Powertrain Torque Control Based on Torque Observer

To reduce shock during transmission gear shift, a transmission torque feedback closed loop control system is proposed based on the powertrain system model and a torque observer. The ignition time of engine was delayed to reduce transmission output shaft torque during gear shift. In contrast to traditional control method, the closed loop control system based on torque observer can obviously reduce the transmission output shaft torque during gear shift. It can be concluded that by way of torque feedback closed loop control, transmission shift shock can be reduced.

An Improved Stator Flux Observation Method of Permanent Magnet Synchronous Motor

The stator flux and electromagnetic torque observation is the basis of direct torque controlled permanent magnet synchronous motor( PMSM) drive system. However,the traditional stator flux observer based on voltage model is affected by integral initial values and integral drift,that based on current model is affected by the parameters of PMSM,so a new stator flux observation method is proposed based on an improved secondorder generalized integrator( SOGI). Compared to the stator flux observation method based on the conventional SOGI,the proposed method can not only overcome the influence of integral initial values and integral drift,but also completely eliminate the DC offset's influence. Therefore,the observation accuracy of stator flux is further improved. The simulation and experimental results both show that the proposed method has a higher stator flux and electromagnetic torque observation precision.

Force Compensation Control for Electro-Hydraulic Servo System with Pump-Valve Compound Drive via QFT-DTOC

Each joint of a hydraulic-driven legged robot adopts a highly integrated hydraulic drive unit(HDU),which features a high power-weight ratio.However,most HDUs are throttling-valve-controlled cylinder systems,which exhibit high energy losses.By contrast,pump control systems offer a high efficiency.Nevertheless,their response ability is unsatisfactory.To fully utilize the advantages of pump and valve control systems,in this study,a new type of pump-valve compound drive system(PCDS)is designed,which can not only effectively reduce the energy loss,but can also ensure the response speed and response accuracy of the HDUs in robot joints to satisfy the performance requirements of robots.Herein,considering the force control requirements of energy conservation,high precision,and fast response of the robot joint HDU,a nonlinear mathematical model of the PCDS force control system is first introduced.In addition,pressure-flow nonlinearity,friction nonlinearity,load complexity and variability,and other factors affecting the system are considered,and a novel force control method based on quantitative feedback theory(QFT)and a disturbance torque observer(DTO)is designed,which is denoted as QFT-DTOC herein.This method improves the control accuracy and robustness of the force control system,reduces the effect of the disturbance torque on the control performance of the servo motor,and improves the overall force control performance of the system.Finally,experimental verification is performed using the PCDS performance test platform.The experimental results and quantitative data show that the QFT-DTOC proposed herein can significantly improve the force control performance of the PCDS.The relevant force control method can be used as a bottom-control method for the hydraulic servo system to provide a foundation for implementing the top-level trajectory planning of the robot.

An adaptive load torque observer using hyperstability for PMSM servo system

An adaptive load torque observer is presented to compensate the torque ripple in PMSM servo system. A simple adaptive scheme is derived using Popov ＇ s hyperstability theory. The torque ripple detected by the observer is compensated by a feed forwarding equivalent current which gives fast response. The noisy current information is exempt from the observer to avoid its deterioration to the quality of the observer. The speed measurement delay is considered by using observed speed sinee the instantaneous velocity can＇t be estimated precisely at low speed because of too few position pulses from the absolute encoder during one time interval. Simulation and experimental results demonstrate that the proposed method can improve the dynamic performance of PMSM servo system satisfyingly.