Novel imaging methods of stepped frequency radar based on compressed sensing

The theory of compressed sensing （CS） provides a new chance to reduce the data acquisition time and improve the data usage factor of the stepped frequency radar system. In light of the sparsity of radar target reflectivity, two imaging methods based on CS, termed the CS-based 2D joint imaging algorithm and the CS-based 2D decoupled imaging algorithm, are proposed. These methods incorporate the coherent mixing operation into the sparse dictionary, and take random measurements in both range and azimuth directions to get high resolution radar images, thus can remarkably reduce the data rate and simplify the hardware design of the radar system while maintaining imaging quality. Ex- periments from both simulated data and measured data in the anechoic chamber show that the proposed imaging methods can get more focused images than the traditional fast Fourier trans- form method. Wherein the joint algorithm has stronger robustness and can provide clearer inverse synthetic aperture radar images, while the decoupled algorithm is computationally more efficient but has slightly degraded imaging quality, which can be improved by increasing measurements or using a robuster recovery algorithm nevertheless.

Analysis and application of wavelet transform in target imaging and detection of stepped frequency MMW radar

The imaging and target detection methods for stepped frequency signal based on the wavelet transform and its power spectrum are investigated. Not only an imaging and target detection algorithm for stepped frequency signal based on the wavelet transform, but also its respective power spectrum are proposed. The multisampling property of stepped frequency signal is studied and wavelet transform is well suited for analyzing the signal. After multisampling property of stepped frequency signal being studied, it is shown that the wavelet transform is appropriate to analyze the signal. Based on the theory, the wavelet power spectrum analysis is applied to obtain the target range profile and the binary wavelet transform is used to perform target detection. To determine a suitable wavelet scaling for imaging of range profile's MMW radar, the distance resolution ΔR technique is proposed. The effectiveness of this new method is evaluated using simulated noisy radar signal. Results show that the proposed method can bring out the exactness and low computational complexity of this method.

Grating lobes suppression method for stepped frequency GB-SAR system

A grating lobes suppression method for chirp-subpulse stepped frequency（CSSF） signals is proposed, which is applied to deformation monitoring using the ground based synthetic aperture radar（GB-SAR） system. This method is based on accurate estimation and correction of the phase and amplitude error along two dimensions（range and azimuth）, i.e., the error estimation inside the subpulse（in-subpulse error） and across the stepped frequency subpulses（cross-subpulse error） of transmitted CSSF signals. Validated both with simulated data and experimental data recorded in the deformation monitoring campaign, it can be seen that the method as well as the relative conclusions can be fully and effectively applied to most of the stepped frequency systems.

Stepped frequency chirp signal imaging radar jamming using two-dimensional nonperiodic phase modulation

Stepped frequency chirp signal obtains high-resolution radar images by synthesizing multiple narrowband chirp pulses.It has been one of the most commonly used wideband radar waveforms due to its lower demand for radar instant bandwidth.In this paper,we propose a radar jamming method using two-dimensional nonperiodic phase modulation against stepped frequency chirp signal imaging radar.Using the unique property of nonperiodic phase modulation,the proposed method can generate high-level sidelobes that perform as a special blanket jamming along both the range and azimuth directions and make the target unrecognizable.Then,the influence of different modulation parameters,such as the code width and duty ratio,are further discussed.Based on this,the corresponding parameter design principles are presented.Finally,the validity of the proposed method is demonstrated by the Yake-42 plane data simulation and measured unmanned aerial vehicle data experiment.

HPRF pulse Doppler stepped frequency radar

Stepped frequency radar is a well known scheme to generate high range resolution profile （HRRP） of targets. Through appropriate radar parameter design, the radar enables both unambiguous velocity measurement and high resolution ranging within a single dwell in a high pulse repetition frequency （HPRF） mode. This paper analyzes in detail the design principle of the HPRF stepped frequency radar system, the solution to its ambiguity issue, as well as its signal processing method. Both theoretical analysis and simulation results demonstrate that the proposed radar scheme can work independently to solve the problem of motion compensation, and is therefore highly applicable to many new types of radar.

Simutaneous radar imaging and velocity measuring with step frequency waveforms

The principle and method of both radar target imaging and velocity measurement simultaneously based on step frequency waveforms is presented. Velocity compensation is necessary in order to obtain the good High resolution range profile since this waveform is greatly sensitive to the Doppler shift. The velocity measurement performance of the four styles is analyzed with two pulse trains consisted of positive and negative step frequency waveforms. The velocity of targets can be estimated first coarsely by using the pulse trains with positive-positive step frequency combination, and then fine by positive-negative combination. Simulation results indicate that the method can accomplish the accurate estimation of the velocity with efficient computation and good anti-noise performance and obtain the good HRRP simultaneously.

A Novel 2-D Signal Processing Scheme for Quasi-Random Step Frequency Signal

Due to the heavy congestion in HF bands, HF radars are restricted to operating within narrow frequency bands. To improve the system bandwidth and avoid heavy interference bands, a quasi-random step frequency signal with discontinuous bands is presented. A novel two-dimensional signal processing scheme for this signal is proposed on the basis of delicate signal analysis. Simulation results demonstrate that the scheme could successfully realize the resolutions by decoupling the range-Doppler ambiguity, and effectively suppress the maximal sidelobe. Moreover, the scheme is simple and has good numerical stability.

Lorentz Force Electrical Impedance Detection Using Step Frequency Technique

Lorentz force electrical impedance tomography（LFEIT） inherits the merit of high resolution by ultrasound stimulation and the merit of high contrast through electromagnetic field detection. To reduce the instantaneous peak power of the stimulating signal to the transducer, the sinusoidal pulse and step-frequency technique is investigated in LFEIT. The theory of application of step-frequency technique in LFEIT is formulated with the direct demodulation method and the in-phase quadrature demodulation method. Compared with the in-phase quadrature demodulation method, the direct demodulation method has simple experimental setup but could only detect half of the range. Experiments carried out with copper foils confirmed that LFEIT using the step-frequency technique could detect the electrical conductivity variations precisely, which suggests an alternative method of realization of LFEIT.

Qatar Airways Steps Up Frequency to Shanghai

Fourth Weekly Falight Added To China's Commercial Capital. Doha, QATAR - Qatar Airways has stepped up frequency on its highly-popular Doha - Shanghai route with the introduction of a fourth weekly scheduled flight. ……

Direct Digital Frequency Control Based on the Phase Step Change Characteristic between Signals

We present a new digital phase lock technology to achieve the frequency control and transformation through high precision multi-cycle group synchronization between signals without the frequency transformation circuit. In the case of digital sampling, the passing zero point of the phase of the controlled signal has the phase step characteristic, the phase step of the passing zero point is monotonic continuous with high resolution in the phase lock process, and using the border effect of digital fuzzy area, the gate can synchronize with the two signals, the quantization error is reduced. This technique is quite different from the existing methods of frequency transformation and frequency synthesis, the phase change characteristic between the periodic signals with different nominal is used. The phase change has the periodic phenomenon, and it has the high resolution step value. With the application of the physical law, the noise is reduced because of simplifying frequency transformation circuits, and the phase is locked with high precision. The regular phase change between frequency signals is only used for frequency measurement, and the change has evident randomness, but this randomness is greatly reduced in frequency control, and the certainty of the process result is clear. The experiment shows that the short term frequency stability can reach 10-12/s orders of magnitude.

Research of Hybrid Modulation Radar Signal

Based on the advantage of phase coded signal and stepped frequency signal,a new hybrid modulation signal is introduced in this paper. It combines phase code modulation during the pulse with stepped frequency modulation between the pulses, which is named as phase-coded stepped-frequency ( PCSF ) signal. By analyzing its waveform and ambiguity function,the comparison between Stepped-Frequency ( SF) signal and PCSF signal is given,which shows that the PCSF signal is better than SF signal. Finally,the signal processing method with two stage compressed processing is presented. The simulation results show that this new hybrid modulation radar signal can get a higher stepped frequency than ordinary SF signal,realize the same equivalent bandwidth with less pulse number,and solve the conflict among the stepped frequency,the number of pulse, and transmit average power. Under the premises of a certain range resolution,this new hybrid modulation radar signal not only raises the data rate of radar system,but also reduces Doppler sensitivity with a good prospect, and the effect of one-dimensional range profile is much better than that of traditional SF signal. Therefore,this new hybrid modulation radar signal can be widely used in application.

Simple PID Parameter Tuning Method Based on Outputs of the Closed Loop System

Most of the existing PID parameters tuning methods are only effective with pre-known accurate system models, which often require some strict identification experiments and thus infeasible for many complicated systems. Actually, in most practical engineering applications, it is desirable for the PID tuning scheme to be directly based on the input-output response of the closed-loop system. Thus, a new parameter tuning scheme for PID controllers without explicit mathematical model is developed in this paper. The paper begins with a new frequency domain properties analysis of the PID controller. After that, the definition of characteristic frequency for the PID controller is given in order to study the mathematical relationship between the PID parameters and the open-loop frequency properties of the controlled system. Then, the concepts of M-field and θ-field are introduced, which are then used to explain how the PID control parameters influence the closed-loop frequency-magnitude property and its time responses. Subsequently, the new PID parameter tuning scheme, i.e., a group of tuning rules, is proposed based on the preceding analysis. Finally, both simulations and experiments are conducted, and the results verify the feasibility and validity of the proposed methods. This research proposes a PID parameter tuning method based on outputs of the closed loop system.