Dynamic behavior of a rotating gliding arc plasma in nitrogen:effects of gas flow rate and operating current

The effects of feed gas flow rate and operating current on the electrical characteristics and dynamic behavior of a rotating gliding arc （RGA） plasma codriven by a magnetic field and tangential flow were investigated.The operating current has been shown to significantly affect the time-resolved voltage waveforms of the discharge,particularly at flow rate =21 min^-1.When the current was lower than 140 mA,sinusoidal waveforms with regular variation periods of 13.5-17.0 ms can be observed （flow rate =21 min^-1）.The restrike mode characterized by serial sudden drops of voltage appeared under all studied conditions.Increasing the flow rate from 8 to 121 min^-1 （at the same current） led to a shift of arc rotation mode which would then result in a significant drop of discharge voltage （around 120-200 V）.For a given flow rate,the reduction of current resulted in a nearly linear increase of voltage.

A Hydrogen Iron Flow Battery with High Current Density and Long Cyclability Enabled Through Circular Water Management

The hydrogen-iron(HyFe)flow cell has great potential for long-duration energy storage by capitalizing on the advantages of both electrolyzers and flow batteries.However,its operation at high current density(high power)and over continuous cycling testing has yet to be demonstrated.In this paper,we discuss our design and demonstration of a water management strategy that supports high current and long cycling performance of a HyFe flow cell.Water molecules associated with the movement of protons from the iron electrode to the hydrogen electrode are sufficient to hydrate the membrane and electrode at a low current density of 100 mA cm^(-2)during the charge process.At higher charge current density,more aggressive measures must be taken to counter back-diffusion driven by the acid concentration gradient between the iron and hydrogen electrodes.Our water management approach is based on water vapor feeding in the hydrogen electrode,and water evaporation in the iron electrode,thus enabling the high current density operation of 300 mA cm^(-2).

Effect of Wave Accessibility on Lower Hybrid Wave Current Drive in Experimental Advanced Superconductor Tokamak with H-Mode Operation

The effect of the wave accessibility condition on the lower hybrid cm＇rent drive in the experimental advanced superconductor Tokamak （EAST） plasma with H-mode operation is studied. Based on a simplified model, a mode conversion layer of the lower hybrid wave between the fast wave branch and the slow wave branch is proved to exist in the plasma periphery for typical EAST H-mode parameters. Under the framework of the lower hybrid wave simulation code （LSC）, the wave ray trajectory and the associated current drive are calculated numerically. The results show that the wave accessibility condition plays an important role on the lower hybrid current drive in EAST plasma. For wave rays with parallel refractive index n｜｜= 2.1 or n｜｜ = 2.5 launched from the outside midplane, the wave rays may penetrate the core plasma due to the toroida] geometry effect, while numerous reflections of the wave ray trajectories in the plasma periphery occur. However, low current drive efficiency is obtained. Meanwhile, the wave accessibility condition is improved if a higher confined magnetic field is applied. The simulation results show that for plasma parameters under present EAST H-mode operation, a significant lower hybrid wave current drive could be obtained for the wave spectrum with peak value n｜｜ = 2.1 if a toroidal magnetic field BT =2.5 T is applied.

Method with reliable accuracy and fast speed for measuring operational current of HTS NI closed-loop coils in steady persistent-current-mode

This study proposes a method for measuring the operational current of high temperature superconducting(HTS)non‐insulation(NI)closed‐loop coils,which operate in the steady persistent‐current‐mode(PCM).HTS NI closed‐loop coils are promising for many easily‐quenching direct‐current(DC)applications,where their performance is determined by magnetomotive forces,total number of turns,and dimensions.As the primary interface parameter in an application system,the operational current must be accurately and rapidly measured.Generally,this is achieved by dividing the measured magnetic field by the coil constant.However,even if the influence of the screening current induced field(SCIF)is not considered,existing methods for the coil constant may be disturbed by the performance and location of Hall sensors,or experience a long measuring period.Therefore,a relatively accurate and fast method is proposed in this study,which is based on adjusting the output current of the adjustable power supply and monitoring the coil voltage as an indicator.The proposed method was validated through experiments and simulations using an equivalent circuit model coupled with a finite element method(FEM)model,and its current accuracy can be equivalent to the resolution of the employed power supply.It was demonstrated that this method reduced the requirements for Hall sensor’s performance and location,and has a more reliable accuracy in contrast to the simulation method.Compared to the experimentally conventional method,the proposed method presents a significantly faster speed.The impact of the SCIF was considered and proven to be negligible for the tested pancake coils.Even for coils whose coil constant vibrates owing to the SCIF,this method can be adapted to directly measure various operational currents.Furthermore,it was demonstrated that the measurement error can be influenced by the current discrepancy among turns when the coil is not in the steady PCM,and a procedure for reducing this error was proposed.

Elaboration of a Promising Design of the HTS Conductor for the Central Solenoid of a Compact Thermonuclear Reactor TRT

The results of the preliminary development of the HTS conductor based on the VS-type design and parallel stacks for the central solenoid of the compact thermonuclear reactor TRT are presented. One of the main problems that need to be solved for the successful implementation of such projects is the creation of high-current high-temperature superconducting (HTS) conductors for Toroidal Field coils (TF) and Central Solenoid (CS) sections. The conductor must have a high engineering current density of at least 90 A/mm2. The induction of the magnetic field in the central solenoid reaches 14 T, which leads to the occurrence of large mechanical stresses due to the influence of Lorentz forces. Like many large magnets, CS has a lot of stored energy. For the safe withdrawal of stored energy from the magnet, it requires the inclusion of elements in the conductor that provide an acceptable level of electrical voltage and heating of the conductor insulation. Thus, a sufficient amount of stabilizing and reinforcing materials should be placed in the conductor. In addition, the “cable-in-conduit” type of conductor must have channels for pumping the refrigerant. Two fundamentally different versions of the conductor based on radially arranged REBCO tapes and on the basis of pre-assembled tape packages are considered. Based on the analysis of the magnetic field distribution in the conductor by finite element method, the design characteristics of the proposed conductors under various operating modes of the electromagnetic system (EMS) of the tokamak TRT was evaluated. The results of the evaluation of the current carrying capacity of the conductor and the estimation of energy losses in a changing magnetic field in comparison with known methods are also presented.

Superconducting Magnet of the Gyrotron for HL-2A ECRH System

In order to carry on ECRH experiments and research on HL-2A tokamak, two sets of 4 mm gyrotrons were imported from GYCOM. Each of them has a superconducting magnet system to offer a required magnetic field configuration. In gyrotron, a strong magnetic field is necessary for electron beam to satisfy the electron cyclotron resonance condition and to excite one the eigemodes in the cavity. Its functions are： （I） to make electrons gyrate, （ 2 ） to offer enough adiabatic compression value to make electrons acquire strong transverse energy. During the period of adjustment, magnetic field distribution was measured. Meanwhile, operating current of superconducting magnet and operating frequency of gyrotron were determined.

Wide-Band Polarization-Independent Semiconductor Optical Amplifier Gate with Tensile-Strained Quasi-Bulk InGaAs

A semiconductor optical amplifier gate based on tensile strained quasi bulk InGaAs is developed.At injection current of 80mA,a 3dB optical bandwidth of more than 85nm is achieved due to dominant band filling effect.Moreover,the most important is that very low polarization dependence of gain (<0 7dB),fiber to fiber lossless operation current (70～90mA) and a high extinction ratio (>50dB) are simultaneously obtained over this wide 3dB optical bandwidth (1520～1609nm) which nearly covers the spectral region of the whole C band (1525～1565nm) and the whole L band (1570～1610nm).The gating time is also improved by decreasing carrier lifetime.The wide band polarization insensitive SOA gate is promising for use in future dense wavelength division multiplexing (DWDM) communication systems.

Quantization of the radiation field in an anisotropic dielectric medium

There are both loss and dispersion characteristics for most dielectric media. In quantum theory the loss in medium is generally described by Langevin force in the Langevin noise （LN） scheme by which the quantization of the radiation field in various homogeneous absorbing dielectrics can be successfully actualized. However, it is invalid for the anisotropic dispersion medium. This paper extends the LN theory to an anisotropic dispersion medium and presented the quantization of the radiation field as well as the transformation relation between the homogeneous and anisotropic dispersion media.

Quantization of electromagnetic field in quadratic continuous nonlinear absorptive dielectrics

This paper reports that in the quantization of electromagnetic field in the dielectrics, the wave equation with regard to the Green function is analytically solved by a direct integral method for a quadratic continuous nonlinear absorptive dielectric medium. The quantization of the electromagnetic field in such a nonlinear absorptive dielectric is carried out for which the material dielectric function is assumed as a separable variable about the frequency and the space coordinate. The vacuum field fluctuations for different spatial continuous variations of dielectric function are numerically calculated, which shows that the present result is self-consistent.

Bosonic Operator Realization of Hamiltonian for a Superconducting QuantumInterference Device

Based on the appropriate bosonic phase operator diagonalized in the entangled state representation we construct the Hamiltonian operator model for a superconducting quantum interference device. The current operator and voltage operator equations are derived.

Bounded Algebra and Current-Mode Digital Circuits

This paper proposes two bounded arithmetic operations, which areeasily realized with current signals. Based on these two operations, a bounded algebra system suitable for describing current-mode digital circuits is developed andits relationship with the Boolean algebra, which is suitable for representing voltagemode digital circuits, is investigated. Design procedure for current-mode circuitsusing the proposed algebra system is demonstrated on a number of common circuit elements which are used to realize arithmetic operations, such as adders andmultipliers.

A double-stage start-up structure to limit the inrush current used in current mode charge pump

A double-stage start-up structure to limit the inrush current used in current-mode charge pump with wide input range,fixed output and multimode operation is presented in this paper.As a widely utilized power source implement,a Li-battery is always used as the power supply for chips.Due to the internal resistance,a potential drop will be generated at the input terminal of the chip with an input current.A false shut down with a low supply voltage will happen if the input current is too large,leading to the degradation of the Li-battery＇s service life.To solve this problem,the inrush current is limited by introducing a new start-up state.All of the circuits have been implemented with the NUVOTON 0.6 μm CMOS process.The measurement results show that the inrush current can be limited below 1 A within all input supply ranges,and the power efficiency is higher than the conventional structure.

A low-voltage sense amplifier with two-stage operational amplifier clamping for flash memory

A low-voltage sense amplifier with reference current generator utilizing two-stage operational amplifier clamp structure for flash memory is presented in this paper,capable of operating with minimum supply voltage at1 V.A new reference current generation circuit composed of a reference cell and a two-stage operational amplifier clamping the drain pole of the reference cell is used to generate the reference current,which avoids the threshold limitation caused by current mirror transistor in the traditional sense amplifier.A novel reference voltage generation circuit using dummy bit-line structure without pull-down current is also adopted,which not only improves the sense window enhancing read precision but also saves power consumption.The sense amplifier was implemented in a flash realized in 90 run flash technology.Experimental results show the access time is 14.7 ns with power supply of 1.2 V and slow corner at 125℃.