Single-jet Spray Mixing with a Confined Crossflow

In order to achieve uniform mixing between spray droplets and crossflow, cold-model experiment of a hollow-cone water spray in an air crossflow is investigated via a numerical simulation. The simulation cases are designed by using the orthogonal design method. The Eulerian-Lagrangian formulation is employed for modeling the droplets-crossflow two-phase flow while the realizable k-ε turbulence model is used to describe the turbulence. A new index, mixedness quality, is proposed to assess the overall mixing of the droplets in the crossflow. The simulation results demonstrate that the counter-rotating vortex pair (CVP) imposes a more significant impact on the spatial distribution than on the size distribution of the droplets. Pairs of CVP with smaller scales are preferable for achieving a better mixing. The influencing factors are listed in the following order in terms of the degree of their impact from the greatest to the least: the Sauter diameter of the initial droplets, the mixing tube diameter, the spray angle, the velocity of the inlet crossflow, and the vertical velocity of the initial droplets. A moderate droplet diameter, a smaller tube diameter, a moderate spray angle, a greater crossflow velocity and a moderate vertical velocity of the droplet are favorable for achieving a higher mixedness quality of the jet spray in a confined crossflow.

A new design of foam spray nozzle used for precise dust control in underground coal mines

In order to improve the utilization rate of foam,an arc jet nozzle was designed for precise dust control.Through theoretical analysis,the different demands of foam were compared amongst arc jets,flat jets and full cone jets when the dust source was covered identically by foam.It is proved that foam consumption was least when an arc jet was used.Foam production capability of an arc jet nozzle under different conditions was investigated through experiments.The results show that with the gas liquid ratio(GLR)increasing,the spray state of an arc jet nozzle presents successively water jet,foam jet and mist.Under a reasonable working condition range of foam production and a fixed GLR,foam production quantity increases at first,and then decreases with the increase of liquid supply quantity.When the inner diameter of the nozzle is 14 mm,the best GLR is 30 and the optimum liquid supply quantity is0.375 m^3/h.The results of field experiments show that the total dust and respirable dust suppression efficiency of arc jet nozzles is 85.8%and 82.6%respectively,which are 1.39 and 1.37 times higher than the full cone nozzles and 1.20 and 1.19 times higher than the fiat nozzles.

Novel photoresist stripping technology using steam-water mixture

A novel wet vapor photoresist stripping technology is developed as an alternative to dry plasma ashing and wet stripping. Experiments using this technology to strip hard baked SU-8 photoresist, aurum and chromium film are carried out. Then the images of stripping results are shown and the mechanism is analyzed and discussed. The most striking result of this experiment is that the spraying mixture of steam and water droplets can strip pho- toresist and even metal film with ease.