Influencing factor of sinter body strength and its effects on iron ore sintering indexes

Sinter body strength, which reflects the strength of sinter, plays an important role in the improvement of sinter. In this study, the sinter body strengths of iron ores were measured using a microsintering method. The relationship between the chemical composition and sinter body strength was discussed. Moreover, sinter-pot tests were performed. The effects of sinter body strength on the sintering indexes were then elucidated, and the bottom limit of sinter body strength of blending ores was confirmed. In the results, the compressive strengths（CSs） of iron ores are observed to decrease with the increasing of the contents of loss on ignition（LOI）, SiO 2, and Al2O3; however, LOI of less than 3wt% does not substantially influence the CSs of fine ores. In the case of similar mineral composition, the porosity, in particular, the ratio between the number of large pores and the total number of pores, strongly influences the sinter body strength. With an increase of the blending-ore CSs used in sinter-pot tests, the yield, productivity, and tumbler strength increase, and the solid fuel consumption decreases. The CSs of the blending ores only slightly affect the sintering time. The CS bottom limit of the blending ores is 310 N. When the CSs of the blending ores increase by 10%, the yield, productivity, and tumbler index increase by 1.9%, 2.8%, and 2.0%, respectively, and the solid fuel consumption decreases by 1.9%.

Analysis of the influencing factors of PAEs volatilization from typical plastic products

The primary emphasis of this research was to investigate the foundations of phthalate（PAEs） pollutant source researches and then firstly confirmed the concept of the coefficient of volatile strength, namely phthalate total content in per unit mass and unit surface area of pollutant sources. Through surveying and evaluating the coefficient of volatile strength of PAEs from typical plastic products, this research carried out reasonable classification of PAEs pollutant sources into three categories and then investigated the relationship amongst the coefficient of volatile strength as well as other environmental factors and the concentration level of total PAEs in indoor air measured in environment chambers.Research obtained phthalate concentration results under different temperature, humidity,the coefficient of volatile strength and the closed time through the chamber experiment. In addition, this study further explored the correlation and ratio of influencing factors that affect the concentration level of total PAEs in environment chambers, including environmental factors, the coefficient of volatile strengths of PAEs and contents of total PAEs in plastic products. The research created an improved database system of phthalate the coefficient of volatile strengths of each type of plastic goods, and tentatively revealed that the volatile patterns of PAEs from different typical plastic goods, finally confirmed that the coefficient of volatile strengths of PAEs is a major factor that affects the indoor air total PAEs concentration, which laid a solid foundation for further establishing the volatile equation of PAEs from plastic products.

ANCHORING EFFECT ANALYSIS OF TENSIONED BOLTS

The paper analyses quantitatively the anchoring effect of tensioned bolts on surrounding rock strength, and defines two concepts: one is the surrounding rock strength increased amount Δτ13 and the other is the strength influence factor k. The anchoring effect of tensioned bolts is considered to increase a strength increased amount Δτ13 where Δτ13 is the product k and ten-sioned load p, i. e. Δτ13 = kp, where k is a function of two variables x and y. The distribu-tive properties both Δτ13 and k are also discussed in the paper, obtaining some useful results for designing bolting support parameters.