Highly reactive and reusable heterogeneous activated carbons-based palladium catalysts for Suzuki-Miyaura reaction

Suzuki-Miyaura reaction of aryl halides with phenylboronic acid using a heterogeneous palladium catalyst based on activated carbons(AC) was systematically investigated in this work. Two different reaction modes(batch procedure and continuous-flow procedure) were used to study the variations of reaction processing. The heterogeneous catalysts presented excellent reactivity and recyclability for iodobenzene and bromobenzene substrates in batch mode, which can be attributed to stabilization of Pd nanoparticles by the thiol and amino groups on the AC supports. However, significant dehalogenation in the reaction mixture and Pd leaching from the heterogeneous catalysts were observed in continuous-flow mode.This unique phenomenon in continuous-flow mode resulted in a dramatic decline in reaction selectivity and durability of heterogeneous catalysts comparing with that of batch mode. In addition, the heterogeneous Pd catalysts with thiol-and amino-modified AC supports exhibited different reactivity and durability in batch and continuous-flow mode owing to the difference of interaction between Pd species and AC supports.

Novel Oxygen Storage Components Promoted Palladium Catalysts for Emission Control in Natural Gas Powered Engines

A three-way catalyst comprised novel oxygen storage components for emission control in natural gas powered engines was prepared. The addition of novel oxygen storage components to the Pd/γ-Al2O3 catalysts resulted in improved activities of the fresh and aged catalyst by lowering the light-off temperature for methane in natural gas engines exhaust.

Nation-Teflon bimembrane-supported palladium catalysts for Suzuki coupling reactions

Nation-Teflon bimembrane was used as an efficient support for the preparation and application of heterogeneous palladium catalysts. The supported palladium catalysts exhibit high activity and stability in the Suzuki cross-coupling of aryl bromides with arylboronic acids to afford the corresponding biaryls in good to excellent yields, and can be readily recovered and reused several times without significant loss of activity.

Influence of CeO_2 and La_2O_3 on properties of palladium catalysts used for emission control of natural gas vehicles

Pd/YZ-Al2O3 （Y and Zr modified Al2O3, and hereafter, labelled as A1） catalysts with 4 wt% additive CeO2 and/or La2O3 were prepared and characterized by X-ray photoelectron spectroscopy （XPS）, NO-temperature programmed desorption （NO-TPD）, Nz-adsorption/desorption （Branauer-Emmet-Teller BET method）, X-ray diffraction （XRD） and CO-chemisorption. Catalytic activities for CH4, CO and NO conversion were tested in a gas mixture simulated the emissions from natural gas vehicles （NGVs） operated under stoichiometric conditions. The results indicated that all catalysts exhibited excellent catalytic performances for CH4 and CO oxidation and the promoting effect of CeO2 or La2O3 was significant for NO conversion. XPS results showed that the electron density around Pd was increased by CeO2 and/or La2O3, the binding energy of Pd 3d decreased as the order： Pd/Al 〉 Pd/Ce/Al 〉 Pd/La/Al 〉 Pd/CeLa/Al. The electron-rich Pd showed Rh-like catalytic properties which exhibited good activity for the reduction of NO. NO-TPD results showed that the addition of CeO2 and/or La2O3 increased NO adsorption on surface, and promoted the conversion of NO.

Nitric Oxide Reduction Performance of Automotive Palladium Catalysts

Activity of three-way palladium catalyst was examined by means of a pulse-flam-microreactor. The effects of cerium on the catalytic properties of gamma-alumina-supported palladium for the reduction of nitric oxide were studied with X-ray photoelectron spectroscopy (XPS) and temperature-programmed reduction (TPR). The reduction of nitric oxide on palladium catalysts is inhibited significantly by hydrocarbon. However, the reduction of nitric oxide was improved by the addition of cerium to the catalysts. The XPS and TPR studies showed that the presence of cerium provided, palladium oxide in a hard-reduced state and suppressed the chemisorption of hydrocarbons on the palladium oxide. Additionally,cerium could increase surface specific oxygen storage capacity and decrease the apparent activation energy for the rea;ltion CO+NO-->CO2-+-1/2 N-2. So a high conversion of NOx reduction could shift to higher A/F ratio.

Incorporating Sulfur Atoms into Palladium Catalysts by Reactive Metal–Support Interaction for Selective Hydrogenation

Developing highly active and selective catalysts for the hydrogenation of nitroarenes,an environmentally benign process to produce industrially important aniline intermediates,is highly desirable but very challenging.Pd catalysts are generally recognized as active but nonselective catalysts for this important reaction.Here,we report an effective strategy to greatly improve the selectivity of Pd catalysts based on the reactive metal–support interaction.

POLYMERIZATION OF A NEW SUBSTITUTED ACETYLENE BEARING A FURAN RING WITH PALLADIUM ACETYLIDE CATALYSTS

A substituted polyacetylene bearing a furan ring, poly(2-propynyl 2-furoate) (PPF), was synthesized for the first time with palladium acetylide complex catalysts in CHCl3 at 60°C to give a soluble and stable polymer with a yield of ca. 75%. Some features for polymerization of 2-propynyl 2-furoate are described and discussed. The resulting polymer was characterized by IR, GPC and 1H-NMR analysis.

Complete Oxidation of Methane over Palladium Supported on Alumina Modified with Calcium,Lanthanum,and Cerium Ions

The activity and thermal stability of Pd/Al2O3 and Pd/（Al2O3＋MOx） （M=Ca, La, Ce） palladium catalysts in the reaction of complete oxidation of methane are presented in this study. The catalyst supports were prepared by sol-gel method and they were dried either conventionally or with supercritical carbon dioxide. Then they were impregnated with palladium nitrate solution. The catalysts with unmodified alumina had a high surface area. The activity and thermal stability of the aluminasupported catalyst was also very high. The introduction of calcium, lanthanum, or cerium oxide into alumina support caused a decrease of the surface area in the way dependent on the support precursor drying method. These modifiers decreased the activity of palladium catalysts, and they required higher temperatures for the complete oxidation of methane than unmodified Pd/Al2O3. The improvement of the palladium activity by lanthanum and cerium support modifier was observed only at low temperatures of the reaction.

Effect of Lanthanum on Methanol Fuel Exhaust Deep Oxidation over Palladium Catalyst

The performance of deep oxidation of methanol on supported Pd catalyst was exami ned by a chromatograph-micro-reactor. The results show that the add ition of La into γ-Al 2O 3 support can affect greatly the performance of t he Pd catalyst. In the absence of CO, La can decrease the content of oxygen-c ontaining intermediate, although La can not lower the light-off temperature of methanol oxidation. In the presence of CO, La can lower the light-off tem perature, decrease the amount of CO adsorption, and weaken evidently 'CO inhibi tion' to the oxidation of methanol. By XPS technique, it is shown that La modi fies the electronic structure of Pd, which attributes to the modifications of th e catalytic performance.

Heck Arylation of Acrylonitrile with Aryl Iodides Catalyzed by a Silica-bound Arsine Palladium(0) Complex

Acrylonitrile reacts with aryl iodides in the presence of tri-n-butylamine and a catalytic amount of a silica-bound arsine palladium(0) complex to afford stereoselectively (E)-cinnamo- nitriles in high yields.

Catalytic Hydrogenation over Palladium Complex of Molecular Complex of Poly(4-vinylpyridine) with Acetic Acid

The palladium complex of the molecular complex of poly(4 vinylpyridine) with acetic acid(PVP/ HAc Pd) was prepared. Its catalytic activity for the hydrogenation of nitrobenzene was found much higher than that of the corresponding palladium complex of poly(4 vinylpyridine). In the presence of a strong inorganic alkali, especially potassium hydroxide, the catalytic activity is greatly improved. The suitable hydrogenation condition for PVP/HAc Pd is to use 0 1 mol/L ethanol solution of potassium hydroxide as the hydrogenation medium and the hydrogenation is carried out at 45 ℃.

In-Situ FTIR Study on Effect of Lathanum on Oxidation Mechanism of Methanol Automobile Exhaust on Supported Palladium Catalyst

The performance of severe oxidation of methanol on 0.1%Pd supported on alumina was studied by a combined device of chromatograph-micro reactor. The results show that the addition of La into γ-Al 2O 3 as support can affect the performance of Pd catalyst greatly. By using Pd catalyst containing La in methanol oxidation, though, the ignition temperature is not lower than that by using Pd catalyst, the presence of La does suppress the formation of oxygenic intermediates. The results by in-situ FTIR show that the presence of La in the support affects the adsorbed species and hence the mechanism of severe oxidation of methanol on Pd catalyst.

Palladium Catalyzed Synthesis of Fluorine-containing 3-Biaryl-1-ferrocenyl-2-propene-1-one

The novel organometallic compounds, 3-[4'(or 2')-(4''-fluorophenyl)] phenyl-1-ferroc- enyl-2-propen-1-ones 5 were synthesized for nonlinear optical chromophores by Pd (0) catalyzed Suzuki cross-coupling reaction. Their structures were established with elemental analysis, MS, IR and H NMR spectroscopies. 1

Enantioselective Alternating Copolymerization of Propylene with Carbon Monoxide Using Cationic Palladium-Chiral Diphosphine Catalyst

Enantioselective alternating copolymerization of carbon monoxide with propylene was carried out using palladium catalyst modified by 1,4-3,6-dianhydro-2,5-dideoxy-2,5-bis (diphenylphosphino)-L-iditol (DDPPI). The chiral diphosphine was proved to be effective at enantioselective copolymerization. Optical rotation, elemental analysis, H-1, C-13-NMR and IR spectra showed that the copolymer was optically active, isotactic, alternating poly(1,4-ketone) structure.

MODIFICATION OF PALLADIUM METALLIC CATALYST WITH POLYMER-ANCHORED THIOETHER LIGANDS

A well-dispersed metallic palladium catalyst modified by polymer-anchored thioether ligands was used for the hydrogenation of cyclopentadiene to cyclopentene with high activity and selectivity in ambient condition. The evidences to show the modification of catalytic properties by polymer anchored ligands were given.

Synthesis of （2E）－α，β－Unsaturated Amides Catalyzed by Micro Palladium Under Solid－Liquid Phase－Transfer Conditions

Ｓｙｎｔｈｅｓｉｓｏｆ（２Ｅ）－α，β－ＵｎｓａｔｕｒａｔｅｄＡｍｉｄｅｓＣａｔａｌｙｚｅｄｂｙＭｉｃｒｏＰａｌｌａｄｉｕｍＵｎｄｅｒＳｏｌｉｄ－ＬｉｑｕｉｄＰｈａｓｅ－ＴｒａｎｓｆｅｒＣｏｎｄｉｔｉｏｎｓＤＵＪｉｎ－ｘｉｎｇ（Ｄｅｐａｒｒｍｅｎｔｏ...

Preparation of microcapsule-supported palladium catalyst using SPG (Shirasu Porous Glass)emulsification technique

A new method for the preparation of microcapsule-supported palladium catalyst was described.The highly monodisperse crosslinked polystyrene microcapsules containing phosphine ligand were synthesized by the self-assembling of phase separated polymer （SaPSeP） method using diphenyl（4-vinylphenyl） phosphine and divinylbenzene as a monomer and crosslinking agent,respectively, and 2,2＇-azobisisobutyronitrile（AIBN） as an initiator within the droplets of oil-in-water（O/W） emulsions,which were prepared by using the Shirasu Porous Glass（SPG） membrane emulsification technique.The prepared microcapsule-supported palladium catalyst exhibited high catalytic activity for Heck reaction and can be reused several times without loss of activity.