Compressive strength and frost heave resistance of different types of semi-rigid base materials after freeze-thaw cycles

Freeze-thaw damage is the most common disease of semi-rigid bases in cold regions, which may greatly affect the dura- bility of roadways. In this study, the compressive strength and frost resistance of four different types of semi-rigid bases （lime-fly ash-stabilized sand, cement-stabilized sand, lime-fly ash-stabilized gravel, and cement-stabilized gravel） are assessed by varying the materials content. Based on freeze-thaw and compressive strength tests, this paper presents the performance of the different materials, each having different physical properties, and the optimal amounts of materials contents are proposed.

Heat flow pattern,base of methane hydrates stability zones and BSRs in Shenhu Area,northern South China Sea

Using the collected 433 heat flow values, we estimated the bases of methane hydrate stability zone （BHSZ）, in northern South China Sea （NSCS）. Through comparing BHSZs with the depths of bottom simulating reflectors （BSRs）, in Shenhu Area （SA）, we found that there are big differences between them. In the north of SA, where the water depth is shallow, many slumps developed and the sedimentation rate is high, it appears great negative difference （as large as -192%）. However, to the southeast of SA, where the water depth is deeper, sedimentation rate is relatively low and uplift basement topography exists, it changes to positive difference （as large as ＋45%）. The differences change so great, which haven＇t been observed in other places of the world. After considering the errors from the process of heat flow measurement, the BSR depth, the relationship of thermal conductivity with the sediments depth, and the fluid flow activities, we conclude that the difference should be not caused by these errors. Such big disagreement may be due to the misunderstanding of BSR. The deviant ＂BSRs＂ could represent the paleo-BSRs or just gas-bearing sediment layers, such as unconformities or the specific strata where have different permeability, which are not hydraterelated BSRs.

Frequency Stabilization of Pulsed Injection-Seeded OPO Based on Optical Heterodyne Technique

The resistance between any two lattice points in an infinite,centered-triangular lattice of equal resistors is determined using the lattice Green function method.It is shown that the two-point resistance on the centeredtriangular lattice is expressed in terms of the resistance of a triangular lattice.Some exact values for the resistance near the origin of the lattice are presented.For large separation between lattice points the asymptotic forms of the resistance are calculated.

Real-time digital image stabilization based on regional field image gray projection

Digital image stabilization technique plays important roles in video surveillance and object acquisition.Many useful electronic image stabilization algorithms have been studied.A real-time algorithm is proposed based on field image gray projection which enables the regional odd and even field image to be projected into x and y directions and thus to get the regional gray projection curves in x and y directions,respectively.For the odd field image channel,motion parameters can be estimated via iterative minimum absolute difference based on two successive field image regional gray projection curves.Then motion compensations can be obtained after using the Kalman filter method.Finally,the odd field image is adjusted according to the compensations.In the mean time,motion compensation is applied to the even field image channel with the odd field image gray projection curves of the current frame.By minimizing absolute difference between odd and even field image gray projection curves of the current frame,the inter-field motion parameters can be estimated.Therefore,the even field image can be adjusted by combining the inter-field motion parameters and the odd field compensations.Finally,the stabilized image sequence can be obtained by synthesizing the adjusted odd and even field images.Experimental results show that the proposed algorithm can run in real-time and have a good stabilization performance.In addition,image blurring can be improved.

Performance and Stability of Polymer Solar Cells Based on the Blends of Poly(3-Hexylthiophene) and Indene-C_(60) Bis-Adduct

The performance and morphology stability of polymer bulk heterojunetion solar cells based on poly（3-hexylthiophene） （P3HT） as the donor and indene-C6o bisadduct （ICBA） or methanofullerene [6,6]-phenyl C61-butyric acid methyl ester （PCBM） as the aeceptor are compared. Effect of the different donor and aeeeptor weight ratios on photo- voltaic performance of the P3HT：ICBA device is studied. The optimal device achieved power conversion emeiency of 5.51~o with dso of l0.86mA/cm2, Voc of 0.83 V, and fill factor （FF） of 61.1 % under AM 1.5G （lOOmW/cm2） simulated solar illumination. However, the stability measurement shows that cells based on P3HT：ICBA are less stable than those of the device based on P3HT：PCBM. Atomic force microscope results reveal that the morphol- ogy of the P3HT：ICBA film changed considerably during the storage periods due to unstable interpenetrating D-A network. This observation can be explained by the fact that there is lack of intermolecular hydrogen bonds in the P3HT：ICBA system. However, in the P3HT：PCBM system the molecules in the blend film are firmly held together in the solid state by means of intermoleeular hydrogen bonds originating from C-H. ~. Os bonds （where Os comes from the singly-bonded 0 atom of PCBM）, forming a stable three-dimensional network. The measured PL decay lifetimes for P3HT：PCBM and P3HT：ICBA systems are 33.66 ns and 35.34 ns, respectively, indicating that the P3HT：ICBA system has a less efficient exciton separation eftleiency than that of P3HT：PCBM, which may result in the interracial photogenerated charges accumulated on the D： A interface. Such progressive phase segregation between P3HT and ICBA eventually leads to the degradation in performance and deteriorates the stability of the device. We also present an approach to enhance the stability of P3HT：ICBA systems by adding PCBM as the second acceptor. Our results show that by carefully tuning the contents of PCBM as the second acceptor, more stable polymer solar cells can be obtained.

Small Signal Stability Analysis of DFIG Fed Wind Power System Using a Robust Fuzzy Logic Controller

This paper focuses on the small signal stability analysis of Doubly-Fed Induction Generator (DFIG) fed wind power system under three modes of operation. The system stability is affected by the influence of electromechanical oscillations, which can be damped using Power System Stabilizer (PSS). A detailed modeling of DFIG fed wind system including controller has been carried out. The damping controller is designed using fuzzy logic to damp the oscillatory modes for stability. The robust performance of the system with controllers has been evaluated using eigen value analysis and time domain simulations under various disturbances and wind speeds. The effectiveness of the proposed fuzzy based PSS is compared with the performance of conventional PSS implemented in the wind system.

Global point tracking based panoramic image stabilization system

A novel image stabilization system is presented,which consists of a global feature point tracking based motion estimation,a Kalman filtering based motion smoothing and an image mosaic based panoramic compensation.The global motion is estimated using feature point matching and iteration with the least-square method.Then,the Kalman filter is applied to smooth the original motion vectors to effectively alleviate unwanted camera vibrations and follow the intentional camera scan.Lastly,the loss information of image boundary due to the motion compensation is reconstructed with image mosaic to improve the visual quality.The experimental results show that this system can smooth unwanted translation or rotation of the video sequences and realize a panoramic stabilization at real-time speed.