The formation and distribution of fractures are controlled by paleotectonic stress field, and their preservative status and effects on development are dominated by the modern stress field. Since Triassic, it has exper...The formation and distribution of fractures are controlled by paleotectonic stress field, and their preservative status and effects on development are dominated by the modern stress field. Since Triassic, it has experienced four tectonic movements and developed four sets of tectonic fractures in the extra low-permeability sandstone reservoir at the south of western Sichuan depression. The strikes of fractures are in the S-N, NE-SW, E-W, and NW-SE directions respectively. At the end of Triassic, under the horizontal compression tectonic stress field, for which the maximum principal stress direction was NW.SE, the fractures were well developed near the S-N faults and at the end of NE-SW faults, because of their stress concentration. At the end of Cretaceous, in the horizontal compression stress fields of the NE-SW direction, the stress was obviously lower near the NE-SW faults, thus, fractures mainly developed near the S-N faults. At the end of Neogene-Early Pleistocene, under the horizontal compression tectonic stress fields of E-W direction, stress concentrated near the NE-SW faults and fractures developed at these places, especially at the end of the NE-SE faults, the cross positions of NE-SW, and S-N faults. Therefore, fractures developed mostly near S-N faults and NE-SW faults. At the cross positions of the above two sets of faults, the degree of development of the fractures was the highest. Under the modern stress field of the NW-SE direction, the NW-SE fractures were mainly the seepage ones with tensional state, the best connectivity, the widest aperture, the highest permeability, and the minimum opening pressure.展开更多
Inter-crystalline pores, cavities, and fractures created from diagenetic shrinkage of dolomite are inter-connected each other, forming fine oil- and gas-bearing reservoirs. It is hard to predict these complex fracture...Inter-crystalline pores, cavities, and fractures created from diagenetic shrinkage of dolomite are inter-connected each other, forming fine oil- and gas-bearing reservoirs. It is hard to predict these complex fracture-cavity reservoirs because of their random distribution, different growth timing, and so on. Taking the lacustrine dolomite fracture-pore reservoir in the Lower Cretaceous Xiagou Formation in the Qingxi oilfield within the Jiuquan basin as an example, we put forward a comprehensive geophysical method to predict carbonate fractures.展开更多
Fracture prediction is a technical issue in the field of petroleum exploration and production worldwide.Although there are many approaches to predict the distribution of cracks underground,these approaches have some l...Fracture prediction is a technical issue in the field of petroleum exploration and production worldwide.Although there are many approaches to predict the distribution of cracks underground,these approaches have some limitations.To resolve these issues,we ascertained the relation between numerical simulations of tectonic stress and the predicted distribution of fractures from the perspective of geologic genesis,based on the characteristics of the shale reservoir in the Longmaxi Formation in Dingshan;the features of fracture development in this reservoir were considered.3 D finite element method(FEM)was applied in combination with rock mechanical parameters derived from the acoustic emissions.The paleotectonic stress field of the crack formation period was simulated for the Longmaxi Formation in the Dingshan area.The splitting factor in the study area was calculated based on the rock breaking criterion.The coefficient of fracture development was selected as the quantitative prediction classification criteria for the cracks.The results show that a higher coefficient of fracture development indicates a greater degree of fracture development.On the basis of the fracture development coefficient classification,a favorable area was identified for the development of fracture prediction in the study area.The prediction results indicate that the south of the Dingshan area and the DY3 well of the central region are favorable zones for fracture development.展开更多
This study presents an avant-garde approach for predicting and optimizing production in tight reservoirs,employing a dual-medium unsteady seepage model specifically fashioned for volumetrically fractured horizontal we...This study presents an avant-garde approach for predicting and optimizing production in tight reservoirs,employing a dual-medium unsteady seepage model specifically fashioned for volumetrically fractured horizontal wells.Traditional models often fail to fully capture the complex dynamics associated with these unconventional reservoirs.In a significant departure from these models,our approach incorporates an initiation pressure gradient and a discrete fracture seepage network,providing a more realistic representation of the seepage process.The model also integrates an enhanced fluid-solid interaction,which allows for a more comprehensive understanding of the fluid-structure interactions in the reservoir.This is achieved through the incorporation of improved permeability and stress coupling,leading to more precise predictions of reservoir behavior.The numerical solutions derived from the model are obtained through the sophisticated finite element method,ensuring high accuracy and computational efficiency.To ensure the model’s reliability and accuracy,the outcomes were tested against a real-world case,with results demonstrating strong alignment.A key revelation from the study is the significant difference between uncoupled and fully coupled volumetrically fractured horizontal wells,challenging conventional wisdom in the field.Additionally,the study delves into the effects of stress,fracture length,and fracture number on reservoir production,contributing valuable insights for the design and optimization of tight reservoirs.The findings from this study have the potential to revolutionize the field of tight reservoir prediction and management,offering significant advancements in petroleum engineering.The proposed approach brings forth a more nuanced understanding of tight reservoir systems and opens up new avenues for optimizing reservoir management and production.展开更多
According to the geological characteristics and their influential factors of the low-permeability reservoirs, a comprehensive method for evaluation of low-permeability reservoirs is put forward. The method takes a mat...According to the geological characteristics and their influential factors of the low-permeability reservoirs, a comprehensive method for evaluation of low-permeability reservoirs is put forward. The method takes a matrix system as the basis, a fracture system as the focus and a stress field system as the restricted factor. It can objectively reflect not only the storage capability and seepage capability of low-permeability reservoirs, but also the effect on development as well. At the same time, it can predict the seepage characteristics at different development stages and provide a reasonable geological basis for the development of low-permeability reservoirs.展开更多
基金This paper is financially supported by the National Natural Science Foundation of China (No. 40572080)the China National Petroleum Corporation (CNPC) Petroleum Science and Technology Innovation Foundation (No.05E7026)
文摘The formation and distribution of fractures are controlled by paleotectonic stress field, and their preservative status and effects on development are dominated by the modern stress field. Since Triassic, it has experienced four tectonic movements and developed four sets of tectonic fractures in the extra low-permeability sandstone reservoir at the south of western Sichuan depression. The strikes of fractures are in the S-N, NE-SW, E-W, and NW-SE directions respectively. At the end of Triassic, under the horizontal compression tectonic stress field, for which the maximum principal stress direction was NW.SE, the fractures were well developed near the S-N faults and at the end of NE-SW faults, because of their stress concentration. At the end of Cretaceous, in the horizontal compression stress fields of the NE-SW direction, the stress was obviously lower near the NE-SW faults, thus, fractures mainly developed near the S-N faults. At the end of Neogene-Early Pleistocene, under the horizontal compression tectonic stress fields of E-W direction, stress concentrated near the NE-SW faults and fractures developed at these places, especially at the end of the NE-SE faults, the cross positions of NE-SW, and S-N faults. Therefore, fractures developed mostly near S-N faults and NE-SW faults. At the cross positions of the above two sets of faults, the degree of development of the fractures was the highest. Under the modern stress field of the NW-SE direction, the NW-SE fractures were mainly the seepage ones with tensional state, the best connectivity, the widest aperture, the highest permeability, and the minimum opening pressure.
文摘Inter-crystalline pores, cavities, and fractures created from diagenetic shrinkage of dolomite are inter-connected each other, forming fine oil- and gas-bearing reservoirs. It is hard to predict these complex fracture-cavity reservoirs because of their random distribution, different growth timing, and so on. Taking the lacustrine dolomite fracture-pore reservoir in the Lower Cretaceous Xiagou Formation in the Qingxi oilfield within the Jiuquan basin as an example, we put forward a comprehensive geophysical method to predict carbonate fractures.
基金supported by the Open Fund (PLN 201718) of State Key Laboratory of Oil and Gas Reservoir Geology and ExploitationSouthwest Petroleum University and the Open Fund (SEC-2018-04) of Collaborative Innovation Center of Shale Gas Resources and EnvironmentSouthwest Petroleum University and the National Science and Technology Major Project of China (2017ZX05036003-003)
文摘Fracture prediction is a technical issue in the field of petroleum exploration and production worldwide.Although there are many approaches to predict the distribution of cracks underground,these approaches have some limitations.To resolve these issues,we ascertained the relation between numerical simulations of tectonic stress and the predicted distribution of fractures from the perspective of geologic genesis,based on the characteristics of the shale reservoir in the Longmaxi Formation in Dingshan;the features of fracture development in this reservoir were considered.3 D finite element method(FEM)was applied in combination with rock mechanical parameters derived from the acoustic emissions.The paleotectonic stress field of the crack formation period was simulated for the Longmaxi Formation in the Dingshan area.The splitting factor in the study area was calculated based on the rock breaking criterion.The coefficient of fracture development was selected as the quantitative prediction classification criteria for the cracks.The results show that a higher coefficient of fracture development indicates a greater degree of fracture development.On the basis of the fracture development coefficient classification,a favorable area was identified for the development of fracture prediction in the study area.The prediction results indicate that the south of the Dingshan area and the DY3 well of the central region are favorable zones for fracture development.
文摘This study presents an avant-garde approach for predicting and optimizing production in tight reservoirs,employing a dual-medium unsteady seepage model specifically fashioned for volumetrically fractured horizontal wells.Traditional models often fail to fully capture the complex dynamics associated with these unconventional reservoirs.In a significant departure from these models,our approach incorporates an initiation pressure gradient and a discrete fracture seepage network,providing a more realistic representation of the seepage process.The model also integrates an enhanced fluid-solid interaction,which allows for a more comprehensive understanding of the fluid-structure interactions in the reservoir.This is achieved through the incorporation of improved permeability and stress coupling,leading to more precise predictions of reservoir behavior.The numerical solutions derived from the model are obtained through the sophisticated finite element method,ensuring high accuracy and computational efficiency.To ensure the model’s reliability and accuracy,the outcomes were tested against a real-world case,with results demonstrating strong alignment.A key revelation from the study is the significant difference between uncoupled and fully coupled volumetrically fractured horizontal wells,challenging conventional wisdom in the field.Additionally,the study delves into the effects of stress,fracture length,and fracture number on reservoir production,contributing valuable insights for the design and optimization of tight reservoirs.The findings from this study have the potential to revolutionize the field of tight reservoir prediction and management,offering significant advancements in petroleum engineering.The proposed approach brings forth a more nuanced understanding of tight reservoir systems and opens up new avenues for optimizing reservoir management and production.
文摘According to the geological characteristics and their influential factors of the low-permeability reservoirs, a comprehensive method for evaluation of low-permeability reservoirs is put forward. The method takes a matrix system as the basis, a fracture system as the focus and a stress field system as the restricted factor. It can objectively reflect not only the storage capability and seepage capability of low-permeability reservoirs, but also the effect on development as well. At the same time, it can predict the seepage characteristics at different development stages and provide a reasonable geological basis for the development of low-permeability reservoirs.
