Improper flow control devices in a multi-strand tundish can cause some problems, for example, liquid steel cannot reach every nozzle at the same time and the liquid steel in nozzles far away from the entry zone has a ...Improper flow control devices in a multi-strand tundish can cause some problems, for example, liquid steel cannot reach every nozzle at the same time and the liquid steel in nozzles far away from the entry zone has a lower temperature. The water model experiment of a six-strand tundish of Tianjin Iron ＆ Steel Co. Ltd. was performed, a new ＂U＂ type baffle was obtained, and its parameters were defined by perpendicular analysis. The ＂U＂ baffle can not only improve those imperfections, but also prolong the residence time of nonmetallic inclusions, which is good for their flotation and separation.展开更多
The flow-field index in a 41-ton six-strand tundish is considered through adjusting the ratio of the casting velocity between the strands to eliminate the negative impact of iso-velocity casting in multi-strand tundis...The flow-field index in a 41-ton six-strand tundish is considered through adjusting the ratio of the casting velocity between the strands to eliminate the negative impact of iso-velocity casting in multi-strand tundish on the consistency of each strand due to the large ratio of length to width with narrow shape structure,resulting in poor consistency of each strand.In particular,the response time of strand-1 and strand-6 is relatively long,which affects the uniformity of the temperature field and flow field of the entire tundish.On the basis of verifying that the error between the numerical simulations and hydraulic experiments is less than 6%,six cases with the casting velocity ratio changing from 0.8 to 1.3(with an interval of 0.1)are considered by calculation of numerical models.It is concluded that the consistency of each flow can be obviously improved by increasing the casting velocity ratio between side-strand and middle-strand.With increasing the casting velocity ratio,the flow field in the tundish became much active,the temperature field presented well uniformity,and the tracer concentration distribution in local dead zones was improved.展开更多
A 1∶2.5 scale tundish model was set up in laboratory for a six-strand billet continuous casting tundish with different configurations to investigate fluid flow characteristics under different operational conditions b...A 1∶2.5 scale tundish model was set up in laboratory for a six-strand billet continuous casting tundish with different configurations to investigate fluid flow characteristics under different operational conditions by measuring residence time distribution curves.It was found that minimum residence time,maximum concentration time and average residence time of the three strands on the same side of the tundish with the former configuration under normal operation,that is,six strands were open,were small and non-uniform and the tundish had large dead volume fraction.Vortexes easily formed on the liquid surface in the pouring zone of the tundish.The fluid flow characteristics in the tundish with the optimal turbulence inhibitor and baffles were improved and became less non-uniform among the strands.Vortexes were not found on the pouring zone surface in the optimal tundish.For non-normal operation,that is,one strand was close,it was important to choose which strand to be closed for maintaining flow characteristics of the rest two strands.It was found from this investigation that fluid flow characteristics in the optimal configuration tundish with closing strand 2 were better than those with closing strand 3 on the same side.展开更多
文摘Improper flow control devices in a multi-strand tundish can cause some problems, for example, liquid steel cannot reach every nozzle at the same time and the liquid steel in nozzles far away from the entry zone has a lower temperature. The water model experiment of a six-strand tundish of Tianjin Iron ＆ Steel Co. Ltd. was performed, a new ＂U＂ type baffle was obtained, and its parameters were defined by perpendicular analysis. The ＂U＂ baffle can not only improve those imperfections, but also prolong the residence time of nonmetallic inclusions, which is good for their flotation and separation.
基金supported by the National Natural Science Foundation of China (Grant Number51774031)the State Key Laboratory of Advanced Metallurgy Foundation (Grant Number 41619018)。
文摘The flow-field index in a 41-ton six-strand tundish is considered through adjusting the ratio of the casting velocity between the strands to eliminate the negative impact of iso-velocity casting in multi-strand tundish on the consistency of each strand due to the large ratio of length to width with narrow shape structure,resulting in poor consistency of each strand.In particular,the response time of strand-1 and strand-6 is relatively long,which affects the uniformity of the temperature field and flow field of the entire tundish.On the basis of verifying that the error between the numerical simulations and hydraulic experiments is less than 6%,six cases with the casting velocity ratio changing from 0.8 to 1.3(with an interval of 0.1)are considered by calculation of numerical models.It is concluded that the consistency of each flow can be obviously improved by increasing the casting velocity ratio between side-strand and middle-strand.With increasing the casting velocity ratio,the flow field in the tundish became much active,the temperature field presented well uniformity,and the tracer concentration distribution in local dead zones was improved.
基金Item Sponsored by National High Technology Research and Development Plan of China(2007AA04Z194)
文摘A 1∶2.5 scale tundish model was set up in laboratory for a six-strand billet continuous casting tundish with different configurations to investigate fluid flow characteristics under different operational conditions by measuring residence time distribution curves.It was found that minimum residence time,maximum concentration time and average residence time of the three strands on the same side of the tundish with the former configuration under normal operation,that is,six strands were open,were small and non-uniform and the tundish had large dead volume fraction.Vortexes easily formed on the liquid surface in the pouring zone of the tundish.The fluid flow characteristics in the tundish with the optimal turbulence inhibitor and baffles were improved and became less non-uniform among the strands.Vortexes were not found on the pouring zone surface in the optimal tundish.For non-normal operation,that is,one strand was close,it was important to choose which strand to be closed for maintaining flow characteristics of the rest two strands.It was found from this investigation that fluid flow characteristics in the optimal configuration tundish with closing strand 2 were better than those with closing strand 3 on the same side.
