Effect of Trace Sc and Zr on the Mechanical Properties and Microstructure of A1 Alloy 2618

An experimental 2618(Al-Cu-Mg-Fe-Ni) alloy added with trace Sc and Zr was prepared by ingot metallurgy (IM) method. The aging behavior of the alloy was studied by Vickers hardness measurement at 200℃ and 300℃. and the tensile properties of alloy specimens were measured at 20℃, 200℃, 250℃ and 300℃. The microstructure was observed by using optical microscope, SEM and TEM. It was found that the addition of Sc and Zr to 2618 alloy resulted in a primary Al_3(Sc,Zr) phase which could refine the grain because it acts as nuclei of heterogeneous crystallization in the melt during solidification. The secondary Al_3(Sc,Zr) particles were full coherent with matrix and had obvious precipitation hardening effect. They also made the S' phase precipitate more homogeneous. So the strength of alloy increases at both ambient and elevated temperatures without a decrease of ductility. The ductile fracture of alloy occurs by microvoid nucleation, growth and coalescence, so the microvoid coalescence is the dominant fracture mechanism.

Editorial: Special subject on the mechanical behavior of thermal protection materials and structures

The thermal protection materials and structures are widely used in hypersonic vehicles for the purpose of thermal insulation, and their mechanical behavior is one of the key issues in design and manufacture of hypersonic vehicles. It is our great pleasure to present the seven papers in this special subject of Theoretical ＆ Applied Mechanics Letters （TAML） and introduce the recent progresses on the mechanical behavior of thermal protection materials and structures by the authors.

Effect of Mineral Oil on the Mechanical Properties and Fractographs of Fe_3(Al,Cr,Zr) Intermetallic Alloy

The effect of mineral oil on the mechanical properties and fractographs of Fe3(Al,Cr,Zr) in termetallic alloy has been investigated. The results show that the tensile ductility of the Fe3(Al,Cr,Zr) alloy tested in oil is comparable with the results obtained in oxygen and is in sensitive to strain rate. The fracture mode of the Fe3(Al,Cr,Zr) alloy treated at 700℃/1.5 h and tested in oil, is cleavage and with dimples in some areas.

Editorial: Special subject on the mechanical behavior of fire dynamics in high-rise buildings

With rapid economic and social development in China, high-rise buildings have continuously sprung up since 2006. However, several big fire accidents in high-rise buildings such as the Beijing Television Cultural Center fire in 2009 and the Shanghai Jing＇an District fire in 2010 etc. have claimed people＇s lives and caused huge amounts of economic and property losses,

The mechanical response of multi-tower continuous-span suspension bridge deck pavement based on whole bridge analysis

The effect of multiple span suspension structure on the mechanical response of bridge deck pavement was studied, and finite element analysis (FEM) of stress and strain of pavement according to the bridge floor system features of super-long and high flexibility was made. Meanwhile, the FEM results were compared with those of the single span suspension structure. Three-stage analytic hierarchy process (AHP) is developed to analyze the mechanical response including whole bridge analysis, partial beams section analysis and orthotropic plate analysis. The most unfavorable load position was determined by the numerical solutions acquired from each stage to study the main mechanical index of multiple span suspension structure. The FEM results showed that the mechanical response numerical solutions by using the three-stage AHP are greater than those by simplified boundary condition, and the force condition of multiple span suspension structure is worse than that of the single span suspension structure.

To improve the mechanical function of bovine jugular vein by external stent

Objective To increase the mechanic characteristic of bovine jugular veins conduit (BJVC) by combined knitted stent outside made of nylon fiber. Methods Got rid of the cells of BJVC by enzymolysis,then combined a fabric stent with a acellular bovine jugular vein

The Study on the Mechanical Properties of Optical Fiber With Long-Term Time Aging

The fiber properties depending on the coating thickness and long-term time aging were investigated. The coating strip forces of optical fiber were strongly increased with secondary coating thickness. But it did not change with time aging up to 90 days. The tensile strength and stress corrosion parameters of coated fiber were increased with time aging also but the increasing rate was quite different depending on the coating

Effects of Strain Rate,Temperature and Grain Size on the Mechanical Properties and Microstructure Evolutions of Polycrystalline Nickel Nanowires:A Molecular Dynamics Simulation

Through molecular dynamics（MD） simulation, the dependencies of temperature, grain size and strain rate on the mechanical properties were studied. The simulation results demonstrated that the strain rate from 0.05 to 2 ns–1 affected the Young＇s modulus of nickel nanowires slightly, whereas the yield stress increased. The Young＇s modulus decreased approximately linearly; however, the yield stress firstly increased and subsequently dropped as the temperature increased. The Young＇s modulus and yield stress increased as the mean grain size increased from 2.66 to 6.72 nm. Moreover, certain efforts have been made in the microstructure evolution with mechanical properties association under uniaxial tension. Certain phenomena such as the formation of twin structures, which were found in nanowires with larger grain size at higher strain rate and lower temperature, as well as the movement of grain boundaries and dislocation, were detected and discussed in detail. The results demonstrated that the plastic deformation was mainly accommodated by the motion of grain boundaries for smaller grain size. However, for larger grain size, the formations of stacking faults and twins were the main mechanisms of plastic deformation in the polycrystalline nickel nanowire.

AN EXPERIMENTAL SIMULATION ON THE MECHANICAL EFFECT OF TIBETAN PLATEAU ON ZONAL CIRCULATION OF STRATIFIED ATMOSPHERE

The present work is intended to simulate, in a rotating annulus of stratified liquid, the me-chanical effect of the Xizang (Tibetan) Plateau on the zonal circulation. The main featuresof three flow patterns around the plateau for different Rossby number R and rotating Eulernumber E are analysed. and a division diagram of the flow pattern in (R, E) plane is given.It has been found that under the condition that similarity criterions R and E of the experimentalfluid are the same as those existing in the atmosphere for monthly mean states in spring, au-tumn and winter months, the experimental results are satisfied for the following weathersystems over the plateau and its vicinities: the low vortex, trough and shear line over thesoutheast part of the plateau, the tilted ridge over the northwest part of the plateau, the troughpatterns over the upstream and dewnstream of the plateau, the vertical circulation structure, thejets on both north and southeast sides of the plateau, and so on. This shows that the mechanicaleffect of the Tibetan Plateau on the general circulation over East Asia deserves close atten-tion.

Ehrenfest Approach to the Adiabatic Invariants and Calculation of the Intervals of Time Entering the Energy Emission Process in Simple Quantum Systems

In the first step, the Ehrenfest reasoning concerning the adiabatic invariance of the angular orbital momentum is applied to the electron motion in the hydrogen atom. It is demonstrated that the time of the energy emission from the quantum level n+1 to level n can be deduced from the orbital angular momentum examined in the hydrogen atom. This time is found precisely equal to the time interval dictated by the Joule-Lenz law governing the electron transition between the levels n+1 and n. In the next step, the mechanical parameters entering the quantum systems are applied in calculating the time intervals characteristic for the electron transitions. This concerns the neighbouring energy levels in the hydrogen atom as well as the Landau levels in the electron gas submitted to the action of a constant magnetic field.