Genetic Control of Air-Dried Wood Density, Mechanical Properties and Its Implication for Veneer Timber Breeding of New Triploid Clones in Populus tomentosa Carr

The wood samples of 9 triploid clones of Populus tomentosa Carr. taken from a 9 year old clonal test site were analyzed in order to investigate the genetic variation of wood properties, including air dried wood density and some mechanical properties. The results showed that significant or extremely significant difference in air dried wood density and the mechanical properties existed among the clones, this means these wood properties were under moderate or strong genetic controls and could be improved by genetic manipulations. The radial and vertical variation patterns of air dried wood density were also studied and the results were found to coordinate with other previous research results. The vertical variation patterns of most mechanical properties within the individual tree also conformed to the general wood theories except the modulus of elasticity and cross section hardness. Among the mechanical properties, modulus of elasticity (MOE) and tangent section hardness were under strong genetic control, with the clonal repeatabilities being 0 90 and 0 80, respectively. However, the clonal repeatabilities of other mechanical properties under study were a little lower than above two indexes. Genetic correlation analysis indicated that super clonal selection and breeding for veneer timber could be realized through indirect selection of wood density and form indexes.

Lignin Characterization of Triploid Clones of Populus tomentosa Carr.

In order to understand the structural characteristics of lignin in triploid clones ofPopulus tomentosa and its changes in the processes of pulping and bleaching, milled wood lignin （MWL）, lignin carbohydrate complex （LCC） and the residual lignin from kraft pulp （KP） and sulfite pulp （SP） were isolated and analyzed by Fourier transform infrared （FTIR） spectrum and ^13C nuclear magnetic resonance （NMR）. The most diagnostic peaks were assigned and the differences were discussed. The spectral patterns reveal that triploid P tomentosa shows the specific features of hardwood from temperate areas, but in the spectrum of FTIR, the strength ratio orAl270 cm^-1 to A1226 cm^-1 is 0.88, higher than the average of hardwood from temperate areas, which will make the lignin delignification more difficult during pulping and bleaching. The LCC from triploid P tomentosa is mainly composed of xyloglucan and glucuronic acid, and other glucides have much lower ratio. In LCC FTIR, there are three peaks at 1 427, 1 329 and 1 046 cm^-1, indicating that both semi-cellulose and cellulose could exist in LCC, and that there might be relationships between cellulose and lignin. Compared with the residual lignin from KP and SP, the condensed structure in KP is more than that in SP.

Effects of Fertilization Treatments on Plantation Growth of Triploid Clones in Populus tomentosa

With four clones of triploid Populus tomentosa as materials, the effects of fertilization treatment on growth and physiological characters in terms of leaf nitrogen content, phosphorous content, potassium content, net photosynthetic rate, transpiration rate, water utilization efficiency and chlorophyll content have been studied. Compared with the general fertilizer as a control, the long-effect fertilizer, especially for Populus, produce more favorable results, for P. tomentosa on sandy land.