期刊文献+
共找到5篇文章
< 1 >
每页显示 20 50 100
Flow response hysteresis of throat regulation process of a two-dimensional mixed-compression supersonic inlet 被引量:2
1
作者 Yi JIN Shu SUN +2 位作者 Huijun TAN Yue ZHANG Hexia HUANG 《Chinese Journal of Aeronautics》 SCIE EI CAS CSCD 2022年第3期112-127,共16页
The variable geometry supersonic inlet tends to decrease the throat area to reduce the Mach number upstream of the terminal shock,so as to reduce the flow loss.However,excessive Internal Contraction Ratio(ICR)exposes ... The variable geometry supersonic inlet tends to decrease the throat area to reduce the Mach number upstream of the terminal shock,so as to reduce the flow loss.However,excessive Internal Contraction Ratio(ICR)exposes the inlet to a greater risk of unstart,which inevitably results in a process of increasing the throat area to aid the inlet restart.In the above throat regulation process,the inlet undergoes the start,unstart,and restart states in turn.In order to reveal the flow structure and mechanism of this process,a two-dimensional unsteady numerical simulation combined with a dynamic mesh technique were employed.The shock-on-lip Mach number of the studied inlet is 4.0 and the flight angle of attack is+6°.Analysis was focused on the state with a freestream Mach number of 3.0.The results clearly show that the flow response hysteresis appears,and restart is only realized when the throat area is obviously increased as compared to that of unstart due to the historical unstart flow structure.In addition,three typical flow fields were analyzed,and it is found that the separation ahead of the inlet was the key factor affecting the hysteresis.Finally,unstart and restart boundaries of the inlet were discussed,and the factors influencing its deviation from the typical boundaries of dual-solution area were analyzed.The newly predicted unstart and restart boundaries are much closer to the CFD results. 展开更多
关键词 HYSTERESIS RESTART Supersonic inlet Throat regulation process UNSTART Unsteady numerical simulation
原文传递
Preparation of ultrafine WC-Co powder via fluidized bed
2
作者 Huijun Shang Hengli Li +2 位作者 Weijun Li Feng Pan Zhan Du 《Chinese Journal of Chemical Engineering》 SCIE EI CAS CSCD 2024年第9期15-26,共12页
In this study,the effects of reaction parameters on the deep-reduction and carbonization process of WO_(2)-Co to WC-Co were studied.The results indicate that the oxygen loss rate of WO_(2) is positively correlated wit... In this study,the effects of reaction parameters on the deep-reduction and carbonization process of WO_(2)-Co to WC-Co were studied.The results indicate that the oxygen loss rate of WO_(2) is positively correlated with temperature and methane partial pressure.The partial pressure of methane has no significant effect on the formation rate of WC.The carbon content and particle size of the product increase with the increase of CH_(4) partial pressure.By synergistically regulating the reaction temperature to 950℃,the CH_(4) partial pressure to 1.25%,and the reaction time to 60 min,ultrafine WC-Co powder without h phase can be obtained.The particle size of the composite powder is 128 nm,with total carbon content of 6.16%,free carbon content of 0.4%,and residual oxygen content of 0.05%,respectively.The growth rate relationship of tungsten carbide is as follows:δ(t)=1.21×10^(-13)exp(-12809.72/T)√t. 展开更多
关键词 Ultrafine WC-Co powder Gas-solid reaction FLUIDIZATION Reaction process regulation Growth rate equation
下载PDF
Experimental investigation on unstart-restart hysteresis of a supersonic inlet during throat regulation
3
作者 Yi JIN Huijun TAN +3 位作者 Hao ZHANG Gaojie ZHENG Shu SUN Yue ZHANG 《Chinese Journal of Aeronautics》 SCIE EI CAS CSCD 2023年第11期135-152,共18页
The hysteresis during the throat regulation process of a supersonic variable inlet is unconducive to restart.Hence,detailed experimental studies of such a hysteresis and its control are necessary.A throat variable sup... The hysteresis during the throat regulation process of a supersonic variable inlet is unconducive to restart.Hence,detailed experimental studies of such a hysteresis and its control are necessary.A throat variable supersonic inlet was designed at a shock-on-lip Mach number of 4.0 and an Internal Contraction Ratio(ICR)ranging over 1.21–2.94.Meanwhile,a distributed bleed system was proposed to suppress the hysteresis.The wind tunnel tests were conducted at Mach number 2.9.The throat regulation processes were recorded using a high-speed schlieren and dynamic pressure acquisition system.The results indicate that the unstart and restart ICRs during the uncontrolled inlet’s throat regulation process were 1.95 and 1.48,respectively,demonstrating an unstart-restart hysteresis.Four typical flowfields were summarized during the uncontrolled inlet’s restart process.The proposed bleed control increased the unstart and restart ICRs to 2.06 and 1.75,respectively,and the inlet realized the designed state as the ICR was further decreased to 1.67.The controlled inlet’s hysteresis loop was decreased compared to the uncontrolled inlet.Finally,the mechanism of the hysteresis,dominated by the entrance separation-induced wave system,was clarified.The mechanisms of the bleed control to broaden the unstart and restart boundaries and suppress the hysteresis were elucidated. 展开更多
关键词 Supersonic inlet Unstart-restart hysteresis Bleed control Throat regulation process Wind tunnel test
原文传递
On Deepening Reform of Processing Trade Regulations 被引量:1
4
作者 Wan Zhongxin 《China & World Economy》 SCIE 2003年第1期25-29,共5页
The processing trade has, since 1996, taken half of the total import and export trade value for a consecutive six years. Despite the impact and influence of the Asian financial crisis, it has maintained a momentum of ... The processing trade has, since 1996, taken half of the total import and export trade value for a consecutive six years. Despite the impact and influence of the Asian financial crisis, it has maintained a momentum of steady growth. In the five years from 1997 to 2001, import and export value through the processing trade grew at an annual average rate of 10.5 percent, with exports growing at an annual average rate of 11.8 percent. This good growth momentum continued into 展开更多
关键词 of on IT AS On Deepening Reform of processing Trade regulations been for IS MODE HAVE that into
原文传递
Practical application of pressure regulating technology for fire district in Meiyukou Coal Mine
5
作者 章庆丰 贾宝山 《Journal of Coal Science & Engineering(China)》 2008年第4期546-549,共4页
Based on the simulated laboratory experiment of pressure balance for fire ex- tinguishing,the pressure regulating technology was summarized for the fire district in Meiyukou Coal Mine.The technology includes three mea... Based on the simulated laboratory experiment of pressure balance for fire ex- tinguishing,the pressure regulating technology was summarized for the fire district in Meiyukou Coal Mine.The technology includes three measures for air pressure regulation, namely applying the pressure regulating chamber to balance the air pressure of fire district, increasing the air pressure of the working face,and filling the ground surface fractures.A good effect was obtained to prevent and extinguish the fire.When the measures fail to in- crease the pressure of working face or to regulate that of air chamber,the measure to fill the ground surface fractures will play an important role. 展开更多
关键词 fire district pressure regulating technology pressure regulating process pressure balancing ventilation
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部