According to statistics, the average dust collection efficiency of flue gas emission in the large and medium- sized power plants in Zhejiang Province at present has attained higher than 97% which surpasses the 95% sta...According to statistics, the average dust collection efficiency of flue gas emission in the large and medium- sized power plants in Zhejiang Province at present has attained higher than 97% which surpasses the 95% standard as stipulated by the Ministry of Electric Power. The dust collection efficiency of the Beilungang Power Plant has already attained 99.92%. In recent years, Zhejiang Electric Power Corporation has stipulated that all the newly constructed generating units shall be equipped with high efficiency electrostatic precipitator (ESP) while the existing power plants shall speed up their renovation work for their dust collectors. In combination with the fourth stage project of the Taizhou Power Plant, the improvement work of the dust展开更多
Coal consumption curve of the thermal power plant can reflect the function relationship between the coal consumption of unit and load, which plays a key role for research on unit economic operation and load optimal di...Coal consumption curve of the thermal power plant can reflect the function relationship between the coal consumption of unit and load, which plays a key role for research on unit economic operation and load optimal dispatch. Now get coal consumption curve is generally obtained by least square method, but which are static curve and these curves remain unchanged for a long time, and make them are incompatible with the actual operation situation of the unit. Furthermore, coal consumption has the characteristics of typical nonlinear and time varying, sometimes the least square method does not work for nonlinear complex problems. For these problems, a method of coal consumption curve fitting of the thermal power plant units based on genetic algorithm is proposed. The residual analysis method is used for data detection;quadratic function is employed to the objective function;appropriate parameters such as initial population size, crossover rate and mutation rate are set;the unit’s actual coal consumption curves are fitted, and comparing the proposed method with least squares method, the results indicate that fitting effect of the former is better than the latter, and further indicate that the proposed method to do curve fitting can best approximate known data in a certain significance, and they can real-timely reflect the interdependence between power output and coal consumption.展开更多
DD （Dust deposition） was monitored over a 6-month period （April to September, 2011） at four sites located in villages near CADDⅡ（coal ash disposal site Divkovici Ⅱ）, one inside recultivated CADDⅠ （coal ash d...DD （Dust deposition） was monitored over a 6-month period （April to September, 2011） at four sites located in villages near CADDⅡ（coal ash disposal site Divkovici Ⅱ）, one inside recultivated CADDⅠ （coal ash disposal site Divkovici Ⅰ） and at one in the middle of forest barrier as control site. The main aim of this paper is to perform monitoring of air dust pollution in the area by measuring of dust deposition, different metals associated with it, and probable adverse effects on human health. Concentrations of metals were measured by using Perkin-Elmer model Inductively Coupled Plasma and statistically evaluated with SPSS 17.0 statistical program. There was a correlation between some metals （Mn, Mo and Pb） and DD distribution. The daily limit values for concentration of DD proposed by national ＂Regulations on air quality＂ （200 mg/m^2d average annual value and 350 mg/m^2d high value） exceed at three measuring sites. The average maximum content of DD was 684.8 mg/m^2d downwind of CADDII, and the average minimum was 46.8 mg/m^2d at measuring site F. Concentrations of pollutants hazardous to the environment as Ni, Cr, Cu, Mo, Mn and Pb vary from one site to another.展开更多
In this paper, the mechanical and thermal properties of a sand-clay ceramic with additives coal bottom ash (CBA) waste from incinerator coal power plant are investigated to develop an alternative material for thermal ...In this paper, the mechanical and thermal properties of a sand-clay ceramic with additives coal bottom ash (CBA) waste from incinerator coal power plant are investigated to develop an alternative material for thermal energy storage (TES). Ceramic balls are developed at 1000°C and 1060°C using sintering or firing method. The obtained ceramics were compressed with a compression machine and thermally analyse using Decagon devise KD2 Pro thermal analyser. A muffle furnace was also used for thermal cycling at 610°C. It was found that the CBA increased the porosity, which resulted in the increase of the axial tensile strength reaching 3.5 MPa for sand-clay and ash ceramic. The ceramic balls with the required tensile strength for TES were selected. Their volumetric heat capacity, and thermal conductivity range respectively from 2.4075 MJ·m-3·°C-1 to 3.426 MJ·m-3·°C-1 and their thermal conductivity from 0.331 Wm-1·K-1, to 1.014 Wm-1·K-1 depending on sand origin, size and firing temperature. The selected formulas have good thermal stability because the most fragile specimens after 60 thermal cycles did not present any cracks. These properties allow envisioning the use of the ceramic balls developed as filler material for thermocline thermal energy storage (structured beds) in Concentrating Solar Power plants. And for other applications like solar cooker and solar dryer.展开更多
“双碳目标”背景下,煤电机组将长期作为主力调峰电源,保障电网安全稳定。储热是提升煤电机组灵活性的重要手段,但煤电耦合储热系统的运行特性尚不明确,不同储热技术与煤电机组耦合适应性亟待研究。为此,该文构建600 MW煤电-90 MW显热/...“双碳目标”背景下,煤电机组将长期作为主力调峰电源,保障电网安全稳定。储热是提升煤电机组灵活性的重要手段,但煤电耦合储热系统的运行特性尚不明确,不同储热技术与煤电机组耦合适应性亟待研究。为此,该文构建600 MW煤电-90 MW显热/潜热/热化学储热3种耦合系统,详细考察系统储/释热过程调峰能力及热力学性能,并基于优劣解距离法(technique for order preference by similarity to an ideal solution,TOPSIS)综合评价,明确最优耦合方案。研究发现,储热过程,Ca(OH)_(2)/CaO热化学储热的调峰容量、调峰深度及?效率均优于热水及熔融盐储热,而释热过程熔融盐储热性能最优;通过TOPSIS综合评价法确定热储热方案均为抽取主蒸汽作为热源,最佳释热方案均为以#2高加进水为冷源,同时确定煤电耦合熔融盐储热为最佳系统耦合方案。相关研究结论可为构建煤电耦合储热调峰系统提供一定的理论和数据支撑。展开更多
In India coal combustion is the single largest source of emission of mercury which is a widespread persistent global toxicant,travelling across international borders through air and water.As a party to the Minamata co...In India coal combustion is the single largest source of emission of mercury which is a widespread persistent global toxicant,travelling across international borders through air and water.As a party to the Minamata convention,India aims to monitor and reduce Hg emissions and stricter norms are introduced for mercury emissions from power plants(30μg/Nm 3 for flue gas in stack).This paper presents the results obtained during the experimental studies performed on mercury emissions at four coal-fired and one lignite-fired power plants in India.The mercury concentration in the feed coal varied between 0.12-0.27 mg/Kg.In the mercury mass balance,significant proportion of feed coal mercury has been found to be associated with fly ash,whereas bottom ash contained very low mercury.80%-90%of mercury was released to air through stack gas.However,for circulating fluidised bed boiler burning lignite,about 64.8%of feed mercury was found to get captured in the fly ash and only 32.4%was released to air.The mercury emission factor was found to lie in the range of 4.7-15.7 mg/GJ.展开更多
文摘According to statistics, the average dust collection efficiency of flue gas emission in the large and medium- sized power plants in Zhejiang Province at present has attained higher than 97% which surpasses the 95% standard as stipulated by the Ministry of Electric Power. The dust collection efficiency of the Beilungang Power Plant has already attained 99.92%. In recent years, Zhejiang Electric Power Corporation has stipulated that all the newly constructed generating units shall be equipped with high efficiency electrostatic precipitator (ESP) while the existing power plants shall speed up their renovation work for their dust collectors. In combination with the fourth stage project of the Taizhou Power Plant, the improvement work of the dust
文摘Coal consumption curve of the thermal power plant can reflect the function relationship between the coal consumption of unit and load, which plays a key role for research on unit economic operation and load optimal dispatch. Now get coal consumption curve is generally obtained by least square method, but which are static curve and these curves remain unchanged for a long time, and make them are incompatible with the actual operation situation of the unit. Furthermore, coal consumption has the characteristics of typical nonlinear and time varying, sometimes the least square method does not work for nonlinear complex problems. For these problems, a method of coal consumption curve fitting of the thermal power plant units based on genetic algorithm is proposed. The residual analysis method is used for data detection;quadratic function is employed to the objective function;appropriate parameters such as initial population size, crossover rate and mutation rate are set;the unit’s actual coal consumption curves are fitted, and comparing the proposed method with least squares method, the results indicate that fitting effect of the former is better than the latter, and further indicate that the proposed method to do curve fitting can best approximate known data in a certain significance, and they can real-timely reflect the interdependence between power output and coal consumption.
文摘DD （Dust deposition） was monitored over a 6-month period （April to September, 2011） at four sites located in villages near CADDⅡ（coal ash disposal site Divkovici Ⅱ）, one inside recultivated CADDⅠ （coal ash disposal site Divkovici Ⅰ） and at one in the middle of forest barrier as control site. The main aim of this paper is to perform monitoring of air dust pollution in the area by measuring of dust deposition, different metals associated with it, and probable adverse effects on human health. Concentrations of metals were measured by using Perkin-Elmer model Inductively Coupled Plasma and statistically evaluated with SPSS 17.0 statistical program. There was a correlation between some metals （Mn, Mo and Pb） and DD distribution. The daily limit values for concentration of DD proposed by national ＂Regulations on air quality＂ （200 mg/m^2d average annual value and 350 mg/m^2d high value） exceed at three measuring sites. The average maximum content of DD was 684.8 mg/m^2d downwind of CADDII, and the average minimum was 46.8 mg/m^2d at measuring site F. Concentrations of pollutants hazardous to the environment as Ni, Cr, Cu, Mo, Mn and Pb vary from one site to another.
文摘In this paper, the mechanical and thermal properties of a sand-clay ceramic with additives coal bottom ash (CBA) waste from incinerator coal power plant are investigated to develop an alternative material for thermal energy storage (TES). Ceramic balls are developed at 1000°C and 1060°C using sintering or firing method. The obtained ceramics were compressed with a compression machine and thermally analyse using Decagon devise KD2 Pro thermal analyser. A muffle furnace was also used for thermal cycling at 610°C. It was found that the CBA increased the porosity, which resulted in the increase of the axial tensile strength reaching 3.5 MPa for sand-clay and ash ceramic. The ceramic balls with the required tensile strength for TES were selected. Their volumetric heat capacity, and thermal conductivity range respectively from 2.4075 MJ·m-3·°C-1 to 3.426 MJ·m-3·°C-1 and their thermal conductivity from 0.331 Wm-1·K-1, to 1.014 Wm-1·K-1 depending on sand origin, size and firing temperature. The selected formulas have good thermal stability because the most fragile specimens after 60 thermal cycles did not present any cracks. These properties allow envisioning the use of the ceramic balls developed as filler material for thermocline thermal energy storage (structured beds) in Concentrating Solar Power plants. And for other applications like solar cooker and solar dryer.
文摘“双碳目标”背景下,煤电机组将长期作为主力调峰电源,保障电网安全稳定。储热是提升煤电机组灵活性的重要手段,但煤电耦合储热系统的运行特性尚不明确,不同储热技术与煤电机组耦合适应性亟待研究。为此,该文构建600 MW煤电-90 MW显热/潜热/热化学储热3种耦合系统,详细考察系统储/释热过程调峰能力及热力学性能,并基于优劣解距离法(technique for order preference by similarity to an ideal solution,TOPSIS)综合评价,明确最优耦合方案。研究发现,储热过程,Ca(OH)_(2)/CaO热化学储热的调峰容量、调峰深度及?效率均优于热水及熔融盐储热,而释热过程熔融盐储热性能最优;通过TOPSIS综合评价法确定热储热方案均为抽取主蒸汽作为热源,最佳释热方案均为以#2高加进水为冷源,同时确定煤电耦合熔融盐储热为最佳系统耦合方案。相关研究结论可为构建煤电耦合储热调峰系统提供一定的理论和数据支撑。
文摘In India coal combustion is the single largest source of emission of mercury which is a widespread persistent global toxicant,travelling across international borders through air and water.As a party to the Minamata convention,India aims to monitor and reduce Hg emissions and stricter norms are introduced for mercury emissions from power plants(30μg/Nm 3 for flue gas in stack).This paper presents the results obtained during the experimental studies performed on mercury emissions at four coal-fired and one lignite-fired power plants in India.The mercury concentration in the feed coal varied between 0.12-0.27 mg/Kg.In the mercury mass balance,significant proportion of feed coal mercury has been found to be associated with fly ash,whereas bottom ash contained very low mercury.80%-90%of mercury was released to air through stack gas.However,for circulating fluidised bed boiler burning lignite,about 64.8%of feed mercury was found to get captured in the fly ash and only 32.4%was released to air.The mercury emission factor was found to lie in the range of 4.7-15.7 mg/GJ.
