A single-ended wideband reconfigurable receiver front-end for multi-mode multi-standard applications in 0.18μm CMOS

This paper presents a reconfigurable RF front-end for multi-mode multi-standard(MMMS) applications. The designed RF front-end is fabricated in 0.18 μm RF CMOS technology. The low noise characteristic is achieved by the noise canceling technique while the bandwidth is enhanced by gate inductive peaking technique. Measurement results show that, while the input frequency ranges from 100 MHz to 2.9 GHz, the proposed reconfigurable RF front-end achieves a controllable voltage conversion gain(VCG) from 18 dB to 39 dB. The measured maximum input third intercept point(IIP3) is-4.9 dBm and the minimum noise figure(NF) is 4.6 dB. The consumed current ranges from 16 mA to 26.5 mA from a 1.8 V supply voltage. The chip occupies an area of 1.17 mm^2 including pads.

城镇居民休闲行为特征研究——以湖南永州为例

在问卷调查和对调查数据进行分析的基础上,探讨了永州市城镇居民休闲行为的一般特征、居民休闲场所选择的影响因素以及休闲活动参与度与向往度特征,最后提出相关对策和建议。

基于多标准交叉验证的城市加氢站定量风险分析

针对不同领域国家标准中安全距离计算的差异性问题对某典型加氢站配置模型进行定量风险分析(QRA),计算出加氢站设施与站外防护目标安全距离和个人风险,实现多领域(氢能领域与危险化学品领域)标准交叉验证并通过揭示加氢站氢能标准和危化品标准的适配性差异,为加氢站的设计、建设和风险控制提供多维度参考。

A tunable passive mixer for SAW-less front-end with reconfigurable voltage conversion gain and intermediate frequency bandwidth

An adjustable mixer for surface acoustic wave( SAW)-less radio frequency( RF) front-end is presented in this paper. Through changing the bias voltage,the presented mixer with reconfigurable voltage conversion gain( VCG) is suitable for multi-mode multi-standard( MMMS) applications. An equivalent local oscillator( LO) frequency-tunable high-Q band-pass filter( BPF) at low noise amplifier( LNA) output is used to reject the out-of-band interference signals. Base-band( BB) capacitor of the mixer is variable to obtain 15 kinds of intermediate frequency( IF) bandwidth( BW). The proposed passive mixer with LNA is implemented in TSMC 0. 18μm RF CMOS process and operates from 0. 5 to 2. 5 GHz with measured maximum out-of-band rejection larger than 40 d B. The measured VCG of the front-end can be changed from 5 to 17 d B; the maximum input intercept point( IIP3) is0 d Bm and the minimum noise figure( NF) is 3. 7 d B. The chip occupies an area of 0. 44 mm^2 including pads.

A reconfigurable active-G_m-RC filter formultistandard wireless receivers

A 4th-order low-pass filter （LPF） based on active-Gm-RC structure for multi-standard system application is presented in this paper. The performances of LPF are controlled by a 1-bit control- voltage, and the cut-off frequency, channel selectivity, and linearity of the proposed filter can be reconfigured accordingly. In order to improve the accuracy of the cut-off frequency, a binary-weigh- ted switched-capacitor array is employed as the auto-tuning circuits to calibrate the RC-time con- stant. Fabricated in TSMC 0. 18μm RF CMOS process, the proposed LPF achieves a measured cutoff frequency of 1.95 and 12.3MHz for WCDMA and GPS/Galileo application with a bandwidth de viation less than 4%. The measured l dB compression points are -3.0dBm and -5.1 dBm respectively for different modes. The core circuit of LPF consumes l mW and 1.6mW for WCDMA and GPS/Galileo respectively. And the proposed LPF occupies an area of 0.78ram2.

Low power fast settling multi-standard current reusing CMOS fractional-N frequency synthesizer

A low power fast settling multi-standard CMOS fractional-N frequency synthesizer is proposed. The current reusing and frequency presetting techniques are adopted to realize the low power fast settling multi-standard fractional-N frequency synthesizer. An auxiliary non-volatile memory （NVM） is embedded to avoid the repetitive calibration process and to save power in practical application. This PLL is implemented in a 0.18 #m technology. The frequency range is 0.3 to 2.54 GHz and the settling time is less than 5 #s over the entire frequency range. The LC-VCO with the stacked divide-by-2 has a good figure of merit of-193.5 dBc/Hz. The measured phase noise of frequency synthesizer is about -115 dBc/Hz at 1 MHz offset when the carrier frequency is 2.4 GHz and the reference spurs are less than -52 dBc. The whole frequency synthesizer consumes only 4.35 mA @ 1.8 V.

A fractional-N frequency divider for multi-standard wireless transceiver fabricated in 0.18μm CMOS process

With the rapid evolution of wireless communication technology, integrating various communication modes in a mobile terminal has become the popular trend. Because of this, multi-standard wireless technology is one of the hot spots in current research. This paper presents a wideband fractional-N frequency divider of the multi-standard wireless transceiver for many applications. High-speed divider-by-2 with traditional source- coupled-logic is designed for very wide band usage. Phase switching technique and a chain of divider-by-2/3 are applied to the programmable frequency divider with 0.5 step. The phase noise of the whole frequency synthesizer will be decreased by the narrower step of programmable frequency divider. A-E modulator is achieved by an improved MASH 1-1-1 structure. This structure has excellent performance in many ways, such as noise, spur and input dynamic range. Fabricated in TSMC 0.18/tin CMOS process, the fractional-N frequency divider occupies a chip area of 1130 × 510μm^2 and it can correctly divide within the frequency range of 0.8-9 GHz. With 1.8 V supply voltage, its division ratio ranges from 62.5 to 254 and the total current consumption is 29 mA.

A multi-standard active-RC filter with accurate tuning system

A low-power, highly linear, multi-standard, active-RC filter with an accurate and novel tuning architecture is presented. It exhibits IEEE 802.11 a/b/g （9.5 MHz） and DVB-H （3 MHz, 4 MHz） application. The filter exploits digitally-controlled polysilicon resistor banks and a phase lock loop type automatic tuning system. The novel and complex automatic frequency calibration scheme provides better than 4 corner frequency accuracy, and it can be powered down after calibration to save power and avoid digital signal interference. The filter achieves OIP3 of 26 dBm and the measured group delay variation of the receiver filter is 50 ns （WLAN mode）. Its dissipation is 3.4 mA in RX mode and 2.3 mA （only for one path） in TX mode from a 2.85 V supply. The dissipation of calibration consumes 2 mA. The circuit has been fabricated in a 0.35μm 47 GHz SiGe BiCMOS technology; the receiver and transmitter filter occupy 0.21 mm^2 and 0.11 mm^2 （calibration circuit excluded）, respectively.

A fractional-N frequency synthesizer-based multi-standard I/Q carrier generation system in 0.13μm CMOS

This paper proposes a sigma-delta fractional-N frequency synthesizer-based multi-standard I/Q carrier generation system.With reasonable frequency planning,the system can be used in multi-standard wireless communication applications（GSM,WCDMA,GPRS,TD-SCDMA,WLAN（802.11a/b/g））.The implementation is achieved by a 0.13μm RF CMOS process.The measured results demonstrate that three quadrature VCOs（QVCO） continuously cover the frequency from 3.1 to 6.1 GHz（65.2%）,and through the successive divide-by-2 prescalers to achieve the frequency from 0.75 to 6.1 GHz continuously.The chip was fully integrated with the exception of an off-chip filter.The entire chip area is only 3.78 mm^2,and the system consumes a 21.7 mA@1.2 V supply without output buffers.The lock-in time of the PLL frequency synthesizer is less than 4μs over the entire frequency range with a direct frequency presetting technique and the auxiliary non-volatile memory（NVM）can store the digital configuration signal of the system,including presetting signals to avoid the calibration process case by case.

A wideband current-commutating passive mixer for multi-standard receivers in a 0.18μm CMOS

This paper reports a wideband passive mixer for direct conversion multi-standard receivers.A brief comparison between current-commutating passive mixers and active mixers is presented.The effect of source and load impedance on the linearity of a mixer is analyzed.Specially,the impact of the input impedance of the transimpedance amplifier（TIA）,which acts as the load impedance of a mixer,is investigated in detail.The analysis is verified by a passive mixer implemented with 0.18 μm CMOS technology.The circuit is inductorless and can operate over a broad frequency range.On wafer measurements show that,with radio frequency（RF） ranges from 700 MHz to 2.3 GHz,the mixer achieves 21 dB of conversion voltage gain with a-1 dB intermediate frequency（IF） bandwidth of 10 MHz.The measured IIP3 is 9 dBm and the measured double-sideband noise figure（NF） is 10.6 dB at 10 MHz output.The chip occupies an area of 0.19 mm2 and drains a current of 5.5 mA from a 1.8 V supply.

A fully integrated multi-standard frequency synthesizer for GNSS receivers with cellular network positioning capability

A fully integrated hybrid integer/fractional frequency synthesizer is presented.With a single multiband voltage-controlled-oscillator（VCO）,the frequency synthesizer can support GPS,Galileo,Compass and TDSCDMA standards.Design is carefully performed to trade off power,die area and phase noise performance.By reconfiguring between the integer mode and fractional mode,different frequency resolution requirements and a constant loop bandwidth for each standard can be achieved simultaneously.Moreover,a long sequence length,reduced hardware complexity multi-stage-noise-shaping（MASH）.-.modulator is employed to reduce fractional spur in the fractional mode.Fabricated in a 0.18 m CMOS technology,the frequency synthesizer occupies an active area of 1.48 mm2 and draws a current of 13.4-16.2 mA from a 1.8 V power supply.The measured phase noise is lower than-80 dBc/Hz at 100 kHz offset and-113 to-124 dBc/Hz at 1 MHz offset respectively,while the measured reference spur is-71 dBc in integer mode and the fractional spur is-65 dBc in fractional mode.

政策工具视角下民航安全管理政策分析

本文选取航空安全办公室2000年-2023年6月发布的45份民航安全管理政策为研究对象,选用内容分析法,基于政策工具视角构建政策工具-政策要素-政策时间三维分析框架,对政策文本进行量化分析。研究结果发现政策发布数量总体呈上升趋势;政策文本类型以规范性文件为主;政策主题集中于事故调查、信息安全、报告、人员培训、隐患风险、运行等方面;政策工具使用不均衡,权威工具占主导地位,占比为87.8%;政策要素配置差异明显,以安全责任制为主;随着时间的变迁,权威工具使用频率有所下降,其它四类工具应用都有提高;政策要素分布也在不断变动中,表明民航安全管理政策在不断完善。

A wideband low power low phase noise dual-modulus prescaler

This paper describes a novel divide-by-32/33 dual-modulus prescaler （DMP）. Here, a new combination of DFF has been introduced in the DMP. By means of the cooperation and coordination among three types, DFF, SCL, TPSC, and CMOS static flip-flop, the DMP demonstrates high speed, wideband, and low power consumption with low phase noise. The chip has been fabricated in a 0.18μm CMOS process of SMIC. The measured results show that the DMP＇s operating frequency is from 0.9 to 3.4 GHz with a maximum power consumption of 2.51 mW under a 1.8 V power supply and the phase noise is -134.78 dBc/Hz at 1 MHz offset from the 3.4 GHz carrier. The core area of the die without PAD is 57 x 30 #m2. Due to its excellent performance, the DMP could be applied to a PLL-based frequency synthesizer for many RF systems, especially for multi-standard radio applications.

A fractional-N frequency synthesizer for WCDMA/Bluetooth/ZigBee applications

A triple-mode fractional-N frequency synthesizer with a noise-filter voltage controlled oscillator（VCO） for WCDMA/Bluetooth/ZigBee applications has been implemented in 0.18-μm RF-CMOS technology.The proposed synthesizer achieves a good phase noise lower than-80 dBc/Hz in band and-115 dBc/Hz @ 1 MHz for the three modes, and only draws 21 mA from a 1.8 V supply.It has a high hardware sharing and a small size, only 1.5 × 1.4 mm2.The system architecture, circuit design, and measured results are also presented.

A reconfigurable passive mixer for multimode multistandard receivers in 0.18 μm CMOS

This paper presents a reconfigurable quadrature passive mixer for multimode multistandard receivers. By using controllable transconductor and transimpedance-amplifier stages, the voltage conversion gain of the mixer is reconfigured according to the requirement of the selected communication standard Other characteristics such as noises figure, linearity and power consumption are also reconfigured consequently. The design concept is verified by implementing a quadrature passive mixer in 0.18 μm CMOS technology. On wafer measurement results show that, with the input radio frequency ranges from 700 MHz to 2.3 GHz, the mixer achieves a controllable voltage conversion gain from 4 to 22 dB with a step size of 6 dB. The measured maximum IIP3 is 8.5 dBm and the minimum noise figure is 8.0 dB. The consumed current for a single branch （I or Q） ranges from 3.1 to 5.6 mA from a 1.8 V supply voltage. The chip occupies an area of 0.71 mm2 including pads.