Three-dimensional inversion of knot defects recognition in timber cutting

The comprehensive utilization of wood is the main goal of log cutting,but knot defects increase the diffi-culty of rationally optimizing cutting.Due to the lack of real shape data of knot defects in logs,it is diffi cult for detection methods to establish a correlation between signal and defect morphology.An image-processing method is proposed for knot inversion based on distance regularized level set segmentation(DRLSE)and spatial vertex clustering,and with the inversion of the defects existing relative board position in the log,an inversion model of the knot defect is established.First,the defect edges of the top and bottom images of the boards are extracted by DRLSE and ellipse fi tting,and the major axes of the ellipses made coplanar by angle correction;second,the coordinate points of the top and bottom ellipse edges are extracted to form a spatial straight line;third,to solve the intersection dispersion of spatial straight lines and the major axis plane,K-medoids clustering is used to locate the vertex.Finally,with the vertex and the large ellipse,a 3D cone model is constructed which can be used to invert the shape of knots in the board.The experiment was conducted on ten defective larch boards,and the experimental results showed that this method can accurately invert the shapes of defects in solid wood boards with the advantages of low cost and easy operation.

Characteristics of fault zones and their control on remaining oil distribution at the fault edge: a case study from the northern Xingshugang Anticline in the Daqing Oilfield, China

Most major oil zones in the Daqing Oilfield have reached a later,high water cut stage,but oil recovery is still only approximately 35%,and 50%of reserves remain to be recovered.The remaining oil is primarily distributed at the edge of faults,in poor sand bodies,and in insufficiently injected and produced areas.Therefore,the edge of faults is a major target for remaining oil enrichment and potential tapping.Based on the dynamic change of production from development wells determined by the injection-recovery relationship at the edge of faults,we analyzed the control of structural features of faults on remaining oil enrichment at the edge.Our results show that the macroscopic structural features and their geometric relationship with sand bodies controlled remaining oil enrichment zones like the edges of NNE-striking faults,the footwalls of antithetic faults,the hard linkage segments（two faults had linked together with each other to form a bigger through-going fault）,the tips of faults,and the oblique anticlines of soft linkages.Fault edges formed two types of forward microamplitude structures：（1） the tilted uplift of footwalls controlled by inverse fault sections and（2） the hanging-wall horizontal anticlines controlled by synthetic fault points.The remaining oil distribution was controlled by microamplitude structures.Consequently,such zones as the tilted uplift of the footwall of the NNW-striking antithetic faults with a fault throw larger than 40 m,the hard linkage segments,the tips of faults,and the oblique anticlines of soft linkage were favorable for tapping the remaining oil potential.Multi-target directional drilling was used for remaining oil development at fault edges.Reasonable fault spacing was determined on the basis of fault combinations and width of the shattered zone.Well core and log data revealed that the width of the shattered zone on the side of the fault core was less than 15 m in general;therefore,the distance from a fault to the development target should be larger than 15 m.Vertically segmented growth faults should take the separation of the lateral overlap of faults into account.Therefore,the safe distance of remaining oil well deployment at the fault edge should be larger than the sum of the width of shattered zone in faults and the separation of growth faults by vertical segmentation.