Interpretation of Temperature Profiles during Soak Periods in Steam-stimulated Wells

To address the problems existing in testing steam injection profiles in a steam-stimulated well during steam injection and production periods, this paper proposes that the temperature profile in the completion interval could be tested during the soak period. A mathematical model for calculating the vertical distribution of temperature in a single layer reservoir is established based on the temperature characteristics of steam stimulated reservoirs, and the vertical distribution of temperature in a single layer reservoir could be obtained and heat loss could be calculated. The temperature, which is disturbed by thermal conduction in a multilayer reservoir, and heat loss could be derived based on the superposition principle of temperature potential. This paper establishes a multilayer testing temperature profile interpretation method and interprets the actual test temperature profile of Well Gao 3-7-66. The results indicate that the temperature profile in the soak period can reflect the thermal absorption conditions in various reservoir beds.

Partial phase flow rate measurements for stratified oil-water flow in horizontal wells

To accurately measure and evaluate the oil-water production profile of horizontal wells, a dynamic measurement experiment of oil-water two-phase flow in horizontal wells and numerical simulation were combined to establish a method for measuring the partial phase flow rate of oil-water two-phase stratified flow in horizontal wells. An experimental work was performed in horizontal oil-water two-phase flow simulation well using combination production logging tool including mini-capacitance sensor and mini-spinner. The combination tool provides a recording of holdup and velocity profiles at five different heights of the borehole cross-section. The effect of total flow rate and water-cut on the response of spinner and capacitive sensor at five measured positions were investigated. The capacitance water holdup interpolation imaging algorithm was used to determine the local fluid property and oil-water interface height, and the measured local fluid speed was combined with the numerical simulation result to establish an optimal calculation model for obtaining the partial phase flow rate of the oil-water two-phase stratified flow in the horizontal well. The calculated flow rates of five measured points are basically consistent with the experimental data, the total flow rate and water holdup from calculation are in agreement with the set values in the experiment too, suggesting that the method has high accuracy.