Failure characteristics of surface vertical wells for relieved coal gas and their influencing factors in Huainan mining area

Based on data from through-hole and logging,we studied the failure characteristics of surface drainage wells for relieved coal gas in Huainan mining area and its influencing factors.The results show that the damaged positions of drainage wells are mainly located at the thick clay layer in the low alluvium and the lithological interface in the upper section of bedrock in west mining area.The failure depth of casing is 244-670 m and concentrates at about 270-460 m deep.These damaged positions are mainly located in the bending zone according to three zones of rock layers in the vertical section above the roof divided. Generally,the casing begins to deform or damage before the face line about 30-150 m.Special formation structure and rock mass properties are the direct causes of the casing failure,high mining height and fast advancing speed are fundamental reasons for rock mass damage.However,the borehole configuration and spacing to the casing failure are not very clear.

Mechanism of Surface Vertical Deformation in Parts of the Underground Gas Storage Reservoir of Hutubi, Xinjiang, China

The Underground Gas Storage( UGS) in Hutubi( HTB),Xinjiang is the largest gas storage reservoir in China and it has significance for coordinating the gas supply and demand relationship,peak-load regulation,implementation of strategic reserves,national security, and social economic sustainable development. Therefore, the deformation monitoring and simulation analysis of UGS operation has important technical support and reference value for the stability and safe operation of the underground gas storage. In this paper,we use the elevation data obtained from 7 periods of second-order leveling surveys in the Hutubi underground gas storage area in 2013- 2015 to analyze the influence of gas well pressure on the vertical deformation of the underground gas storage reservoir.Research has shown that the absolute vertical subsidence rate is approximately in the range from 11. 8mm to 16. 1mm and the relative subsidence change is about 4. 3mm,near the surface deformation of Hutubi underground gas storage area except for the annual subsidence rate of- 2. 86 mm by the basic influence of uplift of the Tianshan Mountains.Groundwater over-extraction in the Hutubi area also has an impact on the vertical variation of the surface in this region. The land surface change per unit pressure of gas storage has an impact of about 0. 625mm- 1. 125 mm. 17 scenes Terra SAR-X radar images acquired from August,2013 to August,2014 are exploited by Small Baseline Subset( SBAS) In SAR method to obtain the surface deformation time series during the operation of UGS in Hutubi,meanwhile combined with the pressure data of injection / productionwells,the multi-point source Mogi model is used to simulate the UGS deformation field in Hutubi. The results show that the deformation characteristics of the whole UGS area is a discontinuous distribution with the peak deformation value of 10 mm and- 8mm in the satellite line of sight( LOS) during gas injection and production,respectively and the retrieved deformation sequences correspond very well to the gas injection / production pressure changes. Based on the multi- point source Mogi model, we simulate the deformation process of UGS,HTB,and with the adaptive forward search method,the radius and depth of point source are obtained. The simulated results indicate that when the average injection / production pressure of UGS,HTB is 18 MPa and 15 MPa, LOS deformation is up to 7mm and- 4mm,respectively,and surface deformation is related to the density of gas injection( production) wells. The UGS gas distribution is not uniform,indicating that the structure of underground gas storage is complex. Thus using a more elaborate geomechanical model and other deformation observation data will be helpful for better simulating the UGS internal structure and explaining the mechanism of deformation.