Since the satellite communication goes in the trend of high-frequency and fast speed, the coefficients updating and the precision of the traditional pre-distortion feedback methods need to be further improved. On this...Since the satellite communication goes in the trend of high-frequency and fast speed, the coefficients updating and the precision of the traditional pre-distortion feedback methods need to be further improved. On this basis, this paper proposes dual loop feedback pre-distortion, which uses two first-order Volterra filter models to reduce the computing complexity and a dynamic error adjustment model to construct a revised feedback to ensure a better pre-distortion performance. The computation complexity, iterative convergence speed and precision of the proposed method are theoretically analyzed. Simulation results show that this dual loop feedback pre-distortion can speed the updating of coefficients and ensure the linearity of the amplifier output.展开更多
In this paper,a Radio Over Fiber (ROF) system with a Digital Pre-Distorter (DPD) for WCDMA signal transmission is investigated.A Look-Up Table (LUT) based DPD and a Memory Polynomial (MP) DPD are applied in the ROF li...In this paper,a Radio Over Fiber (ROF) system with a Digital Pre-Distorter (DPD) for WCDMA signal transmission is investigated.A Look-Up Table (LUT) based DPD and a Memory Polynomial (MP) DPD are applied in the ROF link so as to suppress the out-of-band spurious spectrum and improve the transmission performance.The experimental results show that the out-of-band emission due to existence of the third-order Inter-Modulation Distortion (IMD3) is obviously sup-pressed by these two DPD.An Adjacent Channel Power Ratio (ACPR) improvement of 8 dB is ob-tained for a single-carrier WCDMA signal transmission.These two DPD have equal ability in lin-earization of the ROF system for a three-carrier WCDMA signal transmission.There is no apparent memory effects exist in the ROF link.展开更多
A 240-nm thick Al0.4In0.02Ga0.58N layer is grown by metal organic chemical vapour deposition, with an over 1-μm thick GaN layer used as a buffer layer on a substrate of sapphire （0001）. Rutherford backscattering an...A 240-nm thick Al0.4In0.02Ga0.58N layer is grown by metal organic chemical vapour deposition, with an over 1-μm thick GaN layer used as a buffer layer on a substrate of sapphire （0001）. Rutherford backscattering and channeling are used to characterize the microstructure of AlInGaN. The results show a good crystalline quality of AIInGaN （χmin = 1.5%） with GaN buffer layer. The channeling angular scan around an off-normal {1213} axis in the {1010} plane of the AlInGaN layer is used to determine tetragonal distortion eT, which is caused by the elastic strain in the AIInGaN. The resulting AlInGaN is subjected to an elastic strain at interracial layer, and the strain decreases gradually towards the near-surface layer. It is expected that an epitaxial AlInGaN thin film with a thickness of 850 nm will be fully relaxed （^eT = 0）.展开更多
动脉粥样硬化是心血管疾病重要的病理生理基础,延缓和防治动脉粥样硬化对于减少和降低心血管疾病的发病率及病死率具有重要意义。高密度脂蛋白(high density lipoprotein,HDL)通过参与介导胆固醇逆向转运(reverse cholesterol transport...动脉粥样硬化是心血管疾病重要的病理生理基础,延缓和防治动脉粥样硬化对于减少和降低心血管疾病的发病率及病死率具有重要意义。高密度脂蛋白(high density lipoprotein,HDL)通过参与介导胆固醇逆向转运(reverse cholesterol transport,RCT)在抗动脉粥样硬化的形成和进展中发挥了重要作用。Preβ-1高密度脂蛋白(prebeta-1 high density lipoprotein,Preβ-1HDL)作为HDL的一种亚类,是外周细胞移出胆固醇的最初接受体,直接参与了RCT的起始步骤,并在随后的胆固醇酯化及转运中起着重要作用。本文就Preβ-1HDL的结构、代谢及其与心血管疾病的关系作一简要综述。展开更多
Based on the conventional uniaxial pre-tensile stress method during welding, this study presents a new method of welding with biaxial pre-stress. With the help of numerical simulation, experiments were carried out on ...Based on the conventional uniaxial pre-tensile stress method during welding, this study presents a new method of welding with biaxial pre-stress. With the help of numerical simulation, experiments were carried out on the self-designed device. Except for the control on residual stress and distortion us-welded, the experimental results also show its effect on the prevention of hot cracks, thus this method can make up for the disadvantage of the conventional pre-stress method. Hot cracks disappear when the value of pre-stress surpasses 0. 2 σs（yield limit）. Welded thin plates with low-level residual stress, little distortion and no hot cracks are obtained with longitudinal pre-tensile stress level between 0. 6σsand 0. 7σs and precompressive stress between 0. 2 σs and 0. 3 σs in transverse direction.展开更多
文摘Since the satellite communication goes in the trend of high-frequency and fast speed, the coefficients updating and the precision of the traditional pre-distortion feedback methods need to be further improved. On this basis, this paper proposes dual loop feedback pre-distortion, which uses two first-order Volterra filter models to reduce the computing complexity and a dynamic error adjustment model to construct a revised feedback to ensure a better pre-distortion performance. The computation complexity, iterative convergence speed and precision of the proposed method are theoretically analyzed. Simulation results show that this dual loop feedback pre-distortion can speed the updating of coefficients and ensure the linearity of the amplifier output.
基金Supported by the National Natural Science Foundation of China (No. 60972064)
文摘In this paper,a Radio Over Fiber (ROF) system with a Digital Pre-Distorter (DPD) for WCDMA signal transmission is investigated.A Look-Up Table (LUT) based DPD and a Memory Polynomial (MP) DPD are applied in the ROF link so as to suppress the out-of-band spurious spectrum and improve the transmission performance.The experimental results show that the out-of-band emission due to existence of the third-order Inter-Modulation Distortion (IMD3) is obviously sup-pressed by these two DPD.An Adjacent Channel Power Ratio (ACPR) improvement of 8 dB is ob-tained for a single-carrier WCDMA signal transmission.These two DPD have equal ability in lin-earization of the ROF system for a three-carrier WCDMA signal transmission.There is no apparent memory effects exist in the ROF link.
基金Project supported by the National Natural Science Foundation of China(Grant No.10875004)the National Basic Research Program of China(Grant No.2010CB832904)
文摘A 240-nm thick Al0.4In0.02Ga0.58N layer is grown by metal organic chemical vapour deposition, with an over 1-μm thick GaN layer used as a buffer layer on a substrate of sapphire （0001）. Rutherford backscattering and channeling are used to characterize the microstructure of AlInGaN. The results show a good crystalline quality of AIInGaN （χmin = 1.5%） with GaN buffer layer. The channeling angular scan around an off-normal {1213} axis in the {1010} plane of the AlInGaN layer is used to determine tetragonal distortion eT, which is caused by the elastic strain in the AIInGaN. The resulting AlInGaN is subjected to an elastic strain at interracial layer, and the strain decreases gradually towards the near-surface layer. It is expected that an epitaxial AlInGaN thin film with a thickness of 850 nm will be fully relaxed （^eT = 0）.
文摘动脉粥样硬化是心血管疾病重要的病理生理基础,延缓和防治动脉粥样硬化对于减少和降低心血管疾病的发病率及病死率具有重要意义。高密度脂蛋白(high density lipoprotein,HDL)通过参与介导胆固醇逆向转运(reverse cholesterol transport,RCT)在抗动脉粥样硬化的形成和进展中发挥了重要作用。Preβ-1高密度脂蛋白(prebeta-1 high density lipoprotein,Preβ-1HDL)作为HDL的一种亚类,是外周细胞移出胆固醇的最初接受体,直接参与了RCT的起始步骤,并在随后的胆固醇酯化及转运中起着重要作用。本文就Preβ-1HDL的结构、代谢及其与心血管疾病的关系作一简要综述。
文摘Based on the conventional uniaxial pre-tensile stress method during welding, this study presents a new method of welding with biaxial pre-stress. With the help of numerical simulation, experiments were carried out on the self-designed device. Except for the control on residual stress and distortion us-welded, the experimental results also show its effect on the prevention of hot cracks, thus this method can make up for the disadvantage of the conventional pre-stress method. Hot cracks disappear when the value of pre-stress surpasses 0. 2 σs（yield limit）. Welded thin plates with low-level residual stress, little distortion and no hot cracks are obtained with longitudinal pre-tensile stress level between 0. 6σsand 0. 7σs and precompressive stress between 0. 2 σs and 0. 3 σs in transverse direction.
