Performance analysis of optical burst switching node with limited wavelength conversion capabilities

The systematical and scalable frameworks were provided for estimating the blocking probabilities under asynchronous traffic in optical burst switching(OBS) nodes with limited wavelength conversion capability(LWCC) . The relevant system architectures of limited range and limited number of wavelength converters(WCs) deployed by a share-per-fiber(SPF) mode were developed,and the novel theoretical analysis of node blocking probability was derived by combining the calculation of discouraged arrival rate in a birth-death process and two-dimensional Markov chain model of SPF. The simulation results on single node performance verify the accuracy and effectiveness of the analysis models. Under most scenarios,it is difficult to distinguish the plots generated by the analysis and simulation. As the conversion degree increases,the accuracy of the analysis model worsens slightly. However,the utmost error on burst loss probability is far less than one order of magnitude and hence,still allows for an accurate estimate. Some results are of actual significance to the construction of next-generation commercial OBS backbones.

QoS aware routing and wavelength allocation in optical burst switching networks using differential evolution optimization

The issue of burst losses imposes a constraint on the development of Optical Burst Switching （OBS） networks. Heavy burst losses strongly affect the Quality of Service （QoS） intended by end users. This article presents a QoS aware Routing and Wavelength Allocation （RWA） technique for burst switching in OBS networks. The RWA problem is modeled as a bi-objective Integer Linear Programming （ILP） problem, where objective functions are based on minimizing the number of wavelengths used and the number of hops traversed to fulfill the burst transmission requests for a given set of node pairs. The ILP model is solved using a novel approach based on a Differential Evolution （DE） algorithm. Analytical results show that the DE algorithm provides a better performance compared to shortest path routing, which is a widely accepted routing strategy for OBS networks.

Study of Token Generation for Burst Traffic Shaping in Optical Burst Switching Networks

Traffic shaping is one of important control operation to guarantee the Quality of Service (QoS) in optical burst switching (OBS) networks. The efficiency of traffic shaping is mainly determined by token generation method. In this paper, token generation methods of traffic shaping are evaluated by using three kinds of probability distribution, and are analyzed in terms of burst blocking probability, through-put and correlation by simulation. The simulation results show that the token generation methods decrease the burst correlation of Label Switched Paths (LSPs), and solve traffic congestion as well. The different burst arrival processes have small impact on the blocking probability for OBS net works. Key words optical burst switching - traffic shaping - token generation - quality of service CLC number TP 929.11 Foundation item: Supported by the National Natural Science Foundation of China (60132030) and the Korea Science and Engineering Foundation (KOSEF) through OIRC ProjectBiography: Tang Wan (1974-), female, Ph. D candidate, research direction: contention resolution and routing mechanism in OBS networks.

Contention avoidance using dual-fuzzy assembly threshold algorithm in optical burst switching networks

To avoid burst contention efficiently,on the basis of feedback-based source flow-rate control(SFC) strategy,a novel fuzzy-control-based assembly algorithm,called dual-fuzzy assembly threshold(DFAT),is proposed in an optical burst switching network.In our algorithm,according to the variations of burst assembly period and the interarrival of burst control packet,the traffic states of edge-switching nodes and core-switching nodes are first obtained.Then,the assembly threshold of bursts is set dynamically in order to operate the source traffic management from the information of traffic states.The performance of DFAT algorithm on burst loss probability is evaluated,and simulation results show that,compared with conventional assembly algorithms,the proposed scheme can constrain the birth of burst contention efficiently,when being a heavy load state of network.

Transmission Mechanism Based on Burst Filling in Hybrid Optical Burst/Circuit Switching Networks

Hybrid optical switching networks make full use of the advantages of Optical Circuit Switching(OCS)and Optical Burst Switching(OBS).In parallel hybrid optical switching networks,edge nodes choose a switching mode for traffic and no longer change.The inflexible decision making of the traffic transfer mode leads to low resource utilization when the arrival rate of the OCS traffic is lower than the capacity of the light path.In this paper,a new transmission scheme is proposed to improve resource utilization for hybrid optical switching networks.When the traffic arrival rate of the light path is lower than the transmission rate of the light path,the OCS traffic flow is reshaped at the edge nodes to generate a series of voids.Then,several message packets are sent along the light path to inform the core nodes of the voids of the light paths that represent the unused bandwidth resources.To improve the resource utilization,the voids can be filled with data bursts by core nodes.The simulation results show that the new scheme can effectively reduce the burst loss rate and improve the link utilization of the hybrid optical switching network on the premise of a providing service quality guarantee for OCS traffic.

Limited Delay Preemption Based Priority in Differentiated Optical Burst Switching Networks with Small Buffers

The composite scheme based on preemption and small buffers is an efficient method for contention resolution. To support services differentiation, it is the first time that the analytical model of delay preemption based priority is built. Further, in order to guarantee the low-loss requirement for high priority bursts, an improved scheme is proposed and investigated by limiting the buffered right of low priority bursts within the specific traffic states. The simulation results show that, without the deterioration of blocking performance, there is more than 40% reduction on burst loss being achieved under the conditionρ=1.0 for high priority bursts.

A novel data channel fault detection mechanism in optical burst switching networks

Fault detection in optical burst switching （OBS） networks will be a challenging task in the future. A novel mechanism based on probe burst （PB） and a new key concept is proposed to detect faults of OBS networks by sampling the health of data channels, which solve the difficulty of optical monitoring schemes while keeps the transparency of data network to Internet protocol （IP） packets. It takes full advantage of the characteristics of OBS, including architecture and signalling scheme, and introduces the excellent performances of single-hop-test used in electrical communication networks into OBS environment while avoids the shortcoming that any optical burst must undergo an optical-electric-optical （OEO） conversion. Well designed PB can provide exact criterion for judging whether protection/restoration should be excuted according to hard or soft fault identification.

A NEW SCHEDULING ALGORITHM TO PROVIDE PROPORTIONAL QOS IN OPTICAL BURST SWITCHING NETWORKS

A new scheduling algorithm, which aims to provide proportional and controllable QoS (Quality of Service) in terms of burst loss probability for OBS (Optical Burst Switching) networks, is proposed on the ba- sis of a survey of QoS schemes in current OBS networks. With simulations, performance analysis and com- parisons are carried out in detail. The results show that, in the proposed scheme, burst loss probabilities are proportional to the given factors and the control of QoS performance can be achieved with better performance. This scheme will be beneficial to the OBS network management and the tariff policy making.

Research and Progress of Service Driven Optical Switching Network in China

National R&D activities on optical switching networkare introduced. Optical switching network testbedswere established in China including 3T-net andOBS ring and mesh network test-bed with the supportof national '863' program. As an importantmodule in OPS network, a novel all-optical serialmulticast mode is discussed.

AN EFFECTIVE MODEL TO EVALUATE BLOCKING PROBABILITY OF TIME-SLOTTED OPTICAL BURST SWITCHED NETWORKS

Time-slotted optical burst switched network is a potential technique to support IP over Wavelength Division Multiplexing (WDM) by introduce Time Division Multiplexing (TDM) channel to Optical Burst Switching (OBS) technology. This paper presents a framework to evaluate blocking performance of time-slot-ted OBS networks with multi-fiber wavelength channels. The proposed model is efficient for not only single class traffic such as individual circuit switch traffics or best-effort traffics but also mixed multi-class traffics. The effectiveness of the proposed model is validated by simulation results. The study shows that blocking per-formance of multi-fiber TS-OBS network is acceptable for future Internet services.

UNITED STABILIZING SCHEME FOR EDGE DELAY IN OPTICAL BURST SWITCHED NETWORKS

A novel scheme, namely united stabilizing scheme for edge delay, is introduced in optical burst switched networks. In the scheme, the limits of burst length and assembly time are both set according to certain qualifications. For executing the scheme, the conception for unit input bit rate is introduced to improve universality, and the assembly algorithm with a buffer safety space under the self-similar traffic model at each ingress edge router is proposed. Then, the components of burst and packet delay are concluded, and the equations that limits of burst length and assembly time should satisfy to stabilize the burst edge delay under different buffer offered loads are educed. The simulation results show that united stabilizing scheme stabilizes both burst and packet edge delay to a great extent when buffer offered load changes from 0.1 to 1, and the edge delay of burst and packet are near the limit values under larger offered load, respectively.

A Novel Switching Architecture for IP Over WDM Networks

Integrating IP and WDM is an attractive direction for research. Many solutions have been presented but it is noted that the existing switching technologies still need more concern. Since optical packet switching is not practical yet, there are just two possible solutions left. One is wavelength routing(WR), which is circuit switching in essence and the other is newly proposed optical burst switching (OBS). In this paper, characteristics of WR and OBS are first described, then, compared in several aspects. It is notice that in many aspects, the wavelength routing and burst switching are complement. This stimulates us to propose a new switching architecture, which may be considered as 'mixture' of WR and OBS. We believe the network built on new switching structure can accommodate the requirements of practicability, flexibility, robustness, efficiency and etc. simultaneously. However, many related problems still need to be further researched.

A Novel Framework for IP DiffServ over Optical Burst Switching Networks

This paper presents a novel framework for IP Differentiated Services (DiffServ) over optical burst switching (OBS), namely, DS-OBS. The network architecture, functional model of edge nodes and core nodes, the control packet format, a novel burst assembly scheme at ingress nodes and scheduling algorithm of core nodes are presented. The basic idea is to apply DiffServ capable burst assembly at ingress nodes and perform different per hop behavior (PHB) electronic treatments for control packets of different QoS class services at core nodes. Simulation results show that the proposed schemes can provide the best differentiated service for expedited forwarding (EF), assured forwarding (AF) and best effort (BE) services in terms of end-to-end delay, throughput and IP packet loss probability. Keywords IP quality of service - differentiated service - per hop behavior - optical burst switching NoteThis work is supported by the National Natural Science Foundation of China (Grant No.90304004), the National Hi-Tech Development 863 Program of China (Grant No.2003AA121540), and the research grants by the Ministry of Education of China (Grant No.204125), the Chongqing Education Commission (Grant No.050309) and the Chongqing Science Commission.

A new burst assembly technique for supporting QoS in optical burst switching networks

This letter proposes a new burst assembly technique for supporting QoS in optical burst switching (OBS) networks. It consists of the adaptive-threshold burst assembly mechanism and QoS-based random offset-time scheme. The assembly mechanism, which is fit well to multi-class burst assembly, not only matches with IP QoS mechanism based on packet classification, and also utilizes fairly and efficiently assembly capacity. Based on token-bucket model and burst segment selective discard (BSSD), the offset-time scheme can smooth the traffic to support OBS QoS. The simulation results show that the technique can improve the performance in terms of packet loss probability (PLP).

A novel optical burst switching architecture for high speed networks

A novel optical burst switching （OBS） high speed network architecture has been proposed. To verify its feasibility and evaluate its performance, just-enough-time （JET） signaling has been considered as a high performance protocol. In the proposed architecture, to avoid burst losses, firstly, a short-prior- confirmation-packet （SPCP） is sent over the control channel that simulates the events that the actual packet will experience. Once SPCP detects a drop at any of the intermediate nodes, the actual packet is not sent but the process repeats. In order to increase network utilization, cost effectiveness and to overcome some limitations of conventional OBS, inherent codes （e.g., orthogonal optical codes （OOC））, which are codified only in intensity, has been used. Through simulations, it shows that a decrease in burst loss probability, cost effectiveness and a gain in processing time are obtained when optical label processing is used as compared with electronic processing.

A congestion alleviated scheme in optical burst switching network

An optical burst switching （OBS） network platform is established with a ring topology of three nodes. A congestion Mleviated scheme using advanced token protocol and wavelength tunable receivers is demon- strated to optimize the network platform. Experimental results testify that this scheme can resist collision at the level of 0.1% congestion rate.

Performance analysis of optical burst switching under bursty traffic

The performance of the algorithm of the data channel scheduling algorithm of latest available unscheduled channel with void filling (LAUC-VF) under bursty traffic is presented firstly. A bursty traffic model for optical burst switch performance simulation is also introduced.

A novel scheme based on minimum delay at the edges for optical burst switching networks

This paper proposes a novel scheme based on minimum delay at the edges (MDE) for optical burst switching (OBS) networks. This scheme is designed to overcome the long delay at the edge nodes of OBS networks. The MDE scheme features simultaneous burst assembly, channel scheduling, and pre-transmission of control packet. It also features estimated setup and explicit release (ESXR) signaling protocol. The MDE scheme can minimize the delay at the edge nodes for data packets, and improve the end-to-end latency performance for OBS networks. In addition, comparing with the conventional scheme, the performances of the MDE scheme are analyzed in this paper.

A QoS-Guanranteed Scheduling Algorithm with High Throughput for Edge Nodes of Optical Burst Switching Networks

A scheduling algorithm for the edge nodes of optical burst switching (OBS) networks is proposed to guarantee the delay requirement of services with different CoS (Class of Service) and provide lower burst loss ratio at the same time. The performance of edge nodes based on the proposed algorithm is presented.

A new prediction method at the edge of optical burst switching network

To achieve lower assembly delay at optical burst switching edge node, this paper proposes an approach called current weight length prediction (CWLP) to improve existing estimate mechanism in burst assembly. CWLP method takes into account the arrived traffic in prediction time adequately. A parameter 'weight' is introduced to make a dynamic tradeoff between the current and past traffic under different offset time. Simulation results show that CWLP can achieve a significant improvement in terms of traffic estimation in various offset time and offered load.