The paper proposes a novel zero current transition (ZCT) push pull forward converter. The auxiliary resonant cell is in parallel with the main circuit and the zero current switching (ZCS) range of the main and the aux...The paper proposes a novel zero current transition (ZCT) push pull forward converter. The auxiliary resonant cell is in parallel with the main circuit and the zero current switching (ZCS) range of the main and the auxiliary switches of the proposed converter are entirely achieved. The resonant capacitor achieves high voltage by operating the auxiliary cell. The auxiliary switch turns on before the main switches turn off, the high voltage of resonant capacitor blanks off the rectifier, and then the curr...展开更多
A circuit configuration and a circuit topologic family of the novel forward mode AC/AC converters with high frequency link are presented. The circuit configuration is constituted of input cycloconverter, high frequenc...A circuit configuration and a circuit topologic family of the novel forward mode AC/AC converters with high frequency link are presented. The circuit configuration is constituted of input cycloconverter, high frequency transformer, output cycloconverter, input and output filters. The circuit topologic family includes eight circuit topologies, such as full-bridge-full-wave mode, etc. The bi-polarity phase-shifted control strategy and steady principles are thoroughly investigated. The output characteristics are obtained. By using the bi-polarity phase-shifted control strategy with phase-shifted control between the output cycloconveter and the input cycloconverter, commutation overlap period of the output cycloconverter, and polarity selection of the output filtering inductance current and the input voltage, the leakage inductance energy and the output filtering inductance current are naturally commutated, and surge voltage and surge current of the cycloconverters are overcome. The converters have such advantages as simple topology, two-stage power conversions(LFAC/HFAC/LFAC), bi-directional power flow, high frequency electrical isolation, good output waveforms, and strong ability to stabilize voltage. The converters lay key technical foundation on a new-type of regulated sinusoidal AC power supplies and electronic transformers. The correction and advancement of the converters are well verified by a principle test.展开更多
In this paper,a stand-alone photovoltaic(PV)system based on a Double Ended Forward Converter(DEFC)is presented.The proposed converter is specified for 48 V,100Wapplications as most of the equipment used in telecommuni...In this paper,a stand-alone photovoltaic(PV)system based on a Double Ended Forward Converter(DEFC)is presented.The proposed converter is specified for 48 V,100Wapplications as most of the equipment used in telecommunication and aircraft fall in this range.The literature has limited potential application of DEFCin PV systems.The research work deals with an in-depth study of DEFCand proposes an improvedDEFCfor PV applications with battery backup.Besides,a bi-directional dc-dc converter for the battery is integrated to track theMaximumPower Point(MPP)of the PV generator.The converter is examined under variable irradiance and load conditions,and the analytical analysis of boundary conditions are implemented.The converter’s architecture also ensures built-in I-V curve tracing for the identification of MPP of PV generator.It offers low voltage stresses across switches and avoids sinking power supply and core resetting circuits.The topology’s behavior is analyzed based onMPP achievement and maintaining output under different conditions of battery backup availability,environmental,and load conditions.The PV system architecture is designed and analyzed theoretically and verified with simulations on the PSIM software.展开更多
As the switching frequency in DC/DC converter increases, original ‘hard-switch’ working mode is not compatible. Another problem is the reliability, which is puzzled in single-ended forward, push-pull or bridge-like ...As the switching frequency in DC/DC converter increases, original ‘hard-switch’ working mode is not compatible. Another problem is the reliability, which is puzzled in single-ended forward, push-pull or bridge-like structures. In this paper, a new dual-ZCS (zero current switches) forward topology is proposed. The operating principle of soft-switch is analyzed, showing the relationship between voltage and current in time domain. Then how to calculate the key parameters of resonant network is . Finally, a prototype ZCS SMPS is implemented and tested. The results consisted with the analyzing results well, and illustrated the advantages of the proposed structure.展开更多
In high voltage input DC-DC converter, auxiliary winding of isolation transformer is usually used to supply power for control circuit. Due to the wide-range of input voltage, the variable output voltage of auxiliary w...In high voltage input DC-DC converter, auxiliary winding of isolation transformer is usually used to supply power for control circuit. Due to the wide-range of input voltage, the variable output voltage of auxiliary winding will cause a series of problems, such as variable drive pulse amplitude, increased driver switching devices loss and drive transformer core saturation. This paper analyzes the influence of variable output voltage of auxiliary winding in detail. A novel method is proposed to solve the problem of large variation range of auxiliary winding output voltage, which is adding a buck converter between the auxiliary winding and the control circuit. A dual switch forward convert has been designed with 300 V - 800 V input and 24 V/5 A output. The results show that this method is effective by comparing the different results of using buck converter or not.展开更多
In this paper, an analytical technique is presented for time domain analysis （transient and steady-state response） of perturbed PWM push-pull DC-DC converter using interesting corollary on Kharitonov＇s theorem. The...In this paper, an analytical technique is presented for time domain analysis （transient and steady-state response） of perturbed PWM push-pull DC-DC converter using interesting corollary on Kharitonov＇s theorem. The main advantage of the proposed analysis is that even though the transfer function model of a PWM push-pull DC-DC converter is perturbed, the complete analysis has been done on a linear transfer function model of a PWM push-pull DC-DC converter. The proposed analysis is verified using MATLAB simulation. This analysis will be very much useful to power electronics engineers, since the technique is very simple and computationally efficient and easily applicable in precise applications such as aerospace applications.展开更多
A feed-forward Common-Mode （CM） charge control circuit for a high-speed Charge-Domain （CO） pipelined Analog-to-Digital Converter （ADC） is presented herein. This study aims at solving the problem whereby the prec...A feed-forward Common-Mode （CM） charge control circuit for a high-speed Charge-Domain （CO） pipelined Analog-to-Digital Converter （ADC） is presented herein. This study aims at solving the problem whereby the precision of CD pipelined ADCs is restricted by the variation in input CM charge, which can compensate for CM charge errors caused by a variation in CM charge input in real time. Based on the feed-forward CM charge control circuit, a 12-bit 250-MS/s CD pipelined ADC is designed and realized using a 1P6M 0.18-μm CMOS process. The ADC achieved a Spurious Free Dynamic Range （SFDR） of 78.1 dB and a Signal-to-Noise-and-Distortion Ratio （SNDR） of 64.6 dB for a 20.1-MHz input; a SFDR of 74.9 dB and SNDR of 62.0 dB were achieved for a 239.9-MHz input at full sampling rate. The variation in signal-to-noise ratio was less than 3 dB over a 0-1.2 V input CM voltage range. The power consumption of the prototype ADC is only 85 mW at 1.8 V supply, and it occupies an active die area of 2.24 mm^2.展开更多
文摘The paper proposes a novel zero current transition (ZCT) push pull forward converter. The auxiliary resonant cell is in parallel with the main circuit and the zero current switching (ZCS) range of the main and the auxiliary switches of the proposed converter are entirely achieved. The resonant capacitor achieves high voltage by operating the auxiliary cell. The auxiliary switch turns on before the main switches turn off, the high voltage of resonant capacitor blanks off the rectifier, and then the curr...
文摘A circuit configuration and a circuit topologic family of the novel forward mode AC/AC converters with high frequency link are presented. The circuit configuration is constituted of input cycloconverter, high frequency transformer, output cycloconverter, input and output filters. The circuit topologic family includes eight circuit topologies, such as full-bridge-full-wave mode, etc. The bi-polarity phase-shifted control strategy and steady principles are thoroughly investigated. The output characteristics are obtained. By using the bi-polarity phase-shifted control strategy with phase-shifted control between the output cycloconveter and the input cycloconverter, commutation overlap period of the output cycloconverter, and polarity selection of the output filtering inductance current and the input voltage, the leakage inductance energy and the output filtering inductance current are naturally commutated, and surge voltage and surge current of the cycloconverters are overcome. The converters have such advantages as simple topology, two-stage power conversions(LFAC/HFAC/LFAC), bi-directional power flow, high frequency electrical isolation, good output waveforms, and strong ability to stabilize voltage. The converters lay key technical foundation on a new-type of regulated sinusoidal AC power supplies and electronic transformers. The correction and advancement of the converters are well verified by a principle test.
文摘In this paper,a stand-alone photovoltaic(PV)system based on a Double Ended Forward Converter(DEFC)is presented.The proposed converter is specified for 48 V,100Wapplications as most of the equipment used in telecommunication and aircraft fall in this range.The literature has limited potential application of DEFCin PV systems.The research work deals with an in-depth study of DEFCand proposes an improvedDEFCfor PV applications with battery backup.Besides,a bi-directional dc-dc converter for the battery is integrated to track theMaximumPower Point(MPP)of the PV generator.The converter is examined under variable irradiance and load conditions,and the analytical analysis of boundary conditions are implemented.The converter’s architecture also ensures built-in I-V curve tracing for the identification of MPP of PV generator.It offers low voltage stresses across switches and avoids sinking power supply and core resetting circuits.The topology’s behavior is analyzed based onMPP achievement and maintaining output under different conditions of battery backup availability,environmental,and load conditions.The PV system architecture is designed and analyzed theoretically and verified with simulations on the PSIM software.
文摘As the switching frequency in DC/DC converter increases, original ‘hard-switch’ working mode is not compatible. Another problem is the reliability, which is puzzled in single-ended forward, push-pull or bridge-like structures. In this paper, a new dual-ZCS (zero current switches) forward topology is proposed. The operating principle of soft-switch is analyzed, showing the relationship between voltage and current in time domain. Then how to calculate the key parameters of resonant network is . Finally, a prototype ZCS SMPS is implemented and tested. The results consisted with the analyzing results well, and illustrated the advantages of the proposed structure.
文摘In high voltage input DC-DC converter, auxiliary winding of isolation transformer is usually used to supply power for control circuit. Due to the wide-range of input voltage, the variable output voltage of auxiliary winding will cause a series of problems, such as variable drive pulse amplitude, increased driver switching devices loss and drive transformer core saturation. This paper analyzes the influence of variable output voltage of auxiliary winding in detail. A novel method is proposed to solve the problem of large variation range of auxiliary winding output voltage, which is adding a buck converter between the auxiliary winding and the control circuit. A dual switch forward convert has been designed with 300 V - 800 V input and 24 V/5 A output. The results show that this method is effective by comparing the different results of using buck converter or not.
文摘In this paper, an analytical technique is presented for time domain analysis （transient and steady-state response） of perturbed PWM push-pull DC-DC converter using interesting corollary on Kharitonov＇s theorem. The main advantage of the proposed analysis is that even though the transfer function model of a PWM push-pull DC-DC converter is perturbed, the complete analysis has been done on a linear transfer function model of a PWM push-pull DC-DC converter. The proposed analysis is verified using MATLAB simulation. This analysis will be very much useful to power electronics engineers, since the technique is very simple and computationally efficient and easily applicable in precise applications such as aerospace applications.
基金supported by National Natural Science Foundation of China under grant No.61704161Key Project of Natural Science of Anhui Provincial Department of Education under grant No.KJ2017A396
文摘A feed-forward Common-Mode （CM） charge control circuit for a high-speed Charge-Domain （CO） pipelined Analog-to-Digital Converter （ADC） is presented herein. This study aims at solving the problem whereby the precision of CD pipelined ADCs is restricted by the variation in input CM charge, which can compensate for CM charge errors caused by a variation in CM charge input in real time. Based on the feed-forward CM charge control circuit, a 12-bit 250-MS/s CD pipelined ADC is designed and realized using a 1P6M 0.18-μm CMOS process. The ADC achieved a Spurious Free Dynamic Range （SFDR） of 78.1 dB and a Signal-to-Noise-and-Distortion Ratio （SNDR） of 64.6 dB for a 20.1-MHz input; a SFDR of 74.9 dB and SNDR of 62.0 dB were achieved for a 239.9-MHz input at full sampling rate. The variation in signal-to-noise ratio was less than 3 dB over a 0-1.2 V input CM voltage range. The power consumption of the prototype ADC is only 85 mW at 1.8 V supply, and it occupies an active die area of 2.24 mm^2.
