Simulation of a Novel Schottky Body-Contacted Structure Suppressing Floating Body Effect in Partially-Depleted SOI nMOSFET's

A novel Schottky body-contacted structure for partially depleted SOI nMOSFET's is presented.This structure can be realized by forming a shallow n +-p junction and two sidewall spacers in the source region,and then growing a thick silicide film,which can punch through the shallow junction and make a Schottky contact to the p-type silicon.Simulation results show that the anomalous subthreshold slope and kink effects are suppressed successfully and the drain breakdown voltage is improved considerably.This method has the same device area and is completely compatible with the bulk MOSFET process.

Floating Body Effect in Partially Depleted SOI nMOSFET with Asymmetric Structure and Ge-Implantation

The floating body effect of an asymmetric and Ge implanted partially depleted 0 8μm SOI nMOSFET is investigated.It is found that the drain breakdown voltage can be improved by about 1V and that the anomalous subthreshold slope and kink effect are also lessened.It is believed that the shallow junction in the source and defect states introduced by Ge implantation are responsible for the reduction of the floating body effect.

Influence of Floating Body Effect on Radiation Hardness of PD SOI nMOSFETs

H-gate and closed-gate PD SOI nMOSFETs are fabricated on SIMOX substrate,and the influence of floating body effect on the radiation hardness is studied.All the subthreshold characteristics of the devices do not change much after radiation of the total dose of 106rad(Si).The back gate threshold voltage shift of closed-gate is about 33% less than that of H-gate device.The reason should be that the body potential of the closed-gate device is raised due to impact ionization,and an electric field is produced across the BOX.The floating body effect can improve the radiation hardness of the back gate transistor.

Wave Radiation and Diffraction by A Two-Dimensional Floating Body with An Opening Near A Side Wall

The radiation and diffraction problem of a two-dimensional rectangular body with an opening floating on a semi- infinite fluid domain of finite water depth is analysed based on the linearized velocity potential theory through an analytical solution procedure. The expressions for potentials are obtained by the method of variation separation, in which the unknown coefficients are determined by the boundary condition and matching requirement on the interface. The effects of the position of the hole and the gap between the body and side wall on hydrodynamic characteristics are investigated. Some resonance is observed like piston motion in a moon pool and sloshing in a closed tank because of the existence of restricted fluid domains.

Experimental Study of Nonlinear Behaviors of A Free-Floating Body in Waves

Nonlinear behaviors of a free-floating body in waves were experimentally investigated in the present study. The experiments were carried out for 6 different wave heights and 6 different wave periods to cover a relatively wide range of wave nonlinearities. A charge-coupled device （CCD） camera was used to capture the real-time motion of the floating body. The measurement data show that the sway, heave and roll motions of the floating body are all harmonic oscillations while the equilibrium position of the sway motion drifts in the wave direction. The drift speed is proportional to wave steepness when the size of the floating body is comparable to the wavelength, while it is proportional to the square of wave steepness when the floating body is relatively small. In addition, the drift motion leads to a slightly longer oscillation period of the floating body than the wave period of nonlinear wave and the discrepancy increases with the increment of wave steepness.

Side Wall Effects on the Hydrodynamics of a Floating Body by ImageGreen Function Based on TEBEM

A novel numerical model based on the image Green function and first-order Taylor expansion boundary element method(TEBEM), which can improve the accuracy of the hydrodynamic simulation for the non-smooth body, was developed to calculate the side wall effects on first-order motion responses and second-order drift loads upon offshore structures in the wave tank. This model was confirmed by comparing it to the results from experiments on hydrodynamic coefficients, namely the first-order motion response and second-order drift load upon a hemisphere, prolate spheroid, and box-shaped barge in the wave tank. Then,the hydrodynamics of the KVLCC2 model were also calculated in two wave tanks with different widths. It was concluded that this model can predict the hydrodynamics for offshore structures effectively, and the side wall has a significant impact on the firstorder quantities and second-order drift loads, which satisfied the resonant rule.

Mechanism of floating body effect mitigation via cutting off source injection in a fully-depleted silicon-on-insulator technology

In this paper, the effect of floating body effect （FBE） on a single event transient generation mechanism in fully depleted （FD） silicon-on-insulator （SOI） technology is investigated using three-dimensional technology computer-aided design （3D- TCAD） numerical simulation. The results indicate that the main SET generation mechanism is not carder drift/diffusion but floating body effect （FBE） whether for positive or negative channel metal oxide semiconductor （PMOS or NMOS）. Two stacking layout designs mitigating FBE are investigated as well, and the results indicate that the in-line stacking （IS） layout can mitigate FBE completely and is area penalty saving compared with the conventional stacking layout.

Numerical Investigation of Heave and Pitch Motion Effects on Green Water Loading for a Floating Body

In this paper,the influence of heave and pitch motions on green water impact on the deck is numerically investigated.The vessel motions are determined using a potential theory based method and provided as input to finite volume based CFD computations of green water phenomenon.A dynamic mesh approach is adopted to determine instantaneous body positioning in the fluid domain.Detailed validation studies with published experimental results for 2D and 3D fixed vessel cases are initially performed to validate the present numerical approach before studying the moving vessel problem.The results show that inclusion of heave and pitch motion changes the disturbed wave field near the bow which influences the free surface as well as the impact loading due to green water.The effect of wave steepness on green water impact is also investigated and it is seen that the present numerical method is capable of capturing green water load.It is observed that the effects of vessel motions on green water load are not negligible and one should consider this effect too.The incorporation of vessel motions in the vertical plane affects the green water loading on the deck.

Wave Drift Forces on Two Floating Bodies Arranged Side by Side

An innovative hydrodynamic theory and numerical model were developed to help improve the efficiency, accuracy, and convergence of the numerical prediction of wave drift forces on two side-by-side deepwater floating bodies. The wave drift forces were expressed by the double integration of source strength and the corresponding Green function on the body surface, which is consistent with the far field formula based on momentum conservation and sharing the advantage of near field calculations providing the drift force on each body. Numerical results were validated through comparing the general far field model and pressure integral model, as well as the middle field model developed usin^z the software HydroStar.

New Method for Predicting the Motion Responses of A Flexible Joint Multi-Body Floating System to Irregular Waves

A new hybrid method of frequency domain and time domain is developed in this paper to predict the motion responses of a flexibly joint multi-body floating system to irregular waves. The main idea of the method is that the three-dimensional frequency method is used to obtain the hydrodynamic coefficients and the response equations are solved in time domain step by step. All the forces can be obtained at the same time. The motions and nonlinear mooring forces of a box type six-body floating system are predicted. A comparison of the theoretical method-based Solutions with experimental results has shown good agreement.

Array Characteristics of Oscillating-Buoy Two-Floating-Body Wave-Energy Converter

As the energy supply problem worsens, the development and utilization of marine renewable energy have become a research hotspot. The development of wave energy is moving from the near shore to the distant sea. The power-generation efficiency of a single two-floating-body wave-energy converter is relatively low. To fully utilize wave energy and improve the wave-energy capture rate of a fixed sea area, arranging a two-floating-body wave-energy converter array is necessary. This paper first introduces the basic theory of multi-floating flow field, time-domain calculation method, and influence factor of the waveenergy converter array. Then, the development of AQWA software in Fortran language considers the effect of power takeoff. A calculation method based on ANSYS–AQWA is proposed to simulate the motion of the oscillating-buoy two-floating-body wave-energy converter. The results are compared with the experimental results from the National Renewable Energy Laboratory. Finally, the ANSYS–AQWA method is used to study the power characteristics of simple and complex arrays of wave-energy converters. The average power generation of simple arrays is largest at 0°, and the average power generation of complex arrays does not change with the wave direction. Optimal layout spacing exists for the simple and complex arrays. These findings can serve as a valuable reference for the large-scale array layout of wave-energy converters in the future.

Nonlinear Time-Domain Theory for the Simulation of Moored Floating Body Motion

Nonlinear wave loads can induce low-frequency and high-frequency resonance motions of a moored platform in deep water. For the analysis of the nonlinear response of an offshore platform under the action of irregular waves, the most widely used method in practice is the Cummins method, in which the second-order exciting forces in the time domain are computed by a two-term Volterra series model based on incident waves, first-order body motion response, and quadratic transfer functions(QTFs). QTFs are bichromatic waves acting on a body and are computed in the frequency domain in advance. For moving bodies, QTFs are related to the first-order body response, which is to be determined in the simulation process of body motion response but is unknown in the computation procedure of QTFs. In solving this problem, Teng and Cong(2017) proposed a method to divide the QTFs into different components,which are unrelated to the body response. With the application of the new QTF components, a modified Cummins method can be developed for the simulation of the nonlinear response of a moored floating platform. This paper presents a review of the theory.

Wave Radiation by a Floating Body in Water of Finite Depth Using an Exact DtN Boundary Condition

The present paper focuses on the wave radiation by an oscillating body with six degrees of freedom by using the DtN artifi-cial boundary condition.The artificial boundary is usually selected as a circle or spherical surface to solve various types of fields,such as sound waves or electromagnetic waves,provided that the considered domain is infinite or unbounded in all directions.However,the substantial wave motion is considered in water of finite depth,that is,the fluid domain is bounded vertically but unbounded horizon-tally.Thus,the DtN boundary condition is given on an artificial cylindrical surface,which divides the water domain into an interior and exterior region.The boundary integral equation is adopted to implement the present model.In the case of a floating cylinder,the results of hydrodynamic coefficients of a chamfer box are discussed.

Mathematical Modelling of Response Amplitude Operator for Roll Motion of a Floating Body：Analysis in Frequency Domain with Numerical Validation

This paper investigates mathematical modelling of response amplitude operator （RAO） or transfer function using the frequency-based analysis for uncoupled roll motion of a floating body under the influence of small amplitude regular waves. The hydrodynamic coefficients are computed using strip theory formulation by integrating over the length of the floating body. Considering sinusoidal wave with frequency （ω ） varying between 0.3 rad/s and 1.2 rad/s acts on beam to the floating body for zero forward speed, analytical expressions of RAO in frequency domain is obtained. Using the normalization procedure and frequency based analysis, group based classifications are obtained and accordingly governing equations are formulated for each case. After applying the fourth order Runge-Kutta method numerical solutions are obtained and relative importance of the hydrodynamic coefficients is analyzed. To illustrate the roll amplitude effects numerical experiments have been carried out for a Panamax container ship under the action of sinusoidal wave with a fixed wave height. The effect of viscous damping on RAO is evaluated and the model is validated using convergence, consistency and stability analysis. This modelling approach could be useful to model floating body dynamics for higher degrees of freedom and to validate the result.

THE SUDDEN STARTING OF A FLOATING BODY IN DEEP WATER

This paper applies Lagrangian method to discuss the sudden starting of a floating hotly in deep water and the analytical'solutions are obtained. It is known from the numerical results that the disturbing domain extends and the dynamic pressure also increases when the breadth of the floating body keeps constant and its depth increases.

Time-domain simulation for water wave radiation by floating structures (Part A)

Direct time-domain simulation of floating structures has advantages:it can calculate wave pressure fields and forces directly; and it is useful for coupled analysis of floating structures with a mooring system. A time-domain boundary integral equation method is presented to simulate three-dimensional water wave radiation problems. A stable form of the integration free-surface boundary condition (IFBC) is used to update velocity potentials on the free surface. A multi-transmitting formula (MTF) method with an artificial speed is introduced to the artificial radiation boundary (ARB). The method was applied to simulate a semi-spherical liquefied natural gas (LNG) carrier and a semi-submersible undergoing specified harmonic motion. Numerical parameters such as the form of the ARB, and the time and space discretization related to this method are discussed. It was found that a good agreement can be obtained when artificial speed is between 0.6 and 1.6 times the phase velocity of water waves in the MTF method. A simulation can be done for a long period of time by this method without problems of instability, and the method is also accurate and computationally efficient.

A novel planar vertical double-diffused metal-oxide-semiconductor field-effect transistor with inhomogeneous floating islands

A novel planar vertical double-diffused metal-oxide-semiconductor （VDMOS） structure with an ultra-low specific on-resistance （Ron,sp）, whose distinctive feature is the use of inhomogeneous floating p-islands in the n-drift region, is proposed. The theoretical limit of its Ron,sp is deduced, the influence of structure parameters on the breakdown voltage （BV） and Ron,sp are investigated, and the optimized results with BV of 83 V and Ron,sp of 54 mΩ.mm2 are obtained. Simulations show that the inhomogeneous-floating-islands metal-oxide-semiconductor field-effect transistor （MOSFET） has a superior ＂Ron,sp/BV＂ trade-off to the conventional VDMOS （a 38% reduction of Ron,sp with the same BV） and the homogeneous-floating-islands MOSFET （a 10% reduction of Ron,sp with the same BV）. The inhomogeneous-floatingislands MOSFET also has a much better body-diode characteristic than the superjunction MOSFET. Its reverse recovery peak current, reverse recovery time and reverse recovery charge are about 50, 80 and 40% of those of the superjunction MOSFET, respectively.

Coupled Aerodynamic and Hydrodynamic Analysis of Floating Offshore Wind Turbine Using CFD Method

To simulate floating offshore wind turbine(FOWT)in coupled wind-wave domain via CFD method,the NREL 5MW wind turbine supported by the OC3-Hywind Spar platform is modeled in the STAR-CCM+ software.Based on the Reynolds-averaged Navier-Stokes(RANS)equations and re-normalisation group(RNG)k-εturbulence model,the rotor aerodynamic simulation for wind turbine is conducted.Numerical results agree well with the NREL data.Taking advantage with the volume of fluid(VOF)method and dynamic fluid body interaction(DFBI)technology,the dynamic responses of the floating system with mooring lines are simulated under the coupled wind-wave sea condition.The free-decay tests for rigid-body degrees of freedom(DOFs)in still water and hydrodynamic tests in a regular wave are performed to validate the numerical model by comparing its result with the results simulated by FAST.Finally,the simulations of the overall FOWT system in the coupled wind-wave flow field are carried out.The relationship between the power output and dynamic motion responses of the platform is investigated.The numerical results show that the dynamic response of wind turbine performance and platform motions all vary in the same frequency as the inlet wave.During platform motion,the power output of wind turbine is more sensitive than the thrust force.This study may provide some reference for further research in the coupled aero-hydro simulation of FOWT.