2.5 Gbit/s monolithic ICs for optical fiber transmitter and receiver in 0.35 μm CMOS process

2.5 Gbit/s monolithic integrated circuits （ICs） for optical fiber transmitter and receiver in 0.35 μm CMOS （complementary metal-oxide-semiconductor transistor） process are presented. The transmitter, which includes a 4： 1 multiplexer and a laser diode driver （LDD）, has four 622 Mbit/s random signals as its inputs and gets a 2.5 Gbit/s driving signal as its output; the receiver detects a 2.5 Gbit/s random signal and gets four 622 Mbit/s signals at the output. The main circuits include a trans-impedance amplifier （TIA）, a limiting amplifier, a clock and data recovery （CDR） unit, and a 1： 4 demultiplexer （DEMUX）. Test results prove the logic functions of the transmitter to be right, and the 10% to 90% rise and fall times of transmitter＇s output data eye diagram are 211.1 ps and 200 ps, respectively. The sensitivity of the receiver is measured to be better than 20 mV. The root mean square jitter of the DEMUX＇s output data is 15.6 ps and that of the clock after 1： 4 frequency dividing is 1.9 ps. Two chips are both applicable to 2.5 Gbit/s optical fiber communication systems.

A novel 3-stage structure for a low-noise, high-gain and gain-flattened L-band erbium doped fiber amplifier

The configuration of the novel three-stage L-band erbium-doped fiber amplifier with very large and flat gain and very low noise figure presented in this paper uses the forward ASE (amplified spontaneous emission) from the first section of the EDF (erbium-doped fiber) and the backward ASE from the third section of the EDF (both serve as the secondary pump sources of energy) to pump the second EDF. To improve the pump efficiency, the power of the pump is split into two parts (with a ratio of e.g. 2:7). The characteristics of this L-band EDFA are studied on the basis of the Giles Model with ASE.

Equivalent Noise Models in Fiber Optical Communication Systems

An equivalent noise model of optical receiver amplifiers as shown in Fig.1 has been given in many fiber optical communication literatures. It is proved in this paper that this equivalent noise model is neither equivalent to the original one nor measurable. The main reason is that the position of the input impedance in this noise model is not the same with its in the typical noise model,but the same S vn , S in with the typical noise model are used. So the equivalent noise model above is wrong and is not fit to be taken into application.

Remote I/O Unit for Optical Fiber Demmunication

Abstract:Based on optical fiber technology, the main electric circuit of the remote I/O unit controller is studied. And the application of the system is illustrated.

STUDY ON MINE FIRE-RESISTANT OPTICAL FIBER CABLE KL5004

This paper introduces a new-developed mine fire-resistant optical fiber cable (OFC)KL5004,its structural characteristics, main feature, the theory about fire resistance and its application in high output and efficiency mine.

Toward Low-Cost Flexible Intelligent OAM in Optical Fiber Communication Networks

Low-cost,flexible and intelligent optical performance monitoring and management is a key enabling technology for network quality guarantee,especially in the era of explosive growth of communication capacity and network scale.However,to the best of our knowledge,it is extremely challenging to implement real-time performance monitoring and operations,administration and maintenance(OAM) in a highly complex dynamic network.In this paper,we propose an innovative optical identification(OID) scheme that can realize both performance monitoring and some advanced OAM sub-functions.The basic concepts,applications,challenges and evolution directions of this OID tool are also discussed.

Design and Implementation of Optical Fiber Test Equipment

In order to meet the needs of the rapid development of optical fiber communication technology, combined with the thinking of the Internet of Things, a new idea of designing an optical fiber test equipment using Raspberry Pi is proposed. At the same time, the design of a multi-parameter measuring device for optical fiber signals based on Flask was completed.

Fiber Grating Ring Laser in All Optical Communication System

Erbium fiber grating ring laser (EFRL) witn an integrated travelling wave and low polarization mode noise is reported. Through modulated experiment of a successful 2.488 Gb/s RZ data, it is shown that the EFRL is a promising alternative to DFB lasers for high-speed transmission applications.

4.096 Tbit/s multidimensional multiplexing signals transmission over 1000 km few mode fiber

We experimentally transmit eight wavelength-division-multiplexing(WDM)channels,16 quadratic-amplitude-modulation(QAM)signals at 32-GBaud,over 1000 km few mode fiber(FMF).In this experiment,we use WDM,mode division multiplexing,and polarization multiplexing for signal transmission.Through the multiple-input-multiple-output(MIMO)equalization algorithms,we achieve the total line transmission rate of 4.096 Tbit/s.The results prove that the bit error rates(BERs)for the16QAM signals after 1000 km FMF transmission are below the soft-decision forward-error-correction(SD-FEC)threshold of2.4×10^(-2),and the net rate reaches 3.413 Tbit/s.Our proposed system provides a reference for the future development of high-capacity communication.

Capacity and Flexibility Improvement of Traffic Aggregation for Fixed 5G:Key Enabling Technologies,Challenges and Trends

As the emergence of various highbandwidth services and the requirements to support 5G/Wi-Fi 6 wireless networks,the next generation fixed networks,i.e.F5G,are expected to be realized in the 5G era.F5G is endowed with new characteristics,including ultra-high bandwidth,all-optical connections and optimal service experience.With the prospect of optical-to-everywhere,optical technologies are used for mobile front-haul,mid-haul,and back-haul.Optical access networks would play an important role in F5G to support radio access network and fixed access network.Low-latency PON is a key for cost effective-haul traffic aggregation.In terms of signal transmission,intensity modulation directdetection(IM-DD)is a promising scheme due to its simple architecture.The fundamental challenge associated with direct-detection is the disappearance of the transmitted signal’s phase.In access network,the flexibility and low latency are the two key factors affecting service experience.In this article,we review the evolution of PONs and the challenges of current PONs in detail.We analyze key enabling digital signal processing(DSP)techniques,including detection linearization for direct-detection and simplified coherent detection,adaptive equalizers,digital filer enabled flexible access network and low-latency inter-ONU communications.Finally,we discuss the developing trends of future optical access networks.

MZI wavelength interleaving filter based on double microring structure

To improve the output characteristics of all-fiber Mach-Zehnder interferometer(MZI)-interleaver,a dual microring-assisted MZI interleaver is designed.According to its structure,the output expression of the device is derived from the signal flow diagram.After simulation analysis,the optimal structural parameters during the transmission process are obtained.In addition,the coupling coefficient and transmission loss of the coupler are analyzed.The results show that the improved interleaver output line wave is closer to the square wave,and its 25 dB cutoff band bandwidth and 0.5 dB passband bandwidth are significantly improved,with the values of 41.2 GHz and 18.9 GHz,respectively.The device has a certain resistantability to deviation,and the transmission loss has less influence on the extinction characteristics of the filter.

Effect of PMD-induced Pulse Broadening on Sensitivity and Frequency Spectrum

The PMD-induced pulse broadening may cause the degradation ofreceiver sensitivity and has negative effects on the power spectrumof received signals. The expression s of PMO-induced pulse broadeningeffects on receiver sensitivity are derived based on the concept ofman square pulse width. The effects of PMD on the spectrum ofreceived power are analyzed in detail. Finally, the scheme isdiscussed with which the poser of a certain frequency component isextracted as a feedback control signal in a PMD compensation system.

Exploiting the Faster-Than-Nyquist Concept in Wavelength-Division Multiplexing Systems Using Duobinary Shaping

This paper begins with Nyquist wavelengthdivision multiplexing （WDM） and then introduces fasterthanNyquist. In fasterthanNyquist a certain amount of intersymbol interference （ISI） is accepted, which violates the fundamental principle of Nyquist WDM. This results in muchrelaxed transceiver bandwidth and simpler spectral design. However, in fasterthanNyquist, implementation complexity is shifted from the transmitter side to the receiver side. Therefore, successful application of fasterthanNyquist depends on innovation in the receiver structure. In this paper, we discuss the guidelines for implementing suboptimum, lowcomplexity receivers based on fasterthanNyquist. We suggest that duobinary shaping is a good technique for trading off achievable spectral efficiency, detection performance, and implementation complexity and might be preferable to Nyquist WDM. Experiments are conducted to verify robustness of the proposed technique.

Recent progress on high-speed optical transmission

The recently reported high spectral efficiency （SE） and high-baud-rate szgnal transmission are all Daseo on digital coherent optical communications and digital signal processing （DSP）. DSP simplifies the re- ception of advanced modulation formats and also enables the major electrical and optical impairments to be processed and compensated in the digital domain, at the transmitter or receiver side. In this paper, we summarize the research progress on high-speed signal generation and detection and also show the progress on DSP for high-speed signal detection. We also report the latest progress on multi-core and multi-mode multiplexing.

Beyond 100 Gb/s Optical OFDM Transmitted in Optical Long-Haul System

100 G Ethernet is considered to become the next generation Ethernet standard for IP networks.Typical 100 Gb/s transmission systems and their performance are presented.Comparision and analysis for 100 Gb/s transmission systems have been discussed.It is demonstrated that optical OFDM can be used in future 100 Gb/s/ch and long-haul system.

Blind Nonlinearity Equalization by Machine-Learning-Based Clustering for QAM-Based Quantum Noise Stream Cipher Transmission

In quantum noise stream cipher(QNSC)systems,it is difficult to compensate fiber nonlinearity by digital signal processing(DSP)due to interactions between chromatic dispersion(CD),amplified spontaneous emission(ASE)noise from erbiumdoped fiber amplifier(EDFA)and Kerr nonlinearity.Nonlinearity equalizer(NLE)based on machine learning(ML)algorithms have been extensively studied.However,most NLE based on supervised ML algorithms have high training overhead and computation complexity.In addition,the performance of these algorithms have a lot of randomness.This paper proposes two clustering algorithms based on Fuzzylogic C-Means Clustering(FLC)to compensate the fiber nonlinearity in quadrature amplitude modulation(QAM)-based QNSC system,including FLC based on subtractive clustering(SC)and annealing evolution(AE)algorithm.The performance of FLC-SC and FLC-AE are evaluated through simulation and experiment.The proposed algorithms can promptly obtain suitable initial centroids and choose optimal initial centroids of the clusters to achieve the global optimal initial centroids especially for high order modulation scheme.In the simulation,different parameter configurations are considered,including fiber length,optical signal-to-noise ratio(OSNR),clipping ratio and resolution of digital to analog converter(DAC).Further-more,we measure the Q-factor of transmission signal with different launched powers,DAC resolution and laser linewidth in the optical back-to-back(BTB)experiment with 80-km single mode fiber.Both simulation and experimental results show that the proposed techniques can greatly mitigate the signal impairments.

Relative Intensity Noise in the Single Quantum Well Diode

Based on the mathematical model of quantum well laser diode(QW LDs) developed, the paper presents a relative intensity noise(RIN) model, which employs Gaussian form random noise with its average being to zero. It can be straightforwardly used to describe the effect of the noise on the performance of QW LDs. The RIN becomes notable in the frequency range of interests and therefore affects the device modulation property. The results are in good agreement of the published data. The RIN model proposed and the results can be used for purpose of device technique improvement and performance simulation of optical communication systems and networks.

Optimal Higher-order Dispersion Management Methods in WDM Transmission Systems

In order to reduce the four-wave mixing crosstalk and avoid the signal waveform distortion in long-haul dense-wavelength division multiplexing systems,helpful methods on how to choose suitable local parameters in higher-order dispersion managed line are presented, which are used to increase the system capacity and improve the system performances.

Dispersion Monitoring Techniques in High Bit-rate Optical Communication Systems

For the efficient dynamic dispersion compensation, it is essential to monitor the dispersion accurately. The existing main dispersion monitoring techniques in high bit-rate optical communication systems are presented as well as their operating principles and research progress. The advantages and disadvantages of these methods are analyzed and discussed.