The Yangtze Valley was one of the most important metallogenic regions during the Jurassic-Cretaceous period in East China, where more than 200 polymetallic Cu-Fe-Au, Mo, Zn, Pb, Ag deposits have been found. Trace elem...The Yangtze Valley was one of the most important metallogenic regions during the Jurassic-Cretaceous period in East China, where more than 200 polymetallic Cu-Fe-Au, Mo, Zn, Pb, Ag deposits have been found. Trace elements were chemically analyzed and the relevant data were collected from literature for the Yanshanian (Mesozoic) igneous rocks which have close relationship with Cu-Au mineralization. Copper mineralization in the lower Yangtze Valley can be divided into three major types: skarn type, porphyry type and volcanic type. The porphyry type is of rare occurrence, such as the Shaxi porphyry copper deposit in the northern part of the lower Yangtze metallogenic valley. This paper focuses on the REE and trace element geochemistry of several Cu-Au deposits along the lower part of Yangtze metallogenic valley in Anhui. The results showed that there are differences in REE distribution for these four types of Cu-Au mineralization, which confine the sources of REE and trace elements as well as other mantle and transitional compatible elements. The results of both REE and trace element geochemical studies showed that these elements with different characteristics have different origins, probably representing different sources of Cu-Au deposits in the deep crust and upper mantle environments. The 40Ar/39Ar dating of one biotite sample gave an age of 131 Ma with a high level of confidence, which represents the age of formation of the Shaxi porphyrite intrusive with porphrytic Cu-Au mineralization, which is consistent with that of the majority of the adjacent acid intrusives with mass Cu-Au mineralization along the Yangtze metallogenic belt in the Yanshanian period (Mesozoic). This is the first attempt to use the high precision method to date the Shaxi porphyrite intrusive.展开更多
Laser ablation–inductively coupled plasma–mass spectrometry（LA–ICP–MS） was used to determine the trace element concentrations of magnetite from the Heifengshan, Shuangfengshan, and Shaquanzi Fe（–Cu） deposits ...Laser ablation–inductively coupled plasma–mass spectrometry（LA–ICP–MS） was used to determine the trace element concentrations of magnetite from the Heifengshan, Shuangfengshan, and Shaquanzi Fe（–Cu） deposits in the Eastern Tianshan Orogenic Belt. The magnetite from these deposits typically contains detectable Mg, Al, Ti, V, Cr, Mn, Co, Ni, Zn and Ga. The trace element contents in magnetite generally vary less than one order of magnitude. The subtle variations of trace element concentrations within a magnetite grain and between the magnetite grains in the same sample probably indicate local inhomogeneity of ore–forming fluids. The variations of Co in magnetite between samples are probably due to the mineral proportion of magnetite and pyrite. Factor analysis has discriminated three types of magnetite： Ni–Mn–V–Ti（Factor 1）, Mg–Al–Zn（Factor 2）, and Ga– Co（Factor 3） magnetite. Magnetite from the Heifengshan and Shuangfengshan Fe deposits has similar normalized trace element spider patterns and cannot be discriminated according to these factors. However, magnetite from the Shaquanzi Fe–Cu deposit has affinity to Factor 2 with lower Mg and Al but higher Zn concentrations, indicating that the ore–forming fluids responsible for the Fe–Cu deposit are different from those for Fe deposits. Chemical composition of magnetite indicates that magnetite from these Fe（–Cu） deposits was formed by hydrothermal processes rather than magmatic differentiation. The formation of these Fe（–Cu） deposits may be related to felsic magmatism.展开更多
本文采用扫描金相-微区成分分析和 X 射线衍射物相分析方法,对 Cu-Zn-Cr 合金的组织结构进行了观察和分析,并测定了经过不同时效工艺处理后合金的拉伸力学性能和电学性能。研究结果表明:该合金经在线水淬+45%预冷变形+450℃时效4 h 后,...本文采用扫描金相-微区成分分析和 X 射线衍射物相分析方法,对 Cu-Zn-Cr 合金的组织结构进行了观察和分析,并测定了经过不同时效工艺处理后合金的拉伸力学性能和电学性能。研究结果表明:该合金经在线水淬+45%预冷变形+450℃时效4 h 后,其抗拉强度、屈服强度和延伸率分别达到482 MPa、388 MPa和23.6%,相对电导率则达到78.2%IACS。显微组织结构分析结果表明,时效态合金的力学性能由回复-再结晶软化和时效析出强化二个过程控制,合金的高强度主要源于预冷变形引起的亚结构强化和 Cr 粒子的析出强化。展开更多
文摘The Yangtze Valley was one of the most important metallogenic regions during the Jurassic-Cretaceous period in East China, where more than 200 polymetallic Cu-Fe-Au, Mo, Zn, Pb, Ag deposits have been found. Trace elements were chemically analyzed and the relevant data were collected from literature for the Yanshanian (Mesozoic) igneous rocks which have close relationship with Cu-Au mineralization. Copper mineralization in the lower Yangtze Valley can be divided into three major types: skarn type, porphyry type and volcanic type. The porphyry type is of rare occurrence, such as the Shaxi porphyry copper deposit in the northern part of the lower Yangtze metallogenic valley. This paper focuses on the REE and trace element geochemistry of several Cu-Au deposits along the lower part of Yangtze metallogenic valley in Anhui. The results showed that there are differences in REE distribution for these four types of Cu-Au mineralization, which confine the sources of REE and trace elements as well as other mantle and transitional compatible elements. The results of both REE and trace element geochemical studies showed that these elements with different characteristics have different origins, probably representing different sources of Cu-Au deposits in the deep crust and upper mantle environments. The 40Ar/39Ar dating of one biotite sample gave an age of 131 Ma with a high level of confidence, which represents the age of formation of the Shaxi porphyrite intrusive with porphrytic Cu-Au mineralization, which is consistent with that of the majority of the adjacent acid intrusives with mass Cu-Au mineralization along the Yangtze metallogenic belt in the Yanshanian period (Mesozoic). This is the first attempt to use the high precision method to date the Shaxi porphyrite intrusive.
基金financially supported by the Chinese 973 project(2012CB416804)the ‘‘CAS Hundred Talents’’ Project from the Chinese Academy of Sciences(KZCX2-YW-BR-09)to Qi Liang
文摘Laser ablation–inductively coupled plasma–mass spectrometry（LA–ICP–MS） was used to determine the trace element concentrations of magnetite from the Heifengshan, Shuangfengshan, and Shaquanzi Fe（–Cu） deposits in the Eastern Tianshan Orogenic Belt. The magnetite from these deposits typically contains detectable Mg, Al, Ti, V, Cr, Mn, Co, Ni, Zn and Ga. The trace element contents in magnetite generally vary less than one order of magnitude. The subtle variations of trace element concentrations within a magnetite grain and between the magnetite grains in the same sample probably indicate local inhomogeneity of ore–forming fluids. The variations of Co in magnetite between samples are probably due to the mineral proportion of magnetite and pyrite. Factor analysis has discriminated three types of magnetite： Ni–Mn–V–Ti（Factor 1）, Mg–Al–Zn（Factor 2）, and Ga– Co（Factor 3） magnetite. Magnetite from the Heifengshan and Shuangfengshan Fe deposits has similar normalized trace element spider patterns and cannot be discriminated according to these factors. However, magnetite from the Shaquanzi Fe–Cu deposit has affinity to Factor 2 with lower Mg and Al but higher Zn concentrations, indicating that the ore–forming fluids responsible for the Fe–Cu deposit are different from those for Fe deposits. Chemical composition of magnetite indicates that magnetite from these Fe（–Cu） deposits was formed by hydrothermal processes rather than magmatic differentiation. The formation of these Fe（–Cu） deposits may be related to felsic magmatism.
