Stable single longitudinal mode erbium-doped silica fiber laser based on an asymmetric linear three-cavity structure

We present a stable linear-cavity single longitudinal mode （SLM） erbium-doped silica fiber laser. It consists of four fiber Bragg gratings （FBGs） directly written in a section of photosensitive erbium-doped fiber （EDF） to form an asymmetric three-cavity structure. The stable SLM operation at a wavelength of 1545.112 nm with a 3-dB bandwidth of 0.012 nm and an optical signal-to-noise ratio （OSNR） of about 60 dB is verified experimentally. Under laboratory conditions, the performance of a power fluctuation of less than 0.05 dB observed from the power meter for 6 h and a wavelength variation of less than 0.01 nm obtained from the optical spectrum analyzer （OSA） for about 1.5 h are demonstrated. The gain fiber length is no longer limited to only several centimeters for SLM operation because of the excellent mode-selecting ability of the asymmetric three-cavity structure. The proposed scheme provides a simple and cost-effective approach to realizing a stable SLM fiber laser.

Optical Pulse Compression Based on High-doped Erbium Fiber Amplifier and Standard Single-mode Fiber

Proposed is a novel optical pulse compression technique based on high-doped erbium fiber amplifier and standard single-mode fiber(SMF). We used the amplifier with the erbium ion concentration of 6.3×10-3 to amplify a hyperbolic secant pulse from a regeneratively mode-locked fiber laser. The central wavelength, pulsewidth and peak power of the pulse are 1 550 nm, 12.5 ps and 3 mW, respectively. Then the amplified pulse with peak power level corresponding to a higher-order soliton is compressed when it propagates through a 3-km-long single-mode fiber. Studied are the compressed pulses under different pump powers and fiber lengths. The results show that it can get a narrower pulse, and solve the difficulty that pulses at low power can not be compressed directly in the fiber. And the construct is compact.

Visible-light all-fiber vortex lasers based on mode selective couplers

We demonstrate visible-light all-fiber vortex lasers by incorporating the home-made mode selective couplers (MSCs). The MSC at green or red wavebands is fabricated by specially designing and fusing a single-mode fiber (SMF) and a few-mode fiber (FMF). The MSCs inserted into visible fiber cavities act as power splitters and mode converters from the LP01 to LP11 mode at green and red wavelengths, respectively. The red-light all-fiber vortex laser is formed by a 10-cm Pr3+/Yb3+:ZBLAN fiber, a fiber Bragg grating, a fiber end-facet mirror and the MSC at 635 nm, which generates vortex beams with OAM±1 at 634.4 nm and an output power of 13 mW. The green-light all-fiber vortex laser consists of a 12-cm Ho3+:ZBLAN fiber, two fiber pigtail mirrors, and the MSC at 550 nm, which generates vortex beams with OAM±1 at 548.9 nm and an output power of 3 mW.

RESEARCH ON TRANSVERSE STRESS CHARACTER OF SINGLE MODE OPTICAL FIBER

This paperdetails experimental work done to quantify stress measurements made optically utilizing ordinary single mode optical fibers. Strain-induced changes of birefringence for ordinary single mode optical fiber responses are characterized against standard stress measurements in a well understand configuration. The experimental scheme for this work and the results are presented in detaial. In this paper, POssible applications for this transverse stress character of single mode fibers are also proposed.

Properties of Single Mode Polymer Optical Fiber

The density,dynamic modulus,Youngs modulus,tensile strength,extension properties,Fourier transform infrared spectrum and differential scanning calorimetry have been measured and discussed for single mode polymethyl-methacrylate optical fiber.The results show that the fiber can provide large strain range for polymeric optical fiber Bragg gratings.

Derivation of General Formula for Coupling Loss of Single-mode Fiber Collimators with Gradient-index Rod Lenses

Gradient-index rod lens (GRIN-lens) whose pitch is ordinary value with bevel ferrule coupling system is analyzed, an equivalent method which can be used to analyze this system is put forward, and a general formula for determining the coupling loss with axes mismatch, radial mismatch, and angular mismatch is derived by use of the Gaussian field approximation and mode-field coupling theory. The experimental results are in good agreement with the theory prediction. It indicates that these formulas are suitable to analyze the gradient-index rod lens coupling system with pigtail fiber.

FAST EVALUATION OF THE CHARACTERISTICS OF SINGLE-MODE OPTICAL FIBERS

This paper describes a method for fast engineering evaluation of the transmission characteristicsof single-mode optical fibers.A versatile microcomputer program is presented which can be utilized to ana-lyze mode field characteristics of single-mode fibers with arbitrary refractive index profiles.Our computationshows that the mathematical algorithm and the corresponding programs developeod in this paper are rela-tively simple and accurate enough for the engineenring design of single-mode fibers for optical communica-tion systems.

Frequency-stabilized Yb：fiber comb with a tapered single-mode fiber

We demonstrate a stable Yb：fiber frequency comb with supercontinuum generation by using a specially designed tapered single-mode fiber, in which a spectrum spanning from 500 nm to 1500 nm is produced. The carrier-envelope offset signal of the Yb：fiber comb is measured with a signal-to-noise ratio of more than 40 dB and a linewidth narrower than 120 kHz. The repetition rate and carrier-envelope offset signals are simultaneously phase locked to a microwave reference frequency.

A tunable comb filter using single-mode/multimode/polarization-maintaining-fiber-based Sagnac fiber loop

A novel tunable comb filter composed of a single-mode/multimode/polarization-maintaining-fiber-based Sagnac fiber loop is proposed and experimentally demonstrated. The filter tunability is achieved by rotating the polarization controller. The spectral shift is dependent on rotation direction and the position of the polarization controller. In addition, the adjustable range achieved by rotating the half-wave-plate polarization controller is twice higher than that of the quarter-wave-plate one.

Real-Time 4-Mode MDM Transmission Using Commercial 400G OTN Transceivers and All-Fiber Mode Multiplexers

Weakly-coupled mode division multiplexing(MDM)technique is considered a promising candidate to enhance the capacity of an optical transmission system,in which mode multiplexers/demultiplexers(MMUX/MDEMUX)with low insertion loss and modal crosstalk are the key components.In this paper,a low-modal-crosstalk 4-mode MMUX/MDEMUX for the weakly-coupled triple-ring-core few-mode fiber(TRC-FMF)is designed and fabricated with side-polishing processing.The measurement results show that a pair of MMUX/MDEMUX and 25 km weakly-coupled TRC-FMF MDM link achieve low modal crosstalk of lower than−17.5 dB and insertion loss of lower than 11.56 dB for all the four modes.Based on the TRC-FMF and all-fiber MMUX/MDEMUX,an experiment for 25 km real-time 4-mode 3-λwavelength division multiplexing(WDM)-MDM transmission is conducted using commercial 400G optical transport network(OTN)transceivers.The experimental results prove weakly-coupled MDM techniques facilitate a smooth upgrade of the optical transmission system.

Interference of selective higher-order modes in optical fibers

The interference of selective higher-order modes in optical fibers is investigated both theoretically and experimentally. It has been demonstrated that by coupling the LP01 mode in a step-index single-mode fiber (SMF) to the LP0m modes in step-index multimode fibers (MMFs) with different parameters, one can selectively generate higher-order modes and construct all-fiber interferometers. The research presented in this paper forms a basis of a new type of fiber devices with potential applications in fiber sensing, optical fiber communications, and optical signal processing.

Self-starting all-fiber PM Er:laser mode locked by a biased nonlinear amplifying loop mirror

A compact all-fiber polarization-maintaining Er:laser using a nonlinear amplifying loop mirror is reported. Fundamental single-pulse mode-locking operation can always self start, with a cavity round-trip decreased from ~ 4.7 m to~ 1.7 m. When the pulse repetition rate is 121.0328 MHz, output pulse is measured to have a center wavelength/3-d B spectral bandwidth/radio frequency signal to noise ratio(SNR)/pulse width of 1571.65 nm/18.70 nm/80 d B/477 fs, respectively. Besides, three states including the exponential growth, damping state, and steady state are investigated through the build-up process both experimentally and numerically. Excellent stability of this compact Er:laser is further evaluated,demonstrating that it can be an easy-fabrication maintenance-free ultrafast candidate for the scientific area of this kind.

Polarization Characteristics of the Deformed Low-Mode Fiber Waveguides with Polarization Conservation

In this work the results of polarization researches of low-optical fiber waveguides with conservation of polarization are presented. Obtained results quite convincingly testify regarding a high sensitivity low-mode regime of work of an optical fiber to anisotropic external influences, in comparison with one-mode regime of work of the same fibre. This result, can represent a big practical value at the realization of high-sensitivity fiber-optical devices of different physical values.

A high-efficiency grating coupler between single-mode fiber and silicon-on-insulator waveguide

We present the design of a diffractive grating structure and get the optimal parameters which can achieve more than 75%coupling efficiency（CE） between single-mode fiber and silicon-on-insulator（SOI） waveguide through 2D finite-different time-domain（FDTD） simulation.The proposed architecture has a uniform structure with no bottom reflection element or silicon overlay.The structure,including grating couplers,adiabatic tapers and interconnection waveguides can be fabricated on the SOI waveguide with only a single electron-beam lithography（ICP） step,which is CMOS-compatible.A relatively high coupling efficiency of 47.2%was obtained at a wavelength of 1562 nm.

Influence of optical filtering on transmission capacity in single mode fiber communications

This paper presents the design and analysis of optical filters that are placed at the output of directly modulated vertical cavity surface emitting laser （VCSEL） in the process of inexpensive transmitter＇s implementation for upcoming generation optical access network. Generation of non return to zero （NRZ） optical signal from the transmitter for 110 km error-free single mode fiber （SMF） transmission at 10 Gb/s with bit error rate （BER） of 10-30 in the absence of the external modulator and encoder was proposed. Effects of super-Gaussian and Butterworth optical filters at VCSEL output were demonstrated to maximize performance of SMF optical systems without need of any dispersion compensation technique.

4-W single transverse mode Yb^(3+)-doped fiber laser pumped by 915-nm laser diode array

A cladding-pumped ytterbium-doped fiber laser is described in this letter. Using unusual pumping source with 915-nm wavelength, slope efficiency up to 75% with respect to absorbed input power and output power is obtained, a maximum output power of 4.006 W with fundamental mode is measured.

Analysis of Radio over Fiber system for mitigating four-wave mixing effect

In this paper,an efficient 8-channel 32Gbps RoF(Radio over Fiber)system incorporating Bessel Filter(8/32 RoFBF)has been demonstrated to reduce the impact of non-linear transmission effects,specifically Four-Wave Mixing(FWM).The simulation results indicate that the proposed 8/32 RoF-BF system provides an optimum result w.r.t.channel spacing(75 GHz),input source power(0 dBm)and number of input channels(8).In comparison with the existing RoF system,the proposed 8/32 RoF-BF system has been validated analytically and it is found that the performance of the proposed system is in close proximity particularly in FWM sideband power reduction of the order of 4 dBm for the 8-channel 32Gbps RoF system.

Axial intensity in a fiber-optic confocal microscope

A fiber-optic confocal microscope has been analyzed by Fourier optics.It is found that the detected light intensity has three parts,each of which is depennted on the coupled lens,the detective lens,and the part comprised of the fiber and the microprobe.The simulated results show that the less the value of the parameter A is,which is dependent on the fiber and microprobe,the higher the axial resolution of the system is. For the case,as A→∞, the axial resolution is zero,which is corresponding to the conventional microscope.as A≤1,the axial resolution changes slightly,and is close to the optimal value,which is corresponding to the perfect confocal microscope.when the reflective loss takes place at the end of fiber,the contrast of axial intensity will decrease.All that will help the design of endoscope with confocal microscope at cellular level.

Amplified spontaneous emission properties of a single mode Er^(3+)-doped tellurite fiber

Spectral characteristics of the amplified spontaneous emission (ASE) from a novel single mode Er^(3+) doped tellurite fiber with D-type cladding is reported in this letter. When pumped at 980 nm, an ASE source that has nearly a 100-nm flat FWHM bandwidth is obtained with a fiber length of 30-60 cm. Variation of ASE spectra with pump powers and fiber lengths are measured. Output power up to 2.0 mW is obtained with a launched pump power of 660 mW.

Nd^(3+) Doped Silicate Glass Photonic Crystal Fiber with Random Hole Distributions

The fabrication of one kind of large core area Nd3 + doped silicate glass photonic crystal fiber, and demonstration of the fiber's waveguidence properties were reported. This fiber owns a random air hole distribution in the cladding. The measured minimum loss of this kind of fiber is 10 dB·m-1 at 660 nm. These fibers can sustain only a single mode at least over wavelength ranging from 660 nm to 980 nm.