期刊文献+
共找到8篇文章
< 1 >
每页显示 20 50 100
Numerical investigations of asymmetric flow of a micropolar fluid between two porous disks 被引量:4
1
作者 Muhammad Ashraf M.Anwar Kamal K.S.Syed 《Acta Mechanica Sinica》 SCIE EI CAS CSCD 2009年第6期787-794,共8页
Numerical solution is presented for the two- dimensional flow of a micropolar fluid between two porous coaxial disks of different permeability for a range of Reynolds number Re (-300≤ Re 〈 0) and permeability para... Numerical solution is presented for the two- dimensional flow of a micropolar fluid between two porous coaxial disks of different permeability for a range of Reynolds number Re (-300≤ Re 〈 0) and permeability parameter A (1.0≤A ≤2.0). The main flow is superimposed by the injection at the surfaces of the two disks. Von Karman's similarity transformations are used to reduce the governing equations of motion to a set of non-linear coupled ordinary differential equations (ODEs) in dimensionless form. An algorithm based on the finite difference method is employed to solve these ODEs and Richardson's extrapolation is used to obtain higher order accuracy. The results indicate that the parameters Re and A have a strong influence on the velocity and microrotation profiles, shear stresses at the disks and the position of the viscous/shear layer. The micropolar material constants cl, c2, c3 have profound effect on microrotation as compared to their effect on streamwise and axial velocity profiles. The results of micropolar fluids are compared with the results for Newtonian fluids. 展开更多
关键词 porous disks . Asymmetric flow .Micropolar fluid . Finite differences.viscous layer
下载PDF
Review on the Development of Oil and Gas Flow in Underground Porous Media 被引量:1
2
作者 李军诗 王晓冬 +1 位作者 刘鹏程 侯晓春 《Petroleum Science》 SCIE CAS CSCD 2004年第4期88-94,共7页
Through reviewing the flow theory’s birth and development history in underground porous media and contrasting the mechanics of underground fluids and mechanics of viscous fluids, this paper points out the main facto... Through reviewing the flow theory’s birth and development history in underground porous media and contrasting the mechanics of underground fluids and mechanics of viscous fluids, this paper points out the main factors, which affect the development of the theory on oil and gas porous flow. The development law and development route of the mechanics of fluids in porous media are also summarized in this paper. 展开更多
关键词 porous flow mechanics of fluids in porous media viscous fluids mechanics of ground water petroleum and natural gas engineering REVIEW PROGRESSION
下载PDF
Entropy generation for mixed convection flow in vertical annulus with two regions hydromagnetic viscous and Cu-Ag water hybrid nanofluid through porous zone: a comparative numerical study
3
作者 T.Rahim J.Hasnain +1 位作者 N.Abid Z.Abbas 《Propulsion and Power Research》 SCIE 2022年第3期401-415,共15页
The primary determination of this study is a numerical investigation of the entropygeneration (EG) in the steady two-region flow of viscous fluid and hybrid nanofluid (NF) in along-infinite vertical annulus having a c... The primary determination of this study is a numerical investigation of the entropygeneration (EG) in the steady two-region flow of viscous fluid and hybrid nanofluid (NF) in along-infinite vertical annulus having a clear region as well as porous media. Stoke’s and single-phase NF models are used to study the viscous fluid and hybrid nanofluid (HNF) heat transferdevelopments, respectively. Two types of nanoparticles are taken, such as copper (Cu) and sil-ver (Ag) within base fluid water to make it a HNF. Darcy-Brinkman law is also used to examinethe flow through the porous zone in the annulus. Necessary quantities have been used in thesystem of equations to transfer them into non-dimensional forms. For momentum and energytransport, the numerical results are evaluated for various model parameters and are examinedvia the shooting method in MATHEMATICA. It is noted that the momentum and energy trans-port are more significant when two immiscible fluids in a clear vertical annulus are taken. Thefindings also indicate that two-phase momentum and heat flow are greater when a NF is used in Region-II and lower when a HNF is used. The temperature (in Region-II) falls with a high na-nomaterials volume fraction (see Figure 4) while it is increased when the Hartman number isincreased. Moreover, velocity declines with increment in nanomaterials volume fraction. Thus,higher thermal conductivity can be accomplished by using a magnetic field. 展开更多
关键词 Two-phase flow Hybrid nanofluid viscous fluid porous zone Vertical annulus Entropy generation
原文传递
聚合物驱油粘性流体渗流的分形研究 被引量:2
4
作者 田根林 孙立群 +2 位作者 孙永达 鞠岩 孙广煜 《石油学报》 EI CAS CSCD 北大核心 1998年第4期73-76,共4页
针对聚合物驱油两相渗流过程中的指进现象,建立了平面可视的渗流实验装置与实验方法和图像及数据处理方法。以驱替的波及面积为主要参数,建立了分维计算方法,并通过不同粘度的驱替液的驱油实验,确证油水两相的驱替渗流过程是分维的... 针对聚合物驱油两相渗流过程中的指进现象,建立了平面可视的渗流实验装置与实验方法和图像及数据处理方法。以驱替的波及面积为主要参数,建立了分维计算方法,并通过不同粘度的驱替液的驱油实验,确证油水两相的驱替渗流过程是分维的,同时得出了分维数是和聚合物驱替液粘度间的函数关系。由五点法井网注采模型上进行的实验现象表明,随着聚合物溶液浓度增加其粘度也增加,驱油时其前缘的推进也愈均匀。定量计算结果表明,随着聚合物溶液粘度增加,分维数也增大。如用不含聚合物的清水驱替时,分维数是1.563,当用1500mg/L的聚合物溶液驱替时,分维数是1.791;当聚合物浓度为4000mg/L时,分维数增加到1.956,且很接近于完全波及时的极限值2.0。这表明:用聚合物溶液驱油,驱替波及过的地方“破碎”程度减小,波及效果增加。这一实验和理论计算结果表明,用聚合物溶液驱油时,在扩大波及系数的同时,还可提高波及效果。从微观上讲,聚合物驱还可以降低残余油饱和度,提高洗油系数,其量和聚合物溶液粘度有关。 展开更多
关键词 聚合物驱油 粘性流体 渗流 分形研究 提高采收率
下载PDF
圆管聚合物热流中黏性耗散分析的无网格模拟 被引量:4
5
作者 张小华 欧阳洁 张林 《化工学报》 EI CAS CSCD 北大核心 2007年第1期15-20,共6页
以与温度相关的指数定律作为本构方程,应用无网格方法模拟了外表面为恒温时的圆管内具有黏性耗散的聚合物流动热传导问题,给出了离入口不同位置处的温度分布。计算结果表明:根据黏性耗散模型计算的温度比无黏性耗散模型高出64℃,从而说... 以与温度相关的指数定律作为本构方程,应用无网格方法模拟了外表面为恒温时的圆管内具有黏性耗散的聚合物流动热传导问题,给出了离入口不同位置处的温度分布。计算结果表明:根据黏性耗散模型计算的温度比无黏性耗散模型高出64℃,从而说明了黏性耗散在聚合物流动热传导问题中具有举足轻重的作用。并且,无论是无黏性耗散模型,还是黏性耗散模型,其极限温度与壁面温度有很大的关系,但与入口温度无关。 展开更多
关键词 热传导 黏性耗散 非牛顿流体 聚合物流动 无网格方法
下载PDF
Transient pressure analysis in porous and fractured fractal reservoirs 被引量:1
6
作者 KONG XiangYan LI DaoLun LU DeTang 《Science China(Technological Sciences)》 SCIE EI CAS 2009年第9期2700-2708,共9页
Fluid flow in porous and fractured fractal reservoirs is studied in the paper. The basic formulae of seepage velocity,permeability and porosity in both porous and fractured fractal media are developed. The pressure di... Fluid flow in porous and fractured fractal reservoirs is studied in the paper. The basic formulae of seepage velocity,permeability and porosity in both porous and fractured fractal media are developed. The pressure diffusion equation of slightly compressible fluid in fractal reservoirs is derived. The analytical solutions of the transient pressure are given for the line-source well and the well with well-bore storage and skin factor. The typical curves of pressure and the derivative of pressure are established,along with the interpretation of the well-testing method via type-curve matching. In addition,3-D pressure diffusion equations for anisotropic fractal media are given in both Cartesian coordinates and Cy-lindrical coordinates. 展开更多
关键词 fluid flow porous MEDIA fractal MEDIA PERMEABILITY POROSITY type-curves for fractal RESERVOIRS anisotropic MEDIA
原文传递
多孔介质中的粘性指进与分形特征(英文)
7
作者 侯望奇 江体乾 《湘潭大学自然科学学报》 CAS CSCD 1993年第1期167-177,共11页
本文介绍了多孔介质中粘性指进现象的研究进展,景响粘性指进过程的因素很多,主要受流体与介质的润湿性及驱替液与被驱替液的粘度的影响。本文还讨论了利用计算机模拟研究多孔介质内流体流动及分形特性,粘性指进的分维在1.70左右。
关键词 流体流动 粘性指进 分形学 多孔介质
下载PDF
聚合物粘(液)流成膜力学
8
作者 沈爱梓 《渝州大学学报》 1991年第2期21-28,共8页
聚合物粘液(如涂料,漆、树脂等)通过导轨(如机口,载运带,载体等,在重力作用下或粘附力作用下,或挤压力作用上)流延成膜技术已在塑料、绝缘、包装、照相、装饰、建筑、防腐蚀等工业领域中广泛使用,本文目的是研究聚合物粘流在等温条件下... 聚合物粘液(如涂料,漆、树脂等)通过导轨(如机口,载运带,载体等,在重力作用下或粘附力作用下,或挤压力作用上)流延成膜技术已在塑料、绝缘、包装、照相、装饰、建筑、防腐蚀等工业领域中广泛使用,本文目的是研究聚合物粘流在等温条件下通过导轨流延成膜过程中,平均流速与机口间距的关系,与制平板膜的条件,以助制膜质量的提高。 展开更多
关键词 聚合物粘 成膜 牛顿流体
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部