An equivalent noise model of optical receiver amplifiers as shown in Fig.1 has been given in many fiber optical communication literatures. It is proved in this paper that this equivalent noise model is neither equiva...An equivalent noise model of optical receiver amplifiers as shown in Fig.1 has been given in many fiber optical communication literatures. It is proved in this paper that this equivalent noise model is neither equivalent to the original one nor measurable. The main reason is that the position of the input impedance in this noise model is not the same with its in the typical noise model,but the same S vn , S in with the typical noise model are used. So the equivalent noise model above is wrong and is not fit to be taken into application.展开更多
Stimulated Raman scattering in a double cladding optical fiber is studied with a continuous wave laser used as a pump source. Under various launch conditions, pump modes are differently excited. Considering the mode c...Stimulated Raman scattering in a double cladding optical fiber is studied with a continuous wave laser used as a pump source. Under various launch conditions, pump modes are differently excited. Considering the mode coupling effect among the pump modes, the evolution of the power in the Stokes modes is studied. The results show that the scattered waves （the Stokes waves） in the fiber core with 9%tm diameter and 0.14 NA could propagate predominantly in the fundamental mode of the fiber by carefully adjusting the pump light launching conditions.展开更多
A novel and fast model of erbium-doped fiber amplifiers (EDFAs) is presented. By calculating a typical EDFA, numerical results are compared with the results obtained by spectral-solved method. The results of compariso...A novel and fast model of erbium-doped fiber amplifiers (EDFAs) is presented. By calculating a typical EDFA, numerical results are compared with the results obtained by spectral-solved method. The results of comparison show that such a model can improve the computational speed and preserve the precision. Some characteristics of the EDFA are then analyzed using this model. The results are consistent with those of the experiments.展开更多
The configuration of the novel three-stage L-band erbium-doped fiber amplifier with very large and flat gain and very low noise figure presented in this paper uses the forward ASE (amplified spontaneous emission) from...The configuration of the novel three-stage L-band erbium-doped fiber amplifier with very large and flat gain and very low noise figure presented in this paper uses the forward ASE (amplified spontaneous emission) from the first section of the EDF (erbium-doped fiber) and the backward ASE from the third section of the EDF (both serve as the secondary pump sources of energy) to pump the second EDF. To improve the pump efficiency, the power of the pump is split into two parts (with a ratio of e.g. 2:7). The characteristics of this L-band EDFA are studied on the basis of the Giles Model with ASE.展开更多
In this paper,we report a simulation study on the performance enhancement of Praseodymium doped silica fiber amplifiers(PDFAs)in O-band(1270-1350 nm)in terms of small signal gain,power conversion efficiency(PCE),and o...In this paper,we report a simulation study on the performance enhancement of Praseodymium doped silica fiber amplifiers(PDFAs)in O-band(1270-1350 nm)in terms of small signal gain,power conversion efficiency(PCE),and output optical power by employing bidirectional pumping.The PDFA performance is examined by optimizing the length of Praseodymium doped silica fiber(PDF),its mode-field diameter(MFD)and the concentration of Pr^(3+).A small-signal peak gain of 56.4 dB,power conversion efficiency(PCE)of 47%,and output optical power of around 1.6 W(32 dBm)is observed at optimized parameters for input signal wavelength of 1310 nm.Minimum noise figure(NF)of 4.1 dB is observed at input signal wavelength of 1310 nm.Moreover,the effect of varying the pump wavelength and pump power on output optical power of the amplifier and amplified spontaneous emission(ASE)noise is also investigated,respectively.Finally,the impact of ion-ion interaction(up-conversion effect)on small-signal gain of the amplifier is also studied by considering different values of up-conversion coefficient.展开更多
A new receiver is proposed, which uses the fiber optical parametric amplifier(FOPA) in optical code division multiple access(OCDMA) over free space optic(FSO) communication system. The noise tolerance as the performan...A new receiver is proposed, which uses the fiber optical parametric amplifier(FOPA) in optical code division multiple access(OCDMA) over free space optic(FSO) communication system. The noise tolerance as the performance index in this receiver is derived. The receiver can not only improve the noise tolerance but also change the pump data conveniently for adapting to the length variation of the coding sequence under a complex and fast-changing weather condition. The influence of different factors on the noise tolerance is analyzed, and a significant improvement of about 18.77 d B for the noise tolerance can be achieved when the pump power and the length of coding sequence are 5 W and 256, respectively.展开更多
Optical networks are evolving toward ultrawide bandwidth and autonomous operation.In this scenario,it is crucial to accurately model and control optical power evolutions(OPEs)through optical amplifiers(OAs),as they di...Optical networks are evolving toward ultrawide bandwidth and autonomous operation.In this scenario,it is crucial to accurately model and control optical power evolutions(OPEs)through optical amplifiers(OAs),as they directly affect the signal-to-noise ratio and fiber nonlinearities.However,a fundamental contradiction arises between the complex physical phenomena in optical transmission and the required precision in network control.Traditional theoretical methods underperform due to ideal assumptions,while data-driven approaches entail exorbitant costs associated with acquiring massive amounts of data to achieve the desired level of accuracy.In this work,we propose a Bayesian inference framework(BIF)to construct the digital twin of OAs and control OPE in a data-efficient manner.Only the informative data are collected to balance the exploration and exploitation of the data space,thus enabling efficient autonomous-driving optical networks(ADONs).Simulations and experiments demonstrate that the BIF can reduce the data size for modeling erbium-doped fiber amplifiers by 80%and Raman amplifiers by 60%.Within 30 iterations,the optimal controlling performance can be achieved to realize target signal/gain profiles in links with different types of OAs.The results show that the BIF paves the way to accurately model and control OPE for future ADONs.展开更多
We report a 2 kW all-fiberized Raman fiber amplifier with efficient brightness enhancement based on the graded-index fiber.The maximum power output reaches up to 2.034 kW centered at 1130 nm,with a conversion efficien...We report a 2 kW all-fiberized Raman fiber amplifier with efficient brightness enhancement based on the graded-index fiber.The maximum power output reaches up to 2.034 kW centered at 1130 nm,with a conversion efficiency of 79.35%with respect to the injected pump power.To the best of our knowledge,this is the highest conversion efficiency obtained for any Raman laser system using graded-index fiber.An optimized fiber combiner adopting graded-index fiber as the pigtail fiber was fabricated,enabling the preservation of the seeding brightness in the core-pumped Raman fiber amplifier,and further enhancing the ultimate brightness of the output laser after amplification.At the maximum power output,the beam quality parameter M2 is 2.8,corresponding to a signal-to-pump brightness enhancement factor of 11.2.As far as we know,we obtain the highest brightness enhancement among Raman fiber lasers of over 100 W,and the best beam quality for graded-index Raman fiber lasers of over 150 W.展开更多
文摘An equivalent noise model of optical receiver amplifiers as shown in Fig.1 has been given in many fiber optical communication literatures. It is proved in this paper that this equivalent noise model is neither equivalent to the original one nor measurable. The main reason is that the position of the input impedance in this noise model is not the same with its in the typical noise model,but the same S vn , S in with the typical noise model are used. So the equivalent noise model above is wrong and is not fit to be taken into application.
文摘Stimulated Raman scattering in a double cladding optical fiber is studied with a continuous wave laser used as a pump source. Under various launch conditions, pump modes are differently excited. Considering the mode coupling effect among the pump modes, the evolution of the power in the Stokes modes is studied. The results show that the scattered waves （the Stokes waves） in the fiber core with 9%tm diameter and 0.14 NA could propagate predominantly in the fundamental mode of the fiber by carefully adjusting the pump light launching conditions.
文摘A novel and fast model of erbium-doped fiber amplifiers (EDFAs) is presented. By calculating a typical EDFA, numerical results are compared with the results obtained by spectral-solved method. The results of comparison show that such a model can improve the computational speed and preserve the precision. Some characteristics of the EDFA are then analyzed using this model. The results are consistent with those of the experiments.
文摘The configuration of the novel three-stage L-band erbium-doped fiber amplifier with very large and flat gain and very low noise figure presented in this paper uses the forward ASE (amplified spontaneous emission) from the first section of the EDF (erbium-doped fiber) and the backward ASE from the third section of the EDF (both serve as the secondary pump sources of energy) to pump the second EDF. To improve the pump efficiency, the power of the pump is split into two parts (with a ratio of e.g. 2:7). The characteristics of this L-band EDFA are studied on the basis of the Giles Model with ASE.
文摘In this paper,we report a simulation study on the performance enhancement of Praseodymium doped silica fiber amplifiers(PDFAs)in O-band(1270-1350 nm)in terms of small signal gain,power conversion efficiency(PCE),and output optical power by employing bidirectional pumping.The PDFA performance is examined by optimizing the length of Praseodymium doped silica fiber(PDF),its mode-field diameter(MFD)and the concentration of Pr^(3+).A small-signal peak gain of 56.4 dB,power conversion efficiency(PCE)of 47%,and output optical power of around 1.6 W(32 dBm)is observed at optimized parameters for input signal wavelength of 1310 nm.Minimum noise figure(NF)of 4.1 dB is observed at input signal wavelength of 1310 nm.Moreover,the effect of varying the pump wavelength and pump power on output optical power of the amplifier and amplified spontaneous emission(ASE)noise is also investigated,respectively.Finally,the impact of ion-ion interaction(up-conversion effect)on small-signal gain of the amplifier is also studied by considering different values of up-conversion coefficient.
基金supported by the National Key Basic Research Special Foundation(Nos.2010CB327605 and 2010CB328300)the National Natural Science Foundation of China(No.61307109)+2 种基金the National High Technology Research and Development Program of China(Nos.2013AA031501 and 2013AA013303)the Specialized Research Fund for the Doctoral Program of Higher Education(No.20120005120021)the Fundamental Research Funds for the Central Universities(No.2013RC1202)
文摘A new receiver is proposed, which uses the fiber optical parametric amplifier(FOPA) in optical code division multiple access(OCDMA) over free space optic(FSO) communication system. The noise tolerance as the performance index in this receiver is derived. The receiver can not only improve the noise tolerance but also change the pump data conveniently for adapting to the length variation of the coding sequence under a complex and fast-changing weather condition. The influence of different factors on the noise tolerance is analyzed, and a significant improvement of about 18.77 d B for the noise tolerance can be achieved when the pump power and the length of coding sequence are 5 W and 256, respectively.
基金supported by the Shanghai Pilot Program for Basic Research-Shanghai Jiao Tong University(Grant No.21TQ1400213)the National Natural Science Foundation of China(Grant No.62175145)
文摘Optical networks are evolving toward ultrawide bandwidth and autonomous operation.In this scenario,it is crucial to accurately model and control optical power evolutions(OPEs)through optical amplifiers(OAs),as they directly affect the signal-to-noise ratio and fiber nonlinearities.However,a fundamental contradiction arises between the complex physical phenomena in optical transmission and the required precision in network control.Traditional theoretical methods underperform due to ideal assumptions,while data-driven approaches entail exorbitant costs associated with acquiring massive amounts of data to achieve the desired level of accuracy.In this work,we propose a Bayesian inference framework(BIF)to construct the digital twin of OAs and control OPE in a data-efficient manner.Only the informative data are collected to balance the exploration and exploitation of the data space,thus enabling efficient autonomous-driving optical networks(ADONs).Simulations and experiments demonstrate that the BIF can reduce the data size for modeling erbium-doped fiber amplifiers by 80%and Raman amplifiers by 60%.Within 30 iterations,the optimal controlling performance can be achieved to realize target signal/gain profiles in links with different types of OAs.The results show that the BIF paves the way to accurately model and control OPE for future ADONs.
基金supported by Huo Yingdong Education Foundation(No.151062)Hunan Provincial Innovation Construct Project(No.2019RS3017)National Natural Science Foundation of China(Nos.11704409 and 61605246)。
文摘We report a 2 kW all-fiberized Raman fiber amplifier with efficient brightness enhancement based on the graded-index fiber.The maximum power output reaches up to 2.034 kW centered at 1130 nm,with a conversion efficiency of 79.35%with respect to the injected pump power.To the best of our knowledge,this is the highest conversion efficiency obtained for any Raman laser system using graded-index fiber.An optimized fiber combiner adopting graded-index fiber as the pigtail fiber was fabricated,enabling the preservation of the seeding brightness in the core-pumped Raman fiber amplifier,and further enhancing the ultimate brightness of the output laser after amplification.At the maximum power output,the beam quality parameter M2 is 2.8,corresponding to a signal-to-pump brightness enhancement factor of 11.2.As far as we know,we obtain the highest brightness enhancement among Raman fiber lasers of over 100 W,and the best beam quality for graded-index Raman fiber lasers of over 150 W.
