Scattering and absorption characteristics of non-spherical cirrus cloud ice crystal particles in terahertz frequency band

We used discrete dipole approximation(DDA)to examine the scattering and absorption characteristics of spherical ice crystal particles.On this basis,we studied the scattering characteristics of spherical ice crystal particles at different frequencies and non-spherical ice crystal particles with different shapes,aspect ratios,and spatial orientations.The results indicate that the DDA and Mie methods yield almost the same results for spherical ice crystal particles,illustrating the superior calculation accuracy of the DDA method.Compared with the millimeter wave band,the terahertz band particles have richer scattering characteristics and can detect ice crystal particles more easily.Different frequencies,shapes,aspect ratios,and spatial orientations have specific effects on the scattering and absorption characteristics o f ice crystal particles.The results provide an important theoretical basis for the design of terahertz cloud radars and related cirrus detection methods.

Experimental study of C-band microwave scattering characteristics during the emulsification process of oil spills

In this study,oil spill experiments were performed in a water tank to determine changes in the surface scattering characteristics during the emulsification of oil spills.A C-band fully-polarimetric microwave scatterometer and a vector network analyzer were used to observe films of the following oils:crude oil with an asphalt content below3%that is prone to emulsification(type A),fresh crude oil extracted from an oilfield(type B),and industrial crude oil that was dehydrated and purified(type C).The difference in the backscatter results between the emulsified oil film and the calm water surface under C-band microwaves and the influence of the emulsification of the oil film on the backscatter were analyzed in detail.The results demonstrate that under a low-wind and no-waves condition(the maximum wave height was below than 3 mm),the emulsification of crude oil could modulated the backscatter through changes in the surface roughness and the dielectric constant,where the surface roughness had the dominant effect.The surface backscatters of the type B oil were greater than that of the type C oil in both the emulsified and non-emulsified states.In the non-emulsified state,the average differences in the backscatter between the type B and C oils were 2.19 dB,2.63 dB,and 2.21 dB for the polarization modes of VV,HH,and HV/VH,respectively.Smaller corresponding average differences of 0.98 dB,1.49 dB,and 1.5 dB were found for the emulsified state with a 20%moisture constant for the oil film.The results demonstrated that the surface roughness of the different oil films could vary due to the differences in the oil compositions and the oil film properties,which in turn affect the backscatter of the oil film surface.

The microwave scattering characteristics of sea ice in the Bohai Sea

Microwave remote sensing has become the primary means for sea-ice research, and has been supported by a great deal of field experiments and theoretical studies regarding sea-ice microwave scattering. However, these studies have been barely carried in the Bohai Sea. The sea-ice microwave scattering mechanism was first developed for the thin sea ice with slight roughness in the Bohai Sea in the winter of 2012, and included the backscattering coefficients which were measured on the different conditions of three bands（L, C and X）, two polarizations（HH and VV）, and incident angles of 20° to 60°, using a ground-based scatterometer and the synchronous physical parameters of the sea-ice temperature, density, thickness, salinity, and so on. The theoretical model of the sea-ice electromagnetic scattering is obtained based on these physical parameters. The research regarding the sea-ice microwave scattering mechanism is carried out through two means, which includes the comparison between the field microwave scattering data and the simulation results of the theoretical model, as well as the feature analysis of the four components of the sea-ice electromagnetic scattering. It is revealed that the sea-ice microwave scattering data and the theoretical simulation results vary in the same trend with the incident angles. Also, there is a visible variant in the sensitivity of every component to the different bands.For example, the C and X bands are sensitive to the top surface, the X band is sensitive to the scatterers, and the L and C bands are sensitive to the bottom surface, and so on. It is suggested that the features of the sea-ice surfaces and scatterers can be retrieved by the further research in the future. This experiment can provide an experimental and theoretical foundation for research regarding the sea-ice microwave scattering characteristics in the Bohai Sea.

Distribution characteristic of scattering field for an ellipsoidal target irradiated by an electromagnetic wave from an arbitrary direction

It is of great importance for engineering applications to obtain the expression of scattering field for an ellipsoidal target irradiated by an electromagnetic wave from an arbitrary direction. Literature relevant to this problem is seldom found. In this paper, the scattering field for an ellipsoidal target is presented by utilizing the scale transformation of electromagnetic field and the rotation of coordinate system, with an electromagnetic wave projecting on the target from an arbitrary direction. The obtained result is in good agreement with the solution available from the literature if we consider the scale factors to be unity. Taking a conducting ellipsoidal target for sample, we perform the partial simulations of the ellipsoidal model and a plant leaf model by choosing different scale factors. The obtained results show that the distribution characteristic of scattering field is sensitively affected by the polarization of the incident wave and varies not much with the incident wave angle but changes with the observation point. At some points the scattering energy arrives at its maximum.

LOW RCS MODIFIED DESIGN OF EXTERNAL CARRIAGE AND ANALYSIS OF ITS SCATTERING CHARACTERISTIC

An external carriage and a wing have a high radar cross section (RCS) level in a wide range of angles of pitch because they form an efficient corner reflector. Coupling scattering between the external carriage and the wing is controlled by designing a saw tooth structure of the external carriage on condition that the wing structure is not changed. A low RCS saw tooth scheme of the external carriage is given in the paper. The ray tracing method and the physical theory of diffraction are used to calculate the radar scattering characteristics of low RCS structures of the external carriage and wing. The results show that the saw tooth scheme of the external carriage is feasible and effective for low RCS design.

Scattering Characteristics of Metallic Plates in Radial Waveguide

Mode matching is a useful method to analyze the mode characteristics during the section change of a waveguide. By applying this method to the radial waveguide, and solving specific problems due to the radial transmission of electromagnetic wave, this presents a calculating method in radial waveguide based on mode matching. The scattering characteristics of metallic plates in the radial waveguide are calculated, and verified qualitatively using an electromagnetic simulator, which confirmed the validity of this method.

Analysis of echo signal modulation characteristic parameters on aerial and space targets

Based on the scattering characteristic,the comparison of RCS(radar cross-section)at different positions of a target in the same direction of incidence can be obtained first by extruding or deleting part of the entity.A simulation method of aerial&space targets echo characteristics(A&STEC)is proposed that is universal to aerial and space targets.We utilize a fixed-wing UAV(unmanned aerial vehicle)and typical missiles in simulation.The echo signal modulation characteristic parameters are calculated theoretically by the atmospheric attenuation model,the finite element method and a MUMPS solver.The verification simulations show that this method can analyze the influence of the target shape,incident direction,detection position and detection frequency on echo waveform,intensity and energy distribution.The results show that the profile of echo waveform can invert the general shape of the target.The relationship between time and intensity can determine whether the target is moving towards or away from the detector in addition.These conclusions can provide a reference for the ballistic missile target tracking and the defense against UVA intrusion in theory.

Doppler shift of a laser pulse beam scattered by a rotating cone and cylinder

Based on laser radar equations, a Doppler shift model of a laser pulse beam scattered by a rotating arbitrary convex target is reported in this paper. The boundary relations between an incident pulse beam and the detected area elements are analyzed by geometric methods. The Doppler shift characteristics of the rotating cone and cylinder are discussed and the difference between the laser pulse beam and the plane wave scattered from the same rotating target is compared accordingly. Numerical simulations show that the Doppler shift is tightly relevant to their dimensions, speeds, and so on. In the same incidence conditions, the pulse beam and plane wave have difference peak values and the same Doppler shift bandwidth. If the waist radius of the pulse beam is larger, the peak value is higher, and the Doppler shifts are proportional to the speed of the rotating target. By virtue of our theoretical model, we probe into the scattered characteristics of the Doppler shifts of a laser pulse beam, which would benefit target identification in national defense.

Influence of aircraft surface distribution on electromagnetic scattering characteristics

In this paper,two typical stealth aircraft concepts（wing fuselage blended and flyingwing） were designed.Then three gradually changed surface distribution models with the same planform for each concept were created.Based on the multilevel fast multipole algorithm（MLFMA）,the vertical polarization transmitting/vertical polarization receiving（VV） and horizontal polarization transmitting/horizontal polarization receiving（HH） radar cross section（RCS） characteristics were simulated with five frequencies between 0.1 and 1.0 GHz.The influences and mechanisms of aircraft surface distribution on electromagnetic scattering characteristics were investigated.The results show that for the wing fuselage blended concept,the W RCS of this frequency range is higher than the HH RCS in most cases,while it is just the opposite for the flying-wing concept.As for the two aircraft concepts,the RCS levels of HH and W both decrease with the frequency increasing,but the HH RCS has a faster downward trend.The surface distribution has little influence on HH RCS characteristics.On the contrary,it has a significant impact on W RCS characteristics,and the amplitude of the VV RCS increases with the surface thickness.

Raman scattering enhancement characteristic of NbCl_5-and Nb_20_5-doped silica fibers

Two kinds of Nb-doped silica fibers, an NbCl5-doped fiber and an Nb205-doped fiber, are fabricated and char- acterized in this Letter. First, the refractive index profiles of both fibers are obtained, and then their Raman spectra are measured with 785 nm exciting light. The Nb-doped fibers＇ Raman spectra are compared with a conventional GeO2-doped single-mode silica fiber that is prepared with the same method and under the same conditions. As a result, the Raman gain coefficients of the Nb-doped silica fiber core are obtained. The exper- imental results show that Nb2O5 doping can enhance the Raman scattering intensity of the optical fibers.

Regional characteristics of ultrasonic structural scattering in liver

In this paper, the ultrasonic spectra of liver's structural scattering wave obtained by autoregressive model and the spectral characteristics were analyzed statisticaJly The experimellt and analysis results show that a liver can be divided into three distingulshed scattering regions. The top layer region shows approkimate Rayleigh scattering characteristic, the central region shows diffosion scattering, and the region between the top layer and centre shows random scattering. These distribution characteristics correlate with the distribution of the microstructure characteristics of liver. The experiment results provide possibilities for tissue recognition using spectrum characteristics of the regional structure scattering.

CHARACTERISTIC DISTRIBUTION OF SLOPE SCATTERED RADIATION WITH ITS CALCULATION MODEL

Detailed analysis is made of anisotropy of slope scattered radiation(SSR)in terms of the data obtained by a pyranometer mounted on a theodolite,indicating the change of SSR as a function of orientation and slope. And also reviewed are the models for SSR calculation developed by earlier researchers through the tests with the data.On this basis a new model for SSR flux density is proposed which is of higher applicability and has advantage over the analogues abroad both in physical implication and accuracy of the calculations.

Design of a wideband random phase gradient metasurface by using line-shaped element

Based on phase randomization theory, a method for manufacturing metasurface with diffuse scatter performance is proposed. By using the line-shaped elements with random rotate angles and random distributing positions, the metasurface can achieve good diffusion scatter performance with polarization independent characteristic. This paper studies the effects of the length of line-shaped elements on the metasurface response frequency and the radar cross section (RCS) reduction bandwidth. The simulated result shows that the wideband properties of metasurface benefit from two different length line-shaped elements. The proposed metasurface can reduce the RCS significantly for both normal and oblique incident waves. The line-shaped element is suitable for all sizes of detected objects and it can be directly sprayed on the detected object surface. To demonstrate the effectiveness of the proposed method, the metasurface prototype is fabricated and measured. Experimental results show that the fabricated metasur-face can effectively reduce RCS, and it has great application prospects in stealth technology. Keywords: Diffuse scatter characteristics;polarization independent;radar cross section reduction.