Parametric Influence on Thermal Performance of Flat Plate Closed Loop Pulsating Heat Pipes

This paper presents an experimental study on a flat plate closed loop pulsating heat pipes. It consisted of total 40 channels with square cross section （2 × 2 mm^2, 165 mm long） machined directly on an aluminum plate（180×120×3 nm^2）, which was covered by a transparent plate. The working fluid employed was ethanol. As the results, the influence parameters of thermal performance were investigated, such as filling ratio, heat load and operational orientations etc. Filling ratio was found to be a critical parameter, and its effect was rather complicated. According to its values the PHP plate could have four distinct working zones with different operational characteristics and heat transfer performance. The effect of heat load on thermal performance was found to be positive, and in general, iucrcasing the heat load would improve heat transfer performance. In order to analyze the effect of gravity on thermal performance, three different heat modes and total seven tilt angles were tested and compared. Successful operation at all orientations with respect to gravity was also achieved.

INFLUENCE OF SHOT AND STEP RESPONSE ON PARAMETRIC SENSITIVITY UNDER THE STIMULUS-RESPONSE OF ANALYSIS

Shot and step response measurements were carried out with inert bed and adsorption bed both under iso-thermal conditions.Parameter values were determined from a time domain analysis of the measured inputand response signal.Sensitivity test in the parameter values showed that shot response measurements maygive more reliable parameter values than step measurements.Since Kubin[1]and Kucera[2]proposed a parameter estimation technique based on a moment methodfor adsorption system,attention has been focused on dynamic input-output measurements with variouspacked bed systems for the parameter estimation.The object of this work is to compare shot and step re-sponse measurements and see which measurement gives more reliable parameter values.

Two-Phase Flow Modeling in a Single Closed Loop Pulsating Heat Pipes

Mathematical modeling of pulsating heat pipes through ‘first’ principles is a contemporary problem which remains quite elusive. Simplifications and assumptions made in all the modeling approaches developed so far render them unsuitable for engineering design. In this paper, a more realistic modeling scheme is presented which provides considerable try for thought toward the next progressive step. At high enough heat flux level, closed loop pulsating heat pipes experience a bulk internal unidirectional fluid circulation. Under such a condition, conventional two-phase flow modeling in capillary tubes may be applied. This has been attempted for single-loop PHPs. A homogeneous model and a separated two-fluid flow model based on simultaneous conservation of mass, momentum and energy, have been developed for an equivalent ‘open flow’ system. The model allows prediction of two-phase flow parameters in each sub-section of the device thereby providing important insights into its operation. The concept of ‘void fraction constraint’ in pulsating heat pipe operation is introduced and its relevance to future modeling attempts is outlined.