Recent high-resolution deep seismic reflection profile across the Kunlun fault in northeastern Tibet shows clearly that the Moho is cut off by a complex thrust fault system. Moho offset is a general phenomenon, but li...Recent high-resolution deep seismic reflection profile across the Kunlun fault in northeastern Tibet shows clearly that the Moho is cut off by a complex thrust fault system. Moho offset is a general phenomenon, but little is known about the dynamic mechanism. In this study, contact models with Maxwell materials are used to simulate the mechanical process of Moho offset induced by the aseismic slip of deeply buried faults. Based on the seismic reflection data, we project a single fault model and a complex fault system model with two faults inter- secting. The deformations of the Moho, the aseismic slips, and contact stresses on faults in different models are discussed in detail. Results show that the Moho offset might be produced by aseismic slip of deeply buried faults, and the magnitude is influenced by the friction coefficient of faults and the viscosity of the lower crust. The maximum slip occurs near the Moho on the single fault or at the crossing point of two intersecting faults system. Stress concentrates mainly on the Moho, the deep end of faults, or the crossing point. This study will throw light on understanding the mechanism of Moho offset and aseismic slip of deeply buried faults. The results of complex fault system with two faults intersecting are also useful to understand the shallow intersecting faults that may cause earthquakes.展开更多
The Late Quaternary slip rate along the Maqu segment of the eastern Kunlun Fault was estimated using a combination of high-resolution remote sensing imagery interpretation, field observations and differential Global P...The Late Quaternary slip rate along the Maqu segment of the eastern Kunlun Fault was estimated using a combination of high-resolution remote sensing imagery interpretation, field observations and differential Global Positioning System（GPS） measurements of offset river terraces, and 14 C dating of snail shells collected from offset risers. The results show that the left-slip rate along the segment is 3–5 mm/a, and that the vertical slip rate is 0.3–0.5 mm/a. Both the horizontal and vertical slips on the segment remain consistent over a distance of ~100 km. It means that no slip gradient as previously suggested occurred along the Maqu segment, and which thus might behave as an independent seismogenic fault. Judging from multiple relationships among young terrace offsets, we infer that co-seismic surface rupture produced by a characteristic earthquake with a magnitude of Ms7.0–7.5 on the Maqu fault could generate a horizontal slip of 4.5–5 m and a vertical slip of 0.45–0.5 m, with a corresponding ratio（Dh/Dv） of about 9. Two surface rupture events must have occurred over the past 3300 years, the latest one possibly between 1485 cal BP and 1730 cal BP.展开更多
The easternmost Tian Shan lies in eastern Xinjiang, Central Asia. The South Barkol basin fault（SBF） in the northern part of the easternmost Tian Shan is a major tectonic structure in this orogenic region. The late Q...The easternmost Tian Shan lies in eastern Xinjiang, Central Asia. The South Barkol basin fault（SBF） in the northern part of the easternmost Tian Shan is a major tectonic structure in this orogenic region. The late Quaternary activity, paleoseismology, and deformation characteristics of the fault provide important clues for understanding the tectonic process of the eastern Tian Shan orogen and implementing seismic mitigation. Through interpretation of high-resolution satellite images, unmanned aerial vehicle measurements, and detailed geological and geomorphic investigations, we suggest that the fault exhibits clear left-lateral slip along its western segment. Paleoseismic trenches dug near Xiongkuer reveal evidence of six large paleoearthquakes. The four latest paleoearthquakes were dated： the oldest event occurred at 4663 BC–3839 BC. Data on the horizontal offsets along the probable 1842 Barkol earthquake coseismic rupture suggest clear multiple relationships between cumulative offsets and possible ~4 m of coseismic left-lateral slip per event. From the cumulative offsets and 14 C sample ages, we suggest an average Holocene left-lateral slip rate of 2.4–2.8 mm/a on the SBF, accounting for ~80% of lateral deformation within the entire eastern Tian Shan fault system. This result is comparable with the shortening rate of 2–4 mm/a in the whole eastern Tian Shan, indicating an equal role of strike-slip tectonics and compressional tectonics in this orogen, and that the SBF may accommodate substantial lateral tectonic deformation.展开更多
库水位循环作用下,库岸边坡岩土体物理力学性质劣化,引起岸坡变形、滑移,将对桥梁基础、桥墩及上部结构产生不同程度损伤,甚至会导致桥梁上部结构落梁、垮塌。针对重庆万州长江二桥库岸边坡失稳致灾问题,采用FEM-SPH(finite element met...库水位循环作用下,库岸边坡岩土体物理力学性质劣化,引起岸坡变形、滑移,将对桥梁基础、桥墩及上部结构产生不同程度损伤,甚至会导致桥梁上部结构落梁、垮塌。针对重庆万州长江二桥库岸边坡失稳致灾问题,采用FEM-SPH(finite element method-smoothed particle hydrodynamics)转换耦合算法建立了岸坡-桥梁三维有限元模型,结合桥位处地质勘测数据模拟了变动水位条件下岸坡变形、滑移、失稳全过程,揭示了岸坡滑移与桥梁桩基相互作用机理,研究了桥墩偏位规律及下部结构失效模式。结果表明:以滑动带有限元网格悉数转换为SPH(smoothed particle hydrodynamics)粒子作为岸坡失稳判据,FEM-SPH转换耦合算法能够更直观、准确地模拟库岸边坡从变形、滑移至失稳全过程;桥位处岸坡将在第16、20次水位升降循环过程中发生失稳破坏;随着岸坡变形、滑移、失稳演化,桥墩偏位呈“缓增-激增”的变化趋势;岸坡发生第2次失稳时,桩基础在土-岩交界面上部发生剪切破坏,破坏面与水平面夹角约为60°。展开更多
基金supported by SinoProbe (Grant 08-01)the National Natural Science Foundation of China (Grant Nos.41174035 and 41130316)+1 种基金the National High Technology Research and Development Program of China (863 Program) (Grant No.2009AA093401-05)the Major State Basic Research Development Program of China (973 Program) (Grant No.2012CB417301)
文摘Recent high-resolution deep seismic reflection profile across the Kunlun fault in northeastern Tibet shows clearly that the Moho is cut off by a complex thrust fault system. Moho offset is a general phenomenon, but little is known about the dynamic mechanism. In this study, contact models with Maxwell materials are used to simulate the mechanical process of Moho offset induced by the aseismic slip of deeply buried faults. Based on the seismic reflection data, we project a single fault model and a complex fault system model with two faults inter- secting. The deformations of the Moho, the aseismic slips, and contact stresses on faults in different models are discussed in detail. Results show that the Moho offset might be produced by aseismic slip of deeply buried faults, and the magnitude is influenced by the friction coefficient of faults and the viscosity of the lower crust. The maximum slip occurs near the Moho on the single fault or at the crossing point of two intersecting faults system. Stress concentrates mainly on the Moho, the deep end of faults, or the crossing point. This study will throw light on understanding the mechanism of Moho offset and aseismic slip of deeply buried faults. The results of complex fault system with two faults intersecting are also useful to understand the shallow intersecting faults that may cause earthquakes.
基金support of the Natural Science Foundation of China(41472178)the China Geological Survey projects(1212011120167,12120114002211)
文摘The Late Quaternary slip rate along the Maqu segment of the eastern Kunlun Fault was estimated using a combination of high-resolution remote sensing imagery interpretation, field observations and differential Global Positioning System（GPS） measurements of offset river terraces, and 14 C dating of snail shells collected from offset risers. The results show that the left-slip rate along the segment is 3–5 mm/a, and that the vertical slip rate is 0.3–0.5 mm/a. Both the horizontal and vertical slips on the segment remain consistent over a distance of ~100 km. It means that no slip gradient as previously suggested occurred along the Maqu segment, and which thus might behave as an independent seismogenic fault. Judging from multiple relationships among young terrace offsets, we infer that co-seismic surface rupture produced by a characteristic earthquake with a magnitude of Ms7.0–7.5 on the Maqu fault could generate a horizontal slip of 4.5–5 m and a vertical slip of 0.45–0.5 m, with a corresponding ratio（Dh/Dv） of about 9. Two surface rupture events must have occurred over the past 3300 years, the latest one possibly between 1485 cal BP and 1730 cal BP.
基金funded by foundation of seismic risk assessment of active faults,China Earthquake Administration(Grant no.1521044025)
文摘The easternmost Tian Shan lies in eastern Xinjiang, Central Asia. The South Barkol basin fault（SBF） in the northern part of the easternmost Tian Shan is a major tectonic structure in this orogenic region. The late Quaternary activity, paleoseismology, and deformation characteristics of the fault provide important clues for understanding the tectonic process of the eastern Tian Shan orogen and implementing seismic mitigation. Through interpretation of high-resolution satellite images, unmanned aerial vehicle measurements, and detailed geological and geomorphic investigations, we suggest that the fault exhibits clear left-lateral slip along its western segment. Paleoseismic trenches dug near Xiongkuer reveal evidence of six large paleoearthquakes. The four latest paleoearthquakes were dated： the oldest event occurred at 4663 BC–3839 BC. Data on the horizontal offsets along the probable 1842 Barkol earthquake coseismic rupture suggest clear multiple relationships between cumulative offsets and possible ~4 m of coseismic left-lateral slip per event. From the cumulative offsets and 14 C sample ages, we suggest an average Holocene left-lateral slip rate of 2.4–2.8 mm/a on the SBF, accounting for ~80% of lateral deformation within the entire eastern Tian Shan fault system. This result is comparable with the shortening rate of 2–4 mm/a in the whole eastern Tian Shan, indicating an equal role of strike-slip tectonics and compressional tectonics in this orogen, and that the SBF may accommodate substantial lateral tectonic deformation.
