Low cycle fatigue behavior of extruded AZ80 magnesium alloy was investigated under uniaxial tension-compression at different strain amplitudes and strain rates.The results show that the extruded AZ80 magnesium alloy e...Low cycle fatigue behavior of extruded AZ80 magnesium alloy was investigated under uniaxial tension-compression at different strain amplitudes and strain rates.The results show that the extruded AZ80 magnesium alloy exhibits cyclic hardening at strain amplitudes ranging from 0.4%to 1.0%,the asymmetry of hysteresis loops becomes increasingly obvious when the strain amplitude increases.Higher strain rates correspond to higher stress amplitudes,high mean stresses and short fatigue life.{10–12}extension twins play a role in the cyclic deformation under higher strain amplitudes(0.8%,1.0%).The relationship between total strain energy density and fatigue life can be described by the modified Morrow model.The effect of strain rate on the fatigue life can also be predicted by the model.展开更多
The low cycle fatigue （LCF） behavior of a high-strength structural steel was investigated in the strain rate range of 4×10^-6 -0.12 s^-1 （0. 001-3 Hz） under constant total strain （±1%） control. The cyc...The low cycle fatigue （LCF） behavior of a high-strength structural steel was investigated in the strain rate range of 4×10^-6 -0.12 s^-1 （0. 001-3 Hz） under constant total strain （±1%） control. The cyclic stress response at all strain rates exhibited behavior of rapid softening in the early stage of fatigue life and subsequent saturation up to failure. It was found that the stress amplitude, the plastic strain amplitude, the plastic strain energy density and the fatigue life depend mainly on the strain rate. The strain rate of 0. 012 s-1 was found as a transition point where the LCF of the steel showed different behavior from low strain rate to high strain rate. The relationship between the time to failure and strain rate was expressed well by a power law relation. The fracture surfaces of the fatigue sam-ples were characterized by using a scanning electron microscope （SEM） and the fracture mechanisms were discussed in terms of time-dependent deformation of the steel.展开更多
The ultra-fine grained(UFG)pure titanium was prepared by equal channel angular pressing(ECAP)and rotary swaging(RS).The strain controlled low cycle fatigue(LCF)test was carried out at room temperature.The fatigue life...The ultra-fine grained(UFG)pure titanium was prepared by equal channel angular pressing(ECAP)and rotary swaging(RS).The strain controlled low cycle fatigue(LCF)test was carried out at room temperature.The fatigue life prediction model and mean stress relaxation model under asymmetrical stress load were discussed.The results show that the strain ratio has a significant effect on the low cycle fatigue performance of the UFG pure titanium,and the traditional Manson-coffin model can not accurately predict the fatigue life under asymmetric stress load.Therefore,the SWT mean stress correction model and three-parameter power curve model are proposed,and the test results are verified.The final research shows that the threeparameter power surface model has better representation.By studying the mean stress relaxation phenomenon under the condition of R≠-1,it is revealed that the stress ratio and the strain amplitude are the factors that significantly afiect the mean stress relaxation rate,and the mean stress relaxation model with the two variables is calculated to describe the mean stress relaxation phenomenon of the UFG pure titanium under different strain ratios.The fracture morphology of the samples was observed by SEM,and it was concluded that the final fracture zone of the fatigue fracture of the UFG pure titanium was a mixture of ductile fracture and quasi cleavage fracture.The toughness of the material increases with the increase of strain ratio at the same strain amplitude.展开更多
基金the National Basic Research Program of China(No.2013CB632205).
文摘Low cycle fatigue behavior of extruded AZ80 magnesium alloy was investigated under uniaxial tension-compression at different strain amplitudes and strain rates.The results show that the extruded AZ80 magnesium alloy exhibits cyclic hardening at strain amplitudes ranging from 0.4%to 1.0%,the asymmetry of hysteresis loops becomes increasingly obvious when the strain amplitude increases.Higher strain rates correspond to higher stress amplitudes,high mean stresses and short fatigue life.{10–12}extension twins play a role in the cyclic deformation under higher strain amplitudes(0.8%,1.0%).The relationship between total strain energy density and fatigue life can be described by the modified Morrow model.The effect of strain rate on the fatigue life can also be predicted by the model.
基金Item Sponsored by National Natural Science Foundation of China ( 50978174 , 10925211 )
文摘The low cycle fatigue （LCF） behavior of a high-strength structural steel was investigated in the strain rate range of 4×10^-6 -0.12 s^-1 （0. 001-3 Hz） under constant total strain （±1%） control. The cyclic stress response at all strain rates exhibited behavior of rapid softening in the early stage of fatigue life and subsequent saturation up to failure. It was found that the stress amplitude, the plastic strain amplitude, the plastic strain energy density and the fatigue life depend mainly on the strain rate. The strain rate of 0. 012 s-1 was found as a transition point where the LCF of the steel showed different behavior from low strain rate to high strain rate. The relationship between the time to failure and strain rate was expressed well by a power law relation. The fracture surfaces of the fatigue sam-ples were characterized by using a scanning electron microscope （SEM） and the fracture mechanisms were discussed in terms of time-dependent deformation of the steel.
基金Funded by National Natural Science Foundation of China(No.51474170)the Key Laboratory Project of Shaanxi Provincial Department of Education(No.20js075)。
文摘The ultra-fine grained(UFG)pure titanium was prepared by equal channel angular pressing(ECAP)and rotary swaging(RS).The strain controlled low cycle fatigue(LCF)test was carried out at room temperature.The fatigue life prediction model and mean stress relaxation model under asymmetrical stress load were discussed.The results show that the strain ratio has a significant effect on the low cycle fatigue performance of the UFG pure titanium,and the traditional Manson-coffin model can not accurately predict the fatigue life under asymmetric stress load.Therefore,the SWT mean stress correction model and three-parameter power curve model are proposed,and the test results are verified.The final research shows that the threeparameter power surface model has better representation.By studying the mean stress relaxation phenomenon under the condition of R≠-1,it is revealed that the stress ratio and the strain amplitude are the factors that significantly afiect the mean stress relaxation rate,and the mean stress relaxation model with the two variables is calculated to describe the mean stress relaxation phenomenon of the UFG pure titanium under different strain ratios.The fracture morphology of the samples was observed by SEM,and it was concluded that the final fracture zone of the fatigue fracture of the UFG pure titanium was a mixture of ductile fracture and quasi cleavage fracture.The toughness of the material increases with the increase of strain ratio at the same strain amplitude.
