The pilot test of Pt-Pd and Pt-Rh feeds extracted and separated with a new sulfoxide extractant

Platinum, palladium and rhodium of the raw feeds extracted and separated with a new sulfoxide extractant （MSO） were studied in the paper. The pilot test results showed that the percentage extractions are more than 99% for platinum and palladium in Pt-Pd feed, and the percentage strippings are 100% and 99.2% with HCl and ammonia, respectively. The ratio of palladium to platinum is 0.0016 in stripping platinum solution, and the ratio of platinum to palladium is 0.0020 in stripping palladium solution. The percentage extraction of platinum is 99% in Pt-Rh feed, and the percentage stripping is 100%. The ratio of rhodium to platinum is 0.0002 in stripping platinum solution. Therefore, platinum, palladium, and rhodium feeds are separated effectively with MSO.

Feasibility and simulation model of a pilot scale membrane bioreactor for wastewater treatment and reuse from Chinese traditional medicine

The lack and pollution of water resource make wastewater reuse necessary. The pilot scale long-term tests for submerged membrane bioreactor were conducted to treat the effluents of anaerobic or aerobic treatment process for the high-strength Chinese traditional medicine wastewater. This article was focused on the feasibility of the wastewater treatment and reuse at shorter hydraulic retention time （HRT） of 5.0, 3.2 and 2.13 h. MLSS growth, membrane flux, vacuum values and chemical cleaning periods were also investigated. The experimental results of treating two-phase anaerobic treatment effluent demonstrated that the CODfilt was less than 100 mg/L when the influent COD was between 500-10000 mg/L at HRT of 5.0 h, which could satisfy the normal discharged standard in China. The experimental results to treat cross flow aerobic reactor effluent demonstrated that the average value of CODfilt was 17.28 mg/L when the average value of influent COD was 192.84 mg/L at HRT of 2.13 h during 106 d, which could completely meet the normal standard for water reuse. The maximum MLSS and MLVSS reached 24000 and 14500 mg/L at HRT of 3.2 h respectively. Membrane flux had maximal resume degrees of 94.7% at vacuum value of 0.02 MPa after cleaning. Chemical cleaning periods of membrane module were 150 d. A simulation model of operational parameters was also established based on the theory of back propagation neural network and linear regression of traditional mathematical model. The simulation model showed that the optimum operational parameters were suggested as follows： HRT was 5.0 h, SRT was 100 d, the range of COD loading rate was between 10.664-20.451 kg/（m3.d）, the range of MLSS was between 7543-13694 mg/L.

Pilot Test for Nitrogen Foam Flooding in Low Permeability Reservoir

Due to the characteristics of reservoir formation,the producing level of low permeability reservoir is relatively very low.It is hard to obtain high recovery through conventional development schemes.Considering the tight matrix,complex fracture system,low production level of producers,and low recovery factor ofMblock in Xinjiang oilfield,it is selected for on-site pilot test of nitrogen foam flooding.Detailed flooding scheme is made and the test results are evaluated respectively both for producers and injectors.The pressure index,filling degree,and fluid injection profile are found to be all improved in injectors after injection of nitrogen foam.The oil production,water cut and liquid production file are also improved in most of the producers,with the natural decline rate in the test area become slow.Results show that nitrogen foam flooding technology can be good technical storage for enhanced oil recovery in low permeability reservoir.

SINOPEC's Success in Fixed-bed Methanol-to-Propylene Pilot Scale Tests

The first in China pilot tests of fixed-bed methanol-topropylene unit were successfully implemented at the Yangzi Petrochemical Company(YPC).It is told that this technology has opened up a new process for production of propylene through coal gasification,and China has possessed both the fluidized-bed methanolto-propylene process(F-MTP)and the

Preparation and Commercial Application of ZHC-01 Hydrocracking Catalyst

The ZHC-01 hydrocracking catalyst, characterized by high hydrogenation activity, good selectivity for middle distillates, strong resistance to nitrogen poisoning, was prepared by co-gelling. The catalyst is not only suited to the single-stage hydrocracking process, but also to the first stage of serial hydrocracking process. In parallel with the fully loaded operation of the 1.4 Mt/a hydrocracking unit at the SINOPEC Qilu Petrochemical Company, a pilot test of the ZHC-01 catalyst was also carried out on the hydrocracking unit. The test results indicated that the activity, the yield of major target products and quality of the ZHC-01 catalyst could comply with the design requirements for the hydrocracking unit, and this catalyst could be applied in the hydrocracking unit. The commercial test results showed that the ZHC-01 catalyst, featuring good activity, stability, and flexibility in production, not only could meet the demand for producing environmentally friendly middle distillates, but could also increase the resource of optimized steam cracking feedstock.

Treatment of Chinese traditional medicine wastewater in a submerged membrane bioreactor

A pilot scale test was conducted in a submerged membrane bioreactor SMBR with capacity of 10. 0 m^3/d for 120 days to treat high-strength Chinese traditional medicine wastewater. Performance of the SMBR was investigated with a sludge retention time （ TSR ） of 50 days, a hydraulic retention time （ THR ） of 8.0 h, membrane flux of 8. 0 IV（ m^2 · h） and dissolved oxygen （DO） concentration of 2. 0 - 3. 0 mg/L, respectively. It was observed that the SMBR had high capacity of COD and suspended solid （SS） removal. The influent COD concentration was fluctuated between I 000 and 5 000 mg/L, while the averaged effluent COl） concentration was only 44. 6 mg/L. The influent SS concentration was fluctuated between 1 000 and 1 600 mg/L, while little effluent SS was detected. It was found that the COD remove rate increased with mixed liquor suspended solids （MLSS） and organic loading rate （ROL）. In order to obtain good-quality effluent, the operational conditions of the SMBR were suggested as follows： the temperature was controlled above 10 ℃, MLSS about 7000 mg/L, R,L under 24. 76 kg/（ m^3 · d）, low vacuum value and constant water flux.

Pilot test of polymer microsphere alternate surfactant flood(PMAS)with mixtures of anionic-cationic surfactants under harsh conditions in a sandstone reservoir

The first pilot test of polyacrylamide microsphere alternate surfactant flood(PMAS)with mixtures of anionic-cationic surfactants(Sa/c)was carried out for a high-temperature,high-salinity,and highhardness sandstone reservoir to demonstrate the potential of this novel technique to improve oil recovery.A critical micelle concentration(CMC)of 4.82 mg/L,an ultralow interfacial tension(IFT)of 8104 mN/m,and a high oil solubilization of 22 were obtained.Static and dynamic adsorptions of Sa/c on natural core containing 15 wt%clay were reduced to about 2.20 and 0.30 mg/g-core,respectively,with the addition of adsorption inhibitor(AI).Since June 2014,the pilot test of PMAS was carried out in a Sinopec reservoir with a temperature of 87C,a salinity of 260,393 mg/L,and a hardness of 6,401 mg/L.Twelve cycles of alternative injection of 0.0125 PV Sa/c with a concentration of 0.1%and 0.0125 PV polyacrylamide microsphere with a concentration of 0.2%were conducted at an injection rate of 0.1 PV/yr,for a total of 0.3 PV chemical injection.As a result,the net daily oil production increased from 0 t to 6.5 t,and the water cut decreased from 96.3%to 93.8%,leading to an ultimate improved oil recovery of 6.3%original oil-in-place.

Development of an educational cartoon to prevent worm infections in Chinese schoolchildren

Background:With more than two billion people infected worldwide,soil-transmitted helminths(STH)are the most widespread infections.To date,STH control efforts rely predominantly on recurrent mass drug administration(MDA),which does not prevent reinfection.Additional public health measures including novel health educational tools are required for more sustained integrated control of STH.We describe the development of an educational cartoon video(The Magic Glasses)targeting STH infections in Chinese schoolchildren and its pilot testing in China.We applied an extensive community-based mixed methods approach involving input from the target group of 9–10 year old schoolchildren and key informants,such as teachers,doctors and parents,in order to identify potential STH infection risks in the study area and to formulate key messages for the cartoon.The development of the educational cartoon included three major steps:formative research,production,and pilot testing and revision.Results:We found that most adults and approximately 50%of the schoolchildren were aware of roundworm(Ascaris)infection,but knowledge of transmission,prevention and treatment of STH was poor.Observations in the study area showed that unhygienic food practices,such as eating raw and unwashed fruit or playing in vegetable gardens previously fertilised with human faeces,posed major STH infection risks.Conclusions:It was crucial to assess the intellectual,emotional,social and cultural background of the target population prior to video production in order to integrate the key messages of the cartoon into everyday situations.Overall,our strategy for the development of the cartoon and its incorporation into a health education package proved successful,and we provide a summary of recommendations for the development of future educational videos based on our experiences in China.

Development of solid base catalyst X/Y/MgO/-Al_(2)O_(3) for optimization of preparation of biodiesel from Jatropha curcas L.seed oil

The preparation and regeneration conditions of the identified catalyst X/Y/MgO/?-Al2O3 with high catalytic activity were studied and optimized. The biodiesel was prepared by transesterification of Jatropha curcas seed oil produced in Guizhou with methanol at its reflux temoerature in the presence of X/Y/MgO/?-Al2O3 . The pilot plant tests were carried out in a 100 L reaction vessel. Both average yield and fatty acid methyl esters (FAME) content reached more than 96.50% under the optimum reaction conditions of the pilot plant tests designed with an oil/methanol molar ratio of 1 : 10, catalyst concentration of 1.00%, and reaction time of 3 h at reflux temperature. In addition, analysis shows that the quality of biodiesel meets the standard EN 14214.