Composite thin films of PbTiO3 nano-crystals and high transparency polymer polyetherketone (PEK-c) for application of non-linear optical devices were prepared by spin coating. The size of PbTiO3 nano-crystals was es...Composite thin films of PbTiO3 nano-crystals and high transparency polymer polyetherketone (PEK-c) for application of non-linear optical devices were prepared by spin coating. The size of PbTiO3 nano-crystals was estimated to be 30-40 nm using a transmission electron microscope. The refractive index and the mode propagation losses at 633 nm were measured using the prism coupling technique and improved photographic technique respectively. They were found to be 1.6545 and 2.00 dB cm^-1 (fundamental mode),respectively. Moreover, it is observed that this loss is increased at higher mode indices.展开更多
This paper is devoted to the study of polarization properties, scattering properties and propagation properties of global positioning system (GPS) scattering signal over the rough sea surface. To investigate the pol...This paper is devoted to the study of polarization properties, scattering properties and propagation properties of global positioning system (GPS) scattering signal over the rough sea surface. To investigate the polarization and the scattering properties, the scattering field and the bistatic scattering coefficient of modified Kirchhoff approximation using the tapered incident wave is derived in detail. In modeling the propagation properties of the GPS scattering signal in the evaporation duct, the initial field of parabolic equation traditionally computed by the antenna pattern using fast Fourier transform (FFT) is replaced by the GPS scattering field. And the propagation properties of the GPS scattering signal in the evaporation duct with different evaporation duct heights and elevation angles of GPS are discussed by the improved discrete mixed Fourier transform taking into account the sea surface roughness.展开更多
We study on the implementation flow of the radio computerized tomography (RCT) prediction method. A case in real cellular mobile radio (CMR) system together with the prediction results are also presented. As shown by...We study on the implementation flow of the radio computerized tomography (RCT) prediction method. A case in real cellular mobile radio (CMR) system together with the prediction results are also presented. As shown by the results, the RCT prediction method is marked for its convenience and rapidity, as well as its relative high precision even when the prediction procedure is highly simplified. Since it is developed according to the characteristics of wireless communication environments of our country and has concurrently merits from both statistical and deterministic prediction models, the RCT prediction method is in good agreement with engineering practices in cellular mobile communication in cities at home. Optimized by combining with other techniques, further improvement could be achieved in the stability and precision of the RCT prediction method which now serves as the core part of a software tool for commercial use in CMR system analysis and optimization.展开更多
A new method for the coverage prediction of Cellular Mobile Radio (CMR) system is developed and its basic principle is presented. Unlike the Statistical Prediction Model (SPM) that estimates propagation loss by empiri...A new method for the coverage prediction of Cellular Mobile Radio (CMR) system is developed and its basic principle is presented. Unlike the Statistical Prediction Model (SPM) that estimates propagation loss by empirical formulas or the Deterministic Prediction Model (DPM) that reckons propagation loss with analytical expressions, the Radio Computerized Tomography (RCT) method does not seek to express the propagation loss explicitly. The 2 D distribution of propagation loss factor is computed using CT technique, based on measured data collected through drive test under appropriate geometric constraint. The total propagation loss can be obtained by integral of propagation loss factor along the equivalent ray path. The advantages and limitations of the technique, as well as its implementation are discussed.展开更多
We investigate the influences of structure parameters and interface shapes on the bandwidth of the edge state of lithium niobate valley photonic crystals. By increasing the size difference of two air holes in the same...We investigate the influences of structure parameters and interface shapes on the bandwidth of the edge state of lithium niobate valley photonic crystals. By increasing the size difference of two air holes in the same unit cell, we find that the bandwidth of the lossless nontrivial edge state possesses a peak value of 0.0201(a/λ), which can be used to construct broadband valley photonic crystal waveguides. Mode field distributions verify that the waveguide is robust against sharp bends and exhibits chirality. When the unit cell is arranged in a bearded interface with the top and bottom components showing negative and positive valley Chern numbers, respectively, we find that the lithium niobate valley photonic crystal is more likely to exhibit a lossless edge state, which is difficult to be realized in valley waveguides with low refractive index materials. This work can provide guidance on the design of the high-performance topological waveguide.展开更多
基金Founded by the National Natural Science Foundation (Nos. 60377016 and 60476020) the "863" National Plan (No. 2002AA313070) of China.
文摘Composite thin films of PbTiO3 nano-crystals and high transparency polymer polyetherketone (PEK-c) for application of non-linear optical devices were prepared by spin coating. The size of PbTiO3 nano-crystals was estimated to be 30-40 nm using a transmission electron microscope. The refractive index and the mode propagation losses at 633 nm were measured using the prism coupling technique and improved photographic technique respectively. They were found to be 1.6545 and 2.00 dB cm^-1 (fundamental mode),respectively. Moreover, it is observed that this loss is increased at higher mode indices.
基金Project supported by the National Natural Science Foundation of China (Grant No. 60971067)the Specialized Research Fund for the Doctoral Program of Higher Education,China (Grant No. 20070701010)
文摘This paper is devoted to the study of polarization properties, scattering properties and propagation properties of global positioning system (GPS) scattering signal over the rough sea surface. To investigate the polarization and the scattering properties, the scattering field and the bistatic scattering coefficient of modified Kirchhoff approximation using the tapered incident wave is derived in detail. In modeling the propagation properties of the GPS scattering signal in the evaporation duct, the initial field of parabolic equation traditionally computed by the antenna pattern using fast Fourier transform (FFT) is replaced by the GPS scattering field. And the propagation properties of the GPS scattering signal in the evaporation duct with different evaporation duct heights and elevation angles of GPS are discussed by the improved discrete mixed Fourier transform taking into account the sea surface roughness.
文摘We study on the implementation flow of the radio computerized tomography (RCT) prediction method. A case in real cellular mobile radio (CMR) system together with the prediction results are also presented. As shown by the results, the RCT prediction method is marked for its convenience and rapidity, as well as its relative high precision even when the prediction procedure is highly simplified. Since it is developed according to the characteristics of wireless communication environments of our country and has concurrently merits from both statistical and deterministic prediction models, the RCT prediction method is in good agreement with engineering practices in cellular mobile communication in cities at home. Optimized by combining with other techniques, further improvement could be achieved in the stability and precision of the RCT prediction method which now serves as the core part of a software tool for commercial use in CMR system analysis and optimization.
文摘A new method for the coverage prediction of Cellular Mobile Radio (CMR) system is developed and its basic principle is presented. Unlike the Statistical Prediction Model (SPM) that estimates propagation loss by empirical formulas or the Deterministic Prediction Model (DPM) that reckons propagation loss with analytical expressions, the Radio Computerized Tomography (RCT) method does not seek to express the propagation loss explicitly. The 2 D distribution of propagation loss factor is computed using CT technique, based on measured data collected through drive test under appropriate geometric constraint. The total propagation loss can be obtained by integral of propagation loss factor along the equivalent ray path. The advantages and limitations of the technique, as well as its implementation are discussed.
基金supported by the National Natural Science Foundation of China(No.91950107)the National Key R&D Program of China(Nos.2019YFB2203501 and 2017YFA0303701)。
文摘We investigate the influences of structure parameters and interface shapes on the bandwidth of the edge state of lithium niobate valley photonic crystals. By increasing the size difference of two air holes in the same unit cell, we find that the bandwidth of the lossless nontrivial edge state possesses a peak value of 0.0201(a/λ), which can be used to construct broadband valley photonic crystal waveguides. Mode field distributions verify that the waveguide is robust against sharp bends and exhibits chirality. When the unit cell is arranged in a bearded interface with the top and bottom components showing negative and positive valley Chern numbers, respectively, we find that the lithium niobate valley photonic crystal is more likely to exhibit a lossless edge state, which is difficult to be realized in valley waveguides with low refractive index materials. This work can provide guidance on the design of the high-performance topological waveguide.