This paper proposes a virtual router cluster system based on the separation of the control plane and the data plane from multiple perspectives,such as architecture,key technologies,scenarios and standardization.To som...This paper proposes a virtual router cluster system based on the separation of the control plane and the data plane from multiple perspectives,such as architecture,key technologies,scenarios and standardization.To some extent,the virtual cluster simplifies network topology and management,achieves automatic conFig.uration and saves the IP address.It is a kind of low-cost expansion method of aggregation equipment port density.展开更多
The existing active queue management （AQM） algorithm acts on subscribers and edge routers only, it does not support differentiate-serve （Diffserv） quality of service （QoS）, while the existing diffserv QoS has no...The existing active queue management （AQM） algorithm acts on subscribers and edge routers only, it does not support differentiate-serve （Diffserv） quality of service （QoS）, while the existing diffserv QoS has not considered the link capacities between edge routers and connected core routers. When a core router in a two layers’ network experiences congestion, the connected edge routers have no ability to adjust their access data rates. Thus, it is difficult to achieve the congestion control for the large scale network with many edge routers and core routers. To solve these problems, two difffserve AQM algorithms are proposed for the congestion control of multilayer network. One diffserv AQM algorithm implements fair link capacities of edge routers, and the other one implements unequal link capacities of edge routers, but it requires the core routers to have multi-queues buffers and Diffserv AQM to support. The proposed algorithms achieve the network congestion control by operating AQM parameters on the conditions of proposed three theorems for core and edge routers. The dynamic simulation results demonstrate the proposed control algorithms for core and edge routers to be valid.展开更多
Aiming at the weaknesses of LON bus, combining the coexistence of fieldbus and DCS (Distribu ted Control Systems) in control networks, the authors introduce a hierarchical hybrid control network design based on LON an...Aiming at the weaknesses of LON bus, combining the coexistence of fieldbus and DCS (Distribu ted Control Systems) in control networks, the authors introduce a hierarchical hybrid control network design based on LON and master slave RS 422/485 protocol. This design adopts LON as the trunk, master slave RS 422/485 control networks are connected to LON as special subnets by dedicated gateways. It is an implementation method for isomerous control network integration. Data management is ranked according to real time requirements for different network data. The core components, such as control network nodes, router and gateway, are detailed in the paper. The design utilizes both communication advantage of LonWorks technology and the more powerful control ability of universal MCUs or PLCs, thus it greatly increases system response speed and performance cost ratio.展开更多
能量路由器是能源互联网领域的核心设备,其电路拓扑能够实现新能源、储能、各类负荷的统一分配。目前,能量路由器缺乏配电网故障恢复能力。该文提出一种实现故障调控与新能源消纳的多端口能量路由器(multi‐port energy router,MP‐ER)...能量路由器是能源互联网领域的核心设备,其电路拓扑能够实现新能源、储能、各类负荷的统一分配。目前,能量路由器缺乏配电网故障恢复能力。该文提出一种实现故障调控与新能源消纳的多端口能量路由器(multi‐port energy router,MP‐ER)。首先,介绍MP‐ER拓扑及原理,根据MP‐ER整体结构,提出以直流母线电压为主信号,各个端口分散控制的控制策略;其次,通过直流母线电压及配电网零序电压情况,将MP‐ER工作模式分为正常模式和故障柔性消弧两种模式,在所提的控制策略下,实现各模态内的稳定、高效运行;最后,针对连接的微网、配电网系统,利用MATLAB数值软件,对该模型进行仿真并验证该文提出的拓扑结构功能的合理性。该研究为能量路由器的研究提出一种新的拓扑结构和模型。展开更多
基金supported by the Collaboration Research on Key Techniques of Future Network between China,Japan and Korea(2010DFB13470)~~
文摘This paper proposes a virtual router cluster system based on the separation of the control plane and the data plane from multiple perspectives,such as architecture,key technologies,scenarios and standardization.To some extent,the virtual cluster simplifies network topology and management,achieves automatic conFig.uration and saves the IP address.It is a kind of low-cost expansion method of aggregation equipment port density.
基金supported by the Beijing Natural Science Foundation (4102050)NSFC-KOSEF Joint Research Project of China and Korea(60811140343), and the CDSN, GIST.
文摘The existing active queue management （AQM） algorithm acts on subscribers and edge routers only, it does not support differentiate-serve （Diffserv） quality of service （QoS）, while the existing diffserv QoS has not considered the link capacities between edge routers and connected core routers. When a core router in a two layers’ network experiences congestion, the connected edge routers have no ability to adjust their access data rates. Thus, it is difficult to achieve the congestion control for the large scale network with many edge routers and core routers. To solve these problems, two difffserve AQM algorithms are proposed for the congestion control of multilayer network. One diffserv AQM algorithm implements fair link capacities of edge routers, and the other one implements unequal link capacities of edge routers, but it requires the core routers to have multi-queues buffers and Diffserv AQM to support. The proposed algorithms achieve the network congestion control by operating AQM parameters on the conditions of proposed three theorems for core and edge routers. The dynamic simulation results demonstrate the proposed control algorithms for core and edge routers to be valid.
文摘Aiming at the weaknesses of LON bus, combining the coexistence of fieldbus and DCS (Distribu ted Control Systems) in control networks, the authors introduce a hierarchical hybrid control network design based on LON and master slave RS 422/485 protocol. This design adopts LON as the trunk, master slave RS 422/485 control networks are connected to LON as special subnets by dedicated gateways. It is an implementation method for isomerous control network integration. Data management is ranked according to real time requirements for different network data. The core components, such as control network nodes, router and gateway, are detailed in the paper. The design utilizes both communication advantage of LonWorks technology and the more powerful control ability of universal MCUs or PLCs, thus it greatly increases system response speed and performance cost ratio.
文摘能量路由器是能源互联网领域的核心设备,其电路拓扑能够实现新能源、储能、各类负荷的统一分配。目前,能量路由器缺乏配电网故障恢复能力。该文提出一种实现故障调控与新能源消纳的多端口能量路由器(multi‐port energy router,MP‐ER)。首先,介绍MP‐ER拓扑及原理,根据MP‐ER整体结构,提出以直流母线电压为主信号,各个端口分散控制的控制策略;其次,通过直流母线电压及配电网零序电压情况,将MP‐ER工作模式分为正常模式和故障柔性消弧两种模式,在所提的控制策略下,实现各模态内的稳定、高效运行;最后,针对连接的微网、配电网系统,利用MATLAB数值软件,对该模型进行仿真并验证该文提出的拓扑结构功能的合理性。该研究为能量路由器的研究提出一种新的拓扑结构和模型。
