Through thermal test, cold state experiment, analysis and simulation of thermal process, the gas flow distribution in pelletizing shaft furnace （PSF） was discussed. The results show that there are five flowing trend...Through thermal test, cold state experiment, analysis and simulation of thermal process, the gas flow distribution in pelletizing shaft furnace （PSF） was discussed. The results show that there are five flowing trends among them, the downward roasting gas and the upward cooling gas are the most unsteady, which influence flow distribution greatly. Among the operating parameters, the ratio of inflow is a key factor affecting the flow distribution. The roasting and cooling gases will entirely flow into the roasting zone and internal vertical air channels （IVAC）, respectively, if the ratio of inflow is critical. From such a critical operating condition increasing roasting gas flow or decreasing cooling gas flow, the roasting gas starts flowing downwards so as to enter the inside of IVAC the greater the ratio of inflow, the larger the downward flowrate. Among constructional parameters, the width of roasting zone b1, width of IVAC b2 and width of cooling zone b3, and the height of roasting zone h1, height of soaking zone h2 and height of cooling zone hs are the main factors affecting flow distribution. In case the ratio of b2/b3, or h3/h2, or h1/h2 is increased, the upward cooling gas tends to decrease while the downward roasting gas tends to increase with a gradual decrease in the ratio of inflow.展开更多
Based on the laboratory experiment of reducing iron ore-coal pellet in oxidizing atmosphere,a new self-heating reduction method of iron ore-coal pellet in the cocurrent shaft furnace(CSF) has been developed.In this pr...Based on the laboratory experiment of reducing iron ore-coal pellet in oxidizing atmosphere,a new self-heating reduction method of iron ore-coal pellet in the cocurrent shaft furnace(CSF) has been developed.In this process,the pellets and preheated oxygen-enriched air enter the shaft furnace through its top and descend cocurrently in the furnace.Most of the heat required for rising temperature and endothermic reduction of descending pellets is provided by the way that the descending air burns the volatile from pellets and CO from the reduction of iron oxide in pellets.The reduced pellets and high temperature gas are discharged from the lower part.The sensible heat and chemical energy of the off-gas are used to heat the oxygen-enriched air in stove.This process is applicable to the direct reduction of iron pellets and prereduction of iron pellets in smelting reduction with iron bath.展开更多
The downward moving behavior of pellets in a 8 m2 pellet shaft furnace with an internal vertical air channel and a drying bed was studied by means of a visualized model(1-15) and a top model(1-1).The visualized model ...The downward moving behavior of pellets in a 8 m2 pellet shaft furnace with an internal vertical air channel and a drying bed was studied by means of a visualized model(1-15) and a top model(1-1).The visualized model experiment shows that the downward movement of pellets can be regarded as plug flow approximately inside the furnace except for the lower region of cooling zone due to the influence of the drained hopper.The top model experiment reveals that the pellet sizes increase along the moving direction because of the percolation phenomenon,which results in a decrease of the resistance coefficient and an increase of the gas flow rate from the furnace wall toward the furnace center.展开更多
When carbon-bearing pellets of oolitic hematite are treated in a shaft furnace,some problems are typically encountered：the metallization ratio of the metal pellets is low;the carbon-bearing pellets bond with each oth...When carbon-bearing pellets of oolitic hematite are treated in a shaft furnace,some problems are typically encountered：the metallization ratio of the metal pellets is low;the carbon-bearing pellets bond with each other at high temperatures;and the separation of phosphorus from iron is difficult.To solve these problems,experiments were conducted on oolitic hematite reduction in a resistance furnace and semi-industrial test shaft furnace.The results showed that the metallization rate reached 90% or greater under the conditions of a reduction temperature of 1 150℃,an atmosphere of simulated flue gas,and a reduction time between 1.5and 2.0h.The problem of high-temperature bonding among pellets can be solved by increasing the strength of the pellets,coating their surface with a surface transfer agent and maintaining an even temperature inside the shaft furnace.The basicity of the ore blend exerted no obvious effect on the magnetic concentrate and phosphorus content.The phosphorus content in the magnetic concentrate can be further reduced by improving the grinding capacity of the ball mills used in the experiments.On the basis of the experimental results related to oolitic hematite reduction with carbon-bearing pellets in a shaft furnace,the experimental requirements were satisfied with an average 88.27%total Fe content and 0.581% P content in the pellets.展开更多
The technology of coal gasification in shaft furnace is an effective way to develop direct reduction iron in China. In order to clarify the process of the reduction of oxidized pellets in shaft furnace by carbon monox...The technology of coal gasification in shaft furnace is an effective way to develop direct reduction iron in China. In order to clarify the process of the reduction of oxidized pellets in shaft furnace by carbon monoxide or hydrogen in two ways, i.e. thermodynamics and kinetics, the gas utilization and reaction mechanism were studied by theoretical computations and isothermal thermogravimetric experiment. The results showed that the gas utilization increased with the rise of temperature when xH2/xco≥1 and with the increase of xco/（xH2 ＋xco） when temperature is less than 1073 K. The water-gas shift reaction restrains efficient utilization of gas, particularly in high tem- perature and hydrogen-rich gas. The gas utilization dropped with increase of carburization quantity of direct reduction iron （DRI） and oxygen potential of atmosphere. With the increase of both temperature and content of H2 in inlet gas, the reaction rate increased. At 100% Hz atmosphere, the interfacial chemical reaction is the dominant reaction re- stricted step. For the H2-CO mixture atmosphere, the reduction process is controlled by both interfacial chemical reaction and internal diffusion展开更多
基金ItemSponsored by National Natural Science Foundation of China (50334020) National Key Fundamental Research andDevelopment Project of China (2000026300)
文摘Through thermal test, cold state experiment, analysis and simulation of thermal process, the gas flow distribution in pelletizing shaft furnace （PSF） was discussed. The results show that there are five flowing trends among them, the downward roasting gas and the upward cooling gas are the most unsteady, which influence flow distribution greatly. Among the operating parameters, the ratio of inflow is a key factor affecting the flow distribution. The roasting and cooling gases will entirely flow into the roasting zone and internal vertical air channels （IVAC）, respectively, if the ratio of inflow is critical. From such a critical operating condition increasing roasting gas flow or decreasing cooling gas flow, the roasting gas starts flowing downwards so as to enter the inside of IVAC the greater the ratio of inflow, the larger the downward flowrate. Among constructional parameters, the width of roasting zone b1, width of IVAC b2 and width of cooling zone b3, and the height of roasting zone h1, height of soaking zone h2 and height of cooling zone hs are the main factors affecting flow distribution. In case the ratio of b2/b3, or h3/h2, or h1/h2 is increased, the upward cooling gas tends to decrease while the downward roasting gas tends to increase with a gradual decrease in the ratio of inflow.
基金Project supported by the National Foundation of Nature Science of China
文摘Based on the laboratory experiment of reducing iron ore-coal pellet in oxidizing atmosphere,a new self-heating reduction method of iron ore-coal pellet in the cocurrent shaft furnace(CSF) has been developed.In this process,the pellets and preheated oxygen-enriched air enter the shaft furnace through its top and descend cocurrently in the furnace.Most of the heat required for rising temperature and endothermic reduction of descending pellets is provided by the way that the descending air burns the volatile from pellets and CO from the reduction of iron oxide in pellets.The reduced pellets and high temperature gas are discharged from the lower part.The sensible heat and chemical energy of the off-gas are used to heat the oxygen-enriched air in stove.This process is applicable to the direct reduction of iron pellets and prereduction of iron pellets in smelting reduction with iron bath.
基金Projects(59374166,58974155) supported by the National Natural Science Foundation of China
文摘The downward moving behavior of pellets in a 8 m2 pellet shaft furnace with an internal vertical air channel and a drying bed was studied by means of a visualized model(1-15) and a top model(1-1).The visualized model experiment shows that the downward movement of pellets can be regarded as plug flow approximately inside the furnace except for the lower region of cooling zone due to the influence of the drained hopper.The top model experiment reveals that the pellet sizes increase along the moving direction because of the percolation phenomenon,which results in a decrease of the resistance coefficient and an increase of the gas flow rate from the furnace wall toward the furnace center.
基金Item Sponsored by National Science and Technology Support Program for 12th Five-year Plan of China(2013BAE07B03)
文摘When carbon-bearing pellets of oolitic hematite are treated in a shaft furnace,some problems are typically encountered：the metallization ratio of the metal pellets is low;the carbon-bearing pellets bond with each other at high temperatures;and the separation of phosphorus from iron is difficult.To solve these problems,experiments were conducted on oolitic hematite reduction in a resistance furnace and semi-industrial test shaft furnace.The results showed that the metallization rate reached 90% or greater under the conditions of a reduction temperature of 1 150℃,an atmosphere of simulated flue gas,and a reduction time between 1.5and 2.0h.The problem of high-temperature bonding among pellets can be solved by increasing the strength of the pellets,coating their surface with a surface transfer agent and maintaining an even temperature inside the shaft furnace.The basicity of the ore blend exerted no obvious effect on the magnetic concentrate and phosphorus content.The phosphorus content in the magnetic concentrate can be further reduced by improving the grinding capacity of the ball mills used in the experiments.On the basis of the experimental results related to oolitic hematite reduction with carbon-bearing pellets in a shaft furnace,the experimental requirements were satisfied with an average 88.27%total Fe content and 0.581% P content in the pellets.
基金Item Sponsored by National Natural Science Foundation of China(51090384)Fundamental Research Funds for Central Universities of China(N110202001)
文摘The technology of coal gasification in shaft furnace is an effective way to develop direct reduction iron in China. In order to clarify the process of the reduction of oxidized pellets in shaft furnace by carbon monoxide or hydrogen in two ways, i.e. thermodynamics and kinetics, the gas utilization and reaction mechanism were studied by theoretical computations and isothermal thermogravimetric experiment. The results showed that the gas utilization increased with the rise of temperature when xH2/xco≥1 and with the increase of xco/（xH2 ＋xco） when temperature is less than 1073 K. The water-gas shift reaction restrains efficient utilization of gas, particularly in high tem- perature and hydrogen-rich gas. The gas utilization dropped with increase of carburization quantity of direct reduction iron （DRI） and oxygen potential of atmosphere. With the increase of both temperature and content of H2 in inlet gas, the reaction rate increased. At 100% Hz atmosphere, the interfacial chemical reaction is the dominant reaction re- stricted step. For the H2-CO mixture atmosphere, the reduction process is controlled by both interfacial chemical reaction and internal diffusion
