Characterization of odorous charge and photochemical reactivity of VOC emissions from a full-scale food waste treatment plant in China

Food waste treatment plants （FWTPs） are usually associated with odorous nuisance and health risks, which are partially caused by volatile organic compound （VOC） emissions. This study investigated the VOC emissions from a selected full-scale FWTP in China. The feedstock used in this plant was mainly collected from local restaurants. For a year, the FWTP was closely monitored on specific days in each season. Four major indoor treatment units of the plant, including the storage room, sorting/crushing room, hydrothermal hydrolysis unit, and aerobic fermentation unit, were chosen as the monitoring locations. The highest mean concentration of total VOC emissions was observed in the aerobic fermentation unit at 21,748.2-31,283.3 μg/m^3, followed by the hydrothermal hydrolysis unit at 10,798.1-23,144.4 μg/m^3. The detected VOC families included biogenic compounds （oxygenated compounds, hydrocarbons, terpenes, and organosulfur compounds） and abiogenic compounds （aromatic hydrocarbons and halocarbons）. Oxygenated compounds, particularly alcohols, were the most abundant compounds in all samples. With the use of odor index analysis and principal components analysis, the hydrothermal hydrolysis and aerobic fermentation units were clearly distinguished from the pre-treatment units, as characterized by their higher contributions to odorous nuisance. Methanthiol was the dominant odorant in the hydrothermal hydrolysis unit, whereas aldehyde was the dominant odorant in the aerobic fermentation unit. Terpenes, specifically limonene, had the highest level of propylene equivalent concentration during the monitoring periods. This concentration can contribute to the increase in the atmospheric reactivity and ozone formation potential in the surrounding air.

Positively charged microporous ceramic membrane for the removal of Titan Yellow through electrostatic adsorption

To develop a depth filter based on the electrostatic adsorption principle, positively charged microporous ceramic membrane was prepared from a diatomaceous earth ceramic membrane.The internal surface of the highly porous ceramic membrane was coated with uniformly distributed electropositive nano-Y2O3 coating. The dye removal performance was evaluated through pressurized filtration tests using Titan Yellow aqueous solution. It showed that positively charged microporous ceramic membrane exhibited a flow rate of 421 L/（m^2·hr） under the trans-membrane pressure of 0.03 bar. Moreover it could effectively remove Titan Yellow with feed concentration of 10 mg/L between pH 3 to 8. The removal rate increased with the enhancement of the surface charge properties with a maximum rejection of 99.6%. This study provides a new and feasible method of removing organic dyes in wastewater. It is convinced that there will be a broad market for the application of charged ceramic membrane in the field of dye removal or recovery from industry wastewater.

Charge transfer between biogenic jarosite derived Fe^3＋ and TiO2 enhances visible light photocatalytic activity of TiO2

In this work, we have shown that mining waste derived Fe^3＋can be used to enhance the photocatalytic activity of TiO2. This will allow us to harness a waste product from the mines, and utilize it to enhance TiO2 photocatalytic waste water treatment efficiency. An organic linker mediated route was utilized to create a composite of TiO2 and biogenic jarosite. Evidence of Fe／O／Ti bonding in the TiO2/jarosite composite was apparent from the FTIR, EFTEM, EELS and ELNEFS analysis. The as prepared material showed enhanced photocatalytic activity compared to pristine TiO2, biogenic jarosite and mechanically mixed sample of jarosite and TiO2 under both simulated and natural solar irradiation. The prepared material can reduce the electrical energy consumption by 4 times compared to pristine P25 for degradation of organic pollutant in water. The material also showed good recyclability. Results obtained from sedimentation experiments showed that the larger sized jarosite material provided the surface to TiO2 nanoparticles, which increases the settling rate of the materials. This allowed simple and efficient recovery of the catalyst from the reaction system after completion of photocatalysis. Enhanced photocatalytic activity of the composite material was due to effective charge transfer between TiO2 and jarosite derived Fe^3＋as was shown from the EELS and ELNEFS. Generation of OHU was supported by photoluminesence（PL） experiments.