Performance analysis of LDPC codes on OOK terahertz wireless channels

Atmospheric absorption, scattering, and scintillation are the major causes to deteriorate the transmission quality of terahertz（THz） wireless communications. An error control coding scheme based on low density parity check（LDPC） codes with soft decision decoding algorithm is proposed to improve the bit-error-rate（BER） performance of an on-off keying（OOK） modulated THz signal through atmospheric channel. The THz wave propagation characteristics and channel model in atmosphere is set up. Numerical simulations validate the great performance of LDPC codes against the atmospheric fading and demonstrate the huge potential in future ultra-high speed beyond Gbps THz communications.

Construction of protograph LDPC codes with circular generator matrices

The application of protograph low density parity check （LDPC） codes involves the encoding complexity problem. Since the generator matrices are dense, and if the positions of ＂1＂ s are irregularity, the encoder needs to store every ＂1＂ of the generator matrices by using huge chip area. In order to solve this problem, we need to design the protograph LDPC codes with circular generator matrices. A theorem concerning the circulating property of generator matrices of nonsingular protograph LDPC codes is proposed. The circulating property of generator matrix of nonsingular protograph LDPC codes can be obtained from the corresponding quasi-cyclic parity check matrix. This paper gives a scheme of constructing protograph LDPC codes with circulating generator matrices, and it reveals that the fast encoding algorithm of protograph LDPC codes has lower encoding complexity under the condition of the proposed theorem. Simulation results in ad- ditive white Gaussian noise （AWGN） channels show that the bit error rate （BER） performance of the designed codes based on the proposed theorem is much better than that of GB20600 LDPC codes and Tanner LDPC codes.

Construction of time-frequency codes based on protograph LDPC codes in OFDM communication systems

This paper proposes a scheme to construct time- frequency codes based on protograph low density parity check （LDPC） codes in orthogonal frequency division multiplexing （OFDM） communication systems. This approach synthesizes two techniques： protograph LDPC codes and OFDM. One symbol of encoded information by protograph LDPC codes corresponds to one sub-carrier, namely the length of encoded information equals to the number of sub-carriers. The design of good protograph LDPC codes with short lengths is given, and the proposed proto- graph LDPC codes can be of fast encoding, which can reduce the encoding complexity and simplify encoder hardware implementa- tion. The proposed approach provides a higher coding gain in the Rayleigh fading channel. The simulation results in the Rayleigh fading channel show that the bit error rate （BER） performance of the proposed time-frequency codes is as good as random LDPC- OFDM codes and is better than Tanner LDPC-OFDM codes under the condition of different fading coefficients.

High Robust Broadcasting over DTMB-A with Low-rate LDPC Codes

As the 2nd generation digital terrestrial television broadcasting(DTTB)standard,digital terrestrial/television multimedia broadcasting-advanced(DTMB-A)can provide higher spectrum efficiency and transmission reliability by adopting flexible frame structure and advanced forward error correction coding compared with the 1 st generation DTTB systems.In order to increase the flexibility and robustness of the DTTB network,the frequency reuse scheme of factor one(reuse-1)is proposed,where the same RF channel is used by different stations covering the adjacent service areas.However,it demands a very low carrier-tonoise ratio(C/N)threshold below 0 dB at the DTTB physical layer.In this paper,a robust broadcasting technique is proposed based on DTMB-A with newly designed low-rate low density parity check(LDPC)codes.By adopting quasi-cyclic(QC)Raptor-like structure and progressive lifting method,the high performance low-rate LDPC codes are designed supporting multiple code lengths.Both density-evolution analyses and laboratory measurements demonstrate that DTMB-A with low-rate coding can complete the demodulation reliably with the C/N threshold below0 d B,which is one important necessary condition to support frequency reuse-1 scheme.

A NOVEL CONSTRUCTION OF QUANTUM LDPC CODES BASED ON CYCLIC CLASSES OF LINES IN EUCLIDEAN GEOMETRIES

The dual-containing (or self-orthogonal) formalism of Calderbank-Shor-Steane (CSS) codes provides a universal connection between a classical linear code and a Quantum Error-Correcting Code (QECC). We propose a novel class of quantum Low Density Parity Check (LDPC) codes constructed from cyclic classes of lines in Euclidean Geometry (EG). The corresponding constructed parity check matrix has quasi-cyclic structure that can be encoded flexibility, and satisfies the requirement of dual-containing quantum code. Taking the advantage of quasi-cyclic structure, we use a structured approach to construct Generalized Parity Check Matrix (GPCM). This new class of quantum codes has higher code rate, more sparse check matrix, and exactly one four-cycle in each pair of two rows. Ex-perimental results show that the proposed quantum codes, such as EG(2,q)II-QECC, EG(3,q)II-QECC, have better performance than that of other methods based on EG, over the depolarizing channel and decoded with iterative decoding based on the sum-product decoding algorithm.

Area-efficient analog decoder design for low density parity check codes in deep-space applications

Area-efficient design methodology is proposed for the analog decoding implementations of the rate-l/2 accumulate repeat-4 jagged-accumulate （AR4JA） low density parity check （LDPC） code. The proposed approach is designed using optimized decoding architecture and regularized routing network, in such a way that the overall wiring overhead is minimized and the silicon area utilization is significantly improved. The prototyping chip used to verily the approach is tully integrated in a four-metal double-poly 0.35 lam complementary metal oxide semiconductor （CMOS） technology, and includes an input-output interface that maximizes the decoder throughput. The decoding core area is 2.02 mm2 with a post-layout area utilization of 80%. The decoder was successfully tested at the maximum data rate of 10 Mbit/s, with a core power consumption of 6.78 mW at 3.3 V, which corresponds to an energy per decoded bit of 0.677 nJ. The proposed analog LDPC decoder with low processing power and high-reliability is suitable lbr space- and power-constrained spacecraft system.

Optimized LDPC differential-encoded 16QAM scheme for high-speed transmission systems

The 16-ary quadrature amplitude modulation （16QAM） is a high spectral efficient scheme for high-speed transmission systems. To remove the phase ambiguity in the coherent detection system, differential-encoded 16QAM （DE-16QAM） is usually used, however, it will cause performance degradation about 3 dB as compared to the conventional 16QAM. To overcome the performance loss, a serial concatenated system with outer low density parity check （LDPC） codes and inner DE-16QAM is proposed. At the receiver, joint iterative differential demodulation and decoding （ID） is carried out to approach the maximum likelihood performance. Moreover, a genetic evolution algorithm based on the extrinsic information transfer chart is proposed to optimize the degree distribution of the outer LDPC codes. Both theoretical analyses and simulation results indicate that this algorithm not only compensates the performance loss, but also obtains a significant performance gain, which is up to 1 dB as compared to the conventional non-DE-16QAM.

An Enhanced LDPC Coded Partial Incremental Redundancy HARQ Scheme

An enhanced scheme is proposed for high code rate low density parity check （LDPC） coded partial incremental redundancy （PIR） hybrid automatic repeat request （HARQ）. It employs the unequal error protection （UEP） technique for incremental redundancy bits and uses the constellation rearrangement （CoRe） technique for information bits in retransmissions so as to reduce the reliability variances of all encoded bits after soft combining. Simulation results show that the proposed scheme applies to both regular LDPC and irregular LDPC cases and can efficiently improve frame error rate （FER） performance and throughput performance.

LDPC Code’s Decoding Algorithms for Wireless Sensor Network:a Brief Review

As an effective error correction technology,the Low Density Parity Check Code(LDPC)has been researched and applied by many scholars.Meanwhile,LDPC codes have some prominent performances,which involves close to the Shannon limit,achieving a higher bit rate and a fast decoding.However,whether these excellent characteristics are suitable for the resource-constrained Wireless Sensor Network(WSN),it seems to be seldom concerned.In this article,we review the LDPC code’s structure brief.ly,and them classify and summarize the LDPC codes’construction and decoding algorithms,finally,analyze the applications of LDPC code for WSN.We believe that our contributions will be able to facilitate the application of LDPC code in WSN.

Multiple accumulated-crossover parallel concatenated SPC codes

By constructing an accumulated-crossover relationship in multiple parallel concatenated single parity check （M-PC-SPC） codes, a class of error-correcting codes, termed multiple accumulated-crossover parallel concatenated single parity check （M-ACPC-SPC） codes, is proposed. M-ACPC-SPC codes possess linear encoding complexity and can be decoded iteratively with low complexity by the sum-product algorithm （SPA）. Simulation results show that M-ACPC-SPC codes have lower error floors than M-PCSPC codes with the same dimension, and when the dimension is 5, M-ACPC-SPC codes achieve bit error rate （BER） better than （3, 6） regular low density parity check （LDPC） codes.

Study on the distribution law of random code structure of irregular LDPC codes and its application in eliminating short cycles

The distribution law of the random code structure of randomly constructed irregular low-density parity-check （LDPC） codes is studied, Based on the Progressive Edge-Growth （PEG） algorithm, a new algorithm which can both ellminate short cycles and keep the distribution of the random code structure is presented, The experimentsl results show that the performance of the irregular LDPC codes constructed by the new algorithm is superior to that of the PEG algorithm,

A new construction method of LDPC codes for optical transmission systems

Based on the construction method of system- atically constructed Gallager （SCG）（4, k） code, a new improved construction method of low density parity check （LDPC） code is proposed. Compared with the construction method of SCG（4, k） codes improved before, the proposed construction method has some advantages, such as saving storage space and reducing computation complexity in the hardware implementation. And then LDPC（5929, 5624） code with 5.42% redundancy is constructed by the proposed method. The simulation results and analysis show that the constructed LDPC（5929, 5624） code has better error-correction performance, lower redundancy and lower decoding complexity than those of a classic Reed- Solomon （RS）（255, 239） code. Therefore, LDPC（5929, 5624） code, constructed by the proposed construction method on LDPC codes, can better suitable for optical transmission systems.

LDPC Decoder for CCSDS Code by Flipping Bits and Fetching Words

The well-known CCSDS(consultative committee for space data systems) LDPC(low density parity check) code for near-earth applications is discussed and used for a case study of Mc Eliece system. First, a data error is picked out with the CCSDS LDPC code. The problem with its generator matrix is illustrated and overcome by a shortened code with some middle code bits deleted. In correspondence, its parity check matrix is also revised with the new quasi-cyclic(QC)-LDPC code. Second, a fast decoding scheme for general QC-LDPC codes is proposed based on flipping bits and fetching words. Besides, a lightweight CCSDS LDPC code based Mc Eliece system can be set up with such codes. The repaired CCSDS LDPC code is supposed to be still useful for communications and storages, and the normalized decoding algorithm is also efficient for general QC-LDPC codes.

Low Complexity LDPC Decoder with Modified Sum-Product Algorithm

This paper describes an efficient implementation of the Sum-Product Algorithm （SPA） within a Low Density Parity Check （LDPC） code decoder, where a horizontal process correction term is used to improve the decocling performance of the Min-Sum algorithms. The correction term is implemented as a look-up table. The algorithm uses the correction term redundancy by means of a coordinate transformation to reduce the hardware complexity. Simulations and hardware tests indicate that the decoding performance is very good with the appropriate look-up table