Experimental Study and Numerical Simulation of Directionally Solidified Turbine Blade Casting

The directional solidification process of turbine blade sample castings was investigated in the work. Variable withdrawal rates were used in one withdrawal process and compared with the other using uniform rate. A mathematical model for heat radiation transfer and microstructure simulation of directional solidification process was developed based on CA-FD method. The temperature distribution and microstructure w.ere simulated and compared with the experimental results. The stray grains were predicted and compared with the experimental results. The uneven temperature distribution of platform was the main reason of the formation of stray grains.

Multiscale modelling and simulation of single crystal superalloy turbine blade casting during directional solidification process

As the key parts of an aero-engine,single crystal(SX)superalloy turbine blades have been the focus of much attention.However,casting defects often occur during the manufacturing process of the SX turbine blades.Modeling and simulation technology can help to optimize the manufacturing process of SX blades.Multiscale coupled models were proposed and used to simulate the physical phenomena occurring during the directional solidification(DS)process.Coupled with heat transfer(macroscale)and grain growth(meso-scale),3D dendritic grain growth was calculated to show the competitive grain growth at micro-scale.SX grain selection behavior was studied by the simulation and experiments.The results show that the geometrical structure and technical parameters had strong influences on the grain selection effectiveness.Based on the coupled models,heat transfer,grain growth and microstructure evolution of a complex hollow SX blade were simulated.Both the simulated and experimental results show that the stray grain occurred at the platform of the SX blade when a constant withdrawal rate was used in manufacturing process.In order to avoid the formation of the stray crystal,the multi-scale coupled models and the withdrawal rate optimized technique were applied to the same SX turbine blade.The modeling results indicated that the optimized variable withdrawal rate can achieve SX blade castings with no stray grains,which was also proved by the experiments.

A real-time measuring technology for studying distortion of hydraulic turbine blade castings during heat treatment process

During heat treatment process, the distortion behavior inevitably appears in hydraulic turbine blade castings. In this research, a technology was developed for real-time measurement of the distortion in hydraulic turbine blade castings at the still air cooling and forced air cooling stages during heat treatment process. The method was used to measure the distortion behavior at the cooling stages in both normalizing and tempering processes. At the normalization, the distortion at the blade comer near outlet side undergoes four stages with alternating bending along positive and negative directions. At the tempering stage, the distortion could be divided into two steps. The temperature difference between the two surfaces of blade casting was employed to analyze the distortion mechanism. The measured results could be applied to guide the production, and the machining allowance could be reduced by controlling the distortion behavior.

Distortion behavior of hydro turbine blade castings during heat treatment processes under variation of seasonal temperature

Distortion often appears at the corners of heavy turbine blade castings during heat treatment processes, so a great machining allowance is generally set in production which directly results in cost increase. In this paper, a novel real-time measuring technology is developed for non-contact measuring the deformation behavior of heavy steel castings in heat treatment process. It was employed to measure the distortion and the temperature field of a batch of heavy turbine blade castings at cooling stage in normalizing process. Three inflection points appear in the distortion-time curves, and the residual distortion is affected by the regional area of not finished martensite transformation when the second inflection point appears. When the mean air temperature falls into the range of 10℃-20℃, the residual distortion is small; when it is lower than 10℃, positive distortion appears; when it is higher than 20℃, negative distortion appears. The distortion varies with seasonal temperature, which is directly responsible for the great machining allowance given in production.