 4.35 mA @ 1.8 V.
文摘With the rapid evolution of wireless communication technology, integrating various communication modes in a mobile terminal has become the popular trend. Because of this, multi-standard wireless technology is one of the hot spots in current research. This paper presents a wideband fractional-N frequency divider of the multi-standard wireless transceiver for many applications. High-speed divider-by-2 with traditional source- coupled-logic is designed for very wide band usage. Phase switching technique and a chain of divider-by-2/3 are applied to the programmable frequency divider with 0.5 step. The phase noise of the whole frequency synthesizer will be decreased by the narrower step of programmable frequency divider. A-E modulator is achieved by an improved MASH 1-1-1 structure. This structure has excellent performance in many ways, such as noise, spur and input dynamic range. Fabricated in TSMC 0.18/tin CMOS process, the fractional-N frequency divider occupies a chip area of 1130 × 510μm^2 and it can correctly divide within the frequency range of 0.8-9 GHz. With 1.8 V supply voltage, its division ratio ranges from 62.5 to 254 and the total current consumption is 29 mA.
基金Project supported by the Chinese National High-Tech Research and Development Program(Nos2009ZX03007-001,2009AA011606)the National Natural Science Foundation of China(No60976023)
文摘This paper proposes a sigma-delta fractional-N frequency synthesizer-based multi-standard I/Q carrier generation system.With reasonable frequency planning,the system can be used in multi-standard wireless communication applications（GSM,WCDMA,GPRS,TD-SCDMA,WLAN（802.11a/b/g））.The implementation is achieved by a 0.13μm RF CMOS process.The measured results demonstrate that three quadrature VCOs（QVCO） continuously cover the frequency from 3.1 to 6.1 GHz（65.2%）,and through the successive divide-by-2 prescalers to achieve the frequency from 0.75 to 6.1 GHz continuously.The chip was fully integrated with the exception of an off-chip filter.The entire chip area is only 3.78 mm^2,and the system consumes a 21.7 mA@1.2 V supply without output buffers.The lock-in time of the PLL frequency synthesizer is less than 4μs over the entire frequency range with a direct frequency presetting technique and the auxiliary non-volatile memory（NVM）can store the digital configuration signal of the system,including presetting signals to avoid the calibration process case by case.
文摘A low-power, highly linear, multi-standard, active-RC filter with an accurate and novel tuning architecture is presented. It exhibits IEEE 802.11 a/b/g （9.5 MHz） and DVB-H （3 MHz, 4 MHz） application. The filter exploits digitally-controlled polysilicon resistor banks and a phase lock loop type automatic tuning system. The novel and complex automatic frequency calibration scheme provides better than 4 corner frequency accuracy, and it can be powered down after calibration to save power and avoid digital signal interference. The filter achieves OIP3 of 26 dBm and the measured group delay variation of the receiver filter is 50 ns （WLAN mode）. Its dissipation is 3.4 mA in RX mode and 2.3 mA （only for one path） in TX mode from a 2.85 V supply. The dissipation of calibration consumes 2 mA. The circuit has been fabricated in a 0.35μm 47 GHz SiGe BiCMOS technology; the receiver and transmitter filter occupy 0.21 mm^2 and 0.11 mm^2 （calibration circuit excluded）, respectively.
