Equivalent Noise Models in Fiber Optical Communication Systems

An equivalent noise model of optical receiver amplifiers as shown in Fig.1 has been given in many fiber optical communication literatures. It is proved in this paper that this equivalent noise model is neither equivalent to the original one nor measurable. The main reason is that the position of the input impedance in this noise model is not the same with its in the typical noise model,but the same S vn , S in with the typical noise model are used. So the equivalent noise model above is wrong and is not fit to be taken into application.

Optimization of Spectral Inverters in Optical Fiber Communication Systems with Mid-Span Spectrum Inversion

In this paper, signal distortions caused by spectral inverters which are used in 10Gb/s optical fiber communication systems with mid span spectrum inversion in terms of dispersion shift fibers are analyed numerically. It is shown that there exist the optimal input signal power, fiber length and fiblter bandwidth for the spectral in verters. System transmission penalty can be minimized by optimizing these parameters.

Toward Low-Cost Flexible Intelligent OAM in Optical Fiber Communication Networks

Low-cost,flexible and intelligent optical performance monitoring and management is a key enabling technology for network quality guarantee,especially in the era of explosive growth of communication capacity and network scale.However,to the best of our knowledge,it is extremely challenging to implement real-time performance monitoring and operations,administration and maintenance(OAM) in a highly complex dynamic network.In this paper,we propose an innovative optical identification(OID) scheme that can realize both performance monitoring and some advanced OAM sub-functions.The basic concepts,applications,challenges and evolution directions of this OID tool are also discussed.

Polarization Jitters Caused by Fiber Nonlinearity in PM Optical Communication System

The phenomenon of polarization jitters caused by fiber nonlinearity is investigated. A general formula about the polarization jitter is concluded in polarization multiplexing (PM) system based on two orthogonal linear polarization states when the best polarization correction is used. A 100 Gb/s PM system based on NRZ code is investigated by simulation, and the Stocks parameter about polarization jitter and Poincare sphere diagrams are got for different power and phase difference of two orthogonal polarized light. The results show that the polarization jitters will be suppressed when the combined PM signal is the linear or circular polarization state.

Fiber Grating Ring Laser in All Optical Communication System

Erbium fiber grating ring laser (EFRL) witn an integrated travelling wave and low polarization mode noise is reported. Through modulated experiment of a successful 2.488 Gb/s RZ data, it is shown that the EFRL is a promising alternative to DFB lasers for high-speed transmission applications.

2.5 Gbit/s monolithic ICs for optical fiber transmitter and receiver in 0.35 μm CMOS process

2.5 Gbit/s monolithic integrated circuits （ICs） for optical fiber transmitter and receiver in 0.35 μm CMOS （complementary metal-oxide-semiconductor transistor） process are presented. The transmitter, which includes a 4： 1 multiplexer and a laser diode driver （LDD）, has four 622 Mbit/s random signals as its inputs and gets a 2.5 Gbit/s driving signal as its output; the receiver detects a 2.5 Gbit/s random signal and gets four 622 Mbit/s signals at the output. The main circuits include a trans-impedance amplifier （TIA）, a limiting amplifier, a clock and data recovery （CDR） unit, and a 1： 4 demultiplexer （DEMUX）. Test results prove the logic functions of the transmitter to be right, and the 10% to 90% rise and fall times of transmitter＇s output data eye diagram are 211.1 ps and 200 ps, respectively. The sensitivity of the receiver is measured to be better than 20 mV. The root mean square jitter of the DEMUX＇s output data is 15.6 ps and that of the clock after 1： 4 frequency dividing is 1.9 ps. Two chips are both applicable to 2.5 Gbit/s optical fiber communication systems.

Retinal thickness and vascular parameters using optical coherence tomography in Alzheimer's disease:a meta-analysis

Examining the retinal tissue has the potential to provide a unique method and technique to quantify Alzheimer’s disease-related changes in participants at various stages of the disease.In this metaanalysis,we aimed to investigate the association of various optical coherence tomography parameters with Alzheimer’s disease and whether retinal measurements can be used to diffe rentiate between Alzheimer’s disease and control subjects.Scientific databases including Google Schola r,Web of Science,and PubMed were systematically searched for published articles that evaluated retinal nerve fiber layer thickness and retinal microvascular network in Alzheimer’s disease and control subjects.Seventy-three studies(5850 participants,including 2249 Alzheimer’s disease patients and 3601controls) were included in this meta-analysis.Relative to controls,Alzheimer’s disease patients had a significantly lower global retinal nerve fiber layer thickness(standardized mean difference [SMD]=-0.79,95% confidence intervals [CI]:-1.03 to-0.54,P <0.00001) as well as each quadrant being thinner in Alzheimer’s disease versus controls.Regarding macular paramete rs,values measured by optical coherence tomography were significantly lower in Alzheimer’s disease than controls for macular thickness(pooled SMD:-0.44,95% CI:-0.67 to-0.20,P=0.0003),foveal thickness(pooled SMD=-0.39,95% CI:-0.58 to-0.19,P <0.0001),ganglion cell inner plexiform layer(SMD=-1.26,95% CI:-2.24 to-0.27,P=0.01) and macular volume(pooled SMD=-0.41,95% CI-0.76 to-0.07,P=0.02).Analysis using optical coherence tomography angiography parameters revealed mixed results between Alzheimer’s disease and controls.Superficial vessel density(pooled SMD=-0.42,95% CI:-0.68 to-0.17,P=0.0001) and deep vessel density(pooled SMD=-0.46,95% CI:-0.75 to-0.18,P=0.001) were found to be thinner in Alzheimer’s disease patients whereas the foveal avascular zone(SMD=0.84,95% CI:0.17-1.51,P=0.01) was larger in controls.Vascular density and thickness of various retinal laye rs were decreased in Alzheimer’s disease patients compared to controls.Our results provide evidence for optical coherence tomography technology having the potential to detect retinal and microvascular changes in patients diagnosed with Alzheimer’s disease and aid in monito ring and early diagnosis methods.

Health Monitoring of Long-Haul Fiber Communication System Using Chaotic OTDR

A novel chaotic optical time-domain reflectometry(OTDR)-based approach was proposed for monitoring long-haul fiber communication systems with multiple fiber segments. The self-phase modulation and group velocity dispersion effects of the optical cable was considered in demonstrating the proof-of-concept experiment and simulation. In experiments, the correlation peaks are clearly obtained from the correlation trace between the reference and reflected(or scattered) light signals propagating in three optical-fiber segments. The technique affords a high spatial resolution of 2 m, and further long-haul fiber simulations indicate that the sensing distance can be more than 3300 km. Thus, the new proposed technique can be effectively applied for health monitoring of long-haul fiber communication systems.

基于外部气相沉积的S+C+L波段低色散斜率大有效面积非零色散位移光纤的设计与制备

针对现有光纤无法满足宽带光密集波分复用系统传输和S+C+L波段粗波分复用的要求,设计了一种具有中心凹陷的三角形芯+环形的折射率剖面,利用外部气相沉积工艺制备了一种非零色散位移光纤,并通过调整第一芯层的相对折射率和第二芯层与第一芯层的半径比,探究了其对光纤衰减、色散斜率和有效面积等参数的影响。研究发现,当第一芯层的相对折射率逐渐增大且第二芯层与第一芯层半径比逐渐减小时,零色散波长和有效面积逐渐减小。当第一芯层的相对折射率在0.52%~0.53%,芯层半径比在2.6~2.7时,光纤的有效面积接近70μm^(2),零色散波长在1420 nm附近,在1550 nm波段的色散系数大于8 ps·nm^(-1)·km^(-1),色散斜率为0.059 ps·nm^(-2)·km^(-1),可以较好地抑制传输过程中光非线性效应,满足长途干线网与城域网的使用要求。

2.4Gb/s,50Km Optical Fiber Transmission Using Ti:LiNbO_3 External Modulator

2.488 Gb/s optical fiber transmission experiment using a domestic Ti.LiNbO3 externalmodulator was demonstrated for the first time in China.A receiver sensitivity of -30.3dBmwas obtained at a BER of 10-10after transmission through 50.7 km conventional single modefiber.

Research on Additional Loss of Guidance Optical Fiber

The factors which cause additional losses of guidance optical fiber in wound state were analyzed.A mathematical model used to analyze the macro-bend losses in the cross region producing in the precision winding process was established.For an actual guidance optical fiber,the measured data of the fiber's additional losses under low temperature and the loss curves with radius were given in the paper.The simulation results were compared with the test data.It shows that the additional losses of optical fiber caused by bending and low temperature can meet the actual requirements of the fiber optical guidance system.The established model can be used to predict the change trend of fiber losses in the winding process with a certain tensile force.

FAST EVALUATION OF THE CHARACTERISTICS OF SINGLE-MODE OPTICAL FIBERS

This paper describes a method for fast engineering evaluation of the transmission characteristicsof single-mode optical fibers.A versatile microcomputer program is presented which can be utilized to ana-lyze mode field characteristics of single-mode fibers with arbitrary refractive index profiles.Our computationshows that the mathematical algorithm and the corresponding programs developeod in this paper are rela-tively simple and accurate enough for the engineenring design of single-mode fibers for optical communica-tion systems.

Dispersion Monitoring Techniques in High Bit-rate Optical Communication Systems

For the efficient dynamic dispersion compensation, it is essential to monitor the dispersion accurately. The existing main dispersion monitoring techniques in high bit-rate optical communication systems are presented as well as their operating principles and research progress. The advantages and disadvantages of these methods are analyzed and discussed.

STUDY ON MINE FIRE-RESISTANT OPTICAL FIBER CABLE KL5004

This paper introduces a new-developed mine fire-resistant optical fiber cable (OFC)KL5004,its structural characteristics, main feature, the theory about fire resistance and its application in high output and efficiency mine.

Detecting Threats of Acoustic Information Leakage Through Fiber Optic Communications

Information leaks through regular fiber optic communications is possible in the form of eavesdropping on conversations, using standard fiber optic communications as illegal measuring network. The threat of leakage of audio information can create any kind of irregular light emission, as well as regular light beams modulated at acoustic frequencies. For information protection can be used a means of sound insulation, filtration and noising. This paper discusses the technical possibilities of countering threats by monitoring the optical radiation to detect eavesdropping.

Design and Implementation of Optical Fiber Test Equipment

In order to meet the needs of the rapid development of optical fiber communication technology, combined with the thinking of the Internet of Things, a new idea of designing an optical fiber test equipment using Raspberry Pi is proposed. At the same time, the design of a multi-parameter measuring device for optical fiber signals based on Flask was completed.

Experimental demonstration of single-mode fiber coupling using adaptive fiber coupler

Coupling plane wave into a single-mode fiber （SMF） with high and steady coupling efficiency is crucial for fiber- based free-space laser systems, where random angular jitters are the main influencing factors of fiber coupling. In this paper, we verified a new adaptive-optic device named adaptive fiber coupler （AFC） which could compensate angular jitters and improve the SMF coupling efficiency in some degree. Experiments of SMF coupling under the angular jitter situation using AFC have been achieved. Stochastic parallel gradient descent （SPGD） algorithm is employed as the control strategy, of which the iteration rate is 625 Hz. In closed loop, the coupling efficiency keeps above 65% when angular errors are below 80/3tad. The compensation bandwidth is 35 Hz at sine-jitter of 15 ~rad amplitude with average coupling efficiency of above 60%. Also, experiments with simulated turbulence have been studied. The average coupling efficiency increases from 31.97% in open loop to 61.33% in closed loop, and mean square error （MSE） of coupling efficiency drops from 7.43% to 1.75%.

A Novel and Fast Model of Erbium-doped Fiber Amplifiers

A novel and fast model of erbium-doped fiber amplifiers (EDFAs) is presented. By calculating a typical EDFA, numerical results are compared with the results obtained by spectral-solved method. The results of comparison show that such a model can improve the computational speed and preserve the precision. Some characteristics of the EDFA are then analyzed using this model. The results are consistent with those of the experiments.

Impacts of operational parameters on nonlinear polarization rotation-based passively mode-locked fiber laser

The operational parameters including the polarization controlling and the pump power in a nonlinear polarization rotation-based passively mode-locked fiber laser are studied in this paper.The carrier rate equations of the activated erbium-doped fiber are first employed together with the nonlinear Shro¨dinger equations to reveal the relation between the operational parameters and the output state of the passively mode-locked fiber laser.The numerical and experimental results demonstrate that the output state of the mode-locked laser varies with the polarization controlling and the pump power.The periodicity of the polarization controlling is observed.With given pump power,there exists a set of polarization controlling under which the ultra-short pulse can be generated.With given polarization controlling,the mode-locked state can be maintained generally except for some particular values of pump power.Three shapes of the output optical spectra from the fiber cavity can be identified when the pump power changes.The results in this paper provide a comprehensive insight into the operation of the nonlinear polarization rotation-based passively mode-locked fiber laser.