This paper proposes the new cascaded series parallel design for improved dynamic performance of DC-DC buck boost converters by a new Sliding Mode Control (SMC) method. The converter is controlled using Sliding Mode Co...This paper proposes the new cascaded series parallel design for improved dynamic performance of DC-DC buck boost converters by a new Sliding Mode Control (SMC) method. The converter is controlled using Sliding Mode Control method that utilizes the converter’s duty ratio to determine the skidding surface. System modeling and simulation results are presented. The results also showed an improved overall performance over typical PID controller, and there was no overshoot or settling time, tracking the desired output nicely. Improved converter performance and robustness were expected.展开更多
In the modern era of manufacturing, it is important to optimize every design parameter in product development stage to reduce cost, material usage and to achieve the desired efficacy level. There are various models wh...In the modern era of manufacturing, it is important to optimize every design parameter in product development stage to reduce cost, material usage and to achieve the desired efficacy level. There are various models which serve those purposes, for instance, Design of Experiment (DoE) is used to check the parameters after adopting optimization tactics which results in reduced cost or saving operating time. In this regard, this research aims to construct a DoE model on a portable workstation to optimize its design parameters. The methodology of DOE would be a 2 level 3 factors full factorial DOE which is conducted to determine the optimal value for three design parameters (factors) which are material density, the length of the table and the length of the table stand in terms of the response which is the required time of fold ability function of the portable workstation. Based upon the evaluated interactions between the parameters, the optimized parameters are chosen for responses. Here, the resultant design parameters are at their lowest level, so the goal of time efficiency in fold ability function is achieved. This similar sort of DoE can be implemented in the furniture and other manufacturing industries who wish to optimize their material usage as well as increase efficiency and reduce cycle time.展开更多
文摘This paper proposes the new cascaded series parallel design for improved dynamic performance of DC-DC buck boost converters by a new Sliding Mode Control (SMC) method. The converter is controlled using Sliding Mode Control method that utilizes the converter’s duty ratio to determine the skidding surface. System modeling and simulation results are presented. The results also showed an improved overall performance over typical PID controller, and there was no overshoot or settling time, tracking the desired output nicely. Improved converter performance and robustness were expected.
文摘In the modern era of manufacturing, it is important to optimize every design parameter in product development stage to reduce cost, material usage and to achieve the desired efficacy level. There are various models which serve those purposes, for instance, Design of Experiment (DoE) is used to check the parameters after adopting optimization tactics which results in reduced cost or saving operating time. In this regard, this research aims to construct a DoE model on a portable workstation to optimize its design parameters. The methodology of DOE would be a 2 level 3 factors full factorial DOE which is conducted to determine the optimal value for three design parameters (factors) which are material density, the length of the table and the length of the table stand in terms of the response which is the required time of fold ability function of the portable workstation. Based upon the evaluated interactions between the parameters, the optimized parameters are chosen for responses. Here, the resultant design parameters are at their lowest level, so the goal of time efficiency in fold ability function is achieved. This similar sort of DoE can be implemented in the furniture and other manufacturing industries who wish to optimize their material usage as well as increase efficiency and reduce cycle time.
