Laser patterning of large-scale perovskite single-crystal-based arrays for single-mode laser displays

Lead halide perovskites have attracted considerable attention as potential candidates for high-performance nano/microlasers,owing to their outstanding optical properties.However,the further development of perovskite microlaser arrays(especially based on polycrystalline thin films)produced by the conventional processing techniques is hindered by the chemical instability and surface roughness of the perovskite structures.Herein,we demonstrate a laser patterning of large-scale,highly crystalline perovskite single-crystal films to fabricate reproducible perovskite single-crystal-based microlaser arrays.Perovskite thin films were directly ablated by femtosecond-laser in multiple low-power cycles at a minimum machining line width of approximately 300 nm to realize high-precision,chemically clean,and repeatable fabrication of microdisk arrays.The surface impurities generated during the process can be washed away to avoid external optical loss due to the robustness of the single-crystal film.Moreover,the high-quality,large-sized perovskite single-crystal films can significantly improve the quality of microcavities,thereby realizing a perovskite microdisk laser with narrow linewidth(0.09 nm)and low threshold(5.1µJ/cm2).Benefiting from the novel laser patterning method and the large-sized perovskite single-crystal films,a high power and high color purity laser display with single-mode microlasers as pixels was successfully fabricated.Thus,this study may offer a potential platform for mass-scale and reproducible fabrication of microlaser arrays,and further facilitate the development of highly integrated applications based on perovskite materials.

Stochastic resonance in a single-mode laser driven by frequency modulated signal and coloured noises

By adding frequency modulated signals to the intensity equation of gain noise model of the single-mode laser driven by two coloured noises which are correlated, this paper uses the linear approximation method to calculate the power spectrum and signal-to-noise ratio （SNR） of the laser intensity. The results show that the SNR appears typical stochastic resonance with the variation of intensity of the pump noise and quantum noise. As the amplitude of a modulated signal has effects on the SNR, it shows suppression, monotone increasing, stochastic resonance, and multiple stochastic resonance with the variation of the frequency of a carrier signal and modulated signal.

Time-Delayed Feedback Control in a Single-Mode Laser System

The effects of time-delayed feedback control in a single-mode laser system is investigated.Using the smalltime delay approximation,the analytic expression of the stationary probability distribution function of the laser field isobtained.The mean,normalized variance and skewness of the steady-state laser intensity are calculated.It is found thatthe time-delayed feedback control can suppress the intensity fluctuation of the laser system.The numerical simulationsare in good agreement with the approximate analytic results.

Stationary properties of a single-mode laser system with non-Gaussian and Gaussian noise

A single-mode laser system with non-Gaussian and Gaussian noise is investigated. The stationary mean value and the normalized variance of the laser intensity are numerically calculated under the condition that the stationary probability distribution function （SPDF） is derived. The SPDF as a function of the laser intensity exhibits a maximum, The maximum becomes smaller with the increase of the correlation intensity or the non-Gaussian parameter, where the later is a measure of the deviation from the Gaussian characteristic. The maximum becomes larger as the correlation time increases. The laser intensity stationary mean value decreases with the increase of the correlation intensity or the non-Gaussian parameter while increases with the correlation time increasing. The laser intensity normalized variance increases with the increase of the correlation intensity or the non-Gaussian parameter while decreases as the correlation time increases.

High power semiconductor laser array with single-mode emission

The semiconductor laser array with single-mode emission is presented in this paper.The 6-μm-wide ridge waveguides(RWGs)are fabricated to select the lateral mode.Thus the fundamental mode of laser array can be obtained by the RWGs.And the maximum output power of single-mode emission can reach 36 W at an injection current of 43 A,after that,a kink will appear.The slow axis(SA)far-field divergence angle of the unit is 13.65.The beam quality factor M;of the units determined by the second-order moment(SOM)method,is 1.2.This single-mode emission laser array can be used for laser processing.

The statistical fluctuation of a single-mode laser system driven by coloured pump noise with signal modulation and the quantum noise with cross-correlation between its real and imaginary parts

Using the linear approximation method, this paper studies the statistical property of a single-mode laser driven by both coloured pump noise with signal modulation and the quantum noise with cross-correlation between its real and imaginary parts, and calculates the steady-state mean normalized intensity fluctuation and intensity correlation time. It analyses the influences of the modulation signal, the net gain coefficient, the noise and its correlation form on the statistical fluctuation of the laser system respectively. It is found that the coloured pump noise modulated by the signal has a great suppressing action on the statistical fluctuation of the laser system; the pump noise self-correlation time and the specific frequency of modulation signal have the result that the statistical fluctuation tends to zero. Furthermore, the ＇colour＇ correlation of pump noise has much influences on the statistical fluctuation of the laser system. Increasing the intensity of pump noise will augment the statistical fluctuation of the laser system, but the intensity of quantum noise and the coefficient of cross-correlation between its real and imaginary parts have less influence on the statistical fluctuation of the laser system. Therefore, from the conclusions of this paper the statistical property can be known and a theoretical basis for steady operation and output of the laser system can be provided.

Stable single-mode operation of 894.6 nm VCSEL at high temperatures for Cs atomic sensing

In this paper, stable single-mode operation at high temperatures is produced by the surface-relief-integrated vertical cavity surface emitting laser（VCSEL）. The gain-cavity mode detuning technique is employed to realize high operating temperatures for the VCSEL. The surface relief is etched in the centre of the top side as a mode discriminator for the fundamental mode output, and the threshold current minimum is 1.94 mA at high temperatures by the gain-cavity mode detuning technique. Maximum single-fundamental-mode output power of 0.45 mW at 80℃ is obtained, and the side mode suppression ratios（SMSRs） are more than 30 dB with increasing temperature and current, respectively.

Self-starting all-fiber PM Er:laser mode locked by a biased nonlinear amplifying loop mirror

A compact all-fiber polarization-maintaining Er:laser using a nonlinear amplifying loop mirror is reported. Fundamental single-pulse mode-locking operation can always self start, with a cavity round-trip decreased from ~ 4.7 m to~ 1.7 m. When the pulse repetition rate is 121.0328 MHz, output pulse is measured to have a center wavelength/3-d B spectral bandwidth/radio frequency signal to noise ratio(SNR)/pulse width of 1571.65 nm/18.70 nm/80 d B/477 fs, respectively. Besides, three states including the exponential growth, damping state, and steady state are investigated through the build-up process both experimentally and numerically. Excellent stability of this compact Er:laser is further evaluated,demonstrating that it can be an easy-fabrication maintenance-free ultrafast candidate for the scientific area of this kind.

Stochastic Resonance in Quantum-Well Semiconductor Lasers

The quantum well （QW） semiconductor lasers have become main optical sources for optical fibre communication systems because of their higher modulation speed, broader modulation bandwidth and better temperature characteristics. In order to improve the quality of direct-modulation by means of the stochastic resonance （SR） mechanism in QW semiconductor lasers, we investigate the behaviour of the SR in dlrect-modulated QW semiconductor laser systems. Considering the cross-correlated carrier noise and photon noise, we calculate the power spectrum of the photon density and the signal-to-noise ratio （SNR） of the direct-modulated laser system by using the linear approximation method. The results indicate that the SR always appears in the dependence of the SNR on the bias current density, and is strongly affected by the cross-correlation coefficient of the carrier and photon noises, the frequency of modulation signal, and the photon lifetime in the laser cavity.

Integrated lithium niobate single-mode lasers by the Vernier effect

Microcavity lasers based on erbium-doped lithium niobate on insulator(LNOI),which are key devices for LNOI integrated photonics,have attracted significant attention recently.In this study,we report the realization of a C-band single-mode laser using the Vernier effect in two coupled erbium-doped LNOI microrings with different radii under the pump of a 980-nm continuous laser.The laser,operating stably over a large range of pumping power,has a pump threshold of about 200μW and a side-mode suppression ratio exceeding 26 dB.The high-performance LNOI single-mode laser will promote the development of lithium niobate integrated photonics.

An Optically Reconfigurable Förster Resonance Energy Transfer Process for Broadband Switchable Organic Single-Mode Microlasers

Miniaturized lasers with multicolor output and high spectral purity are indispensable for various ultracompact photonic devices.Here,we propose an optically reconfigurable Förster resonance energy transfer(FRET)process to realize broadband switchable single-mode lasing based on in situ activation of acceptors.The stoichiometric ratio of the donor and acceptor in the ready-made microstructures could be modulated readily by precisely activating the acceptors through a photoisomerization process,leading to a reconstructed FRET process to achieve dynamically switchable lasing.Furthermore,dual-color switchable single-mode lasing was realized by selectively constructing the FRET process in an identical coupled microdisks system.These results advance a comprehensive understanding of excited-state dynamics in organic composite material systems,thereby providing new ideas for the rational design of miniaturized photonic materials and devices with desired performances.

The phenomenon of stochastic resonance in a single-mode laser system with an input periodical signal

Using the linear approximation method, we study a single-mode laser system driven by colored pump noise and quantum noise with coupling between the real and imaginary parts when the laser is operated well above threshold. The steady state mean intensity fluctuation C(0) and signal-to-noise ratio (SNR) are calculated. It is found that there is a maximum in SNR when there is a minimum in the fluctuation of laser system if the coupling coefficient between real and imaginary parts of the quantum noise equals zero.

Stable single-mode operation of a distributed feedback quantum cascade laser integrated with a distributed Bragg reflector

We report an index-coupled distributed feedback quantum cascade laser by employing an equivalent phase shift(EPS) of quarter-wave integrated with a distributed Bragg reflector(DBR) at λ~5.03 μm. The EPS is fabricated through extending one sampling period by 50% in the center of a sampled Bragg grating. The key EPS and DBR pattern are fabricated by conventional holographic exposure combined with the optical photolithography technology, which leads to improved flexibility, repeatability, and cost-effectiveness. Stable single-mode emission can be obtained by changing the injection current or heat sink temperature even under the condition of large driving pulse width.

Universal single-mode lasing in fully chaotic two-dimensional microcavity lasers under continuous-wave operation with large pumping power [Invited]

For a fully chaotic two-dimensional(2D) microcavity laser, we present a theory that guarantees both the existence of a stable single-mode lasing state and the nonexistence of a stable multimode lasing state, under the assumptions that the cavity size is much larger than the wavelength and the external pumping power is sufficiently large. It is theoretically shown that these universal spectral characteristics arise from the synergistic effect of two different kinds of nonlinearities: deformation of the cavity shape and mode interaction due to a lasing medium. Our theory is based on the linear stability analysis of stationary states for the Maxwell–Bloch equations and accounts for single-mode lasing phenomena observed in real and numerical experiments of fully chaotic 2D microcavitylasers.

NOVEL FEATURES IN PHOTON STATISTICS FROM A SINGLE-MODE LASER

Using the quantum electrodynamical theory the photon statistics has been established for a single-mode laser. A general master equation is advanced and, on the basis of the steadystate photon-number distribution, the variation of the Mandel factor with the relative pumping parameter is calculated. Our results show thai photon statistics for a single-mode laser have a novel feature, i.e. the photon-number distribution alternates, in general, between superPoisson distribution and sub-Poisson distribution, and approaches the usual Poisson distribution when the pumping parameter tends to infinite. The dependence of photon statistics on detuning, coupling coefficient, absorption coefficient, thermal mean photon-number and coupling time is discussed.

Single-mode GaAs/AlGaAs quantum cascade microlasers

Single-mode edge emitting GaAs/AlGaAs quantum cascade microlasers at a wavelength of about 11.4μm were realized by shortening the Fabry-Perot cavity length. The spacing of the longitudinal resonator modes is inversely proportional to the cavity length. Stable single-mode emission with a side mode suppression ratio of about 19 dB at 85 K for a 150-μm-long device was demonstrated.

A fiber micro-vibration sensor based on single-mode fiber ring laser

A new micro-vibration sensor based on single-mode fiber ring laser is put forward. The Mach-Zehnder interferometric （MZI） detection technique is presented for interrogating laser frequency shift due to the measurand （piezoelectric transducer （PZT） is used to simulate the micro-vibration） induced laser cavity strain from both single- and multi-mode lasers. In the experiment, compared with multi-mode laser sensors, the single-mode laser sensor is proved to be a sensor with high resolution. When the PZT is driven by the analog signal （0.03 rad near 2 kHz）, the signal-to-noise ratio （SNR） of output signal from the single-mode laser sensor is close to 55 dB and the sensitivity of the sensor is about 5 ×10^-5 rad/Hz1/2.

A Comparative Study of Epi-up and Epi-Down Bonding of High Power 980 nm Single-Mode Semiconductor Lasers

Epi-up and epi-down bonding of high power 980nm lasers have been studied in terms of bonding process, thermal behavior, optical performances, thermal stress effects and long-term laser reliability. We demonstrated that epi-down bonding can offer lower thermal resistance and improved optical performances without significantly degrading the long-term laser reliability.

Effects of Nonlinear Time-Delay on a Stochastic Asymmetric System

We numerically investigate the effects of nonlinear time-delay on the stochastic system. With the delay time increasing, it is found that the peak of probability distribution in low steady states is decreased, and the peak of probability distribution in high steady states is increased. The mean of state variable, the normalized variance, and the normalized autocorrelation function which quantifies the concentrated degree are slowly varied for small delay time. However, the mean of state variable is rapidly increased, and the normalized variance and the normalized autocorrelation function is rapidly decreased for large delay time.

Core Size Scaling of Helical-Core Optical Fibres

The mode-area scaling properties of helical-core optical fibres are numerically studied and the limit of core size for achievable single-mode operation is explored. By appropriate design, helical-core fibres can operate in a single mode with possible scaling up to 300μm in core diameter with numerical aperture 0.1.