Wavelet packet multicarrier system gains widespread concern because of its better resistance performance to Inter-Symbol Interference (ISI) and Inter-Carrier Interference (ICI), as well as the higher spectrum efficien...Wavelet packet multicarrier system gains widespread concern because of its better resistance performance to Inter-Symbol Interference (ISI) and Inter-Carrier Interference (ICI), as well as the higher spectrum efficiency. However, multicarrier system has a high Peak to Average Power Ratio (PAPR), which will lead to many problems such as lower system performance. In order to solve the problem, a kind of PAPR reduction method based on pruning Wavelet Packet Modulation (WPM) and Partial Transmit Sequences (PTS) technology is proposed in this paper, through proper pruning of the full-tree structure of wavelet packet modulation in the PTS technology to reduce the number of nodes in the system, and finally improve the reduction effect of PAPR. Simulation results show that when Complementary Cumulative Distribution Function (CCDF) is 10 -3 , PTS based on pruning WPM compared with PTS technique and pruning technique has improved about 1 dB and 1.5 dB, which will not affect the system's Bit Error Rate (BER) performance in the wavelet packet multicarrier system.展开更多
A 10Gb/s 6-tap transmit equalizer based on partial response signaling for high speed backplane transmission is presented. By combining features of equalizer and frequency-dependent channel,duobinary signaling can be g...A 10Gb/s 6-tap transmit equalizer based on partial response signaling for high speed backplane transmission is presented. By combining features of equalizer and frequency-dependent channel,duobinary signaling can be generated at the output of FR4 backplane,aiming at increasing data rate while reducing design complexity. Based on 0.18μm CMOS technology,this equalizer has been designed and fabricated,in which both variable capacitor and load resistor calibration techniques are explored to eliminate the effect of process variations. The chip occupies 0.68×0.8mm^2 including I/O pads and consumes a power of 194 mW with 1.8V power supply. Measurement results show that a typical 3-level eye diagram can be obtained at the receiver and the equalizer can work properly at the data rate of 10Gb/s.展开更多
文摘Wavelet packet multicarrier system gains widespread concern because of its better resistance performance to Inter-Symbol Interference (ISI) and Inter-Carrier Interference (ICI), as well as the higher spectrum efficiency. However, multicarrier system has a high Peak to Average Power Ratio (PAPR), which will lead to many problems such as lower system performance. In order to solve the problem, a kind of PAPR reduction method based on pruning Wavelet Packet Modulation (WPM) and Partial Transmit Sequences (PTS) technology is proposed in this paper, through proper pruning of the full-tree structure of wavelet packet modulation in the PTS technology to reduce the number of nodes in the system, and finally improve the reduction effect of PAPR. Simulation results show that when Complementary Cumulative Distribution Function (CCDF) is 10 -3 , PTS based on pruning WPM compared with PTS technique and pruning technique has improved about 1 dB and 1.5 dB, which will not affect the system's Bit Error Rate (BER) performance in the wavelet packet multicarrier system.
基金Supported by the National Natural Science Foundation of China(No.61471119)
文摘A 10Gb/s 6-tap transmit equalizer based on partial response signaling for high speed backplane transmission is presented. By combining features of equalizer and frequency-dependent channel,duobinary signaling can be generated at the output of FR4 backplane,aiming at increasing data rate while reducing design complexity. Based on 0.18μm CMOS technology,this equalizer has been designed and fabricated,in which both variable capacitor and load resistor calibration techniques are explored to eliminate the effect of process variations. The chip occupies 0.68×0.8mm^2 including I/O pads and consumes a power of 194 mW with 1.8V power supply. Measurement results show that a typical 3-level eye diagram can be obtained at the receiver and the equalizer can work properly at the data rate of 10Gb/s.
