Coagulation efficiency and flocs characteristics of recycling sludge during treatment of low temperature and micro-polluted water

Drinking water treatment sludge,characterized as accumulated suspended solids and organic and inorganic matter,is produced in large quantities during the coagulation process.The proper disposal,regeneration or reuse of sludge is,therefore,a significant environmental issue.Reused sludge at low temperatures is an alternative method to enhance traditional coagulation efficiency.In the present study,the recycling mass of mixed sludge and properties of raw water （such as pH and turbidity） were systematically investigated to optimize coagulation efficiency.We determined that the appropriate dosage of mixed sludge was 60 mL/L,effective initial turbidity ranges were below 45.0 NTU,and optimal pH for DOMs and turbidity removal was 6.5-7.0 and 8.0,respectively.Furthermore,by comparing the flocs characteristics with and without recycling sludge,we found that floc structures with sludge were more irregular with average size growth to 64.7 μm from 48.1 μm.Recycling sludge was a feasible and successful method for enhancing pollutants removal,and the more irregular flocs structure after recycling might be caused by breakage of reused flocs and incorporation of powdered activated carbon into larger flocs structure.Applied during the coagulation process,recycling sludge could be significant for the treatment of low temperature and micro-polluted source water.

超声对净水沉淀污泥絮体特性及对污泥回流效能的影响

为解决污泥回流强化混凝技术存在的有毒有害物质积累的问题,取净水沉淀污泥经超声预处理后进行回流试验,考察超声作用后净水沉淀污泥絮体特性的变化及其对回流效能的影响.结果表明:超声作用后污泥溶液的温度升高,絮体粒径减小,长时间作用后粒径可降至几个?m,且粒径与声能密度呈现相关性;1,5W/mL的超声处理后,絮体Zeta电位降低,比表面积增大,10,15W/mL的超声处理后絮体Zeta电位升高,比表面积有所下降;低声能密度(1W/mL)超声处理后污泥回流可强化混凝效果,30min超声作用后污泥回流的浊度、UV254和CODMn去除率分别提高了2.7%、23.12%和10.02%,长时间高声能密度(15W/mL)超声波处理污泥回流后混凝效果反而恶化.超声技术对污泥回流后污染物的去除率有一定的提高,但超声时间和声能密度必须很好控制.

吸附架桥机理主导下APAM的多级絮凝效能

对吸附架桥机理主导下阴离子聚丙烯酰胺(APAM)的絮凝过程进行了研究,通过改变絮凝剂投加工况,对比分析常规絮凝与多级絮凝在污染物去除效果、絮体性能、絮体生长动力学与污泥调理能耗等方面的差异。结果表明,相同投药量下,两级絮凝的出水浊度低于三级絮凝和常规絮凝,两级絮凝在最少的APAM投加量(2 mg/L)下达到最低的出水浊度(19.53 NTU);与常规絮凝相比,两级絮凝的絮体成长速率、平均粒径和沉降速率分别增加12.67%、30μm、36.74%。两级絮凝在投加间隔为240 s、投配比为1∶1条件下絮凝效能最优,出水浊度为15.34 NTU,絮体沉降速率为1.1 NTU/s,絮体密度达到1.123 4 g/cm^(3)。絮体破碎再絮凝过程中,两级絮凝与常规絮凝破碎后均能恢复至破碎前水平,但破碎后均出现不可逆的絮体结构破损,粒径在0~100μm的絮体颗粒增多,粒径>400μm的絮体减少,破碎后两级絮凝的絮体强度因子(68.15%)高于常规絮凝(41.63%),两级絮凝的絮体强度和抗破碎剪切能力更高。在剩余污泥调理方面,两级絮凝产生的污泥只需要投加40mg/L的APAM就可以达到最低的滤饼含水率(75.5%)。因此,两级絮凝可以显著提升除浊效能与絮体性能,是强化絮凝的发展方向。