IMPROVEMENTS ON THE ARC-LENGTH-TYPE METHOD

Arc-length-type and energy-type methods are two main strategies used in structural nonlinear tracing analysis, but the former is widely used due to the explicitness and clarity in conception, as well as the convenience and reliability in calculation. It is very important to trace the complete load-deflection path in order to know comprehensively the characteristics of structures subjected to loads. Unfortunately, the nonlinear analysis techniques are only workable for tracing the limit-point-type equilibrium path. For the bifurcation-point-type path, most of them cannot secure a satisfactory result. In this paper, main arc-length-type methods are reviewed and compared, and the possible reasons of failures in tracing analysis are briefly discussed. Some improvements are proposed, a displacement perturbation method and a force perturbation method are presented for tracing the bifurcation-point-type paths. Finally, two examples are analyzed to verify the ideas, and some conclusions are drawn with respect to the arc-length-type methods.

ON A FAMILY OF CHEBYSHEV-HALLEY TYPE METHODS IN BANACH SPACE UNDER WEAKER SMALE CONDITION

In this paper, we discuss local convergence of a family of Chebychev Halley type methods with a parameter θ∈[0,1] in Banach space using Smale type δ criterion under 2 th γ condition. We will see that the properties of the condition used for local convergence is much more different from that used in [6][15] for the semi-local convergence.

A New Newton-Type Method with Third-Order for Solving Systems of Nonlinear Equations

In this paper, a new two-step Newton-type method with third-order convergence for solving systems of nonlinear equations is proposed. We construct the new method based on the integral interpolation of Newton’s method. Its cubic convergence and error equation are proved theoretically, and demonstrated numerically. Its application to systems of nonlinear equations and boundary-value problems of nonlinear ODEs are shown as well in the numerical examples.

Self-accelerating two-step Steffensen-type methods with memory and their applications on the solution of nonlinear BVPs

In this paper, seven self-accelerating iterative methods with memory are derived from an optimal two-step Steffensen-type method without memory for solving nonlinear equations, their orders of convergence are proved to be increased,?numerical examples are demonstrat-ed demonstrated to verify the theoretical results, and applications for solving systems of nonlinear equations and BVPs of nonlinear ODEs are illustrated.

Hybrid Extragradient-Type Methods for Finding a Common Solution of an Equilibrium Problem and a Family of Strict Pseudo-Contraction Mappings

This paper proposes a new hybrid variant of extragradient methods for finding a common solution of an equilibrium problem and a family of strict pseudo-contraction mappings. We present an algorithmic scheme that combine the idea of an extragradient method and a successive iteration method as a hybrid variant. Then, this algorithm is modified by projecting on a suitable convex set to get a better convergence property. The convergence of two these algorithms are investigated under certain assumptions.

A PROJECTION-TYPE METHOD FOR SOLVING VARIOUS WEBER PROBLEMS

This paper investigates various Weber problems including unconstrained Weber problems and constrained Weber problems under l1, l2 and l∞-norms. First with a transformation technique various Weber problems are turned into a class of monotone linear variational inequalities. By exploiting the favorable structure of these variational inequalities, we present a new projection-type method for them. Compared with some other projection-type methods which can solve monotone linear variational inequality, this new projection-type method is simple in numerical implementations and more efficient for solving this class of problems; Compared with some popular methods for solving unconstrained Weber problem and constrained Weber problem, a singularity would not happen in this new method and it is more reliable by using this new method to solve various Weber problems.

A Newton type iterative method for heat-conduction inverse problems

An inverse problem for identification of the coefficient in heat-conduction equation is considered. After reducing the problem to a nonlinear ill-posed operator equation, Newton type iterative methods are considered. The implicit iterative method is applied to the linearized Newton equation, and the key step in the process is that a new reasonable a posteriori stopping rule for the inner iteration is presented. Numerical experiments for the new method as well as for Tikhonov method and Bakushikskii method are given, and these results show the obvious advantages of the new method over the other ones.

Types and Correction Methods of Matrix Effect during Zircon LA-ICP-MS U-Pb Dating

Matrix effect primarily impacts the accuracy and precision of zircon LA-ICP-MS U-Pb data.This paper describes three types of matrix effect in zircon LA-ICPMS U-Pb dating,i.e.,the element matrix effect,high Ddpa or uranium matrix effect and alpha dose matrix effect,and illustrates the correction of these three effects.In addition,we point out the limitation and possible problems of the existing correction methods.

A Discrete-type Continuation Regularization Method and its Application

Discrete-type continuation method for solving nonlinear system of equations and Tikhonov's regularization method for solving linear ill-posed problems are combined into a stable and widely convergent one for solving nonlinear operator equations with difficultly computed and ill-conditioned derivatives. Some results about their convergence are given The application of this method to solve the inverse problem of one-dimensional diffusion equation is demonstrated.

A Class of Mixed Type Methods for Solving Stiff ODEs and Their Parallel Implementation

This paper presents a class of methods with high order, good stability, and complete parallelism.This paper first puts the conception of free parameter with which we can choose some parameters in these methods to make these methods more useable. For several cases, we give concrete formulas and obtain numerical results for several methods. Numerical experiments show that these methods are efficient in solving stiff ODEs with high dimension.

Thermal conductivity measurements on xonotlite-type calcium silicate by the transient hot-strip method

The experimental results of the thermal conductivities of xonotlite-type calcium silicate insulation materials were presented at different temperatures and pressures. Two appropriative surroundings, i.e. an elevated temperature surrounding from ambient temperature to 1450 K and a vacuum surrounding from atmosphere pressure to 10-3 Pa, were designed for the transient hot-strip （THS） method. The thermal conductivities of xonotlite-type calcium silicate with four densities from ambient temperature to 1000 K and 0.045 Pa to atmospheric pressure were measured. The results show that the thermal conductivity of xonotlite-type calcium silicate decreases apparently with the fall of density, and decreases apparently with the drop of pressure, and reaches the least value at about 100 Pa. The thermal conductivity of xonotlite-type calcium silicate increases almost linearly with T0, and increases more abundantly with low density than with high density. The thermal conductivity measurement uncertainty is estimated to be approximately 3% at ambient temperature, and 6% at 800 K.

Study on “J”Type Offshore Pipeline-Laying Method

-Considering both the seabed foundation and wave, an analytic model of 'J' type is proposed for offshore pipeline-laying. The governing differential equation is also obtained for the pipeline on the seabed and for the suspension sections. By utilizing weighted- residual method and dual iteration technique, an approximate solution is obtained, too. In the end, calculation examples are given for analyzing the changeable relationship among the major parameters.

BIMORPH-TYPE PIEZOELECTRIC THIN FILM BENDING ACTUATORS SYNTHESIZED BY HYDROTHERMAL METHOD

Lead zirconate titanium solid-solution (PZT) thin films with variousthickness are synthesized on titanium substrates by repeated hydrothermal treatments. Young modulus,electric-field-induced displacement and the density of the PZT film are measured respectively.Bimorph- type bending actuators are fabricated using these films. The model, which is used toanalyze the driving ability of bimorph-type bending actuators by hydrothermal method, is set up. Itcan be seen that the driving ability of bimorph-type bending actuators can be greatly improved byoptimizing the thickness of PZT thin film and substrate from the theoretical analysis results. Themeasured values are expected to agree with the theoretical values calculated by the above model.

Meshless Method of Lines for Numerical Solution of Kawahara Type Equations

In this work, an algorithm based on method of lines coupled with radial basis functions namely meshless method of lines (MMOL) is presented for the numerical solution of Kawahara, modified Kawahara and KdV Kawahara equations. The motion of a single solitary wave, interaction of two and three solitons and the phenomena of wave generation is discussed. The results are compared with the exact solution and with the results in the relevant literature to show the efficiency of the method.

Three-dimensional Extension of the Unit-Feature Spatial Classification Method for Cloud Type

We describe how the Unit-Feature Spatial Classification Method(UFSCM) can be used operationally to classify cloud types in satellite imagery efficiently and conveniently.By using a combination of Interactive Data Language(IDL) and Visual C++(VC) code in combination to extend the technique in three dimensions(3-D),this paper provides an efficient method to implement interactive computer visualization of the 3-D discrimination matrix modification,so as to deal with the bi-spectral limitations of traditional two dimensional(2-D) UFSCM.The case study of cloud-type classification based on FY-2C satellite data (0600 UTC 18 and 0000 UTC 10 September 2007) is conducted by comparison with ground station data, and indicates that 3-D UFSCM makes more use of the pattern recognition information in multi-spectral imagery,resulting in more reasonable results and an improvement over the 2-D method.

Sign-Changing Solutions for Superlinear Kirchhoff Type Problem via the Nehari Method

In this paper, we consider a class of Kirchhoff type problem with superlinear nonlinearity. A sign-changing solution with exactly two nodal domains will be obtained by combining the Nehari method and an iterative technique.

A GENERALIZED GAUSS-TYPE QUADRATURE FORMULA AND ITS APPLICATIONS TO PSEUDOSPECTRAL METHOD

A generalized Gauss-type quadrature formula is introduced, which assists in selection of collocation points in pseudospectral method for differential equations with two-point derivative boundary conditions. Some results on the related Jacobi interpolation are established. A pseudospectral scheme is proposed for the Kuramoto-Sivashisky equation. A skew symmetric decomposition is used for dealing with the nonlinear convection term. The stability and convergence of the proposed scheme are proved. The error estimates are obtained. Numerical results show the efficiency of this approach.

The Exp-Function Method for Solving Two Dimensional Sine-Bratu Type Equations

In this paper, we apply Exp-function method to give traveling wave solutions of second order sine-Bratu type equations. This method is straightforward, concise and effective.

Type Synthesis of 4-DOF Parallel Kinematic Mechanisms Based on Grassmann Line Geometry and Atlas Method

Many methods are proposed to deal with the type synthesis of parallel kinematic mechanisms（PKMs）, but most of them are less intuitive to some extent. Thus, to propose a concise and intuitive type synthesis method for engineering application is a very challenging issue, which should be further studied in the field. Grassmann line geometry, which can investigate the dimensions of spatial line-clusters in a concise way, is taken as the mathematic foundation. Atlas method is introduced to visually describe the degrees of freedom（DOFs） and constraints of a mechanism, and the dual rule is brought in to realize the mutual conversion of the freedom-space and constraint-space. Consequently, a systematic method based on Grassmann line geometry and Atlas method is generated and the entire type synthesis process is presented. Three type 4-DOF PKMs, i.e., 1T3R, 2T2R and 3T1R（T： translational DOF; R： rotational DOF）, are classified according to the different combinations of the translational DOFs and rotational DOFs. The type synthesis of 4-DOF PKMs is carried out and the possible configurations are thoroughly investigated. Some new PKMs with useful functions are generated during this procedure. The type synthesis method based on Grassmann line geometry and Atlas method is intuitive and concise, and can reduce the complexity of the PKMs＇ type synthesis. Moreover, this method can provide theoretical guidance for other PKMs＇ type synthesis and engineering application. A novel type synthesis method is proposed, which solves the existing methods＇ problems in terms of complicated, not intuitive and unsuitable for practical application.

INTERPOLATION PERTURBATION METHOD FOR SOLVING THE BOUNDARY LAYER TYPE PROBLEMS

In this paper,on the basis of Ref.[1],the author studies the boundary value problems of the second-order differential equations,the highest order derivatives of which contain the small parameters.The numerical examples show that the calculating process of this method is quite simple and its accuracy is even higher than that of the multiple scales method.