This paper describes several main monomial cooling methods of greenhouse in summer, including natural ventilation, mechanical ventilation, wet curtain cooling, external sun-shading etc., as well as analyzes the change...This paper describes several main monomial cooling methods of greenhouse in summer, including natural ventilation, mechanical ventilation, wet curtain cooling, external sun-shading etc., as well as analyzes the change law of the environment on temperature and humidity in greenhouse. The result shows that the four cooling methods stated above make the temperature gradients between internal and external respectively 1.1℃, 0.4℃, -2.6℃ and -1.2℃,so it is obvious that the cooling effect of wet curtain cooling is the optimum;and the internal and external humidity difference is respectively: -13%, 6%, 8% and 1%.展开更多
The severity of the hot and humid conditions to which miners are exposed increases as the depth of the work site increases.This can cause heat stress that can greatly affect the health and safety of workers.To resolve...The severity of the hot and humid conditions to which miners are exposed increases as the depth of the work site increases.This can cause heat stress that can greatly affect the health and safety of workers.To resolve this,a cooling garment has been developed that uses an atmospheric discharge of liquid CO2 to create a cool microclimate with an average temperature of 12.5(±0.4)℃ beneath the garment.To evaluate the garment's cooling efficiency,19 male subjects participated in an experimental procedure.The two modes,cooling on and off,were compared.Significant physiological differences were found between the two modes after minute 27(p<0.05)until the end of the recovery phase for the heart rate(maximum difference of 10 beats per minute)and the internal body temperature(maximum difference of 0.33℃).It was found that the modes also affected the subjects'perceptions.The ON-mode was associated with better well-being and thermal comfort,and reduced humidity sensation.Perceptions of exertion were lower in the ON-mode condition from minute 2.The findings provide strong evidence of the ability of this cooling garment to reduce heat stress in hot and humid conditions similar to those encountered in deep mines.展开更多
Variations of wind effects on large cooling towers observed at different turbulence intensities for our previous full-scale measurements might be caused by the inherent uncertainties in our physical experiments.Accord...Variations of wind effects on large cooling towers observed at different turbulence intensities for our previous full-scale measurements might be caused by the inherent uncertainties in our physical experiments.Accordingly,the one-way analysis of variance(ANOVA)technique is employed for analyzing the data measured on the prototype Pengcheng cooling tower.Because ANOVA indicates that the variations of full-scale wind effects are basically the effects of turbulence intensity,the empirical results of wind loads on cooling towers obtained by generalizing physical experimental data without considering the turbulence intensity effects are updated using model test results obtained in multiple flow fields.The empirical fluctuating wind pressure distribution is updated based on the fact that the fluctuating wind pressure coefficient linearly increases with the increase in the turbulence intensity,and the empirical formulae of the spectra and the coherences is updated based on conservative assumptions.Comparisons of the empirical results and full-scale measurement data suggest that the original empirical results are either too conservative or unsafe for use.However,economic efficiency and conservativeness will be balanced if the updated empirical results are employed for the wind engineering design.展开更多
We present a new Nusselt number correlation for spray cooling at large Reynolds numbers and high surface temperatures for water sprays impinging perpendicularly onto a flat plate. A large set of experimental data on s...We present a new Nusselt number correlation for spray cooling at large Reynolds numbers and high surface temperatures for water sprays impinging perpendicularly onto a flat plate. A large set of experimental data on spray cooling of hot surfaces with water has been analyzed, including the water temperature effects. For large-scale cooling, such as in industrial processes, large number of injection parameters such as number, type, pressure, and angle of the spray injection has led to a multitude of correlations that are difficult for general and practical applications. However, by synthesizing a set of experimental data where all of the above parameters have been varied, we find that the Nusselt number and therefore the heat transfer coefficient can be cast accurately as a function of the Reynolds number. Water is widely used as the coolant during spray cooling, and has a specific phase change characteristic. At large Reynolds number (Re > 100,000) and surface temperature (Ts > 600°C) ranges, which are of interest in large-scale spray cooling, the effect of water temperature is quite significant as it affects the film boiling close to the surface. This effect also has been parameterized using experimental data.展开更多
Developments of the micro-Gal level gravimeter based on atom interferometry are reviewed, and the recent progress and results of our group are also presented. Atom interferometric gravimeters have shown high resolutio...Developments of the micro-Gal level gravimeter based on atom interferometry are reviewed, and the recent progress and results of our group are also presented. Atom interferometric gravimeters have shown high resolution and accuracy for gravity measurements. This kind of quantum sensor has excited world-wide interest for both practical applications and fundamental research.展开更多
High precision time measurement is required in the readout of the neutron wall and TOF walls in the external target experiment of the Cooling Storage Ring(CSR) project in the Heavy Ion Research Facility in Lanzhou(HIR...High precision time measurement is required in the readout of the neutron wall and TOF walls in the external target experiment of the Cooling Storage Ring(CSR) project in the Heavy Ion Research Facility in Lanzhou(HIRFL).Considering the time walk correction,both time and charge are measured in the readout electronics.In this 16-channel measurement module,time and charge information are digitized by TDCs at the same time based on the Time-Over-Threshold(TOT) method;meanwhile,by employing high-density ASIC chips,the electronics complexity is effectively reduced.Test results indicate that this module achieves a time resolution better than 25 ps and a charge resolution better than 5%over the input amplitude range from 50 mV to 3V.展开更多
An experimental investigation of three-dimensional flow field in a film-cooled turbine model is carried out by using particle image velocimeter （PIV） in a low-speed wind tunnel. The effects of different blowing rati...An experimental investigation of three-dimensional flow field in a film-cooled turbine model is carried out by using particle image velocimeter （PIV） in a low-speed wind tunnel. The effects of different blowing ratios （M=1.5, 2） on the flow field are studied. The experimental results reveal the classical phenomena of the formation of kidney vortex pair and secondary flow in wake region behind the jet hole. And the changes of the kidney vortex pair and the wake at different locations away from the hole on the suction and pressure sides are also studied. Compared with the flow field in stationary cascade, there are centrifugal force and Coriolis force existing in the flow field of rotating turbine, and these forces bring the radial velocity in the jet flow. The effect of rotatien on the flow field of the pressure side is more distinct than that on the suction side from the measured flow fields in Y-Z plane and radial velocity contours. The increase of blowing ratio makes the kidney vortex pair and the secondary flow in the wake region stronger and makes the range of the wake region enlarged.展开更多
An experimental investigation was performed to study the heat transfer in an eight-nozzle spray cooling system with de-ionized water as the working fluid. Visualization of the liquid-solid contact area and the flow ne...An experimental investigation was performed to study the heat transfer in an eight-nozzle spray cooling system with de-ionized water as the working fluid. Visualization of the liquid-solid contact area and the flow near the heated surface was made using a microscopic lens system in conjunction with an advanced high-speed camera. The film thickness and film wavelike characteristics under liquid volume flow rates ranged from 2.78×10 -6 m 3 /s to 1.39×10 -5 m 3 /s and surface temperatures between 22℃ and 78.2℃ were examined respectively. The development process of the liquid film on the heated surface was observed. The local mean film thickness, the film wavelike characteristics and the behavior of the bubbles appeared in the liquid film were captured using an image processing technique. It is discovered that there exists a climax of local mean film thickness during the starting process of spray cooling. When the liquid film reaches the dynamic stable state, the dimensionless mean film thickness decreases with the increase of the liquid volume flow rate, and increases with the increase of surface temperature generally. Besides, the volume flow rate has a more significant impact on the wavelength and amplitude of the liquid film compared to the surface temperature.展开更多
文摘This paper describes several main monomial cooling methods of greenhouse in summer, including natural ventilation, mechanical ventilation, wet curtain cooling, external sun-shading etc., as well as analyzes the change law of the environment on temperature and humidity in greenhouse. The result shows that the four cooling methods stated above make the temperature gradients between internal and external respectively 1.1℃, 0.4℃, -2.6℃ and -1.2℃,so it is obvious that the cooling effect of wet curtain cooling is the optimum;and the internal and external humidity difference is respectively: -13%, 6%, 8% and 1%.
基金funded by the Fonds de Recherche du QuébecNature et Technologies (FRQNT)
文摘The severity of the hot and humid conditions to which miners are exposed increases as the depth of the work site increases.This can cause heat stress that can greatly affect the health and safety of workers.To resolve this,a cooling garment has been developed that uses an atmospheric discharge of liquid CO2 to create a cool microclimate with an average temperature of 12.5(±0.4)℃ beneath the garment.To evaluate the garment's cooling efficiency,19 male subjects participated in an experimental procedure.The two modes,cooling on and off,were compared.Significant physiological differences were found between the two modes after minute 27(p<0.05)until the end of the recovery phase for the heart rate(maximum difference of 10 beats per minute)and the internal body temperature(maximum difference of 0.33℃).It was found that the modes also affected the subjects'perceptions.The ON-mode was associated with better well-being and thermal comfort,and reduced humidity sensation.Perceptions of exertion were lower in the ON-mode condition from minute 2.The findings provide strong evidence of the ability of this cooling garment to reduce heat stress in hot and humid conditions similar to those encountered in deep mines.
基金The National Natural Science Foundation of China(No.51908124),the China Postdoctoral Science Foundation(No.2016M601793).
文摘Variations of wind effects on large cooling towers observed at different turbulence intensities for our previous full-scale measurements might be caused by the inherent uncertainties in our physical experiments.Accordingly,the one-way analysis of variance(ANOVA)technique is employed for analyzing the data measured on the prototype Pengcheng cooling tower.Because ANOVA indicates that the variations of full-scale wind effects are basically the effects of turbulence intensity,the empirical results of wind loads on cooling towers obtained by generalizing physical experimental data without considering the turbulence intensity effects are updated using model test results obtained in multiple flow fields.The empirical fluctuating wind pressure distribution is updated based on the fact that the fluctuating wind pressure coefficient linearly increases with the increase in the turbulence intensity,and the empirical formulae of the spectra and the coherences is updated based on conservative assumptions.Comparisons of the empirical results and full-scale measurement data suggest that the original empirical results are either too conservative or unsafe for use.However,economic efficiency and conservativeness will be balanced if the updated empirical results are employed for the wind engineering design.
文摘We present a new Nusselt number correlation for spray cooling at large Reynolds numbers and high surface temperatures for water sprays impinging perpendicularly onto a flat plate. A large set of experimental data on spray cooling of hot surfaces with water has been analyzed, including the water temperature effects. For large-scale cooling, such as in industrial processes, large number of injection parameters such as number, type, pressure, and angle of the spray injection has led to a multitude of correlations that are difficult for general and practical applications. However, by synthesizing a set of experimental data where all of the above parameters have been varied, we find that the Nusselt number and therefore the heat transfer coefficient can be cast accurately as a function of the Reynolds number. Water is widely used as the coolant during spray cooling, and has a specific phase change characteristic. At large Reynolds number (Re > 100,000) and surface temperature (Ts > 600°C) ranges, which are of interest in large-scale spray cooling, the effect of water temperature is quite significant as it affects the film boiling close to the surface. This effect also has been parameterized using experimental data.
基金supported by the National Natural Science Foundation of China(Grant Nos.41127002,11204094,11205064,and 11474115)the National High Technology Research and Development Program of China(Grant No.2011AA060503)
文摘Developments of the micro-Gal level gravimeter based on atom interferometry are reviewed, and the recent progress and results of our group are also presented. Atom interferometric gravimeters have shown high resolution and accuracy for gravity measurements. This kind of quantum sensor has excited world-wide interest for both practical applications and fundamental research.
基金Supported by the Knowledge Innovation Program of the Chinese Academy of Sciences(No.KJCX2-YW-N27)the National Natural Science Foundation of China(No.11079003)
文摘High precision time measurement is required in the readout of the neutron wall and TOF walls in the external target experiment of the Cooling Storage Ring(CSR) project in the Heavy Ion Research Facility in Lanzhou(HIRFL).Considering the time walk correction,both time and charge are measured in the readout electronics.In this 16-channel measurement module,time and charge information are digitized by TDCs at the same time based on the Time-Over-Threshold(TOT) method;meanwhile,by employing high-density ASIC chips,the electronics complexity is effectively reduced.Test results indicate that this module achieves a time resolution better than 25 ps and a charge resolution better than 5%over the input amplitude range from 50 mV to 3V.
基金This project is supported by National Natural Science Foundation ofChina(No. 50406017)
文摘An experimental investigation of three-dimensional flow field in a film-cooled turbine model is carried out by using particle image velocimeter （PIV） in a low-speed wind tunnel. The effects of different blowing ratios （M=1.5, 2） on the flow field are studied. The experimental results reveal the classical phenomena of the formation of kidney vortex pair and secondary flow in wake region behind the jet hole. And the changes of the kidney vortex pair and the wake at different locations away from the hole on the suction and pressure sides are also studied. Compared with the flow field in stationary cascade, there are centrifugal force and Coriolis force existing in the flow field of rotating turbine, and these forces bring the radial velocity in the jet flow. The effect of rotatien on the flow field of the pressure side is more distinct than that on the suction side from the measured flow fields in Y-Z plane and radial velocity contours. The increase of blowing ratio makes the kidney vortex pair and the secondary flow in the wake region stronger and makes the range of the wake region enlarged.
基金supported by the National Natural Science Foundation of China under Grant No.50906083National Basic Research Program of China under Grant No.2011CB710705
文摘An experimental investigation was performed to study the heat transfer in an eight-nozzle spray cooling system with de-ionized water as the working fluid. Visualization of the liquid-solid contact area and the flow near the heated surface was made using a microscopic lens system in conjunction with an advanced high-speed camera. The film thickness and film wavelike characteristics under liquid volume flow rates ranged from 2.78×10 -6 m 3 /s to 1.39×10 -5 m 3 /s and surface temperatures between 22℃ and 78.2℃ were examined respectively. The development process of the liquid film on the heated surface was observed. The local mean film thickness, the film wavelike characteristics and the behavior of the bubbles appeared in the liquid film were captured using an image processing technique. It is discovered that there exists a climax of local mean film thickness during the starting process of spray cooling. When the liquid film reaches the dynamic stable state, the dimensionless mean film thickness decreases with the increase of the liquid volume flow rate, and increases with the increase of surface temperature generally. Besides, the volume flow rate has a more significant impact on the wavelength and amplitude of the liquid film compared to the surface temperature.
