Phase partition of acrylonitrile in the vinylidene chloride/water system at different temperature and under pressure was studied. A calculation method for average VDC-AN copolymer composition with AN phase partition c...Phase partition of acrylonitrile in the vinylidene chloride/water system at different temperature and under pressure was studied. A calculation method for average VDC-AN copolymer composition with AN phase partition considered was proposed. The calculated results are in good agreement with the experimental data nearly the entire conversion range. VDC-AN copolymer with narrower composition distribution can be prepared in the suspension process and interpreted with dynamic equilibrium of AN between the oil and water phases continuously.展开更多
The emeraldine base form of polyaniline (PANI) can be doped by a photo-induced doping method. In this method a. copolymer of vinylidene chloride and methyl acrylate (VCMAC) was used as photo acid generator which can r...The emeraldine base form of polyaniline (PANI) can be doped by a photo-induced doping method. In this method a. copolymer of vinylidene chloride and methyl acrylate (VCMAC) was used as photo acid generator which can release proton when it is exposed to ultraviolet light (lambda = 254 nm). The structure of PANI-VCMAC system before and after irradiation was characterized by elemental analysis, IR, XTP, anti SEM images. Results obtained indicate that the photo-induced doping characteristics, such as doping position and type of charge carriers, are similar to that of PANI doped with HCl. The poor room-temperature conductivity (similar to 10-S-5/cm) of PANI-VCMAC system after irradiation may be due to low doping degree (similar to pH=3) and the difference in morphology as compared with PANI-HCl film.展开更多
A series of vinylidene dichloride (VDC) copolymers with methyl acrylate (MA) as comonomer (3-12wt%), was prepared by free-radical suspension copolymerization. The permeability coefficients of the copolymers to oxygen ...A series of vinylidene dichloride (VDC) copolymers with methyl acrylate (MA) as comonomer (3-12wt%), was prepared by free-radical suspension copolymerization. The permeability coefficients of the copolymers to oxygen and carbon dioxide were measured at 1.0 MPa and at 30 degrees C, and those to water vapor were measured at 30 degrees C and 100% relative humidity. All the VDC/MA copolymers studied are semicrystalline. As the MA content increases, the permeability coefficients of the copolymers to oxygen, carbon dioxide, and water vapor are progressively increased, caused by decrease in crystalline fraction and increase in free volume of VDC/MA copolymers.展开更多
The emulsion copolymerization of vinylidene chloride (VDC) with methyl-methacrylate(MMA) and acrylonitrile (AN) was carried out by batch, seeded batch and semicontinuous pro-cesses,respectively. Significant difference...The emulsion copolymerization of vinylidene chloride (VDC) with methyl-methacrylate(MMA) and acrylonitrile (AN) was carried out by batch, seeded batch and semicontinuous pro-cesses,respectively. Significant differences were found in the physical and mechanical propertiesof the latexes and films, depending on the methods of monomer feeding. The results both intheory and experiments demonstrated that the copolymer composition and the length of the VDC sequences in the copolymer could be controlled by the modes of monomer feeding process.展开更多
The rotational isomeric state（RIS） model was constructed for poly（vinylidene chloride）（PVDC） based on quantum chemistry calculations. The statistical weighted parameters were obtained from RIS representations an...The rotational isomeric state（RIS） model was constructed for poly（vinylidene chloride）（PVDC） based on quantum chemistry calculations. The statistical weighted parameters were obtained from RIS representations and ab initio energies of conformers for model molecules 2,2,4,4-tetrachloropentane（TCP） and 2,2,4,4,6, 6-hexachloroheptane（HCH）. By employing the RIS method, the characteristic ratio C∞ was calculated for PVDC. The calculated characteristic ratio for PVDC is in good agreement with experiment result. Additionally, we studied the influence of the statistical weighted parameters on C∞ by calculating δC∞/δlnw. According to the values of δC∞/δlnw, the effects of second-order Cl-CH2 pentane type interaction and C1--C1 long range interaction on C∞ were found to be important. In contrast, first-order interaction is unimportant.展开更多
Twice-painting technique was adopted to prepare heavy-duty anticorrosive coating films formed by aqueous latexes of copolymers of vinylidene chloride（VDC） with an acrylate, namely methyl acrylate（MA）, ethyl acryl...Twice-painting technique was adopted to prepare heavy-duty anticorrosive coating films formed by aqueous latexes of copolymers of vinylidene chloride（VDC） with an acrylate, namely methyl acrylate（MA）, ethyl acrylate（EA）, butyl acrylate（BA） or 2-ethylhexyl acrylate（EHA）. Harsh salt-spray corrosion tests demonstrated that the optimized twicepainting technique was that the acidic latex solution was adjusted to p H 5-6 for the first painting, while it was utilized directly for the second painting. The test of 600 h of harsh salt-spray corrosion showed that MA-VDC85 coating could protect the steel excellently, whereas the other acrylate-VDC coatings with 75%-90% VDC content could not protect the steel so effectively. Further corrosion test showed that（1） MA-VDC85 coating protected steel from loss of metallic luster for at least 1000 h of salt-spray corrosion;（2） adhesion of MA-VDC85 coating to steel was excellent for at least 800 h of saltspray corrosion, but became very poor after 1000 h. Differential scanning calorimetry, thermogravimetric analysis, X-ray photoelectron spectroscopy and Fourier-transform infrared spectroscopy were used to evaluate the corroded MA-VDC85 film.展开更多
文摘Phase partition of acrylonitrile in the vinylidene chloride/water system at different temperature and under pressure was studied. A calculation method for average VDC-AN copolymer composition with AN phase partition considered was proposed. The calculated results are in good agreement with the experimental data nearly the entire conversion range. VDC-AN copolymer with narrower composition distribution can be prepared in the suspension process and interpreted with dynamic equilibrium of AN between the oil and water phases continuously.
基金The work was supported by the National Natural Science Foundation of China
文摘The emeraldine base form of polyaniline (PANI) can be doped by a photo-induced doping method. In this method a. copolymer of vinylidene chloride and methyl acrylate (VCMAC) was used as photo acid generator which can release proton when it is exposed to ultraviolet light (lambda = 254 nm). The structure of PANI-VCMAC system before and after irradiation was characterized by elemental analysis, IR, XTP, anti SEM images. Results obtained indicate that the photo-induced doping characteristics, such as doping position and type of charge carriers, are similar to that of PANI doped with HCl. The poor room-temperature conductivity (similar to 10-S-5/cm) of PANI-VCMAC system after irradiation may be due to low doping degree (similar to pH=3) and the difference in morphology as compared with PANI-HCl film.
基金This project supported by the National Natural Science Foundation of China
文摘A series of vinylidene dichloride (VDC) copolymers with methyl acrylate (MA) as comonomer (3-12wt%), was prepared by free-radical suspension copolymerization. The permeability coefficients of the copolymers to oxygen and carbon dioxide were measured at 1.0 MPa and at 30 degrees C, and those to water vapor were measured at 30 degrees C and 100% relative humidity. All the VDC/MA copolymers studied are semicrystalline. As the MA content increases, the permeability coefficients of the copolymers to oxygen, carbon dioxide, and water vapor are progressively increased, caused by decrease in crystalline fraction and increase in free volume of VDC/MA copolymers.
基金The project is supported by Beijing Natural Science Fund.
文摘The emulsion copolymerization of vinylidene chloride (VDC) with methyl-methacrylate(MMA) and acrylonitrile (AN) was carried out by batch, seeded batch and semicontinuous pro-cesses,respectively. Significant differences were found in the physical and mechanical propertiesof the latexes and films, depending on the methods of monomer feeding. The results both intheory and experiments demonstrated that the copolymer composition and the length of the VDC sequences in the copolymer could be controlled by the modes of monomer feeding process.
基金Supported by the National Natural Science Foundation of China(Nos.20490220, 20774036).
文摘The rotational isomeric state（RIS） model was constructed for poly（vinylidene chloride）（PVDC） based on quantum chemistry calculations. The statistical weighted parameters were obtained from RIS representations and ab initio energies of conformers for model molecules 2,2,4,4-tetrachloropentane（TCP） and 2,2,4,4,6, 6-hexachloroheptane（HCH）. By employing the RIS method, the characteristic ratio C∞ was calculated for PVDC. The calculated characteristic ratio for PVDC is in good agreement with experiment result. Additionally, we studied the influence of the statistical weighted parameters on C∞ by calculating δC∞/δlnw. According to the values of δC∞/δlnw, the effects of second-order Cl-CH2 pentane type interaction and C1--C1 long range interaction on C∞ were found to be important. In contrast, first-order interaction is unimportant.
基金financially supported by the Program for New Century Excellent Talents in Universitiesthe National Natural Science Foundation of China(No.21074088)
文摘Twice-painting technique was adopted to prepare heavy-duty anticorrosive coating films formed by aqueous latexes of copolymers of vinylidene chloride（VDC） with an acrylate, namely methyl acrylate（MA）, ethyl acrylate（EA）, butyl acrylate（BA） or 2-ethylhexyl acrylate（EHA）. Harsh salt-spray corrosion tests demonstrated that the optimized twicepainting technique was that the acidic latex solution was adjusted to p H 5-6 for the first painting, while it was utilized directly for the second painting. The test of 600 h of harsh salt-spray corrosion showed that MA-VDC85 coating could protect the steel excellently, whereas the other acrylate-VDC coatings with 75%-90% VDC content could not protect the steel so effectively. Further corrosion test showed that（1） MA-VDC85 coating protected steel from loss of metallic luster for at least 1000 h of salt-spray corrosion;（2） adhesion of MA-VDC85 coating to steel was excellent for at least 800 h of saltspray corrosion, but became very poor after 1000 h. Differential scanning calorimetry, thermogravimetric analysis, X-ray photoelectron spectroscopy and Fourier-transform infrared spectroscopy were used to evaluate the corroded MA-VDC85 film.
