Carrier phase shifted SPWM based on current sourced multi-modular converter for active power filter

A novel current-source active power filter (APF) based on multi-modular converter with carrier phase-shifted SPWM (CPS-SPWM) technique is proposed. With this technique, the effect of equivalent high switching frequency con-verter is obtained with low switching frequency converter. It is very promising in current-source APF that adopt super-conducting magnetic energy storage component.

Design of a Control Device for Synthetic Making Test Based on Pre-Arcing Current Detection and Phase Control

The synthetic making test has been widely used in evaluating the break ability of high-voltage circuit breaker. However, the test research and application are still inadequate, especially in the condition of rated voltage. According to the realistic conditions of test stations in China, a control device based on pre-arcing current detection and phase control is proposed in this paper. A sample of the control device made up of DSP TMS320LF2407A is fabricated, in which the CPLD MAX7064 is used to transmit signals for EMC design. It can be applied in full voltage synthetic making test at a level of 126kV/63kA. The test results show that, it is accurate to control the making phase of the applied voltage, whether the closing is demanded at voltage peak or zero.

Phase Evolution Study and Optimization of the Heat Treatment Process for High Current Capacity Bi-2223 Tapes

Powder in tube process（PIT） was adopted for the fabrication of single filament Bi-2223 tapes, and a heat treatment process including the first heat treatment（HT1）, intermediate rolling（IR）, and second heat treatment（HT2） was performed. The phase evolution mechanism and microstructure changes during these heat treatment processes were systematically discussed. The influences of HT1 parameters on the phase evolution process of Bi-2223 tapes were discussed. With the optimized HT1 process, a proper Bi-2223 content of about 90% was achieved. HT2 process was also optimized by adding a post annealing process. An obvious increase of current capacity was obtained due to the enhancement of intergrain connections. Single filament Bi-2223 tapes with the critical current of Ic-90 A were fabricated with the optimized sintering process.

Current–phase relations of a ring-trapped Bose–Einstein condensate with a weak link

The current–phase relations of a ring-trapped Bose–Einstein condensate interrupted by a rotating rectangular barrier are extensively investigated with an analytical solution. A current–phase diagram, single and multi-valued relation, is presented with a rescaled barrier height and width. Our results show that the finite size makes the current–phase relation deviate a little bit from the cosine form for the soliton solution in the limit of a vanishing barrier, and the periodic boundary condition selects only the plane wave solution in the case of high barrier. The reason for multi-valued current–phase relation is given by investigating the behavior of soliton solution.

An Active Inrush Current Limiter Based on SCR Phase Shift Control for EV Charging Systems

This article gives an overview of the main passive solutions and active techniques, based on AC switches to limit inrush currents in medium power AC-DC converters （up to 3.7 kW） for electric vehicle charging systems. In particular, a strategy, based on SCR （silicon controlled rectifier） phase, shift control in a mixed rectifier bridge with diodes and thyristors, is proposed. The challenge is to help designers optimize the triggering delay of SCRs to both limit the peak value of inrush current spikes and optimize the charge duration of the DC-link capacitor. A mathematical model （Mathcad engineering tool） has been defined to point out, the interest of a variable triggering delay to control SCRs to meet the expectations described previously. Experimental measurements using an industrial evaluation board of the AC-DC converter demonstrate the robustness of the method.

Chiral current regulation and detection of Berry phase in triangular triple quantum dots

Based on the hierarchical equations of motion(HEOM)calculation,we theoretically investigate the corresponding control of a triangular triple-quantum-dots(TTQD)ring which is connected to two reservoirs.We initially demonstrate by adding bias voltage and further adjusting the coupling strength between quantum dots,the chiral current induced by bias will go through a transformation of clockwise to counterclockwise direction and an unprecedented effective Hall angle will be triggered.The transformation is very rapid,with a corresponding characteristic time of 80-200 ps.In addition,by adding a magnetic flux to compensate for the chiral current in the original system,we elucidate the relationship between the applied magnetic flux and the Berry phase,which can realize direct measurement of the chiral current and reveal the magnetoelectric coupling relationship.

The Peak Current Control of Permanent Magnet Brushless DC Machine with Asymmetric Dual-Three Phases

The asymmetric dual-three phase BLDC motor has two sets of stator windings,in which the back EMF coefficients are different.This paper takes advantage of the asymmetric dual-three phase BLDC motor’s structural features and proposes a new method for the accelerated problem of the BLDC motor operating in the high speed and the constant electromagnetic power.The dual phase windings of the BLDC motor are integrated into the circuit in the starting stage.When the motor’s back EMF value is equal to the terminal voltage value,switch off a set of RST three phase windingswhose back EMF coefficient is bigger and make the other set of stator windingUVWwith smaller back EMF coefficient continue to operate under the rated power.As the motor rotor speed continues to increase,the electromagnetic torque remains unchanged.By using the peak current control strategy,we can deduce that the phase current of the UVW three-phase winding is twice the RSTthree-phase windingwhen the asymmetric dual-three phase BLDC motor operates at high speed and constant power.

Motion of a Nonrelativistic Quantum Particle in Non-commutative Phase Space

The equation governing the motion of a quantum particle is considered in nonrelativistic non-commutative phase space. For this aim, we first study new Poisson brackets in non-commutative phase space and obtain the modified equations of motion. Next, using novel transformations, we solve the equation of motion and report the exact analytical solutions.

High-sensitivity phase imaging eddy current magneto-optical system for carbon fiber reinforced polymers detection

This paper proposed a high-sensitivity phase imaging eddy current magneto-optical (PI-ECMO) system for carbon fiber reinforced polymer (CFRP) defect detection. In contrast to other eddy current-based detection systems, the proposed system employs a fixed position excitation coil while enabling the detection point to move within the detection region. This configuration effectively mitigates the interference caused by the lift-off effect, which is commonly observed in systems with moving excitation coils. Correspondingly, the relationship between the defect characteristics (orientation and position) and the surface vertical magnetic field distribution (amplitude and phase) is studied in detail by theoretical analysis and numerical simulations. Experiments conducted on woven CFRP plates demonstrate that the designed PI-ECMO system is capable of effectively detecting both surface and internal cracks, as well as impact defects. The excitation current is significantly reduced compared with traditional eddy current magneto-optical (ECMO) systems.

Current Controlled Relaxation Oscillations in Ge_2Sb_2Te_5-Based Phase Change Memory Devices

The relaxation oscillation of the phase change memory （PCM） devices based on the Ge2Sb2Te5 material is investigated by applying square current pulses. The current pulses with different amplitudes could be accurately given by the independently designed current testing system. The relaxation oscillation across the PCM device could be measured using an oscilloscope. The oscillation duration decreases with time, showing an inner link with the shrinking threshold voltage Vth. However, the relaxation oscillation would not terminate until the remaining voltage Von reaches the holding voltage Vh. This demonstrates that the relaxation oscillation might be controlled by Von. The increasing current amplitudes could only quicken the oscillation velocity but not be able to eliminate it, which indicates that the relaxation oscillation might be an inherent behavior for the PCM cell.

Real-Time Method for Detecting Harmonic and Reactive Currents of Single-Phase Circuits

According to the characteristics of single-phase circuits and demand of using active filter for real-time detecting harmonic and reactive currents, a detecting method based on Fryze＇s power definition is proposed. The results of theoretical analysis and simula- tion show that the proposed method is effective in realtime detecting of instantaneous harmonic and reactive currents in single-phase circuits. When only detecting the total reactive currents, this method does not need a phase-locked loop circuit, and it also can be used in some special applications to provide different compensations on the ground of different requirements of electric network. Compared with the other methods based on the theory of instantaneous reactive power, this method is simple and easy to realize.

3D-Printed Monolith Metallic Ni-Mo Electrodes for Ultrahigh Current Hydrogen Evolution

In this work,we reported a series of monolithic 3D-printed Ni-Mo alloy electrodes for highly efficient water splitting at high current density(1500 mA cm^(-2))with excellent stability,which provides a solution to scale up Ni-Mo catalysts for HER to industry use.All possible Ni-Mo metal/alloy phases were achieved by tuning the atomic composition and heat treatment procedure,and they were investigated through both experiment and simulation,and the optimal NiMo phase shows the best performance.Density functional theory(DFT)calculations elucidate that the NiMo phase has the lowest H2O dissociation energy,which further explains the exceptional performance of NiMo.In addition,the microporosity was modulated via controlled thermal treatment,indicating that the 1100℃sintered sample has the best catalytic performance,which is attributed to the high electrochemically active surface area(ECSA).Finally,the four different macrostructures were achieved by 3D printing,and they further improved the catalytic performance.The gyroid structure exhibits the best catalytic performance of driving 500 mA cm^(-2)at a low overpotential of 228 mV and 1500 mA cm^(-2)at 325 mV,as it maximizes the efficient bubble removal from the electrode surface,which offers the great potential for high current density water splitting.

Hydrophobic ionic liquids/water interfacial phase transfer induced by direct current electric field

To investigate the affect of direct current electric field (DCEF) on the interfacial phase,in this paper,a hydrophobic ionic liquid (HIL)/water as liquid-liquid two-phase binary system is established by using the deioned water and l-butyl-3-methyl imidazolium hexafluorophosphate,and the topographies of the HIL nanodroplets and nanolayers in ambient water are observed by atomic force microscope (AFM).The results show the AFM exerting the DCEF can enhance the intersolubility of the HIL/water binary system and induce their interfacial phase transfer.

Evolution of secondary phases and properties of 7B04 aluminum alloy during DC homogenization

The effects of the direct current （DC） on the evolutions of hardness and morphology of the secondary phases in 7B04 aluminum alloy homogenized at 380？465 ℃ for 2 h were investigated in detail by electric conductivity measurement, hardness test, X-ray diffraction analysis, field emission scanning electron microscopy and energy dispersive spectrometry. The results show that with increasing temperature from 380 to 465 ℃, the electric conductivity of normal homogenized sample decreases from 34.9%IACS to 28.7%IACS, the hardness increases from HV 96 to HV 146, and the area fraction of secondary phase reduces from 4.5% to 1.89%. While, DC homogenized sample has a higher hardness, a lower electric conductivity and a smaller area fraction of secondary phases at the same temperature. The DC enhances the homogenization process by promoting the diffusibility of the solute atoms and the mobility of vacancy.

基于鲸鱼算法的10 kV组合互感器失真电流校正

对于10 kV组合互感器而言,电流失真会使输出电流的数值水平异常增大,并且长时间不恢复至常规电流状态,从而影响互感器的正常运行。为解决上述问题,设计基于鲸鱼算法的10 kV组合互感器失真电流校正方法。构建10 kV组合互感器结构模型,完善鲸鱼算法流程,基于鲸鱼算法获取失真的电流计量数值,实现组合互感器的失真特性判定,完成基于鲸鱼算法的10 kV组合互感器失真电流校正算法的设计。实验结果表明,经过设计方法对互感器失真电流进行校正处理后,可在2 min之内将失真电流恢复至与常规电流完全相同的数值状态,校正效果较好。

Ground-state entanglement in a three-spin transverse Ising model with energy current

The ground-state entanglement associated with a three-spin transverse Ising model is studied. By introducing an energy current into the system, a quantum phase transition to energy-current phase may be presented with the variation of external magnetic field; and the ground-state entanglement varies suddenly at the critical point of quantum phase transition. In our model, the introduction of energy current makes the entanglement between any two qubits become maximally robust.

Degradation Process of Coated Tinplate by Phase Space Reconstruction Theory

The degradation process of organosol coated tinplate in beverage was investigated by electrochemical noise (EN) technique combined with morphology characterization.EN data were analyzed using phase space reconstruction theory.With the correlation dimensions obtained from the phase space reconstruction,the chaotic behavior of EN was quantitatively evaluated.The results show that both electrochemical potential noise (EPN) and electrochemical current noise (ECN) have chaotic properties.The correlation dimensions of EPN increase with corrosion extent,while those of ECN seem nearly unchanged.The increased correlation dimensions of EPN during the degradation process are associated with the increased susceptibility to local corrosion.

Design of a CMOS Adaptive Charge Pump with Dynamic Current Matching

A novel structure for a charge pump circuit is proposed, in which the charge-pump （CP） current can adaptively regulated according to phase-locked loops （PLL） frequency synthesis demand. The current follow technology is used to make perfect current matching characteristics, and the two differential inverters are implanted to increase the speed of charge pump and decrease output spur due to theory of low voltage difference signal. Simulation results, with 1st silicon 0. 25μm 2. 5 V complementary metal-oxide-semiconductor （CMOS） mixed-signal process, show the good current matching characteristics regardless of the charge pump output voltages.

Influence of arc current and pressure on non-chemical equilibrium air arc behavior

The influence of arc current and pressure on the non-chemical equilibrium （non-CE） air arc behavior of a nozzle structure was investigated based on the self-consistent non-chemical equilibrium model. The arc behavior during both the arc burning and arc decay phases were discussed at different currents and different pressures. We also devised the concept of a non- equilibrium parameter for a better understanding of non-CE effects. During the arc burning phase, the increasing current leads to a decrease of the non-equilibrium parameter of the particles in the arc core, while the increasing pressure leads to an increase of the non-equilibrium parameter of the particles in the arc core. During the arc decay phase, the non-CE effect will decrease by increasing the arc burning current and the nozzle pressure. Three factors together-- convection, diffusion and chemical reactions--influence non-CE behavior.