Thermodynamic Calculation of Si_3N_4-SiC Phase Equilibrium

SisN4 and SiC phase stability via gas phase reactions among SiO, CO/CO2 and N2 has been calculated based on thermochemical equilibrium. The influences of carbon activity (αC), and the partial pressure of SiO (PSiO), CO (PCO) and N2 (PN2) on the Si3N4-SiC stability have been studied and the related phase diagrams have been constructed. Result shows that the lowering αC and PCO/PSiO ratio and the increasing PN2 greatly elevate the Si3N4-SiC equilibrium temperature. Some previously observed experimental results related to Si3N4 and SiC formation at different temperature from the gas phase reactions have been discussed and some guides for sintering and synthesis Of the Si3N4 materials have been proposed

An experimental and thermodynamic equilibrium investigation of the Pb,Zn,Cr,Cu,Mn and Ni partitioning during sewage sludge incineration

The effects of different chlorides and operational conditions on the distribution and speciation of six heavy metals（Pb, Zn, Cr, Cu, Mn and Ni） during sludge incineration were investigated using a simulated laboratory tubular-furnace reactor. A thermodynamic equilibrium investigation using the Fact Sage software was performed to compare the experimental results. The results indicate that the volatility of the target metals was enhanced as the chlorine concentration increased. Inorganic-Cl influenced the volatilization of heavy metals in the order of Pb 〉 Zn 〉 Cr 〉 Cu 〉 Mn 〉 Ni. However, the effects of organic-Cl on the volatility of Mn, Pb and Cu were greater than the effects on Zn, Cr and Ni.With increasing combustion temperature, the presence of organic-Cl（PVC） and inorganic-Cl（NaCl） improved the transfer of Pb and Zn from bottom ash to fly ash or fuse gas. However,the presence of chloride had no obvious influence on Mn, Cu and Ni. Increased retention time could increase the volatilization rate of heavy metals; however, this effect was insignificant. During the incineration process, Pb readily formed Pb SiO4 and remained in the bottom ash. Different Pb compounds, primarily the volatile PbCl2, were found in the gas phase after the addition of NaCl; the dominant Pb compounds in the gas phase after the addition of PVC were PbCl2, Pb（ClO4）2and Pb Cl2O4.

Effects of nano-sized aluminum on detonation characteristics and metal acceleration for RDX-based aluminized explosive

Nano-sized aluminum(Nano-Al)powders hold promise in enhancing the total energy of explosives and the metal acceleration ability at the same time.However,the near-detonation zone effects of reaction between Nano-Al with detonation products remain unclear.In this study,the overall reaction process of 170 nm Al with RDX explosive and its effect on detonation characteristics,detonation reaction zone,and the metal acceleration ability were comprehensively investigated through a variety of experiments such as the detonation velocity test,detonation pressure test,explosive/window interface velocity test and confined plate push test using high-resolution laser interferometry.Lithium fluoride(LiF),which has an inert behavior during the explosion,was used as a control to compare the contribution of the reaction of aluminum.A thermochemical approach that took into account the reactivity of aluminum and ensuing detonation products was adopted to calculate the additional energy release by afterburn.Combining the numerical simulations based on the calculated afterburn energy and experimental results,the parameters in the detonation equation of state describing the Nano-Al reaction characteristics were calibrated.This study found that when the 170 nm Al content is from 0%to 15%,every 5%increase of aluminum resulted in about a 1.3%decrease in detonation velocity.Manganin pressure gauge measurement showed no significant enhancement in detonation pressure.The detonation reaction time and reaction zone length of RDX/Al/wax/80/15/5 explosive is 64 ns and 0.47 mm,which is respectively 14%and 8%higher than that of RDX/wax/95/5 explosive(57 ns and 0.39 mm).Explosive/window interface velocity curves show that 170 nm Al mainly reacted with the RDX detonation products after the detonation front.For the recording time of about 10 ms throughout the plate push test duration,the maximum plate velocity and plate acceleration time accelerated by RDX/Al/wax/80/15/5 explosive is 12%and 2.9 ms higher than that of RDX/LiF/wax/80/15/5,respectively,indicating that the aluminum reaction energy significantly increased the metal acceleration time and ability of the explosive.Numerical simulations with JWLM explosive equation of state show that when the detonation products expanded to 2 times the initial volume,over 80%of the aluminum had reacted,implying very high reactivity.These results are significant in attaining a clear understanding of the reaction mechanism of Nano-Al in the development of aluminized explosives.

Study on the interaction between inherent minerals of coal with refuse derived fuel(RDF)during co-firing

In this paper,refuse derived fuel(RDF)and bituminous coal were co-fired to investigate the particulate matter(PM)yields and the interaction between the inherit minerals in a lab-scale drop tube furnace(DTF).The PM1-10 yields during the co-firing of coal and RDF dramatically decreased by 16.29%~28.5%of the combustion of coal alone.In addition,methane auxiliary combustion inhibited the PM_(1) yields by 7.95%at air atmosphere.The Si-rich minerals in coal interreacted with the organic alkali(earth)metals in RDF,massively generating sticky particles with high liquid amount of K-Al-Si and Ca-Al-Si,promoting the transformation of fine grains into coarser mode.Moreover,it was proved that both methane auxiliary combustion and co-firing can reduce the emission of fine particles.The additional heat accelerated the burn of the char at the early stage of combustion,providing adequate time for the interaction between the inorganic species.Through thermodynamic equilibrium calculations of 1500~3000 fly ash grains,it was found that co-firing increased the formation of sticky particles by 64.8%~70.3%,resulting in a significant enhancement in capturing fine particles and Na,K vapor.Therefore,the co-firing of coal with RDF offers a promising approach to realize the harmless and resourceful treatment of municipal solid waste(MSW),and inhibit land resource losses caused by landfill.