Development and Performance Evaluation of a Deep Water Synthetic Based Drilling Fluid System

With the enhancement of environmental protection awareness, the requirements on drilling fluid are increasingly strict, and the use of ordinary oil-based drilling fluid has been strictly restricted. In order to solve the environmental protection and oil-gas reservoir protection problems of offshore oil drilling, a new synthetic basic drilling fluid system is developed. The basic formula is as follows: a basic fluid (80% Linear a-olefin + 20% Simulated seawater) + 2.5% nano organobentonite + 3.5% emulsifier RHJ-5# + 2.5% fluid loss agent SDJ-1 + 1.5% CaO + the right amount of oil wetting barite to adjust the density, and a multifunctional oil and gas formation protective agent YRZ has been developed. The performance was evaluated using a high-low-high-temperature rheometer, a high-temperature and high-pressure demulsification voltage tester, and a high-temperature and high-pressure dynamic fluid loss meter. The results show that the developed synthetic based drilling fluid has good rheological property, demulsification voltage ≥ 500 V, temperature resistance up to 160°C, high temperature and high pressure filtration loss < 3.5 mL. After adding 2% - 5% YRZ into the basic formula of synthetic based drilling fluid, the permeability recovery value exceeds 90% and the reservoir protection effect is excellent. The new synthetic deepwater drilling fluid is expected to have a good application prospect in offshore deepwater drilling.

Thermal oxidation of two aviation synthetic lubricant base oils

The thermal degradation of two synthetic lubricants base oils, poly-a-olefins （PAO） and di-esters （DE）, was investigated under oxidative pyrolysis condition and their properties were characterized in simulated ＂areo-engine＂ by comparing the thermal stability and identifying the products of thermal decomposition as a function of exposure temperature. The characterization of the products were performed by means of Fourier transform infrared spectrometry （FTIR）, gas chromatography/mass spectrometry （GC/MS） and viscosity experiments. The results show that PAO has the lower thermal stability, being degraded at 200℃ different from 300 ℃ for DE. Several by-products are identified during the thermal degradation of two lubricant base oils. The majority of PAO products consist of alkenes and olefins, while more oxygen-contained organic compounds are detected in DE samples based on GC/MS analysis. The related reaction mechanisms are discussed based on the experimental results.

Application of Cationic Waterborne Polyurethane as Impregnation Material for Microfiber Synthetic Leather Base

A cationic waterborne polyurethane(CWPU) was synthesized and utilized as impregnation material for manufacturing microfiber synthetic leather base,in an attempt to decrease environmental pollution associated with organic solvents and improve simulation degree relative to genuine leather.The alkali resistance of the CWPU and four manufacture methods were investigated.Meanwhile,the dyeing properties of the microfiber synthetic leather base were studied.It was found that the CWPU displayed enough alkali resistance to endure the alkali deweighting process for microfiber synthetic leather base manufacture.In terms of bending length,bending rigidity,compression elasticity ratio and specific compression elasticity ratio of the resulting base,coagulating the impregnated CWPU with sodium hydroxide before steam treatment was the optimal method.The extent of fiber splitting and the handle of the base from this method were both similar to conventional base filled with solvent-based polyurethane(SPU).The dyeing properties of the microfiber synthetic leather base filled with CWPU were also found superior to the one filled with either anionic waterborne polyurethane(AWPU) or SPU.

Mechanism Study of BF_(3)/n-Butanol-catalyzed 1-Decene Oligomerization Reaction

The active catalysts of the BF_(3)/n-C_(4)H_(9)OH-catalyzed 1-decene oligomerization reaction,as well as the distribution of the reaction products,was investigated by molecular simulation.The calculation results show that(BF_(3))_(2)·n-C_(4)H_(9)OH catalyzes the 1-decene oligomerization reaction with higher activity compared to BF_(3)·n-C_(4)H_(9)OH,which is the most catalytically active substance in the BF_(3)/n-C_(4)H_(9)OH catalyst system.The reaction energy barriers and heats of reaction of chain initiation,chain growth,and chain termination in BF_(3)/n-C_(4)H_(9)OH-catalyzed 1-decene oligomerization are calculated to reveal the product distribution.The calculation results show that the contents of the oligomerization reaction products in descending order are trimer,tetramer,pentamer,and dimer.The calculated results were consistent with the experimentally obtained product distribution.

Grating lobes suppression method for stepped frequency GB-SAR system

A grating lobes suppression method for chirp-subpulse stepped frequency（CSSF） signals is proposed, which is applied to deformation monitoring using the ground based synthetic aperture radar（GB-SAR） system. This method is based on accurate estimation and correction of the phase and amplitude error along two dimensions（range and azimuth）, i.e., the error estimation inside the subpulse（in-subpulse error） and across the stepped frequency subpulses（cross-subpulse error） of transmitted CSSF signals. Validated both with simulated data and experimental data recorded in the deformation monitoring campaign, it can be seen that the method as well as the relative conclusions can be fully and effectively applied to most of the stepped frequency systems.

Synthetic aperture sonar movement compensation algorithm based on time-delay and phase estimation

The effects of movement errors on imaging results of synthetic aperture sonar and the necessity of movement compensation are discussed. Based on analyzing so-called displaced phase center algorithm, an improved algorithm is proposed. In this method, the time delay is estimated firstly, then the phase is estimated for the residual error, so that the range of movement error suited to the algorithm is extended to some extent. Some simulation results on computer and experimental results in the test tank using the proposed algorithm are given as well.

Compressed sensing in synthetic aperture photoacoustic tomography based on a linear-array ultrasound transducer

Photoacoustic tomography（PAT） has the unique capability of visualizing optical absorption inside several centimeters-deep biological tissue with a high spatial resolution. However, single linear-array transducer-based PAT suffers from the limited-view challenge, and thus the synthetic aperture configuration is designed that still requires multichannel data acquisition hardware. Herein, a feasible synthetic aperture PAT based on compressed sensing reconstruction is proposed. Both the simulation and experimental results tested the theoretical model and validated that this approach can improve the image resolution and address the limited-view problem while preserving the target information with a fewer number of measurements.

A new digital information storing and reading system based on synthetic DNA

Dear Editor,In the＂big data era＂,the amount of digital information is growing explosively,therefore,a reliable data storage medium for large-scale digital archiving is urgently needed.However,the increase of existing storage capacity cannot keep up with the growth of digital information.Moreover,the durability of conventional storage teclanologles, sucn as magnetic and optical devices, is very limited. Since the first demonstration of using DNA to store messages in 1988, DNA has been considered as a promising data storage medium due to its high-density and long-term stability （half-life〉500years） （Allentoft et al., 2012）.

Elastohydrodynamic lubrication properties and friction behaviors of several ester base stocks

This paper reports a series of studies on the lubricant properties,elastohydrodynamic film thickness,and coefficients of friction of several commercially available ester base stocks,i.e.,diisooctyl phthalate(DIOP),diisodecyl phthalate(DIDP),diisotridecyl phthalate(DITDP),diisooctyl sebacate(DOS),diisotridecyl sebacate(DTDS),trihydroxymethylpropyl trioleate(TMPTO),and pentaerythritol tetraoleate(PETO).The results include densities and viscosities from 303 to 398 K,and elastohydrodynamic lubricant film thicknesses and friction in the boundary,mixed and full-film lubrication regimes measured at several temperatures,loads,and speeds.These ester base stocks have different lubrication abilities owing to their chain lengths,geometric configurations,and molecular rigidity.This study provides quantitative insight into the use of ester-based lubricants for low friction through the entire lubrication regime(boundary to full film)by utilization of suitable type and size of the ester base stocks.