基于Power Extrapolation和Adaptive Method的网页评估新算法

Google的PageRank算法通过对超链接结构的分析,有效地提高了搜索结果的排序质量。PowerExtrapolation算法通过特征值直接求解马尔可夫超链接矩阵的主特征向量,但该算法的迭代次数与参数d的选择密切相关,而参数d的确定目前无明显规律可寻。另一方面,AdaptiveMethod通过将马尔可夫超链接矩阵稀疏化以达到节省迭代时间的目的。文章在PowerExtrapolation算法的基础上引入AdaptiveMethod,实验结果初步证明了新算法可以减少迭代运算的时间。

Equivalent Method of Integrated Power Generation System of Wind, Photovoltaic and Energy Storage in Power Flow Calculation and Transient Simulation

针对工程实际开展风光储联合发电系统在潮流计算和机电暂态仿真中的等值方法研究，旨在为大容量风光储联合发电系统的并网仿真分析奠定基础。将潮流计算的等值分为单元机组和集电系统2部分来研究。单元机组等值采用根据不同控制模式选取不同节点类型的方法，针对集电系统等值提出基于损耗不变原则的方法。等值模型和详细模型的算例结果表明，潮流计算等值方法具有较好的精度。在机电暂态仿真动态等值中，基于实际工程计算的最严重工况分析原则，提出运行在满出力点的单机“倍乘”等值模型，为工程计算中的风光储联合发电系统动态等值提供了一种解决方案。

一种用于深空网天线组阵的基于归一化权的Matrix-Free Power Method

对深空网天线组阵中的几种信号相关算法作简要介绍,重点研究无需形成矩阵的幂的方法——Matrix-Free Power Method。通过理论分析,提出一种改进算法,即基于归一化权的Matrix-Free Power Method。理论计算和软件仿真结果均表明,基于归一化权的Matrix-Free Power Method信噪比合成性能略优于原Matrix-Free Power Method。

Dynamic analysis of a rotating tapered cantilever Timoshenko beam based on the power series method

The mathematical modeling of a rotating tapered Timoshenko beam with preset and pre-twist angles is constructed. The partial differential equations governing the six degrees, i.e., three displacements in the axial, flapwise, and edgewise directions and three cross-sectional angles of torsion, flapwise bending, and edgewise bending, are obtained by the Euler angle descriptions. The power series method is then used to inves- tigate the natural frequencies and the corresponding complex mode functions. It is found that all the natural frequencies are increased by the centrifugal stiffening except the twist frequency, which is slightly decreased. The tapering ratio increases the first transverse, torsional, and axial frequencies, while decreases the second transverse frequency. Because of the pre-twist, all the directions are gyroscopically coupled with the phase differences among the six degrees.

Accuracy of the half-power bandwidth method with a third-order correction for estimating damping in multi-DOF systems

A third-order correction was recently suggested to improve the accuracy of the half-power bandwidth method in estimating the damping of single DOF systems.This paper analyzes the accuracy of the half-power bandwidth method with the third-order correction in damping estimation for multi-DOF linear systems.Damping ratios in a two-DOF linear system are estimated using its displacement and acceleration frequency response curves,respectively.A wide range of important parameters that characterize the shape of these response curves are taken into account.Results show that the third-order correction may greatly improve the accuracy of the half-power bandwidth method in estimating damping in a two-DOF system.In spite of this,the half-power bandwidth method may significantly overestimate the damping ratios of two-DOF systems in some cases.

Efficient Calculation of the Radar Cross Section at the Interior Resonance by the Inverse Power Method

It is well known that the incorrect results will be given using either the electric or magnetic field integral equation to calculate the radar cross section (RCS) of a closed body at the interior resonance. In this paper, an effective iterative technique is used to correct the calculated surface current density from the electric field integral equation. The radar cross section is computed for an infinite conducting circular cylinder at the interior resonance, and the obtained results are in good agreement with the analytical results. The backscattering cross section of an infinite triangular cylinder in the vicinity of a resonant frequency is also calculated. It is shown that the presence method is efficient and accurate.

Applications of Localized Phase Compensation Method to Design a Stabilizer in a Multi-machine Power System

为了演示和验证稳定器设计的就地相位补偿法在多机电力系统中的应用,介绍在多机电力系统中,就地补偿设计稳定器的2个应用实例。第1个实例是在多机电力系统中就地补偿设计电力系统稳定器（power system stabilizer,PSS）,阻尼电力系统局部模振荡。第2个实例是就地补偿设计附加在静态同步补偿器（static synchronous compensator,STATCOM）上的稳定器,抑制多机电力系统中的区域模振荡,并给出在一个16机电力系统中的应用计算和仿真结果。

INVERSE POWER METHOD AND WEIGHTED SOBOLEV SPACES

1. Introduction This paper is a continuation of the paper [5]. Now we want to treat the problem

Analysis and management strategies for the low voltage problems of rural power grid based on the distribution network flow calculation method

For a long time, because of the lack of investment capital and enough attentions, the overall constructions of rural power grid were far behind than the urban power grid in Chongqing Jiangbei Power Company. The low voltage problems were highlighted in the rural power grid due to the characteristics of rural power grid. Using the distribution network flow calculation method, we evaluated the low voltage problems of the rural power grid which belongs to Chongqing Jiangbei Power Company. In addition, we collected the data of distribution transformers in electricity consumption peak period. Some practical management strategies were proposed by the analysis and evaluation of potential and appeared low voltage problems.

Probabilistic small signal stability analysis of power system with wind power and photovoltaic power based on probability collocation method

Recently, with increasing improvements in the penetration of wind power and photovoltaic power in the world, probabilistic small signal stability analysis(PSSSA) of a power system consisting of multiple types of renewable energy has become a key problem. To address this problem, this study proposes a probabilistic collocation method(PCM)-based PSSSA for a power system consisting of wind farms and photovoltaic farms. Compared with the conventional Monte Carlo method, the proposed method meets the accuracy and precision requirements and greatly reduces the computation; therefore, it is suitable for the PSSSA of this power system. Case studies are conducted based on a 4-machine 2-area and New England systems, respectively. The simulation results show that, by reducing synchronous generator output to improve the penetration of renewable energy, the probabilistic small signal stability(PSSS) of the system is enhanced. Conversely, by removing part of the synchronous generators to improve the penetration of renewable energy, the PSSS of the system may be either enhanced or deteriorated.

Three-dimensional simulation method of multipactor in microwave components for high-power space application

Based on the particle-in-cell technology and the secondary electron emission theory, a three-dimensional simulation method for multipactor is presented in this paper. By combining the finite difference time domain method and the panicle tracing method, such an algorithm is self-consistent and accurate since the interaction between electromagnetic fields and particles is properly modeled. In the time domain aspect, the generation of multipactor can be easily visualized, which makes it possible to gain a deeper insight into the physical mechanism of this effect. In addition to the classic secondary electron emission model, the measured practical secondary electron yield is used, which increases the accuracy of the algorithm. In order to validate the method, the impedance transformer and ridge waveguide filter are studied. By analyzing the evolution of the secondaries obtained by our method, multipactor thresholds of these components are estimated, which show good agreement with the experimental results. Furthermore, the most sensitive positions where multipactor occurs are determined from the phase focusing phenomenon, which is very meaningful for multipactor analysis and design.

Improved Method of Power Loss and Electric Field Calculations of HVAC Transmission Lines

An improved method for calculating the corona power loss and the ground-level electric field on HVAC transmission lines induced by corona is proposed.Based on a charge simulation method combined with a method of successive images,the proposed method has the number and location of the simulated charges not arbitrary.When the surface electric field of a conductor exceeds the onset value,charges are emitted from corona into the space around,and the space ions and the surface charges on each sub-conductor are simulated by using the images of the other sub-conductors.The displacements of the space ions are calculated at every time step during corona periods in both the positive and the negative half cycles.Several examples are calculated by using the proposed method,and the calculated electric field at the ground level and the corona power loss agree well with previous measurements.The results show that simulating 12 charges in each conductor during 600 time steps in one cycle takes less time while guarantees the accuracy.The corona discharge from a 220 kV transmission line enhances slightly(less than 2%) the electric field at the ground level,but this effect is little from a 500 kV line.The improved method is a good compromise between the time cost and the accuracy of calculation.

Nonlinear Free Vibration of a Cantilever Beam Using the Power Series Method

An analytical approach based on the power series method is used to analyze the free vibration of a cantilever beam with geometric and inertia nonlinearities.The time variable is transformed into a“harmonically oscillating time”variable which transforms the governing equation into a form well-conditioned for a power series analysis.Rayleigh’s energy principle is also used to determine the vibration frequency.Convergence of the power series solution is demonstrated and excellent agreement is seen for the vibration response with a numerical solution.

Design method for transistor-inverted welding power supplies

From the viewpoint of reliability and practicability, a general design method and the related considerationsfor transistor- inverted welding power supplies are proposed in this paper. The detail contents are composed of the choice ofinverters, the choice and protection of transistors, the determination of inverting frequency, the design of transformers,and the choice of output rectifiers and rectifying diodes. Besides, a concrete design example of the transistor-invertedpower supply for plasma arc cutting is introduced.

The Initial Guess Estimation Newton Method for Power Flow in Distribution Systems

With the increasing integration of distributed generations(DGs), there is a demand for DGs to play a more important role on the voltage regulation. Meanwhile, the high penetration of DGs could raise a technical problem that the distribution system may operate with bi-directional power flow, leading to the inadequacy of the traditional power flow. Considering this new scenario in distribution system power flow, the convergence theorem is proposed, which contributes to develop a novel selection method of the initial guess closed to the convergent solution.Moreover, to ensure the fast rate of power flow convergence, the theorem of the maximum iterations estimation is also proposed.Based on the two proposed theorems, an Initial Guess Estimation Newton method is proposed, considering different operational status of DGs and initial guess sensitivity simultaneously. Based on the standard node systems, Tongliao grid, and 69 system of USA, three simulation examples are provided to illustrate the effectiveness of the proposed method.

A FAST SEARCH METHOD OF STEERED RESPONSE POWER WITH SMALL-APERTURE MICROPHONE ARRAY FOR SOUND SOURCE LOCALIZATION

The Steered Response Power(SRP)method works well for sound source localization in noisy and reverberant environment.However,the large computation complexity limits its practical application.In this paper,a fast SRP search method is proposed to reduce the computational complexity using small-aperture microphone array.The proposed method inspired by the SRP spatial spectrum includes two steps:first,the proposed method estimates the azimuth of the sound source roughly and determines whether the sound source is in far field or near field;then,different fine searching operations are performed according to the sound source being in far field or near field.Experiments both in simulation environments and real environments have been performed to compare the localization accuracy and computation complexity of the proposed method with those of the conventional SRP-PHAT algorithm.The results show that,the proposed method has a comparative accuracy with the conventional SRP algorithm,and achieves a reduction of 93.62%in computation complexity compared to the conventional SRP algorithm.

An Exact Analysis of the Fundamental and First Higher Order Mode in Graded Index Fibers with Direct Power Series Method

An exact and fast analytic method based on power series is established to predict the modal field distributions, Petermann-2 spot size, the normalized propagation constant corresponding to fundamental and first higher order mode in graded index fibers with any arbitrary power law profile. The variation of normalized cut-off frequencies of some LPlm modes in graded index fibers with different profile exponents are also shown here and an empirical relation between them is determined.